Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Method for Calculating Simultaneous Resonance Conditions in a Three-Level Ruby Maser

Martin A. Garstens

Published Jul 1, 1959• 1 citation
Publisher

Abstract

In operating a three-level maser one wishes to know the external magnetic field and crystal orientation necessary to match a given pair of frequencies. In the case of Cr+++ a fourth-degree secular equation determines four energy levels for each value of external field H and crystal orientation θ. Determination of the latter two variables, given two desired frequencies of operation, ordinarily involves either the solution of a tremendous number of fourth-degree equations and extrapolation towards the required solution, or determination of the matching conditions by experimental methods. In the following a method is described, allowing direct calculation of H and θ for a three-level ruby maser.

DOI
10.1063/1.1777000

Related papers

Paramagnetic Spectra of Substituted Sapphires-Part I: Ruby*

E. O. Schulz-DuBois

The paramagnetic resonance properties of Cr+++ions in Al2O3(ruby) were investigated theoretically and experimentally in order to obtain information necessary for the application of this material as active material in a three-level solid-state maser (3LSSM). Numerically computed energy levels, together with their associated eigenvectors, are presented as a function of applied magnetic field for various orientations of the magnetic field with respect to the crystalline symmetry axis. A more detailed discussion is devoted to energy levels, eigenvectors and transition probabilities at angles O°, 54.74° and 90°, where certain simple relations and symmetries hold. Paramagnetic spectra for signal frequencies between 5 and 24 kmc are shown; agreement between computed and measured resonance fields is satisfactory.

Bell System Technical Journal•Jan 1, 1959•120 citations

A simplified method for the analysis of self-cross-relaxation masers

HUANG WU-HAN, LIN FU-CHENG

A simplified method for the analysis of the effect of self-cross-relaxation on the maser performance is proposed. Calculation of any four-level system involving not more than triple cross-relaxation processes is carried out by means of this method, and some operative modes which may possibly yield improved performance are given. As illustrative examples, some typical design considerations and results are given for X band and S band ruby cavity masers.

Proceedings of the Physical Society•Nov 1, 1964•0 citations

Cavity Maser Experiments using Ruby at S Band†

W.S.C. Chang, J.C. Cromack, Anthony E.. Siegman

A three-level solid-state maser using ruby has been operated at frequencies near 3000 Mc/s, using a high-efficiency cavity having TEM modes in a rectangular geometry. Two different operating points in the θ = 10° to θ =30 ° region of the ruby spectrum gave maser operation with a pump frequency near 10 500 Mc/s, although the inversion obtained was a. sensitive function of the exact operating point. An operating point at θ = 90°, requiring pumping at 13 500 Mc/s, gave a gain-bandwidth product of better than 50 Mc/s. It was also found possible to pump the 1-4 or ΔM = 3 transition at this same operating point, obtaining 3000 Mc/s amplification with a 23 700 Mc/s pump frequency. Although this mode of operation was not fully explored, it is potentially capable of increasing the gain-bandwidth product by a substantial amount.

Journal of Electronics and Control•Jun 1, 1959•4 citations

Cross-Relaxation Effects in a Ruby L?Band (1440 Mc/s) Maser at Low Magnetic Fields

G S Bogle, F. F. Gardner

The reversals of maser behaviour which occur in ruby at low fields on cooling from 80° to 4 oK are explained in terms of cross-relaxation transitions (resonant interchanges of energy between neighbouring paramagnetic ions). For an angle of 29° between the magnetic field and the crystal axis a cross-relaxation process has been demonstrated which involves groups of three ions and has a transition probability of 700± 100 per second in 0·013% ruby. The profile of the cross-relaxation resonance has a half-width of 190±30 Mcts at half-intensity, and has an approximately Gaussian shape. It should be possible to obtain useful low-field L-band maser action at 4 oK by pumping V41 with the magnetic field nearly perpendicular to the crystal axis, and also at 80 oK using a concentration ten times higher, i.e. 0·13%

Australian Journal of Physics•Sep 1, 1961•4 citations

Ruby as a Maser Material

Chihiro Kikuchi, John Lambe, George Makhov +1 more

The reasons for the initial choice of ruby as a maser material are outlined and some measurements of the parameters in the spin Hamiltonian and of spin relaxation times are reported. The relative merits of single- and double-pump modes of operation of a four-level maser are discussed and measurements of the oscillator power for the two cases are included.

