Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Modern Optics

Theory of the Double-amplifier Interferometer

N. Hussain, R. Loudon

Published Dec 1, 1989• 2 citations
Publisher

Abstract

We present an extension of Glauber's theory of the Mach-Zehnder interferometer with optical amplifiers placed in each of its internal paths. Conditions are derived for the achievement of maximum fringe visibility with amplifiers of general linear characteristics. The effects of the phase-conjugated and the phase-preserved components of the amplified light are elucidated for the contrasting cases of coherent and number-state inputs. Particular attention is paid to the minimization of amplifier noise in the limit of high gain.

DOI
10.1080/09500348914551781

Related papers

Gain characteristics of coherent optical amplifiers using a Mach-Zehnder interferometer with Kerr media

Wataru Imajuku, Atsushi Takada

This paper investigates the gain characteristics of coherent optical amplifiers that amplify only one of two quadrature phase components in an input signal light according to the phase of pump light. It is constructed around a Mach-Zehnder interferometer with Kerr media. To heuristically obtain the design parameters of the coherent optical amplifier, small-signal analysis is adapted to the Mach-Zehnder interferometer with Kerr media. The theoretical results are then compared to experimental results and shown to agree well, which confirms the validity of this design approach. By utilizing low-loss and high-nonlinearity silica fiber as the Kerr medium and optimizing its length, a coherent optical amplifier is constructed that yields high-gain (up to 26 dB) operation.

IEEE Journal of Quantum Electronics•Jan 1, 1999•16 citations

Raman amplifiers in a two-leg interferometer: quantum noise versus fringe visibility

R. C. Swanson, Philip R. Battle, John L. Carlsten

Quantum mechanics fundamentally requires any linear amplifier to introduce quantum noise onto the amplified signal.1 In the case of the linear Raman amplifier, the fully quantum-mechanical Raman equations give a precise prediction of how much noise is introduced.2 Understanding and testing this prediction is important not only from a practical point of view, where one might be interested in the conditions for which a signal can be amplified without distortion, but also from the fundamental point of view of understanding the quantum-mechanical Raman process. To test these predictions, we consider the specific case of a Mach-Zehnder interferometer with a Raman amplifier in each leg of the interferometer. The input signal is provided by a separate Raman generator. As the input signal is varied from a small input to a large input, the fringe visibility varies from essentially zero, indicating that the noise dominates the output pulse, to nearly unity, as the amplified input signal dominates the noise. Using the Raman equations, we find that surprisingly few photons are predicted to be necessary for the signal to dominate the noise. The present work is devoted to measuring these fringes experimentally.

Annual Meeting Optical Society of America•Jan 1, 1990•0 citations

Coherence and complementarity in a Mach-Zehnder interferometer with two DOPAs

Suc-Kyoung Hong, Chung‐In Um, Kyu-Hwang Yeon +1 more

The characteristics of the quantum optical complementarity principle and the coherence of the photons generated in a Mach-Zehnder interferometer with two degenerate optical parametric amplifiers are analysed. The photon statistics and the phase fluctuation of the combined states are analysed in a homodyning Mach-Zehnder interferometer with two degenerate optical parametric amplifiers. By analysing the photon statistics, the mean-square phase fluctuation and the fringe visibility, the complementarity is considered as a function of the gain and input phase, when the amplified input is a coherent state containing one photon, on average. It is also considered when the input is a number state with one photon.

Journal of Optics B Quantum and Semiclassical Optics•Sep 2, 1999•1 citation

Amplification and the wave-particle duality

R. C. Swanson, John L. Carlsten

By utilizing amplifiers in a modified interferometer, both particlelike and wavelike characteristics of single input photons are analyzed theoretically. Quantum theory predicts that proposed measurements on the amplified field will indicate that the single input photon exhibits extremes of both wavelike and particlelike characteristics. The evidence for wavelike behavior is fringe visibility at the output of the interferometer. Anticorrelation between the outputs of the two legs of the interferometer provides the evidence for particlelike behavior. Although quantum noise degrades both the particle-sensitive and the wave-sensitive measurement, no trade-off between the wavelike and the particlelike characteristics takes place. Complementarity, however, is maintained by the quantum noise added during amplification.

