Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Electronics Letters

Optimum control beam angle for a biased optical bistable device

Rosie Cush

Published Jun 4, 1987• 2 citations
Publisher

Abstract

The control beam intensity required to switch a multibeam, cascadable Fabry–Perot bistable device may be minimised by varying the beam incident angle.
DOI
10.1049/el:19870444

Related papers

A bistable Fabry-Perot resonator

P. W. E. Smith, E. H. Turner

We propose and demonstrate the operation of a novel bistable optical device that exhibits differential gain and can function as an optical switch, limiter, or optical memory element.

Applied Physics Letters•Mar 15, 1977•151 citations

Bistable optical switching by the incident angle

G. Zartov, Kr.P. Panajotov, Rumiana A. Peyeva

Optics Communications•Oct 1, 1985•0 citations

Optimum Control Beam Angle for a Biased Fabry-Perot Bistable Device

Rosie Cush, Ian Bennion C

The use of bistable Fabry-Perot devices as multi-port cascadable devices has been frequently discussed in the literature (1-3). It has been envisaged that such devices could be addressed by a number of bias and control beams each approaching the device at a different angle (fig. 1). However, if these devices are to be cascadable, the same wavelength of light must be used for all control and bias beams. In this situation the control beam intensities inside the devices will be determined by the amplification effects of the cavity. Their behaviour will differ from that of the bias beam as the different incident angles produce additional phase changes. It has been shown that these additional phase changes give rise to bistable switching as the incident angle of the beam is changed (4) and this behaviour is demonstrated experimentally.

•Jan 1, 1987•0 citations

Critical exponents in dispersive optical bistability

G. Grynberg, Sophie Cribier

We theoretically investigate the switching time ts of a single beam optical device whose bistability relies on a dispersive effect. We show that if we vary an external parameter p (incident intensity or length of the Fabry-Perot cavity) beyond a critical point pc, ts should vary as (p - pc)-1/2 whatever the origin of the non linear dispersion is.

Journal de Physique Lettres•Jan 1, 1983•19 citations

Steady characteristics of a biased optical bistable device

Ch. Golaire, Paul Mandel, P. Laws

Optics Communications•Mar 1, 1986•5 citations

Observation of optical bistability in an atomic beam apparatus (A)

Harry J. Kimble, David E. Grant

Journal of the Optical Society of America A•Dec 1, 1981•0 citations
The use of bistable Fabry-Perot devices as multi-port cascadable devices has been frequently discussed in the literature (1-3). It has been envisaged that such devices could be addressed by a number of bias and control beams each approaching the device at a different angle (fig. 1). However, if these devices are to be cascadable, the same wavelength of light must be used for all control and bias beams. In this situation the control beam intensities inside the devices will be determined by the amplification effects of the cavity. Their behaviour will differ from that of the bias beam as the different incident angles produce additional phase changes. It has been shown that these additional phase changes give rise to bistable switching as the incident angle of the beam is changed (4) and this behaviour is demonstrated experimentally.