Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics Letters

Terahertz Detection with Twin Superconductor–Insulator–Superconductor Tunnel Junctions

Jing Li, Wang Ming-Jye, Shi Sheng-Cai, Hiroshi Matsuo

Published Jan 18, 2007• 4 citations
Publisher

Abstract

Terahertz detection with twin superconductor–insulator–superconductor (SIS) tunnel junctions, which are connected in parallel via an inductive thin-film superconducting microstrip line, is mainly studied. Firstly, we investigate the direct-detection response of a superconducting twin-junction device by means of a Fourier transform spectrometer. Secondly, we construct a direct-detection model of twin SIS tunnel junctions. The superconducting twin-junction device is then simulated in terms of the constructed model. The simulation result is found to be in good agreement with the measured one. In addition, we observe that the direct-detection response of the device is consistent with the noise temperature behaviour.

DOI
10.1088/0256-307x/24/2/075

Related papers

Study of Superconducting Transmission Lines and Tunnel Junctions for Signal Detection at Frequencies above 1 THz

Nickolay V. Kinev, Artem M. Chekushkin, Fedor V. Khan +1 more

Abstract Superconducting integrated circuits based on NbTiN/Al transmission lines at frequencies of up to 1.1 THz have been developed and experimentally investigated. The numerical simulation has been carried out for two topologies of a microcircuit with an operating frequency range of 0.9‒1.2 THz, which contains a slot antenna formed in the NbTiN thin film and output-matched with a microstrip transmission line and a superconductor‒insulator‒superconductor (SIS) tunnel junction with an area of ~1 µm2 acting as a terahertz detector. Experimental samples of the microcircuit have been fabricated and tested in an experimental setup utilizing a backward-wave oscillator with an output frequency of up to 1.1 THz used as a source. The powerful pumping of the SIS detector has been obtained to demonstrate the applicability of the fabricated NbTiN/Al transmission lines for operation in superconducting circuits at frequencies above 750 GHz, where the conventional Nb/Nb transmission lines cannot operate due to high losses.

Journal of Communications Technology and Electronics•Sep 1, 2023•3 citations

0.5-THz waveguide SIS mixers with NbN/AlN/NbN technology

Jing Li, Masanori Takeda, Zhen Wang +1 more

Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AlOx/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region. Considering the bandwidth and output power of local-oscillator (LO) signal sources are quite limited around 1THz, we firstly develop a waveguide NbN-based SIS mixer at 0.5THz. Three types of SIS junctions, i.e., long junction, parallel-connected tunnel junction (PCTJ) and distributed junction array (DJ) are investigated. They are all comprised of NbN-AlN-NbN tri-layer fabricated on an MgO substrate and have the same current density (Jc) of 10kA/cm2. In this paper, we describe their design, fabrication and preliminary experimental results.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 29, 2007•3 citations

Terahertz high-sensitivity SIS mixer based on Nb–AlN–NbN hybrid superconducting tunnel junctions

Bo-Liang 博梁 Liu 刘, Dong 冬 Liu 刘, Ming Yao +8 more

The terahertz band, a unique segment of the electromagnetic spectrum, is crucial for observing the cold, dark universe and plays a pivotal role in cutting-edge scientific research, including the study of cosmic environments that support life and imaging black holes. High-sensitivity superconductor–insulator–superconductor (SIS) mixers are essential detectors for terahertz astronomical telescopes and interferometric arrays. Compared to the commonly used classical Nb/AlO x /Nb superconducting tunnel junction, the Nb/AlN/NbN hybrid superconducting tunnel junction has a higher energy gap voltage and can achieve a higher critical current density. This makes it particularly promising for the development of ultra-wideband, high-sensitivity coherent detectors or mixers in various scientific research fields. In this paper, we present a superconducting SIS mixer based on Nb/AlN/NbN parallel-connected twin junctions (PCTJ), which has a bandwidth extending up to 490 GHz–720 GHz. The best achieved double-sideband (DSB) noise temperature (sensitivity) is below three times the quantum noise level.

Chinese Physics B•Feb 22, 2024•6 citations

Measurement of the Direct-Detection Responses of a 500-GHz and a 660-GHz Waveguide Superconducting SIS Mixer

Jing Li, Ming-Jye Wang, Sheng‐Cai Shi +1 more

This paper presents the direct-detection responses of a 500-GHz and a 660-GHz waveguide superconducting SIS (superconductor-insulator-superconductor) mixer measured with a Fourier transform spectrometer (FTS). The two superconducting SIS mixers adopt the same type of junction tuning circuit (i.e., parallel connected twin SIS junctions), but are of different designs for the junction feed point where RF signals are coupled and then transmitted to the SIS junction tuning circuit and have different mixer design criteria. The experimental results are discussed in detail.

Asia-Pacific Microwave Conference (APMC)•Mar 22, 2006•1 citation

0.5-THz waveguide SIS mixers with NbN/AlN/NbN technology - art. no. 684013

Jing Li, Takeda Masanon, Zhen Wang

Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AIO(x)/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region.

•Jan 1, 2008•0 citations

Investigation of superconducting transmission lines and tunnel junctions for detecting signals at frequencies above 1 THz.

