Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Laser and Fiber-Optical Networks Modeling

General noise considerations of amplified photons in lightwave systems with optically bistable elements

Hooman Abediasl, Ali Naqavi, Khashayar Mehrany, Seyed Mohammad Mousavi, Jaleh Aliakbar, Seyed Mahdi Mousavi

Published Sep 1, 2010• 0 citations
Publisher

Abstract

An optical amplifier followed by a bistable element has been statistically analyzed before. In this manuscript, output noise analysis represents, then signal to noise ratios (SNR) are calculated either for input or output. It will be shown that noise reduction, can be achieved by a proper selection of parameters.
DOI
10.1109/lfnm.2010.5624237

Related papers

Stochastic characterization of amplified photons in lightwave systems with optically bistable elements

Hooman Abediasl, Ali Naqavi, Khashayar Mehrany +1 more

An optical amplifier followed by a bistable element is statistically analyzed. To this end, the birth-death-immigration model and the coupled mode theory are used to characterize the amplifier and the bistable element, respectively.

International Symposium on Communications, Control and Signal Processing•Mar 1, 2010•1 citation

Noise in resonant optical amplifiers of general resonator configuration

E.L. Goldstein, Malvin Carl Teich

The population-statistical description of a linear optical amplifier, extended to include both a resonant optical cavity and explicit input and output photon fluxes, is shown to yield three useful noise relationships. Despite the treatment's plainly particulate character, it provides an expression for the variance of the time-integrated output-photon-detection process in which terms associated with interferometrically generated beat noise are prominent. For systems whose photodetector electrical bandwidth B is much smaller than the amplifier's optical bandwidth Delta v, as is almost invariably the case for semiconductor amplifiers in lightwave-communication systems, the time-integrated photocurrent variance can be written in a simple, physically intuitive form. Two quotients are of central importance: ( Delta nu /B) and the ratio (/) of mean amplified-signal power to mean amplified-spontaneous-emission power. In the usual case of interest for optical amplifiers in communication systems where>>, the signal-to-noise ratio of the integrated photocurrent, on which the error probability in an on-off-keyed system depends, is approximately=1/2( Delta v/B) ((n/sub S/)/(n/sub ASE/)).>

IEEE Journal of Quantum Electronics•Jan 1, 1989•14 citations

Optical amplifiers, phase-shift keying, and signal-to-noise ratio

Jeffrey H. Shapiro, N. C. Wong

Recently, there has been some controversy concerning the role of signal-to-noise ratio (SNR) calculations in conjunction with optical amplifiers and phase-shift keying. Analysis has shown that the large-signal SNR at the output of an optical parametric amplifier (OPA) or optical parametric oscillator (OPO) can exceed the shot-noise limit when an injected signal beam is used to elicit small-signal gain saturation. Although no small-signal SNR gain is obtained in this way, the large-signal SNR improvement does translate into a communication performance improvement if binary phase-shift keying is applied to the resulting output beam. Analysis has also shown that the large-signal, shot-noise limited SNR can be exceeded when a binary phase-shift keyed coherent-state beam is applied to a preamplify-feedforward-homodyne receiver. In this case, however, there is no communication performance improvement. Indeed, the preamplify-feed-forward-homodyne receiver requires twice as many signal photons, on average, to equal the error probability of ordinary homodyne detection. In this talk we will show that there is no contradiction between these two examples.

Annual Meeting Optical Society of America•Jan 1, 1992•0 citations

Optimum noise performance of optical amplifiers

H. A. Haus

The concept of noise figure F and noise measure M applicable to radio frequency and microwave amplifiers is reviewed and extended to cover optical amplifiers. Two noise figures are defined in the optical regime: one gives the ASE output, while the other gives the ratio of signal-to-noise ratios at the input and output. In the quantum regime, the lower limit on these optimum values is set by a generalization of Heisenberg's uncertainty relation. A Raman back-pumped fiber link with post-amplification with an erbium-doped fiber amplifier is used to illustrate the use of noise measure.

IEEE Journal of Quantum Electronics•Jun 1, 2001•16 citations

Field statistics modelling of beat noise in an optical amplifier

Jon Thomas Kringlebotn, N. Blotekjaer, Chris N. Pannell

The authors present a rigorous and self-contained noise analysis of an optical amplifier based on the statistics of the input source field and the amplified spontaneous emission field of the amplifier. The method enables us to obtain the frequency dependence of the output electrical noise power, which has not been derived in previous studies of optical amplifier noise based on the photon-statistics master equation. The authors characterise for the first time the noise of an optical amplifier in combination with a super-fluorescent source, taking into account the frequency dependence of the gain and the presence of optional optical filters.

