Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Dynamic properties of a superconducting quantum interference device containing arrays of Josephson junctions

Marian Darula, P. Seidel, F. H. Busse, Stefan Benacka

Published Aug 15, 1993• 20 citations
Publisher

Abstract

The dynamic properties of a superconducting quantum interference device (SQUID) containing arrays of Josephson junctions in a superconducting loop, and in particular the case of a four-junction SQUID, is analyzed theoretically via computer simulations. It is shown that phase locking of Josephson junctions determines the dynamic behavior of the SQUID. In the case of a stable phase-lock state hysteretic I-V curves as well as unusual voltage-flux dependencies appear. The influence of a small spread in the Josephson junction parameters upon the stability of the phase-lock state is investigated in parameter space.

DOI
10.1063/1.354660

Related papers

Amplification by the phase-locking mechanism in a four-junction SQUID

Donald G. McDonald

It is shown that the phase-locking property of an array of Josephson junctions can be used as a basis for amplification. The particular device simulated is a superconducting quantum interference device (SQUID) with four junctions in the loop, rather than the usual one or two. Novel consequences of this design are that it allows direct rather than inductive coupling to the SQUID and, because of its potentially compact form, it probably can have a bandwidth well into the gigahertz range, in agreement with the simulations.

Applied Physics Letters•Dec 1, 1984•5 citations

Measurements of Phase Dynamics in Planar Josephson Junctions and SQUIDs

D. Z. Haxell, Erik Cheah, Filip Křížek +8 more

We experimentally investigate the stochastic phase dynamics of planar Josephson junctions (JJs) and superconducting quantum interference devices (SQUIDs) defined in epitaxial InAs/Al heterostructures, and characterized by a large ratio of Josephson energy to charging energy. We observe a crossover from a regime of macroscopic quantum tunneling to one of phase diffusion as a function of temperature, where the transition temperature T^{*} is gate-tunable. The switching probability distributions are shown to be consistent with a small shunt capacitance and moderate damping, resulting in a switching current which is a small fraction of the critical current. Phase locking between two JJs leads to a difference in switching current between that of a JJ measured in isolation and that of the same JJ measured in an asymmetric SQUID loop. In the case of the loop, T^{*} is also tuned by a magnetic flux.

arXiv:2204.05619•Physical Review Letters•Feb 23, 2023•23 citations

Static and dynamic transport properties of multi-terminal, multi-junction microSQUIDs realized with Nb/HfTi/Nb Josephson junctions

Silke Wolter, Julian Linek, Thomas Weimann +3 more

Abstract The progressive miniaturization of superconducting quantum interference devices (SQUIDs) used, e.g. for magnetic imaging on the nanoscale or for the detection of the magnetic states of individual magnetic nanoparticles causes increasing problems in realizing a proper flux-bias scheme for reading out the device. To overcome the problem, a multi-terminal, multi-junction layout has been proposed and realized recently for the SQUID-on-tip configuration, which uses constriction-type Josephson junctions (JJ). This geometry is also interesting for SQUIDs based on overdamped superconductor—normal metal—superconductor (SNS) JJ. We fabricated four-terminal, four-junction SQUIDs based on a trilayer Nb/HfTi/Nb process and study their static and dynamic transport properties in close comparison with numerical simulations based on the resistively and capacitively shunted junction model. Simulations and measurements are in very good agreement. However, there are large differences to the transport properties of conventional two-junction SQUIDs, including unusual phase-locked and chaotic dynamic states which we describe in detail. We further extract the current-phase relation of our SNS junctions, which turns out to be purely sinusoidal within the experimental error bars.

Superconductor Science and Technology•Jun 13, 2022•5 citations

Small inductance approximation of phase locking in multijunction SQUIDs

B. Frank, Wolfram Krech, K. Yu. Platov

We present a theoretical analysis of the dynamics of multijunction superconducting quantum interference devices (SQUIDs). The small inductance approximation allows to get analytical expressions for the Josephson phases and voltages, taking into account a finite value of the inductance of the SQUID cells. Contrary to most theoretical investigations which exploited the first-harmonic approximation approach, our results describe the behavior of the circuit for small values of the Josephson frequency as well. Analytical results have been shown to be in a good agreement with numerical simulations.

Journal of Applied Physics•Aug 1, 1998•2 citations

Dynamic electromagnetic response of three-dimensional Josephson junction arrays

J. Oppenländer, Ch. Häussler, Nils Schopohl

We present a theoretical study on the dynamical properties of three-dimensional arrays of Josephson junctions. Our results indicate that such superconducting networks represent highly sensitive three-dimensional superconducting quantum interference devices (3D SQUIDs) having some major advantages in comparison with conventional planar SQUIDs. The voltage response function of 3D SQUIDs is directly related to the vector character of external electromagnetic fields. The theory developed here allows the three-dimensional reconstruction of a detected external field including phase information about the field variables. Applications include the design of magnetometers, gradiometers, and particle detectors.

arXiv:cond-mat/9907105•Journal of Applied Physics•Nov 15, 1999•12 citations

Characteristics of Flux Noise in Long Superconducting Quantum Interference Device Array

T. Morooka, Hiroaki Myoren, S. Takada +1 more

The flux noise in a long superconducting quantum interference device (SQUID) array consisting of at least 100 dc-SQUID elements connected in series was characterized analytically, and then compared with measurements. In the analysis, noise sources in the array were shunt resistors for Josephson junctions, a damping resistor for a SQUID loop, the dynamic resistance of the SQUID array, and the noise of electronics at room temperature. The flux noise of the array was calculated analytically as a function of the number of dc-SQUID elements. The results reveal that the flux noise is significantly influenced by the dynamic resistance of the array, although the influence by the dynamic resistance for a single SQUID is negligibly small. The dynamic resistance becomes dominant for the flux noise when the number of SQUID elements in the array exceeds 100. These results agree well with the measured flux noise for a long SQUID array constructed using a Nb/AlO x /Nb fabrication process.

