Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR)

Improvement of success probability by squeezed light in weak value amplification for single-photon-level nonlinearity

F. Matsuoka, A. Tornita, A. Okamoto

Published Jun 1, 2013• 0 citations
Publisher

Abstract

We propose the use of a squeezed coherent light probe in weak value amplification of single photon nonlinearity. It improves the success probability more than tenfold without the degradation of the error probability.
DOI
10.1109/cleopr.2013.6600619

Related papers

Squeezed Light in Weak Value Amplification for Single-Photon-Level Nonlinearity

F. Matsuoka, Akihisa Tomita, Akihiro Okamoto

We propose the use of a squeezed coherent light probe in weak value amplification of single photon nonlinearity. It improves the success probability more than tenfold without the degradation of the error probability.

Conference on Lasers and Electro-Optics•Jun 30, 2013•0 citations

Amplifying Single-Photon Nonlinearity Using Weak Measurements

Amir Feizpour, Xingxing Xing, Aephraim M. Steinberg

We show that weak measurement can be used to "amplify" optical nonlinearities at the single-photon level, such that the effect of one properly postselected photon on a classical beam may be as large as that of many unpostselected photons. We find that "weak-value amplification" offers a marked improvement in the signal-to-noise ratio in the presence of technical noise with long correlation times. Unlike previous weak-measurement experiments, our proposed scheme has no classical equivalent.

arXiv:1101.0199•Physical Review Letters•Sep 23, 2011•268 citations

Implementation of weak measurement amplification with the weak coherent light and optomechanical system

Gang Li, Wen Yang

Abstract Most studies for postselected weak measurement in optomechanical system focus on using a single photon as a measured system. However, we find that using weak coherent light instead of a single photon can also amplify the mirror’s position displacement of one photon. In the weak value amplification (WVA) regime, the weak value of one photon can lie outside the eigenvalue spectrum, proportional to the difference of the mirror’s position displacement between the successful and failed postselection and its successful postselection probability is dependent of the mean photon number of the coherent light and improved by adjusting it accordingly. Outside the WVA regime, the amplification limit can reach the level of the vacuum fluctuations, and when the mean photon number and the optomechanical coupling parameter are selected appropriately, its successful postselection probability becomes higher, which is beneficial to observe the maximum amplification value under the current experimental conditions. This result breaks the constraint that it is difficult to detect outside the WVA regime. This opens up a new regime for the study of a single photon nonlinearity in optomechanical system.

arXiv:2104.03561•Journal of Physics B Atomic Molecular and Optical Physics•Jun 9, 2021•2 citations

Signal-to-Noise Ratio Enhancement in Weak Measurement, and its Application to Observing Single-Photon-Level Nonlinearities

Amir Feizpour, Xingxgin Xing, Aephraim M. Steinberg

We show theoretically that weak-value amplification can enhance the signal-to-noise ratio in the presence of noise with long correlation times, in particular for measurements of single-photon-level nonlinearities.

Conference on Lasers and Electro-Optics•Jan 1, 2012•0 citations

Optical amplification of single-photon polarization qubit using weak measurement

Ruitong Zhao, Jianjun Guo, Lianglun Cheng

Abstract Single-photon amplification can be used to overcome the photon loss in long-distance quantum communication. However, the trade-off of success probability and amplification gain should be further improved. We propose a single-photon polarization qubit amplification using weak measurement. The polarization qubit can be amplified by the pre- and post-selection of the single-photon meter state weakly coupling with the input state. The success probability does not decrease asymptotically to 0 with increasing amplification gain in the presented proposal, and is higher than that in entanglement-based schemes, without coincidence detection required. Our proposal is feasible in current technology, and helpful for near-future quantum communication.

Applied Physics Express•Nov 18, 2020•3 citations

Realization of entanglement-assisted weak-value amplification in a photonic system

Jiangshan Chen, Bi‐Heng Liu, Mengjun Hu +4 more

Weak-value amplification has been used to enhance the sensitivity of a linear detector response to small interaction parameters. However, the generation of a large weak value gives rise to reduction in postselection probability, which restricts the feasibility of the weak-value amplification technique. Recently, theoretical works have shown that the use of entanglement can increase the efficiency of the weak-value amplification method. Specifically, it is proven that by entangling $n$ particles of a system, the maximum postselection probability scales quadratically with $n$ [Pang, Dressel, and Brun, Phys. Rev. Lett. 113, 030401 (2014)]. In this work, we demonstrate an experimental realization of entanglement-assisted weak-value amplification in a photonic system, which shows that importing quantum entanglement can indeed improve the efficiency of weak-value amplification.

Physical Review A•Mar 25, 2019•18 citations
We show that weak measurement can be used to "amplify" optical nonlinearities at the single-photon level, such that the effect of one properly postselected photon on a classical beam may be as large as that of many unpostselected photons. We find that "weak-value amplification" offers a marked improvement in the signal-to-noise ratio in the presence of technical noise with long correlation times. Unlike previous weak-measurement experiments, our proposed scheme has no classical equivalent.
Abstract Most studies for postselected weak measurement in optomechanical system focus on using a single photon as a measured system. However, we find that using weak coherent light instead of a single photon can also amplify the mirror’s position displacement of one photon. In the weak value amplification (WVA) regime, the weak value of one photon can lie outside the eigenvalue spectrum, proportional to the difference of the mirror’s position displacement between the successful and failed postselection and its successful postselection probability is dependent of the mean photon number of the coherent light and improved by adjusting it accordingly. Outside the WVA regime, the amplification limit can reach the level of the vacuum fluctuations, and when the mean photon number and the optomechanical coupling parameter are selected appropriately, its successful postselection probability becomes higher, which is beneficial to observe the maximum amplification value under the current experimental conditions. This result breaks the constraint that it is difficult to detect outside the WVA regime. This opens up a new regime for the study of a single photon nonlinearity in optomechanical system.
Abstract Single-photon amplification can be used to overcome the photon loss in long-distance quantum communication. However, the trade-off of success probability and amplification gain should be further improved. We propose a single-photon polarization qubit amplification using weak measurement. The polarization qubit can be amplified by the pre- and post-selection of the single-photon meter state weakly coupling with the input state. The success probability does not decrease asymptotically to 0 with increasing amplification gain in the presented proposal, and is higher than that in entanglement-based schemes, without coincidence detection required. Our proposal is feasible in current technology, and helpful for near-future quantum communication.
Weak-value amplification has been used to enhance the sensitivity of a linear detector response to small interaction parameters. However, the generation of a large weak value gives rise to reduction in postselection probability, which restricts the feasibility of the weak-value amplification technique. Recently, theoretical works have shown that the use of entanglement can increase the efficiency of the weak-value amplification method. Specifically, it is proven that by entangling nnn particles of a system, the maximum postselection probability scales quadratically with nnn [Pang, Dressel, and Brun, Phys. Rev. Lett. 113, 030401 (2014)]. In this work, we demonstrate an experimental realization of entanglement-assisted weak-value amplification in a photonic system, which shows that importing quantum entanglement can indeed improve the efficiency of weak-value amplification.