IEE Proceedings - Optoelectronics•Jun 1, 1994•4 citations

The small-noise approximation in linear amplifiers: Limitations and beyond

A. Chia, Michal Hajdušek, Rosario Fazio +2 more

The phase of an optical field inside a linear amplifier is widely known to diffuse with a diffusion coefficient that is inversely proportional to the photon number. The same process occurs in lasers which limits its intrinsic linewidth and makes the phase uncertainty difficult to calculate. The most commonly used simplification is to assume a narrow photon-number distribution for the optical field (which we call the small-noise approximation). This relies on (i) the input to have a good signal-to-noise ratio, and (ii) that such a signal-to-noise ratio can be maintained throughout the amplification process. Here we ask: How many photons must be present in the input to a quantum linear amplifier for the phase noise to be amenable to a small-noise analysis? We show that for a linear amplifier which is signal-to-noise optimised (i.e. an amplifier most favourable to the small-noise approximation), the small-noise approximation breaks down for a coherent-state input with only a few photons on average. Interestingly, when the input strength is increased to tens of photons, the small-noise approximation can be seen to perform much better and the process of phase diffusion permits a small-noise analysis. This demarcates the limit of the small-noise assumption in linear amplifiers as such an assumption is less true for an amplifier which does not have its signal-to-noise performance optimised. In order to explore this limit we propose a description of phase diffusion that goes beyond the small-noise approximation which we call the inverse-number expansion. The small-noise approximation can then be understood as the lowest-order contribution to the inverse-number expansion while phase diffusion with only a few-photon input can be captured by the inclusion of higher-order terms.

•Nov 20, 2018•0 citations
The population-statistical description of a linear optical amplifier, extended to include both a resonant optical cavity and explicit input and output photon fluxes, is shown to yield three useful noise relationships. Despite the treatment's plainly particulate character, it provides an expression for the variance of the time-integrated output-photon-detection process in which terms associated with interferometrically generated beat noise are prominent. For systems whose photodetector electrical bandwidth B is much smaller than the amplifier's optical bandwidth Delta v, as is almost invariably the case for semiconductor amplifiers in lightwave-communication systems, the time-integrated photocurrent variance can be written in a simple, physically intuitive form. Two quotients are of central importance: ( Delta nu /B) and the ratio (/) of mean amplified-signal power to mean amplified-spontaneous-emission power. In the usual case of interest for optical amplifiers in communication systems where>>, the signal-to-noise ratio of the integrated photocurrent, on which the error probability in an on-off-keyed system depends, is approximately=1/2( Delta v/B) ((n/sub S/)/(n/sub ASE/)).>
Recently, there has been some controversy concerning the role of signal-to-noise ratio (SNR) calculations in conjunction with optical amplifiers and phase-shift keying. Analysis has shown that the large-signal SNR at the output of an optical parametric amplifier (OPA) or optical parametric oscillator (OPO) can exceed the shot-noise limit when an injected signal beam is used to elicit small-signal gain saturation. Although no small-signal SNR gain is obtained in this way, the large-signal SNR improvement does translate into a communication performance improvement if binary phase-shift keying is applied to the resulting output beam. Analysis has also shown that the large-signal, shot-noise limited SNR can be exceeded when a binary phase-shift keyed coherent-state beam is applied to a preamplify-feedforward-homodyne receiver. In this case, however, there is no communication performance improvement. Indeed, the preamplify-feed-forward-homodyne receiver requires twice as many signal photons, on average, to equal the error probability of ordinary homodyne detection. In this talk we will show that there is no contradiction between these two examples.
The concept of noise figure F and noise measure M applicable to radio frequency and microwave amplifiers is reviewed and extended to cover optical amplifiers. Two noise figures are defined in the optical regime: one gives the ASE output, while the other gives the ratio of signal-to-noise ratios at the input and output. In the quantum regime, the lower limit on these optimum values is set by a generalization of Heisenberg's uncertainty relation. A Raman back-pumped fiber link with post-amplification with an erbium-doped fiber amplifier is used to illustrate the use of noise measure.
The authors present a rigorous and self-contained noise analysis of an optical amplifier based on the statistics of the input source field and the amplified spontaneous emission field of the amplifier. The method enables us to obtain the frequency dependence of the output electrical noise power, which has not been derived in previous studies of optical amplifier noise based on the photon-statistics master equation. The authors characterise for the first time the noise of an optical amplifier in combination with a super-fluorescent source, taking into account the frequency dependence of the gain and the presence of optional optical filters.
The phase of an optical field inside a linear amplifier is widely known to diffuse with a diffusion coefficient that is inversely proportional to the photon number. The same process occurs in lasers which limits its intrinsic linewidth and makes the phase uncertainty difficult to calculate. The most commonly used simplification is to assume a narrow photon-number distribution for the optical field (which we call the small-noise approximation). This relies on (i) the input to have a good signal-to-noise ratio, and (ii) that such a signal-to-noise ratio can be maintained throughout the amplification process. Here we ask: How many photons must be present in the input to a quantum linear amplifier for the phase noise to be amenable to a small-noise analysis? We show that for a linear amplifier which is signal-to-noise optimised (i.e. an amplifier most favourable to the small-noise approximation), the small-noise approximation breaks down for a coherent-state input with only a few photons on average. Interestingly, when the input strength is increased to tens of photons, the small-noise approximation can be seen to perform much better and the process of phase diffusion permits a small-noise analysis. This demarcates the limit of the small-noise assumption in linear amplifiers as such an assumption is less true for an amplifier which does not have its signal-to-noise performance optimised. In order to explore this limit we propose a description of phase diffusion that goes beyond the small-noise approximation which we call the inverse-number expansion. The small-noise approximation can then be understood as the lowest-order contribution to the inverse-number expansion while phase diffusion with only a few-photon input can be captured by the inclusion of higher-order terms.