Physical Review A•Mar 1, 1993•0 citations

Laser Amplifiers

Bahaa E. A. Saleh, Malvin Carl Teich

A coherent optical amplifier is a device that increases the amplitude of an optical field while maintaining its phase. If the optical field at the input to such an amplifier is monochromatic, the output will also be monochromatic, with the same frequency. The output amplitude is increased relative to the input while the phase is unchanged or shifted by a fixed amount. In contrast, an amplifier that increases the intensity of an optical wave without preserving the phase is called an incoherent optical amplifier. This chapter is concerned with coherent optical amplifiers. Such amplifiers are important for various applications; examples include the amplification of weak optical pulses such as those that have traveled through a long length of optical fiber, and the production of highly intense optical pulses such as those required for laser-fusion applications. Furthermore, it is important to understand the principles underlying the operation of optical amplifiers as a prelude to the discussion of optical oscillators. Light transmitted through matter in thermal equilibrium is attenuated rather than amplified. This is because absorption by the large population of atoms in the lower energy level is more prevalent than stimulated emission by the smaller population of atoms in the upper level. An essential ingredient for achieving laser amplification is the presence of a greater number of atoms in the upper energy level than in the lower level, which is clearly a nonequilibrium situation. Achieving such a population inversion requires a source of power to excite (pump) the atoms into the higher energy level. Although the presentation throughout this chapter is couched in terms of “atoms” and “atomic levels,” these appelations are to be more broadly understood as “active medium” and “laser energy levels,” respectively. The properties of an ideal (optical or electronic) coherent amplifier are displayed schematically. Real coherent amplifiers deliver a gain and phase shift that are frequency dependent, typically in the manner illustrated here. The gain and phase shift constitute the amplifier's transfer function. For a sufficiently high input amplitude, furthermore, real amplifiers may exhibit saturation, a form of nonlinear behavior in which the output amplitude fails to increase in proportion to the input amplitude. Saturation introduces harmonic components into the output, provided that the amplifier bandwidth is sufficiently broad to pass them. Real amplifiers also introduce noise, so that a randomly fluctuating component is always present at the output, regardless of the input. An amplifier may therefore be characterized by the following features: ▪ gain; ▪ bandwidth; ▪ phase shift; ▪ power source; ▪ nonlinearity and gain saturation, and ▪ noise We proceed to discuss these characteristics in turn in this chapter. The theory of laser amplification is developed, leading to expressions for the amplifier gain, spectral bandwidth, and phase shift. The mechanisms by which an amplifier power source can achieve a population inversion are examined. Gain saturation and noise in the amplification process, are discussed respectively. This chapter relies on material presented in Chap. 12.

Wiley eBooks•Aug 14, 1991•2 citations

Interferometric measurement of quantum noise in a Raman amplifier

R. C. Swanson, Philip R. Battle, John L. Carlsten

How large must the input signal to an amplifier be to dominate the quantum noise introduced during amplification? We attempt to answer this question for a Raman amplifier with an experiment that utilizes a modified Mach-Zender interferometer with an amplifier placed in each leg. The quantum noise added by the amplifiers manifests itself by degrading the visibility of the output fringes from the interferometer. Only an average of a few photons per mode were necessary to achieve good visibility.

