Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Quantum networking with quantum dots coupled to micro-cavities

Edo Waks, Deepak Sridharan, Jelena Vučković

Published Sep 9, 2007• 0 citations
Publisher

Abstract

We describe an effect called Dipole Induced Transparency which enables a dipole emitter to strongly modify the cavity spectrum, even in the weak coupling regime. We then describe a method for generating entanglement and performing a full Bell measurement between two QDs using Dipole Induced Transparency. Finally, we show how DIT enables entanglement between QDs with vastly different radiative properties. The proposal is shown to be robust to cavity resonance mismatch.

DOI
10.1117/12.732259

Related papers

Quantum networking with quantum dots coupled to micro-cavities

Edo Waks, Deepak Sridharan, Jelena Vučković

We describe an effect called Dipole Induced Transparency which enables a dipole emitter to strongly modify the cavity spectrum, even in the weak coupling regime. We then describe a method for generating entanglement and performing a full Bell measurement between two QDs using Dipole Induced Transparency. Finally, we show how DIT enables entanglement between QDs with vastly different radiative properties. The proposal is shown to be robust to cavity resonance mismatch.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 11, 2007•1 citation

Generating entanglement between quantum dots with different resonant frequencies based on dipole-induced transparency

Deepak Sridharan, Edo Waks

We describe a method for generating entanglement between two spatially separated dipoles coupled to optical microcavities. The protocol works even when the dipoles have different resonant frequencies and radiative lifetimes. This method is particularly important for solid-state emitters, such as quantum dots, which suffer from large inhomogeneous broadening. We show that high fidelities can be obtained over a large dipole detuning range without significant loss of efficiency. We analyze the impact of higher-order photon number states and cavity resonance mismatch on the performance of the protocol.

arXiv:quant-ph/0703089•Physical Review A•Nov 12, 2008•18 citations

Multipartite entanglement generation with dipole induced transparency effect in indirectly coupled dipole-microcavity systems

Zhaohui Peng, Chun-Xia Jia, Yuqing Zhang Yuqing Zhang +2 more

We propose a feasible scheme of generating multipartite entanglement with the dipole induced transparency (DIT) effect in indirectly coupled dipole-microcavity systems. It is shown that the transmission spectrum is closely related with the interference of dipole-microcavity systems, and we can generate different classes of multipartite entanglement, e.g., the Greenberger–Horne–Zeilinger state, the W state, and the Dicke state, of the dipole emitters just by choosing an appropriate frequency of the incident photon. Benefiting from the DIT effect, the schemes may work in the bad or low-Q cavity regime only if the large Purcell factor of the dipole-microcavity system is fulfilled, and they are also insensitive to experimental noise, which may be feasible with present accessible technology.

Chinese Optics Letters•Jan 1, 2018•0 citations

Dipole-induced transparency in a cavity-waveguide system with attractive cavity modes

Zhao-Hui Peng, Chun-Xia Jia, Yuqing Zhang +4 more

Dipole-induced transparency (DIT) is one of the most well-known transparency effects in quantum optics and has wide applications in scalable quantum information processing and quantum computation. However, most of the existing literatures only focuses on the DIT effect with coherent dipole-cavity coupling, thus its universality in other types of coupling is still to be clarified. Here, we propose a feasible scheme to realize dissipative dipole-cavity coupling with the assistance of a highly dissipative microcavity, and explicitly exhibit cavity-mode attraction. We then investigate the DIT effect in a cavity-waveguide system with attractive cavity modes and find that it can still be achievable even though the probe light is resonant with two attractive cavity modes. Furthermore, we reveal its underlying transparency mechanism with eigenfrequencies and the effective susceptibility of the dipole-cavity system, and show that its transparency lies in the destructive interference of two attractive cavity modes with splitting damping rates instead of splitting resonance frequencies in coherent coupling. Moreover, we find that the attractive and repulsive phenomena of the effective susceptibility, which also plays an important role in the DIT effect, exist in the dipole-cavity system. Our findings may not only be of importance for gaining a more comprehensive understanding on the DIT effect, but also have potential applications in quantum networks.

Physical Review A•Mar 17, 2025•3 citations

Comparative study for coupled high-Q cavity quantum dot system

Alperen Tüğen, Serdar Kocaman

We present the differences between Input-Output formalism and Lindblad Master Equation approach in transmission spectrum of Coupled high-Q Cavity with Quantum Dot system in weak coupling regime. Full-width-half-maximum (FWHM) and the peak transmission of Dipole Induced Transparency (DIT) are analyzed in detail.

