Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum Electronics

Use of an iodine active quantum filter for image intensification

Yu F Kutaev, S. K. Mankevich, O Yu Nosach, E. P. Orlov

Published May 31, 2001• 5 citations
Publisher

Abstract

Intensification of the image brightness using an iodine active quantum filter is studied experimentally. The image brightness was intensified by a factor of 3000 while preserving the diffraction-limited resolution. The obtained results suggest the possibility of using an iodine active quantum filter in laser ranging and laser probing.
DOI
10.1070/qe2001v031n05abeh001969

Related papers

Effect of intense background radiation on the sensitivity of a laser receiver with an iodine active quantum filter

Yu F Kutaev, S. K. Mankevich, O Yu Nosach +1 more

The effect of background light on the sensitivity of a laser receiver with an iodine active quantum filter (λ=1.315 μm) was theoretically and experimentally investigated. Upon the reception of a 40-ns pulsed signal against the background of 2.5-fold attenuated radiation of a pulsed light source with a brightness temperature of 4 × 10 4 K, the sensitivity of this receiver for a signal-to-noise ratio of three and a diffraction-limited acceptance angle was experimentally shown to be equal to 20 photons, which exceeds the quantum limit by about a factor of two. This is consistent with the results of theoretical treatment and suggests that upon the detection of optical signals against the background of the solar disk, the sensitivity of this receiver should decrease by only 12%. This receiver was compared with a receiver employing a photomultiplier of the visible range. Upon the reception of optical signals with the same parameters against the background of the solar disk and an interference filter with a transmission band width of 5 nm, the sensitivity of a receiver equipped with an FEU-115 photomultiplier was shown to be equal to about 1400 photons for a signal-to-noise ratio of three.

Quantum Electronics•Apr 30, 2002•3 citations

Laser receiver with a quantum detection limit in the near-IR range

Yu F Kutaev, S. K. Mankevich, O Yu Nosach +1 more

A laser receiver (LR) with an active quantum filter (AQF) (λ =1.315 μm) based on an iodine photodissociation laser is studied. It is shown that the LR sensitivity can be brought up to the quantum detection limit by increasing the AQF gain. Taking into account the space-time statistics of spontaneous emission of the AQF, the LR sensitivity is determined as a function of the reception solid angle and the recorder response time. Under the conditions of the experiments performed, the LR sensitivity is, to a good approximation, proportional to the square root of the product of the reception solid angle and the recorder time constant. The above dependence is confirmed experimentally upon more than a hundred-fold variation of the response time. For the reception angle that was three times greater than the diffraction-limited angle, the quantum detection limit was achieved, which amounts to approximately three photons for a 40-ns pulse for the unit signal-to-noise ratio.

Quantum Electronics•Sep 30, 2000•6 citations

Amplification of image brightness in strontium vapor

D. V. Vlasov, P I Ivashkin, Anatoly A. Isaev +3 more

A possibility for amplification of image brightness in a strontium vapor has been pointed out for the first time. A regime for image intensification in the violet spectral region has been realized experimentally. An increase in image sharpness was investigated theoretically for a multipass self-conjugate optical system with an active medium.

Physica Scripta•Oct 1, 1993•6 citations

Progress in quantum telescopes

David R. Gozzard, Fiona H. Panther, Andrew G. White

Classically, the angular resolution of a telescope is limited by its diffraction limit: the ratio of its observing wavelength to its diameter. Developments in quantum information theory over the past decade have uncovered quantum-optimal measurement methods that enable super-resolution imaging beyond the diffraction limit, and many laboratory-scale demonstrations of these methods have been performed over the past decade, culminating in the recent first on-sky demonstration of quantum-enhanced astronomical imaging. In this Review, we detail the current progress and achievements of these theoretical and experimental results, discuss the astronomical science cases motivating the development of higher resolution telescopes, summarise the technological challenges facing the practical application of quantum imaging technologies to astronomy, and present a vision for the realization of \emph{quantum telescopes} with imaging resolutions orders of magnitude better than current observatories.

astro-ph.IMCross-listedarXiv:2609.18079•Sep 17, 2026•0 citations

Noise-immune laser receiver — transmitters with the quantum sensitivity limit

Yu F Kutaev, S. K. Mankevich, O Yu Nosach +1 more

We consider the operation principles of noise-immune near-IR receiver — transmitters with the quantum sensitivity limit, in which active quantum filters based on iodine photodissociation quantum amplifiers and iodine lasers are used. The possible applications of these devices in laser location, laser space communication, for the search for signals from extraterrestrial civilisations and sending signals to extraterrestrial civilisations are discussed.