Journal of Applied Physics•Jul 1, 1959•63 citations

Seesaw Maser Operation

Paul Forrester, W. B. Mims

Cross relaxation between adjacent intervals may be used to secure an advantage in maser operation comparable to that obtained by ``push-pull'' pumping. Equations for the rate of change of populations in a scheme of four levels (A,B,C,D) when AC is pumped and cross relaxation takes place between BC, CD have been formulated, and the steady-state condition corresponding to various assumptions regarding lattice relaxation times is discussed. In an experimental investigation of maser operation based on this scheme and using ruby as the active material, an inversion of 0.9:1 was obtained at a signal frequency of 14.5 kMc when pumping at 24.5 kMc.

Journal of Applied Physics•Feb 1, 1961•3 citations
In operating a three-level maser one wishes to know the external magnetic field and crystal orientation necessary to match a given pair of frequencies. In the case of Cr+++ a fourth-degree secular equation determines four energy levels for each value of external field H and crystal orientation θ. Determination of the latter two variables, given two desired frequencies of operation, ordinarily involves either the solution of a tremendous number of fourth-degree equations and extrapolation towards the required solution, or determination of the matching conditions by experimental methods. In the following a method is described, allowing direct calculation of H and θ for a three-level ruby maser.
The paramagnetic resonance properties of Cr+++ions in Al2O3(ruby) were investigated theoretically and experimentally in order to obtain information necessary for the application of this material as active material in a three-level solid-state maser (3LSSM). Numerically computed energy levels, together with their associated eigenvectors, are presented as a function of applied magnetic field for various orientations of the magnetic field with respect to the crystalline symmetry axis. A more detailed discussion is devoted to energy levels, eigenvectors and transition probabilities at angles O°, 54.74° and 90°, where certain simple relations and symmetries hold. Paramagnetic spectra for signal frequencies between 5 and 24 kmc are shown; agreement between computed and measured resonance fields is satisfactory.
A three-level solid-state maser using ruby has been operated at frequencies near 3000 Mc/s, using a high-efficiency cavity having TEM modes in a rectangular geometry. Two different operating points in the θ = 10° to θ =30 ° region of the ruby spectrum gave maser operation with a pump frequency near 10 500 Mc/s, although the inversion obtained was a. sensitive function of the exact operating point. An operating point at θ = 90°, requiring pumping at 13 500 Mc/s, gave a gain-bandwidth product of better than 50 Mc/s. It was also found possible to pump the 1-4 or ΔM = 3 transition at this same operating point, obtaining 3000 Mc/s amplification with a 23 700 Mc/s pump frequency. Although this mode of operation was not fully explored, it is potentially capable of increasing the gain-bandwidth product by a substantial amount.
The reversals of maser behaviour which occur in ruby at low fields on cooling from 80° to 4 oK are explained in terms of cross-relaxation transitions (resonant interchanges of energy between neighbouring paramagnetic ions). For an angle of 29° between the magnetic field and the crystal axis a cross-relaxation process has been demonstrated which involves groups of three ions and has a transition probability of 700± 100 per second in 0·013% ruby. The profile of the cross-relaxation resonance has a half-width of 190±30 Mcts at half-intensity, and has an approximately Gaussian shape. It should be possible to obtain useful low-field L-band maser action at 4 oK by pumping V41 with the magnetic field nearly perpendicular to the crystal axis, and also at 80 oK using a concentration ten times higher, i.e. 0·13%
Cross relaxation between adjacent intervals may be used to secure an advantage in maser operation comparable to that obtained by ``push-pull'' pumping. Equations for the rate of change of populations in a scheme of four levels (A,B,C,D) when AC is pumped and cross relaxation takes place between BC, CD have been formulated, and the steady-state condition corresponding to various assumptions regarding lattice relaxation times is discussed. In an experimental investigation of maser operation based on this scheme and using ruby as the active material, an inversion of 0.9:1 was obtained at a signal frequency of 14.5 kMc when pumping at 24.5 kMc.