Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Semiconductor Science and Technology

Thermally induced absorptive optical bistability in GaAs/(Al,Ga)As multiple quantum wells

U Zimmermann, Dmytro Burak, K.-H. Schlaad, Claus F. Klingshirn

Published Jul 1, 1993• 10 citations
Publisher

Abstract

The temperature distribution in a GaAs/(Al,Ga)As multiple quantum well structure was measured with high lateral and temporal resolution while passing through the characteristic hysteresis loop of a thermally induced absorptive optical bistability. In a pump and probe beam experiment, the local transmission spectra of the quantum well structure were recorded and the temperature distribution in the sample was deduced from the spectral positions of characteristic exciton resonances. These resonances remain sufficiently sharp even far above room temperature to guarantee an accuracy of better than 3 K The experiment was conducted under both steady-state and dynamical conditions. The steady-state results were compared with numerical calculations, showing good agreement. The dependence of the relative width of the characteristic hysteresis on the environmental temperature of the bistable sample was investigated. A simple relaxation-time model of the bistability was shown to describe nicely the observed behaviour if the bleaching of the lowest exciton resonance due to high laser intensities is considered. Based on this dependence, a miniature temperature-sensing device using an optical fibre to guide the laser beam is presented.

DOI
10.1088/0268-1242/8/7/033

Related papers

Room-temperature excitonic optical bistability in bulk GaAs

Jack L. Jewell, Seth Ovadia, Nasser N. Peyghambarian +4 more

Optical bistable devices containing GaAs/AlGaAs multiple quantum well (MQW) structures have shown great potential for performing fast low-power optical switching at room temperature.1 The presence of a much stronger exciton absorption feature in the MQW structures compared to bulk GaAs suggests far superior performance in the former. We report the observation of room-temperature bistability in bulk GaAs with input power <10 mW and intensities of a few kW/cm2. The intensities are consistent with the data of Miller et al.2 which show a saturation intensity of nearly 4 kW/cm2 in a MQW sample with a detuning of less than a halfwidth from the peak of the exciton resonance. Our detunings are always several halfwidths.

Conference on Lasers and Electro-Optics•Jan 1, 1984•1 citation

Intracavity optical bistability in the presence of optically induced absorption

M. Dagenais, Elisa Surkis, Wayne F. Sharfin +1 more

Optical bistability in the presence of an optically induced absorption is observed when a thin 13-μm CdS sample is inserted between two mirrors of 90 % reflectivity, in our experiment, a modulated cw laser of ~15-mW peak power is tuned on each side of the free exciton resonance in CdS, and the transmission characteristics are studied. A theoretical calculation including both absorptive and dispersive effects is presented and good agreement is obtained. The absorption coefficient and the index of refraction of the material are connected by Kramers-Kronig relations. Propagation effects are taken into account. Sufficiently long pulses (40 ms) are considered to allow the thermally induced absorption to occur. For detunings above the free exciton resonance, we predict that counterclockwise hysteresis loops will first be observed as the intensity rises; for detunings below the free exciton resonance, only clockwise hysteresis loops are predicted. These predictions were experimentally verified. Power levels of the order of 5–10 mW were sufficient to observe bistability. Cavity effects were also observed.

Annual Meeting Optical Society of America•Jan 1, 1985•0 citations

Models for Absorption-induced Optical Bistability in CdS and Multiple Quantum Well GaAs

Joseph W. Haus, Chi C. Sung, Y. C. Li +2 more

Mirrorless optical bistability has been established in CdS1 and in multiple quantum well (MQW) GaAs structures2. The mechanism responsible for the bistable behavior in these semiconductors is the coupling between the temperature distribution and the electric field intensity in the sample. In these semiconductors, the mechanism is simple enough that a quantitative analysis should be possible. However, a successful model of bistability in these systems must await a careful experimental analysis of the thermal boundary conditions3. With this caveat we have proceeded with the theoretical development. Steady-state results for CdS and MQW GaAs are presented.

Topical Meeting on Optical Bistability (OB)•Jan 1, 1985•0 citations

Thermally Induced Optical Bistability at Room Temperature in GaAs/AlGaAs Multiple Quantum Wells

Alan Miller, G. Steward, Peter Blood +1 more

Results on both dispersive optical bistability and bistability by increasing absorption are presented for multiple quantum wells consisting of 120 wells of 63 + thickness GaAs separated by 218 + thick barriers of Al0·4 Ga0·6As. Optical bistability is observed in the wavelength range 845–870nm for incident powers below 10mW. A second absorptive switching feature unique to quantum wells is observed at the n=2 transition. Wavelength bistability is also reported for the first time.

Optica Acta International Journal of Optics•Apr 1, 1986•8 citations

Optical bistability in the multiple quantum well structure

Chi C. Sung, Charles M. Bowden, John C. Englund +1 more

The multiple quantum well structure, GaAs/GaAIAs, displays room temperature optical bistability at very low switching powers in various conditions through the temperature variation and the external voltage across the sample.1,2 We have constructed detailed models to calculate these effects. Coupled Maxwell’s equations and the heat conduction equation are solved to demonstrate how the red shift of the band gap leads to absorptive bistability. The spatial variation of the external field strength is a typical PIN junction and the experimental values of the absorption coefficient are used to obtain the bistability properties as a function of the incident frequency and the biased external voltage. The results based on the actual material constants are in good agreement with the experimental data without adjustable parameters. We also extend the previous work on the stability analysis in the mean-field approximation to this system involving complicated boundary conditions with the propagation effects.