IEEE Photonics Conference•Oct 1, 2017•0 citations

Self-assembled quantum dots in a fully tunable microcavity

Lukas Greuter

The interaction of light with matter is at the heart of quantum optics, which itself enables insight into the fundamental aspects of quantum mechanics. First experimental access to this research field has been realized by coupling atoms to light. Here, the transition between discrete energy states of the atom is associated with the absorption and emission of a photon, a single quantum of the electromagnetic field. As a central aspect of quantum optics, the light-emitter interaction can be significantly enhanced by placing the emitter in optical cavity that is on resonance with the emitter. In recent years, this has led to a rapidly evolving research field known as cavity quantum electrodynamics (CQED). In CQED two different regimes are distinguished: the strong and the weak coupling regimes. In the strong coupling regime, the emitted photon is reflected from the cavity mirrors and eventually reabsorbed by the emitter. In contrast, the weak coupling regime describes the irreversible emission, where the photon leaks out of the cavity before it can be reabsorbed. Both the weak and strong coupling regimes enabled fundamental experiments for a better understanding of quantum optical phenomena. \n \n \n \nCQED grants access to the quantum world and hence offers potentially revolutionizing applications, particularly in the field of quantum information processing. A central aspect for the successful implementation of quantum applications is the system's scalability. Unfortunately, placing atoms deterministically inside a cavity remains technologically elaborate and hence minimizes the prospect of scaling a atom-CQED system. \n \nA possibility to address this issue is to implement CQED in the solid state, where sophisticated fabrication strategies allow miniaturization and scalability of the system. Particularly the development of self-assembled quantum dots (QD) in semiconductors represent a promising route. QDs can be considered as artificial atoms that mimic the atomic two-level system. These structures interact strongly with light and therefore have the potential for replacing atoms in CQED. As a central advantage, QDs are naturally trapped, which greatly simplifies the deterministic incorporation into the cavity. \n \nIn recent years, many efforts have been made to couple self-assembled QDs to microcavities. Generally, the successful implementation of CQED requires a cavity with a high quality factor Q and a low mode volume. In a majority of the approaches, the high Q/small mode volume cavities were monolithically defined around the QD, embedding the QD at a fixed position inside the cavity. Both the weak and strong coupling regimes have been reached with these systems. However, for future applications they suffer from several disadvantages. The fixed position of the QD inside the cavity minimizes the prospects for spectral tunability and spatial positioning the QD inside the cavity. Furthermore, prospects for further increasing of the cavity Q-factor and minimization of the mode volume remain limited in these systems. \n \nIn this thesis the mentioned disadvantages are addressed by developing a fully tunable miniaturized Fabry-Pérot microcavity with low mode volume. The design enables both spatial positioning of the emitter inside the cavity and spectral tunability. Successful coupling of a single QD to the microcavity is demonstrated including the strong coupling regime. Further a new approach to decrease the cavity mode volume is presented, where we demonstrate weak coupling is achieved

