Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Mass effects and one-particle detectors in quantum-measuring processes

Kiyotaka Kakazu

Published Feb 1, 1992• 1 citation
Publisher

Abstract

The measuring process of an object system and a detector are studied in the von Neumann model and one of its variants, in which the detector consists of a single particle. If the states of the particle after the interaction with the object system are described partly by coherent states, then the particle can play the role of a detector under certain conditions. The mass (or free Hamiltonian) of the detector does not affect the measuring process at all, while the mass of the object system plays an important role. In the von Neumann model, if the mass of the object system is quite large, the position measurement can be considered, and under certain conditions the statistical operator \ensuremath{\rho} tends to just its mixed-state part, i.e., quantum interference disappears. However, when the time after the interaction becomes very large, interference emerges again. On the other hand, if the mass of the object system is small, we can even consider the momentum measurement and show that \ensuremath{\rho} approaches its mixed-state part when the time becomes very large, i.e., \ensuremath{\rho} is equivalent to its mixed-state part. The momentum can also be measured almost completely in the variant model; the operator \ensuremath{\rho} becomes equivalent to its mixed-state part. The different quantum states distinguish the detectors from the object systems.

DOI
10.1103/physreva.45.1361

Related papers

One-Particle Detectors with SU(1, 1) Coherent States in Quantum Measurement

K. Kakazu, Akihiko Ogawa

The generalized coherent states based on SU(1, 1) are applied to quantum-measuring processes, in which each detector consists of a single particle. Differing from the Glauber coherent states, possible interactions are quite restricted. New definitions of the classical limit and classical operators are presented, where any polynomial of the position and momentum operators becomes classical. Although quantum interference itself becomes very large as the time after the interaction is increased, the statistical operator approaches its mixed-state part in a relative sense.

Progress of Theoretical Physics•Oct 1, 1991•1 citation

On the Quantum Mechanical Description of the Interaction between Particle and Detector

K. Wick

Quantum measurements of physical quantities are often described as ideal measurements. However, only a few measurements fulfil the conditions of ideal measurements. The aim of the present work is to describe real position measurements with detectors that are able to detect single particles. For this purpose, a detector model is developed that can describe the time dependence of the interaction between a non-relativistic particle and a detector. The example of a position measurement shows that this interaction can be described with the methods of quantum mechanics. At the beginning of a position measurement, the detector behaves as a target consisting of a large number of quantum mechanical systems. In the first reaction, the incident particle interacts with a single atom, electron or nucleus, but not with the whole detector. This reaction and all following reactions are quantum mechanical processes. At the end of the measurement, the detector can be considered as a classical apparatus. A detector is neither a quantum mechanical system nor a classical apparatus. The detector model explains why one obtains a well-defined result for each individual position measurement. It further explains that, in general, it is impossible to predict the outcome of an individual measurement.

arXiv:1901.05403•Physics•Nov 8, 2021•1 citation

Generalized Coherent State Approach to Quantum Measurement

Shoju Kudaka, S. Matsumoto, K. Kakazu

We present and discuss some models for the quantum measuring process. Our models indicate that the coherent state approach to classical limits in quantum theories becomes a powerful method for a unified description of various measuring processes. Each detector in the models has a parameter N , the number of its dynamical variables; the whole process of an interaction between an object system and the detector is calculable for any finite number N . It is shown that the detector states after the interaction are characterized by a macroscopic parameter, which is closely connected with the “reliability” of the detector. The reliability plays an essential role in eliminating the quantum interference between two states corresponding to two different positions of the pointer. Finally, the quantum mechanics of the detector reduces to classical mechanics on suitable “phase space” as N becomes large, as is required.

Progress of Theoretical Physics•Oct 1, 1989•26 citations

Generalized model of the quantum measurement process in an environment

Masashi Ban, Sachiko Kitajima, Fumiaki Shibata

A generalized model of the quantum measurement process is considered, in which the relaxation of the detector system interacting with an environment can be treated. When the effect of the environment on the detector system is described by the quantum Markovian process, the model can be solved exactly. The time evolution of the particle and detector is investigated in detail. It is shown that the decay of quantum coherence of the particle becomes negligible when the relaxation time of the detector system is sufficiently short. Furthermore the stochastic model is found, which is equivalent to the proposed model with respect to the particle state.