Physical Review Letters•Jul 1, 1991•15 citations
We present an extension of Glauber's theory of the Mach-Zehnder interferometer with optical amplifiers placed in each of its internal paths. Conditions are derived for the achievement of maximum fringe visibility with amplifiers of general linear characteristics. The effects of the phase-conjugated and the phase-preserved components of the amplified light are elucidated for the contrasting cases of coherent and number-state inputs. Particular attention is paid to the minimization of amplifier noise in the limit of high gain.
This paper investigates the gain characteristics of coherent optical amplifiers that amplify only one of two quadrature phase components in an input signal light according to the phase of pump light. It is constructed around a Mach-Zehnder interferometer with Kerr media. To heuristically obtain the design parameters of the coherent optical amplifier, small-signal analysis is adapted to the Mach-Zehnder interferometer with Kerr media. The theoretical results are then compared to experimental results and shown to agree well, which confirms the validity of this design approach. By utilizing low-loss and high-nonlinearity silica fiber as the Kerr medium and optimizing its length, a coherent optical amplifier is constructed that yields high-gain (up to 26 dB) operation.
Quantum mechanics fundamentally requires any linear amplifier to introduce quantum noise onto the amplified signal.1 In the case of the linear Raman amplifier, the fully quantum-mechanical Raman equations give a precise prediction of how much noise is introduced.2 Understanding and testing this prediction is important not only from a practical point of view, where one might be interested in the conditions for which a signal can be amplified without distortion, but also from the fundamental point of view of understanding the quantum-mechanical Raman process. To test these predictions, we consider the specific case of a Mach-Zehnder interferometer with a Raman amplifier in each leg of the interferometer. The input signal is provided by a separate Raman generator. As the input signal is varied from a small input to a large input, the fringe visibility varies from essentially zero, indicating that the noise dominates the output pulse, to nearly unity, as the amplified input signal dominates the noise. Using the Raman equations, we find that surprisingly few photons are predicted to be necessary for the signal to dominate the noise. The present work is devoted to measuring these fringes experimentally.
The characteristics of the quantum optical complementarity principle and the coherence of the photons generated in a Mach-Zehnder interferometer with two degenerate optical parametric amplifiers are analysed. The photon statistics and the phase fluctuation of the combined states are analysed in a homodyning Mach-Zehnder interferometer with two degenerate optical parametric amplifiers. By analysing the photon statistics, the mean-square phase fluctuation and the fringe visibility, the complementarity is considered as a function of the gain and input phase, when the amplified input is a coherent state containing one photon, on average. It is also considered when the input is a number state with one photon.
By utilizing amplifiers in a modified interferometer, both particlelike and wavelike characteristics of single input photons are analyzed theoretically. Quantum theory predicts that proposed measurements on the amplified field will indicate that the single input photon exhibits extremes of both wavelike and particlelike characteristics. The evidence for wavelike behavior is fringe visibility at the output of the interferometer. Anticorrelation between the outputs of the two legs of the interferometer provides the evidence for particlelike behavior. Although quantum noise degrades both the particle-sensitive and the wave-sensitive measurement, no trade-off between the wavelike and the particlelike characteristics takes place. Complementarity, however, is maintained by the quantum noise added during amplification.
A coherent optical amplifier is a device that increases the amplitude of an optical field while maintaining its phase. If the optical field at the input to such an amplifier is monochromatic, the output will also be monochromatic, with the same frequency. The output amplitude is increased relative to the input while the phase is unchanged or shifted by a fixed amount. In contrast, an amplifier that increases the intensity of an optical wave without preserving the phase is called an incoherent optical amplifier. This chapter is concerned with coherent optical amplifiers. Such amplifiers are important for various applications; examples include the amplification of weak optical pulses such as those that have traveled through a long length of optical fiber, and the production of highly intense optical pulses such as those required for laser-fusion applications. Furthermore, it is important to understand the principles underlying the operation of optical amplifiers as a prelude to the discussion of optical oscillators. Light transmitted through matter in thermal equilibrium is attenuated rather than amplified. This is because absorption by the large population of atoms in the lower energy level is more prevalent than stimulated emission by the smaller population of atoms in the upper level. An essential ingredient for achieving laser amplification is the presence of a greater number of atoms in the upper energy level than in the lower level, which is clearly a nonequilibrium situation. Achieving such a population inversion requires a source of power to excite (pump) the atoms into the higher energy level. Although the presentation throughout this chapter is couched in terms of “atoms” and “atomic levels,” these appelations are to be more broadly understood as “active medium” and “laser energy levels,” respectively. The properties of an ideal (optical or electronic) coherent amplifier are displayed schematically. Real coherent amplifiers deliver a gain and phase shift that are frequency dependent, typically in the manner illustrated here. The gain and phase shift constitute the amplifier's transfer function. For a sufficiently high input amplitude, furthermore, real amplifiers may exhibit saturation, a form of nonlinear behavior in which the output amplitude fails to increase in proportion to the input amplitude. Saturation introduces harmonic components into the output, provided that the amplifier bandwidth is sufficiently broad to pass them. Real amplifiers also introduce noise, so that a randomly fluctuating component is always present at the output, regardless of the input. An amplifier may therefore be characterized by the following features: ▪ gain; ▪ bandwidth; ▪ phase shift; ▪ power source; ▪ nonlinearity and gain saturation, and ▪ noise We proceed to discuss these characteristics in turn in this chapter. The theory of laser amplification is developed, leading to expressions for the amplifier gain, spectral bandwidth, and phase shift. The mechanisms by which an amplifier power source can achieve a population inversion are examined. Gain saturation and noise in the amplification process, are discussed respectively. This chapter relies on material presented in Chap. 12.