•Jan 1, 2015•0 citations
We describe an effect called Dipole Induced Transparency which enables a dipole emitter to strongly modify the cavity spectrum, even in the weak coupling regime. We then describe a method for generating entanglement and performing a full Bell measurement between two QDs using Dipole Induced Transparency. Finally, we show how DIT enables entanglement between QDs with vastly different radiative properties. The proposal is shown to be robust to cavity resonance mismatch.
We describe a method for generating entanglement between two spatially separated dipoles coupled to optical microcavities. The protocol works even when the dipoles have different resonant frequencies and radiative lifetimes. This method is particularly important for solid-state emitters, such as quantum dots, which suffer from large inhomogeneous broadening. We show that high fidelities can be obtained over a large dipole detuning range without significant loss of efficiency. We analyze the impact of higher-order photon number states and cavity resonance mismatch on the performance of the protocol.
We propose a feasible scheme of generating multipartite entanglement with the dipole induced transparency (DIT) effect in indirectly coupled dipole-microcavity systems. It is shown that the transmission spectrum is closely related with the interference of dipole-microcavity systems, and we can generate different classes of multipartite entanglement, e.g., the Greenberger–Horne–Zeilinger state, the W state, and the Dicke state, of the dipole emitters just by choosing an appropriate frequency of the incident photon. Benefiting from the DIT effect, the schemes may work in the bad or low-Q cavity regime only if the large Purcell factor of the dipole-microcavity system is fulfilled, and they are also insensitive to experimental noise, which may be feasible with present accessible technology.
Dipole-induced transparency (DIT) is one of the most well-known transparency effects in quantum optics and has wide applications in scalable quantum information processing and quantum computation. However, most of the existing literatures only focuses on the DIT effect with coherent dipole-cavity coupling, thus its universality in other types of coupling is still to be clarified. Here, we propose a feasible scheme to realize dissipative dipole-cavity coupling with the assistance of a highly dissipative microcavity, and explicitly exhibit cavity-mode attraction. We then investigate the DIT effect in a cavity-waveguide system with attractive cavity modes and find that it can still be achievable even though the probe light is resonant with two attractive cavity modes. Furthermore, we reveal its underlying transparency mechanism with eigenfrequencies and the effective susceptibility of the dipole-cavity system, and show that its transparency lies in the destructive interference of two attractive cavity modes with splitting damping rates instead of splitting resonance frequencies in coherent coupling. Moreover, we find that the attractive and repulsive phenomena of the effective susceptibility, which also plays an important role in the DIT effect, exist in the dipole-cavity system. Our findings may not only be of importance for gaining a more comprehensive understanding on the DIT effect, but also have potential applications in quantum networks.
The interaction of light with matter is at the heart of quantum optics, which itself enables insight into the fundamental aspects of quantum mechanics. First experimental access to this research field has been realized by coupling atoms to light. Here, the transition between discrete energy states of the atom is associated with the absorption and emission of a photon, a single quantum of the electromagnetic field. As a central aspect of quantum optics, the light-emitter interaction can be significantly enhanced by placing the emitter in optical cavity that is on resonance with the emitter. In recent years, this has led to a rapidly evolving research field known as cavity quantum electrodynamics (CQED). In CQED two different regimes are distinguished: the strong and the weak coupling regimes. In the strong coupling regime, the emitted photon is reflected from the cavity mirrors and eventually reabsorbed by the emitter. In contrast, the weak coupling regime describes the irreversible emission, where the photon leaks out of the cavity before it can be reabsorbed. Both the weak and strong coupling regimes enabled fundamental experiments for a better understanding of quantum optical phenomena. \n \n \n \nCQED grants access to the quantum world and hence offers potentially revolutionizing applications, particularly in the field of quantum information processing. A central aspect for the successful implementation of quantum applications is the system's scalability. Unfortunately, placing atoms deterministically inside a cavity remains technologically elaborate and hence minimizes the prospect of scaling a atom-CQED system. \n \nA possibility to address this issue is to implement CQED in the solid state, where sophisticated fabrication strategies allow miniaturization and scalability of the system. Particularly the development of self-assembled quantum dots (QD) in semiconductors represent a promising route. QDs can be considered as artificial atoms that mimic the atomic two-level system. These structures interact strongly with light and therefore have the potential for replacing atoms in CQED. As a central advantage, QDs are naturally trapped, which greatly simplifies the deterministic incorporation into the cavity. \n \nIn recent years, many efforts have been made to couple self-assembled QDs to microcavities. Generally, the successful implementation of CQED requires a cavity with a high quality factor Q and a low mode volume. In a majority of the approaches, the high Q/small mode volume cavities were monolithically defined around the QD, embedding the QD at a fixed position inside the cavity. Both the weak and strong coupling regimes have been reached with these systems. However, for future applications they suffer from several disadvantages. The fixed position of the QD inside the cavity minimizes the prospects for spectral tunability and spatial positioning the QD inside the cavity. Furthermore, prospects for further increasing of the cavity Q-factor and minimization of the mode volume remain limited in these systems. \n \nIn this thesis the mentioned disadvantages are addressed by developing a fully tunable miniaturized Fabry-Pérot microcavity with low mode volume. The design enables both spatial positioning of the emitter inside the cavity and spectral tunability. Successful coupling of a single QD to the microcavity is demonstrated including the strong coupling regime. Further a new approach to decrease the cavity mode volume is presented, where we demonstrate weak coupling is achieved