Physical Review A•Mar 25, 2009•2 citations

A heuristic approach to the quantum measurement problem: How to distinguish particle detectors from ordinary objects

Roberto D. Merlin

Elementary particle detectors fall broadly into only two classes: phase-transformation devices, such as the bubble chamber, and charge-transfer devices like the Geiger–Müller tube. Quantum measurements are seen to involve transitions from a long-lived metastable state (e.g., superheated liquid or a gas of atoms between charged capacitor plates) to a thermodynamically stable condition. A detector is then a specially prepared object undergoing a metastable-to-stable transformation that is significantly enhanced by the presence of the measured particle, which behaves, in some sense, as the seed of a process of heterogeneous nucleation. Based on this understanding of the operation of a conventional detector, and using results of orthogonality-catastrophe theory, we argue that, in the thermodynamic limit, the pre-measurement Hamiltonian is not the same as that describing the detector during or after the interaction with a particle and, thus, that superpositions of pointer states (Schrödinger’s cats) are unphysical because their time evolution is ill defined. Examples of particle-induced changes in the Hamiltonian are also given for ordinary systems whose macroscopic parameters are susceptible to radiation damage, but are not modified by the interaction with a single particle.

arXiv:1507.06202•International Journal of Modern Physics B•Aug 19, 2015•1 citation

Analysis of the Quantum Mechanical Measurement Process

Eugene Paul Wigner, Mutsuo M. Yanase

The quantum mechanical measurement process is analysed in detail, especially from the group theoretical point of view. The first three chapters review the results obtained before briefly. In §1, the classical theory of measurement, originated by von Neumann, is birefly described. The importance of considering more general schemes of measurements than the original one is, however, emphasized. In §2, the role of conservation laws, in imposing limitations on the possibility of measurements, is discussed. Accurately measurable quantities are defined in this context. In §3, the role of conservation laws is further analysed. It is shown that the conserved quantity of the apparatus cannot be used for a “pointer reading.” The following two chapters discuss the nature of the exactly measurable quantities. In §4, exactly measurable quantities are explicitly determined. It is shown that the measurement of projection operators in the Hilbert space of the object which commute with the operators of the restricted Poincaré group give all the information on the states of the object that can be obtained by accurate measurements. In §5, the measurement on objects which are composed of more than one particle is discussed. The last chapter, §6, deals with approximately measurable quantities, but no complete estimate of the unavoidable inaccuracy of the measurement of these is obtained. It also contains some concluding remarks.