Japanese Journal of Applied Physics•Nov 10, 2003•3 citations
The dynamic properties of a superconducting quantum interference device (SQUID) containing arrays of Josephson junctions in a superconducting loop, and in particular the case of a four-junction SQUID, is analyzed theoretically via computer simulations. It is shown that phase locking of Josephson junctions determines the dynamic behavior of the SQUID. In the case of a stable phase-lock state hysteretic I-V curves as well as unusual voltage-flux dependencies appear. The influence of a small spread in the Josephson junction parameters upon the stability of the phase-lock state is investigated in parameter space.
It is shown that the phase-locking property of an array of Josephson junctions can be used as a basis for amplification. The particular device simulated is a superconducting quantum interference device (SQUID) with four junctions in the loop, rather than the usual one or two. Novel consequences of this design are that it allows direct rather than inductive coupling to the SQUID and, because of its potentially compact form, it probably can have a bandwidth well into the gigahertz range, in agreement with the simulations.
We experimentally investigate the stochastic phase dynamics of planar Josephson junctions (JJs) and superconducting quantum interference devices (SQUIDs) defined in epitaxial InAs/Al heterostructures, and characterized by a large ratio of Josephson energy to charging energy. We observe a crossover from a regime of macroscopic quantum tunneling to one of phase diffusion as a function of temperature, where the transition temperature T^{*} is gate-tunable. The switching probability distributions are shown to be consistent with a small shunt capacitance and moderate damping, resulting in a switching current which is a small fraction of the critical current. Phase locking between two JJs leads to a difference in switching current between that of a JJ measured in isolation and that of the same JJ measured in an asymmetric SQUID loop. In the case of the loop, T^{*} is also tuned by a magnetic flux.
Abstract The progressive miniaturization of superconducting quantum interference devices (SQUIDs) used, e.g. for magnetic imaging on the nanoscale or for the detection of the magnetic states of individual magnetic nanoparticles causes increasing problems in realizing a proper flux-bias scheme for reading out the device. To overcome the problem, a multi-terminal, multi-junction layout has been proposed and realized recently for the SQUID-on-tip configuration, which uses constriction-type Josephson junctions (JJ). This geometry is also interesting for SQUIDs based on overdamped superconductor—normal metal—superconductor (SNS) JJ. We fabricated four-terminal, four-junction SQUIDs based on a trilayer Nb/HfTi/Nb process and study their static and dynamic transport properties in close comparison with numerical simulations based on the resistively and capacitively shunted junction model. Simulations and measurements are in very good agreement. However, there are large differences to the transport properties of conventional two-junction SQUIDs, including unusual phase-locked and chaotic dynamic states which we describe in detail. We further extract the current-phase relation of our SNS junctions, which turns out to be purely sinusoidal within the experimental error bars.
We present a theoretical analysis of the dynamics of multijunction superconducting quantum interference devices (SQUIDs). The small inductance approximation allows to get analytical expressions for the Josephson phases and voltages, taking into account a finite value of the inductance of the SQUID cells. Contrary to most theoretical investigations which exploited the first-harmonic approximation approach, our results describe the behavior of the circuit for small values of the Josephson frequency as well. Analytical results have been shown to be in a good agreement with numerical simulations.
We present a theoretical study on the dynamical properties of three-dimensional arrays of Josephson junctions. Our results indicate that such superconducting networks represent highly sensitive three-dimensional superconducting quantum interference devices (3D SQUIDs) having some major advantages in comparison with conventional planar SQUIDs. The voltage response function of 3D SQUIDs is directly related to the vector character of external electromagnetic fields. The theory developed here allows the three-dimensional reconstruction of a detected external field including phase information about the field variables. Applications include the design of magnetometers, gradiometers, and particle detectors.
The flux noise in a long superconducting quantum interference device (SQUID) array consisting of at least 100 dc-SQUID elements connected in series was characterized analytically, and then compared with measurements. In the analysis, noise sources in the array were shunt resistors for Josephson junctions, a damping resistor for a SQUID loop, the dynamic resistance of the SQUID array, and the noise of electronics at room temperature. The flux noise of the array was calculated analytically as a function of the number of dc-SQUID elements. The results reveal that the flux noise is significantly influenced by the dynamic resistance of the array, although the influence by the dynamic resistance for a single SQUID is negligibly small. The dynamic resistance becomes dominant for the flux noise when the number of SQUID elements in the array exceeds 100. These results agree well with the measured flux noise for a long SQUID array constructed using a Nb/AlO x /Nb fabrication process.