Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconducting Quantum Information Processors: Coherence, Control and Quantum Spectroscopy

Antonio D’Arrigo, Elisabetta Paladino, G. Falci

Published Jan 1, 2009• 0 citations
OpenAlex

Abstract

Solid-state implementations of quantum bits are very promising for quantum computation, because of their potential scalability and integrability. On the other side solid state noise represents a serious limitation towards the target of solid state quantum computation. We illustrate various possibilities to apply quantum control techniques to solid state qubits. We focus on open loop quantum control, and show that a simple closed loop protocol can greatly improve the coherence time of single qubit gates.

Related papers

Designing the Electronic Interface for Qubit Control

Jeroen P. G. van Dijk

Quantum computers have gained widespread interest as they can potentially solve problems that are intractable even for today’s supercomputers, such as the simulation of quantum systems as initially proposed by Feynman. To achieve such tremendous progress, a quantum computer relies on processing the information stored in quantum bits (qubits), the fundamental units of quantum computation, similar to the bits in a classical (i.e., non-quantum) processor. In general, a quantum processor comprising several qubits is connected through a quantum-to-classical interface consisting of classical electrical circuits for manipulating and reading out their quantum state. The accuracy of an operation on a qubit is characterized using the fidelity, which is 100 % in case of a perfect operation. In practice, a fidelity between 99 % and 99.9 % is typically achieved in today’s experiments with less than 100 qubits, limited by non-idealities in the control signals and by the implementation of the physical qubit itself. Since such qubit fidelities are too low to execute relevant quantum algorithms, quantum error correction schemes have been developed which rely on a much larger number of qubits to correct for possible errors, resulting in the need for quantum processors with thousands or millions of qubits. Solid-state qubits promise the largescale integration required to scale to millions of qubits, as they exploit the lithographic fabrication techniques borrowed from the semiconductor industry. However, state-of-theart solid-state qubits, such as transmons and single-electron spin qubits, must be typically cooled to cryogenic temperatures in a dilution refrigerator to exhibit quantum behavior. Because of the limited number of qubits (< 100) in state-of-theart solid-state quantum processors, the classical controller is currently implemented by general-purpose instruments or by tailor-made controllers operating at room temperature connected via several wires to the qubits in the cryogenic chamber. However, these systems must scale to support millions of qubits. While scaling up the underlying quantum processor is already exceptionally challenging, building the electronics required to interface such a large-scale processor is just as relevant and arduous.

•Sep 15, 2021•4 citations

Josephson-Junction Qubits

Yuriy Makhlin, Gerd Schön, Alexander Shnirman

Among the potential physical implementations of quantum bits (qubits) solid state devices appear most promising for large scale applications and integration in electronic circuits. Devices based on low-capacitance Josephson junctions exploit the coherence of the superconducting state, combined with the possibility to control individual charges by Coulomb blockade effects. The logical states in these systems differ by one Cooper-pair charge. Single- and two-bit operations can be performed by applying a sequence of gate voltages. The phase coherence time is sufficiently long to allow a series of these steps. If, in addition, the strength of the Josephson coupling is controlled (e.g. by currents in SQUID loops) the system is ideal for quantum computation. Recent experiments by Nakamura et al. show the feasibility of this approach. In addition to the manipulations of qubits the resulting quantum state has to be read out. This quantum measurement process can be accomplished by coupling a single-electron transistor (SET) capacitively to the qubit. We investigate the process by analyzing the time-evolution of the density matrix of the coupled system. The measurement process is characterized by three time scales: the dephasing time, which is fast when a dissipative current flows in the SET, a longer ‘measurement time’ needed to read out the signal, and a third, even longer ‘mixing time’, characterizing measurement induced transitions which destroy the information about the initial quantum state. The noise spectrum of the current in the SET displays these time scales and allows their direct observation.

Fortschritte der Physik•Sep 1, 2000•11 citations

Decoherence of a Quantum Bit Circuit

Grégoire Ithier, François Nguyen, Eddy Collin +5 more

Solid state quantum bit circuits (qubits) are candidates for the implementation of quantum processors, which can in principle perform some computational tasks beyond reach of classical sequential processors. Decoherence is there a key issue since electrical circuits are more prone to decoherence than microscopic objects such as atoms. We introduce the different families of solid state qubits, which are either based on single particle states in semiconductor nanostructures, or on global quantum states of superconducting Josephson circuits. We treat more in detail the Cooper pair box Josephson circuit, and the quantronium circuit derived from it. In this device, a decoupling strategy of the circuit from the outside circuitry allows to improve quantum coherence. We expose results obtained on the manipulation of the qubit state in the quantronium. We develop a general framework for understanding decoherence in qubit circuits, and show how coherence time measurements allow to characterize noise sources coup. These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Birkhäuser Basel eBooks•Jan 1, 2006•0 citations