Nickolay V. Kinev, Artem M. Chekushkin, Fedor V. Khan +1 more

Superconducting integrated circuits based on NbTiN/Al transmission lines at frequencies up to 1.1 THz have been developed and experimentally studied. Numerical modeling of two microcircuit topologies with an operating frequency range of 0.9…1.2 THz, containing a slot antenna, made in a thin NbTiN film and matched in output to a microstrip transmission line, and a tunnel junction of the “superconductor–insulator–superconductor” (SIS) type with an area of the order of 1 μm^2, acting as a terahertz detector. Experimental samples of the microcircuit were manufactured and tested; in the experimental setup, a backward wave lamp (BWL) with an output frequency of up to 1.1 THz was used as a source. A powerful pumping of the SIS detector was obtained, thereby demonstrating the applicability of the manufactured NbTiN/Al transmission lines for operation in superconducting circuits at frequencies above 750 GHz, where traditionally used Nb/Nb transmission lines do not operate due to high attenuation.

Радиотехника и электроника•Sep 1, 2023•0 citations
Terahertz detection with twin superconductor–insulator–superconductor (SIS) tunnel junctions, which are connected in parallel via an inductive thin-film superconducting microstrip line, is mainly studied. Firstly, we investigate the direct-detection response of a superconducting twin-junction device by means of a Fourier transform spectrometer. Secondly, we construct a direct-detection model of twin SIS tunnel junctions. The superconducting twin-junction device is then simulated in terms of the constructed model. The simulation result is found to be in good agreement with the measured one. In addition, we observe that the direct-detection response of the device is consistent with the noise temperature behaviour.
Abstract Superconducting integrated circuits based on NbTiN/Al transmission lines at frequencies of up to 1.1 THz have been developed and experimentally investigated. The numerical simulation has been carried out for two topologies of a microcircuit with an operating frequency range of 0.9‒1.2 THz, which contains a slot antenna formed in the NbTiN thin film and output-matched with a microstrip transmission line and a superconductor‒insulator‒superconductor (SIS) tunnel junction with an area of ~1 µm2 acting as a terahertz detector. Experimental samples of the microcircuit have been fabricated and tested in an experimental setup utilizing a backward-wave oscillator with an output frequency of up to 1.1 THz used as a source. The powerful pumping of the SIS detector has been obtained to demonstrate the applicability of the fabricated NbTiN/Al transmission lines for operation in superconducting circuits at frequencies above 750 GHz, where the conventional Nb/Nb transmission lines cannot operate due to high losses.
Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AlOx/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region. Considering the bandwidth and output power of local-oscillator (LO) signal sources are quite limited around 1THz, we firstly develop a waveguide NbN-based SIS mixer at 0.5THz. Three types of SIS junctions, i.e., long junction, parallel-connected tunnel junction (PCTJ) and distributed junction array (DJ) are investigated. They are all comprised of NbN-AlN-NbN tri-layer fabricated on an MgO substrate and have the same current density (Jc) of 10kA/cm2. In this paper, we describe their design, fabrication and preliminary experimental results.
The terahertz band, a unique segment of the electromagnetic spectrum, is crucial for observing the cold, dark universe and plays a pivotal role in cutting-edge scientific research, including the study of cosmic environments that support life and imaging black holes. High-sensitivity superconductor–insulator–superconductor (SIS) mixers are essential detectors for terahertz astronomical telescopes and interferometric arrays. Compared to the commonly used classical Nb/AlO x /Nb superconducting tunnel junction, the Nb/AlN/NbN hybrid superconducting tunnel junction has a higher energy gap voltage and can achieve a higher critical current density. This makes it particularly promising for the development of ultra-wideband, high-sensitivity coherent detectors or mixers in various scientific research fields. In this paper, we present a superconducting SIS mixer based on Nb/AlN/NbN parallel-connected twin junctions (PCTJ), which has a bandwidth extending up to 490 GHz–720 GHz. The best achieved double-sideband (DSB) noise temperature (sensitivity) is below three times the quantum noise level.
This paper presents the direct-detection responses of a 500-GHz and a 660-GHz waveguide superconducting SIS (superconductor-insulator-superconductor) mixer measured with a Fourier transform spectrometer (FTS). The two superconducting SIS mixers adopt the same type of junction tuning circuit (i.e., parallel connected twin SIS junctions), but are of different designs for the junction feed point where RF signals are coupled and then transmitted to the SIS junction tuning circuit and have different mixer design criteria. The experimental results are discussed in detail.
Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AIO(x)/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region.
Superconducting integrated circuits based on NbTiN/Al transmission lines at frequencies up to 1.1 THz have been developed and experimentally studied. Numerical modeling of two microcircuit topologies with an operating frequency range of 0.9…1.2 THz, containing a slot antenna, made in a thin NbTiN film and matched in output to a microstrip transmission line, and a tunnel junction of the “superconductor–insulator–superconductor” (SIS) type with an area of the order of 1 μm^2, acting as a terahertz detector. Experimental samples of the microcircuit were manufactured and tested; in the experimental setup, a backward wave lamp (BWL) with an output frequency of up to 1.1 THz was used as a source. A powerful pumping of the SIS detector was obtained, thereby demonstrating the applicability of the manufactured NbTiN/Al transmission lines for operation in superconducting circuits at frequencies above 750 GHz, where traditionally used Nb/Nb transmission lines do not operate due to high attenuation.