Annals of the Japan Association for Philosophy of Science•Jan 1, 1973•2 citations
The measuring process of an object system and a detector are studied in the von Neumann model and one of its variants, in which the detector consists of a single particle. If the states of the particle after the interaction with the object system are described partly by coherent states, then the particle can play the role of a detector under certain conditions. The mass (or free Hamiltonian) of the detector does not affect the measuring process at all, while the mass of the object system plays an important role. In the von Neumann model, if the mass of the object system is quite large, the position measurement can be considered, and under certain conditions the statistical operator \ensuremath{\rho} tends to just its mixed-state part, i.e., quantum interference disappears. However, when the time after the interaction becomes very large, interference emerges again. On the other hand, if the mass of the object system is small, we can even consider the momentum measurement and show that \ensuremath{\rho} approaches its mixed-state part when the time becomes very large, i.e., \ensuremath{\rho} is equivalent to its mixed-state part. The momentum can also be measured almost completely in the variant model; the operator \ensuremath{\rho} becomes equivalent to its mixed-state part. The different quantum states distinguish the detectors from the object systems.
The generalized coherent states based on SU(1, 1) are applied to quantum-measuring processes, in which each detector consists of a single particle. Differing from the Glauber coherent states, possible interactions are quite restricted. New definitions of the classical limit and classical operators are presented, where any polynomial of the position and momentum operators becomes classical. Although quantum interference itself becomes very large as the time after the interaction is increased, the statistical operator approaches its mixed-state part in a relative sense.
Quantum measurements of physical quantities are often described as ideal measurements. However, only a few measurements fulfil the conditions of ideal measurements. The aim of the present work is to describe real position measurements with detectors that are able to detect single particles. For this purpose, a detector model is developed that can describe the time dependence of the interaction between a non-relativistic particle and a detector. The example of a position measurement shows that this interaction can be described with the methods of quantum mechanics. At the beginning of a position measurement, the detector behaves as a target consisting of a large number of quantum mechanical systems. In the first reaction, the incident particle interacts with a single atom, electron or nucleus, but not with the whole detector. This reaction and all following reactions are quantum mechanical processes. At the end of the measurement, the detector can be considered as a classical apparatus. A detector is neither a quantum mechanical system nor a classical apparatus. The detector model explains why one obtains a well-defined result for each individual position measurement. It further explains that, in general, it is impossible to predict the outcome of an individual measurement.
We present and discuss some models for the quantum measuring process. Our models indicate that the coherent state approach to classical limits in quantum theories becomes a powerful method for a unified description of various measuring processes. Each detector in the models has a parameter N , the number of its dynamical variables; the whole process of an interaction between an object system and the detector is calculable for any finite number N . It is shown that the detector states after the interaction are characterized by a macroscopic parameter, which is closely connected with the “reliability” of the detector. The reliability plays an essential role in eliminating the quantum interference between two states corresponding to two different positions of the pointer. Finally, the quantum mechanics of the detector reduces to classical mechanics on suitable “phase space” as N becomes large, as is required.
A generalized model of the quantum measurement process is considered, in which the relaxation of the detector system interacting with an environment can be treated. When the effect of the environment on the detector system is described by the quantum Markovian process, the model can be solved exactly. The time evolution of the particle and detector is investigated in detail. It is shown that the decay of quantum coherence of the particle becomes negligible when the relaxation time of the detector system is sufficiently short. Furthermore the stochastic model is found, which is equivalent to the proposed model with respect to the particle state.
Elementary particle detectors fall broadly into only two classes: phase-transformation devices, such as the bubble chamber, and charge-transfer devices like the Geiger–Müller tube. Quantum measurements are seen to involve transitions from a long-lived metastable state (e.g., superheated liquid or a gas of atoms between charged capacitor plates) to a thermodynamically stable condition. A detector is then a specially prepared object undergoing a metastable-to-stable transformation that is significantly enhanced by the presence of the measured particle, which behaves, in some sense, as the seed of a process of heterogeneous nucleation. Based on this understanding of the operation of a conventional detector, and using results of orthogonality-catastrophe theory, we argue that, in the thermodynamic limit, the pre-measurement Hamiltonian is not the same as that describing the detector during or after the interaction with a particle and, thus, that superpositions of pointer states (Schrödinger’s cats) are unphysical because their time evolution is ill defined. Examples of particle-induced changes in the Hamiltonian are also given for ordinary systems whose macroscopic parameters are susceptible to radiation damage, but are not modified by the interaction with a single particle.
The quantum mechanical measurement process is analysed in detail, especially from the group theoretical point of view. The first three chapters review the results obtained before briefly. In §1, the classical theory of measurement, originated by von Neumann, is birefly described. The importance of considering more general schemes of measurements than the original one is, however, emphasized. In §2, the role of conservation laws, in imposing limitations on the possibility of measurements, is discussed. Accurately measurable quantities are defined in this context. In §3, the role of conservation laws is further analysed. It is shown that the conserved quantity of the apparatus cannot be used for a “pointer reading.” The following two chapters discuss the nature of the exactly measurable quantities. In §4, exactly measurable quantities are explicitly determined. It is shown that the measurement of projection operators in the Hilbert space of the object which commute with the operators of the restricted Poincaré group give all the information on the states of the object that can be obtained by accurate measurements. In §5, the measurement on objects which are composed of more than one particle is discussed. The last chapter, §6, deals with approximately measurable quantities, but no complete estimate of the unavoidable inaccuracy of the measurement of these is obtained. It also contains some concluding remarks.