Annual Meeting Optical Society of America•Jan 1, 1986•0 citations

Room-temperature excitonic optical properties in ZnSe-ZnS/GaAs multiple quantum wells

De Z. Shen, Hongyu Li, Jiying Zhang +1 more

Excitonic optical bistability with nanosecond switching time in ZnSe-ZnS multiple quantum wells (MQWs) with a Fabry-Perot (FP) cavity is investigated at room temperature. The research result indicates that the threshold and contrast ratio for the optical bistability in ZnSe-ZnS MQWs with a FP cavity are about 0.2 MW/cm2 and 6:1, respectively. On the basis of the room temperature excitonic absorption spectra obtained here, we attribute the major nonlinear mechanism for the optical bistability to the excitonic saturating absorption due to phase space filling of excitonic states and excitonic band broadening.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 20, 1998•0 citations
The temperature distribution in a GaAs/(Al,Ga)As multiple quantum well structure was measured with high lateral and temporal resolution while passing through the characteristic hysteresis loop of a thermally induced absorptive optical bistability. In a pump and probe beam experiment, the local transmission spectra of the quantum well structure were recorded and the temperature distribution in the sample was deduced from the spectral positions of characteristic exciton resonances. These resonances remain sufficiently sharp even far above room temperature to guarantee an accuracy of better than 3 K The experiment was conducted under both steady-state and dynamical conditions. The steady-state results were compared with numerical calculations, showing good agreement. The dependence of the relative width of the characteristic hysteresis on the environmental temperature of the bistable sample was investigated. A simple relaxation-time model of the bistability was shown to describe nicely the observed behaviour if the bleaching of the lowest exciton resonance due to high laser intensities is considered. Based on this dependence, a miniature temperature-sensing device using an optical fibre to guide the laser beam is presented.
Optical bistable devices containing GaAs/AlGaAs multiple quantum well (MQW) structures have shown great potential for performing fast low-power optical switching at room temperature.1 The presence of a much stronger exciton absorption feature in the MQW structures compared to bulk GaAs suggests far superior performance in the former. We report the observation of room-temperature bistability in bulk GaAs with input power <10 mW and intensities of a few kW/cm2. The intensities are consistent with the data of Miller et al.2 which show a saturation intensity of nearly 4 kW/cm2 in a MQW sample with a detuning of less than a halfwidth from the peak of the exciton resonance. Our detunings are always several halfwidths.
Optical bistability in the presence of an optically induced absorption is observed when a thin 13-μm CdS sample is inserted between two mirrors of 90 % reflectivity, in our experiment, a modulated cw laser of ~15-mW peak power is tuned on each side of the free exciton resonance in CdS, and the transmission characteristics are studied. A theoretical calculation including both absorptive and dispersive effects is presented and good agreement is obtained. The absorption coefficient and the index of refraction of the material are connected by Kramers-Kronig relations. Propagation effects are taken into account. Sufficiently long pulses (40 ms) are considered to allow the thermally induced absorption to occur. For detunings above the free exciton resonance, we predict that counterclockwise hysteresis loops will first be observed as the intensity rises; for detunings below the free exciton resonance, only clockwise hysteresis loops are predicted. These predictions were experimentally verified. Power levels of the order of 5–10 mW were sufficient to observe bistability. Cavity effects were also observed.
Mirrorless optical bistability has been established in CdS1 and in multiple quantum well (MQW) GaAs structures2. The mechanism responsible for the bistable behavior in these semiconductors is the coupling between the temperature distribution and the electric field intensity in the sample. In these semiconductors, the mechanism is simple enough that a quantitative analysis should be possible. However, a successful model of bistability in these systems must await a careful experimental analysis of the thermal boundary conditions3. With this caveat we have proceeded with the theoretical development. Steady-state results for CdS and MQW GaAs are presented.
The multiple quantum well structure, GaAs/GaAIAs, displays room temperature optical bistability at very low switching powers in various conditions through the temperature variation and the external voltage across the sample.1,2 We have constructed detailed models to calculate these effects. Coupled Maxwell’s equations and the heat conduction equation are solved to demonstrate how the red shift of the band gap leads to absorptive bistability. The spatial variation of the external field strength is a typical PIN junction and the experimental values of the absorption coefficient are used to obtain the bistability properties as a function of the incident frequency and the biased external voltage. The results based on the actual material constants are in good agreement with the experimental data without adjustable parameters. We also extend the previous work on the stability analysis in the mean-field approximation to this system involving complicated boundary conditions with the propagation effects.
Excitonic optical bistability with nanosecond switching time in ZnSe-ZnS multiple quantum wells (MQWs) with a Fabry-Perot (FP) cavity is investigated at room temperature. The research result indicates that the threshold and contrast ratio for the optical bistability in ZnSe-ZnS MQWs with a FP cavity are about 0.2 MW/cm2 and 6:1, respectively. On the basis of the room temperature excitonic absorption spectra obtained here, we attribute the major nonlinear mechanism for the optical bistability to the excitonic saturating absorption due to phase space filling of excitonic states and excitonic band broadening.