Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical Review

Optical Signal Inversion Phenomenon for 1.5 μm Derived from the Negative Nonlinear Absorption Effect in an Erbium Nitrate Solution

Yoshinobu Maeda

Published Sep 1, 1999• 0 citations
Publisher
DOI
10.1007/s10043-999-0402-z

Related papers

Optical Signal Inversion Phenomenon Derived from the Negative Nonlinear Absorption Effect in Er^3^+: LiYF~4

Yoshinobu Maeda, Toshikazu Yamada

IEICE Transactions on Electronics•Sep 25, 1998•1 citation

Negative Nonlinear Absorption Effect for 1.5 μm Laser in an Erbium Chloride Solution

Yoshinobu Maeda

Optical Review•Jul 1, 1999•0 citations

Optical bistability derived from the negative nonlinear absorption effect in erbium doped materials

Yoshinobu Maeda

Materials Science and Engineering B•Apr 1, 2001•7 citations

All-optical signal inverter derived from negative nonlinear absorption effect

Toshikazu Yamada, Kazuhiko Tokoro, Yoshinobu Maeda

Materials Science and Engineering B•Apr 1, 2001•0 citations

Optical signal inversion phenomenon for 1.53 μm laser in an erbium-doped lithium niobate

Yoshinobu Maeda, Hirotoshi Nagata, Taizou Nakashima +2 more

Modulation characteristics of a negative nonlinear absorption effect were investigated in 3 wt % erbium-doped lithium niobate using a 1530 nm laser diode. With a decreasing incident modulation degree, a reversed-phase waveform was obtained in the transmitted laser at modulation degrees smaller than 85% for a sample length of 14 mm. The reversed-phase transmitted waveforms were observed at modulation frequencies from 1 kHz to 10 GHz. The negative nonlinear absorption effect for 1.5 μm can be explained by considering an enhanced absorption model for a four-level system of the Er3+ ion.

Applied Physics Letters•Dec 27, 1999•1 citation

Optical signal inversion phenomena due to negative nonlinear absorption effect

Yoshinobu Maeda, Seiichi Ikeda, Takao Sakakibara +1 more

A negative input-output characteristic was obtained in an erbium-doped yttrium aluminum garnet crystal which has multiple-level energy structure: absorption can occur between a ground level and an excited level (4I−4I) and between two other excited levels (4I−2H) in Er3+. It occurred at a wavelength between 786.6 and 788.4 nm by variation of the incident laser intensity in the intensity range of 60 nW/cm2 to 100 W/cm2. It is considered that an enhanced absorption occurs due to the excited-state absorption from 4I to 2H, its spectra matching the wavelength dependence of the incident laser In addition, optical signal inverter phenomenon was observed using a laser diode modulated at 10 MHz. By considering multiple excited-state absorption in detail, active functions such as an optical signal inverter could be derived from the negative nonlinear absorption effect. © 1997 Scripta Technica, Inc. Electr Eng Jpn, 120(4): 74–80, 1997

Electrical Engineering in Japan•Sep 1, 1997•0 citations
Modulation characteristics of a negative nonlinear absorption effect were investigated in 3 wt % erbium-doped lithium niobate using a 1530 nm laser diode. With a decreasing incident modulation degree, a reversed-phase waveform was obtained in the transmitted laser at modulation degrees smaller than 85% for a sample length of 14 mm. The reversed-phase transmitted waveforms were observed at modulation frequencies from 1 kHz to 10 GHz. The negative nonlinear absorption effect for 1.5 μm can be explained by considering an enhanced absorption model for a four-level system of the Er3+ ion.
A negative input-output characteristic was obtained in an erbium-doped yttrium aluminum garnet crystal which has multiple-level energy structure: absorption can occur between a ground level and an excited level (4I−4I) and between two other excited levels (4I−2H) in Er3+. It occurred at a wavelength between 786.6 and 788.4 nm by variation of the incident laser intensity in the intensity range of 60 nW/cm2 to 100 W/cm2. It is considered that an enhanced absorption occurs due to the excited-state absorption from 4I to 2H, its spectra matching the wavelength dependence of the incident laser In addition, optical signal inverter phenomenon was observed using a laser diode modulated at 10 MHz. By considering multiple excited-state absorption in detail, active functions such as an optical signal inverter could be derived from the negative nonlinear absorption effect. © 1997 Scripta Technica, Inc. Electr Eng Jpn, 120(4): 74–80, 1997