The first solid state qubit

J. S. Tsai, Yasunobu Nakamura, Yu. A. Pashkin

The proposal of quantum information processing has shown us the first serious possibility, though still limited in applications, to break away from the traditional spell that has been binding integration scale and processing power for some time. The qubit (quantum bit), the basic element of quantum information processing, consists of a quantum two-level system that can be brought to a superposition by an external mean. Among the numerous possible two-level systems, various typical microscopic two-level systems such as nuclear spins and atomic states have been utilized first to demonstrate the realization of quantum calculation. However, to realize a scaled-up version of a quantum computing system consisting of hundreds of qubits, a solid state electronics version of it is considered to be indispensable. We demonstrate the first electronic control of 1-qubit achieved in a solid state device using a submicron electron device called a single-electron box, a small conductive box connected to the outside by a tunnel junction and a gate capacitor. The scalability of such a solid state qubit is considered to be a prerequisite for a practical quantum computer of the future.

Conference digest•Nov 7, 2002•2 citations

Solid State Quantum Bits

Esteve, D., D. Vion

We present the solid-state quantum circuits that have been developed in order to implement quantum bits suitable for a quantum processor. These qubits are either based on the quantum state of a single particle (semiconductor qubits), or on the quantum state of the global circuit (superconducting qubits). We discuss more in detail the superconducting qubits, and present results on qubit manipulation and readout. We explain the main strategies used to improve and tio maintain quantum coherence.

arXiv:cond-mat/0505676•May 27, 2005•4 citations

Josephson‐Junction Qubits

Yuriy Makhlin, Gerd Schön, Alexander Shnirman

Among the potential physical implementations of quantum bits (qubits) solid state devices appear most promising for large scale applications and integration in electronic circuits. Devices based on low-capacitance Josephson junctions exploit the coherence of the superconducting state, combined with the possibility to control individual charges by Coulomb blockade effects. The logical states in these systems differ by one Cooper-pair charge. Single- and two-bit operations can be performed by applying a sequence of gate voltages. The phase coherence time is sufficiently long to allow a series of these steps. If, in addition, the strength of the Josephson coupling is controlled (e.g. by currents in SQUID loops) the system is ideal for quantum computation. Recent experiments by Nakamura et al. show the feasibility of this approach. In addition to the manipulations of qubits the resulting quantum state has to be read out. This quantum measurement process can be accomplished by coupling a single-electron transistor (SET) capacitively to the qubit. We investigate the process by analyzing the time-evolution of the density matrix of the coupled system. The measurement process is characterized by three time scales: the dephasing time, which is fast when a dissipative current flows in the SET, a longer ‘measurement time’ needed to read out the signal, and a third, even longer ‘mixing time’, characterizing measurement induced transitions which destroy the information about the initial quantum state. The noise spectrum of the current in the SET displays these time scales and allows their direct observation.