Quantum Electronics•Nov 30, 2009•1 citation

Optical elegance: Quantum imaging for smart material revelation

Bakkaiahgari Padma Vijetha Dev, Sunaina Ahuja, Ruby Pant +5 more

The present research expands the understanding of quantum imaging and smart materials to identify the set of experimental parameters and their impact on imaging outcomes. Based on these investigations, we present a novel quantum picture of picture properties using laser wavelengths with proper photon entanglement conditions at 800, 700, & 850 nm. It is necessary to pay attention to Experiment 001 with 120 seconds of observations; it has high brightness levels, 0.92 of contrast ratio and 95% quantum picture resolution indicating possibility of recording material processes. As a result of compromising the specificity of wavelength and 150 seconds of observation time, experiment 003 yields high performance indicators, such as resolution limit of 18 nm, quantum efficiency of 0.92, and signal-to-noise ratio of 28. These experimental results reveal the contributions of tuning the measuring environment on enhancing the performance of quantum imaging and offer a potential way to understand the complex responses of intelligent materials.

AIP conference proceedings•Jan 1, 2026•0 citations
The effect of background light on the sensitivity of a laser receiver with an iodine active quantum filter (λ=1.315 μm) was theoretically and experimentally investigated. Upon the reception of a 40-ns pulsed signal against the background of 2.5-fold attenuated radiation of a pulsed light source with a brightness temperature of 4 × 10 4 K, the sensitivity of this receiver for a signal-to-noise ratio of three and a diffraction-limited acceptance angle was experimentally shown to be equal to 20 photons, which exceeds the quantum limit by about a factor of two. This is consistent with the results of theoretical treatment and suggests that upon the detection of optical signals against the background of the solar disk, the sensitivity of this receiver should decrease by only 12%. This receiver was compared with a receiver employing a photomultiplier of the visible range. Upon the reception of optical signals with the same parameters against the background of the solar disk and an interference filter with a transmission band width of 5 nm, the sensitivity of a receiver equipped with an FEU-115 photomultiplier was shown to be equal to about 1400 photons for a signal-to-noise ratio of three.
A laser receiver (LR) with an active quantum filter (AQF) (λ =1.315 μm) based on an iodine photodissociation laser is studied. It is shown that the LR sensitivity can be brought up to the quantum detection limit by increasing the AQF gain. Taking into account the space-time statistics of spontaneous emission of the AQF, the LR sensitivity is determined as a function of the reception solid angle and the recorder response time. Under the conditions of the experiments performed, the LR sensitivity is, to a good approximation, proportional to the square root of the product of the reception solid angle and the recorder time constant. The above dependence is confirmed experimentally upon more than a hundred-fold variation of the response time. For the reception angle that was three times greater than the diffraction-limited angle, the quantum detection limit was achieved, which amounts to approximately three photons for a 40-ns pulse for the unit signal-to-noise ratio.
Classically, the angular resolution of a telescope is limited by its diffraction limit: the ratio of its observing wavelength to its diameter. Developments in quantum information theory over the past decade have uncovered quantum-optimal measurement methods that enable super-resolution imaging beyond the diffraction limit, and many laboratory-scale demonstrations of these methods have been performed over the past decade, culminating in the recent first on-sky demonstration of quantum-enhanced astronomical imaging. In this Review, we detail the current progress and achievements of these theoretical and experimental results, discuss the astronomical science cases motivating the development of higher resolution telescopes, summarise the technological challenges facing the practical application of quantum imaging technologies to astronomy, and present a vision for the realization of \emph{quantum telescopes} with imaging resolutions orders of magnitude better than current observatories.
The present research expands the understanding of quantum imaging and smart materials to identify the set of experimental parameters and their impact on imaging outcomes. Based on these investigations, we present a novel quantum picture of picture properties using laser wavelengths with proper photon entanglement conditions at 800, 700, & 850 nm. It is necessary to pay attention to Experiment 001 with 120 seconds of observations; it has high brightness levels, 0.92 of contrast ratio and 95% quantum picture resolution indicating possibility of recording material processes. As a result of compromising the specificity of wavelength and 150 seconds of observation time, experiment 003 yields high performance indicators, such as resolution limit of 18 nm, quantum efficiency of 0.92, and signal-to-noise ratio of 28. These experimental results reveal the contributions of tuning the measuring environment on enhancing the performance of quantum imaging and offer a potential way to understand the complex responses of intelligent materials.