Wiley eBooks•Dec 20, 2000•3 citations
Solid-state implementations of quantum bits are very promising for quantum computation, because of their potential scalability and integrability. On the other side solid state noise represents a serious limitation towards the target of solid state quantum computation. We illustrate various possibilities to apply quantum control techniques to solid state qubits. We focus on open loop quantum control, and show that a simple closed loop protocol can greatly improve the coherence time of single qubit gates.
Quantum computers have gained widespread interest as they can potentially solve problems that are intractable even for today’s supercomputers, such as the simulation of quantum systems as initially proposed by Feynman. To achieve such tremendous progress, a quantum computer relies on processing the information stored in quantum bits (qubits), the fundamental units of quantum computation, similar to the bits in a classical (i.e., non-quantum) processor. In general, a quantum processor comprising several qubits is connected through a quantum-to-classical interface consisting of classical electrical circuits for manipulating and reading out their quantum state. The accuracy of an operation on a qubit is characterized using the fidelity, which is 100 % in case of a perfect operation. In practice, a fidelity between 99 % and 99.9 % is typically achieved in today’s experiments with less than 100 qubits, limited by non-idealities in the control signals and by the implementation of the physical qubit itself. Since such qubit fidelities are too low to execute relevant quantum algorithms, quantum error correction schemes have been developed which rely on a much larger number of qubits to correct for possible errors, resulting in the need for quantum processors with thousands or millions of qubits. Solid-state qubits promise the largescale integration required to scale to millions of qubits, as they exploit the lithographic fabrication techniques borrowed from the semiconductor industry. However, state-of-theart solid-state qubits, such as transmons and single-electron spin qubits, must be typically cooled to cryogenic temperatures in a dilution refrigerator to exhibit quantum behavior. Because of the limited number of qubits (< 100) in state-of-theart solid-state quantum processors, the classical controller is currently implemented by general-purpose instruments or by tailor-made controllers operating at room temperature connected via several wires to the qubits in the cryogenic chamber. However, these systems must scale to support millions of qubits. While scaling up the underlying quantum processor is already exceptionally challenging, building the electronics required to interface such a large-scale processor is just as relevant and arduous.
Among the potential physical implementations of quantum bits (qubits) solid state devices appear most promising for large scale applications and integration in electronic circuits. Devices based on low-capacitance Josephson junctions exploit the coherence of the superconducting state, combined with the possibility to control individual charges by Coulomb blockade effects. The logical states in these systems differ by one Cooper-pair charge. Single- and two-bit operations can be performed by applying a sequence of gate voltages. The phase coherence time is sufficiently long to allow a series of these steps. If, in addition, the strength of the Josephson coupling is controlled (e.g. by currents in SQUID loops) the system is ideal for quantum computation. Recent experiments by Nakamura et al. show the feasibility of this approach. In addition to the manipulations of qubits the resulting quantum state has to be read out. This quantum measurement process can be accomplished by coupling a single-electron transistor (SET) capacitively to the qubit. We investigate the process by analyzing the time-evolution of the density matrix of the coupled system. The measurement process is characterized by three time scales: the dephasing time, which is fast when a dissipative current flows in the SET, a longer ‘measurement time’ needed to read out the signal, and a third, even longer ‘mixing time’, characterizing measurement induced transitions which destroy the information about the initial quantum state. The noise spectrum of the current in the SET displays these time scales and allows their direct observation.
Solid state quantum bit circuits (qubits) are candidates for the implementation of quantum processors, which can in principle perform some computational tasks beyond reach of classical sequential processors. Decoherence is there a key issue since electrical circuits are more prone to decoherence than microscopic objects such as atoms. We introduce the different families of solid state qubits, which are either based on single particle states in semiconductor nanostructures, or on global quantum states of superconducting Josephson circuits. We treat more in detail the Cooper pair box Josephson circuit, and the quantronium circuit derived from it. In this device, a decoupling strategy of the circuit from the outside circuitry allows to improve quantum coherence. We expose results obtained on the manipulation of the qubit state in the quantronium. We develop a general framework for understanding decoherence in qubit circuits, and show how coherence time measurements allow to characterize noise sources coup. These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.
The proposal of quantum information processing has shown us the first serious possibility, though still limited in applications, to break away from the traditional spell that has been binding integration scale and processing power for some time. The qubit (quantum bit), the basic element of quantum information processing, consists of a quantum two-level system that can be brought to a superposition by an external mean. Among the numerous possible two-level systems, various typical microscopic two-level systems such as nuclear spins and atomic states have been utilized first to demonstrate the realization of quantum calculation. However, to realize a scaled-up version of a quantum computing system consisting of hundreds of qubits, a solid state electronics version of it is considered to be indispensable. We demonstrate the first electronic control of 1-qubit achieved in a solid state device using a submicron electron device called a single-electron box, a small conductive box connected to the outside by a tunnel junction and a gate capacitor. The scalability of such a solid state qubit is considered to be a prerequisite for a practical quantum computer of the future.
Among the potential physical implementations of quantum bits (qubits) solid state devices appear most promising for large scale applications and integration in electronic circuits. Devices based on low-capacitance Josephson junctions exploit the coherence of the superconducting state, combined with the possibility to control individual charges by Coulomb blockade effects. The logical states in these systems differ by one Cooper-pair charge. Single- and two-bit operations can be performed by applying a sequence of gate voltages. The phase coherence time is sufficiently long to allow a series of these steps. If, in addition, the strength of the Josephson coupling is controlled (e.g. by currents in SQUID loops) the system is ideal for quantum computation. Recent experiments by Nakamura et al. show the feasibility of this approach. In addition to the manipulations of qubits the resulting quantum state has to be read out. This quantum measurement process can be accomplished by coupling a single-electron transistor (SET) capacitively to the qubit. We investigate the process by analyzing the time-evolution of the density matrix of the coupled system. The measurement process is characterized by three time scales: the dephasing time, which is fast when a dissipative current flows in the SET, a longer ‘measurement time’ needed to read out the signal, and a third, even longer ‘mixing time’, characterizing measurement induced transitions which destroy the information about the initial quantum state. The noise spectrum of the current in the SET displays these time scales and allows their direct observation.