We designed, fabricated, and tested a one-dimensional array of superconducting-nanowire single-photon detectors, integrated with on-chip inductors and resistors. The architecture is suitable for monolithic integration on a single chip operated in a cryogenic environment, and inherits the characteristics of individual superconducting-nanowire single-photon detectors. We demonstrated a working array with four pixels showing position discrimination and a timing jitter of 124 ps. The electronic crosstalk between the pixels in the array was negligible.
We designed, fabricated, and tested a one-dimensional array of superconducting-nanowire single-photon detectors, integrated with on-chip inductors and resistors. The architecture is suitable for monolithic integration on a single chip operated in a cryogenic environment, and inherits the characteristics of individual superconducting-nanowire single-photon detectors. We demonstrated a working array with four pixels showing position discrimination and a timing jitter of 124 ps. The electronic crosstalk between the pixels in the array was negligible.
Detecting spatial and temporal information of individual photons is a crucial technology in today's quantum information science. Among the existing single-photon detectors, superconducting nanowire single-photon detectors (SNSPDs) have been demonstrated with a sub-50 ps timing jitter, near unity detection efficiency1, wide response spectrum from visible to infrared and ~10 ns reset time. However, to gain spatial sensitivity, multiple SNSPDs have to be integrated into an array, whose spatial and temporal resolutions are limited by the multiplexing circuit. Here, we add spatial sensitivity to a single nanowire while preserving the temporal resolution from an SNSPD, thereby turning an SNSPD into a superconducting nanowire single-photon imager (SNSPI). To achieve an SNSPI, we modify a nanowire's electrical behavior from a lumped inductor to a transmission line, where the signal velocity is slowed down to 0.02c (where c is the speed of light). Consequently, we are able to simultaneously read out the landing locations and arrival times of the photons from the output electrical pulses using only two connections. We have demonstrated single-photon imaging by using a 19.7 mm long SNSPI, which is meandered into an imaging area of 286 {\mu}m*193 {\mu}m. The nanowire has a temporal resolution of 50 ps for detecting 1.5 {\mu}m photons. The 2D spatial resolution is 13.0 {\mu}m in the vertical direction and 5.6 {\mu}m in the horizontal direction. The maximum number of resolvable locations (i.e., the effective number of pixels) in such a long nanowire is calculated to be 590. Rather than operating an individual detector in a scanning mode or using SPD arrays, this SNSPI gives an alternative approach to taking large-scale single-photon images and measuring temporal and spatial correlation.
We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.
Superconducting nanowire single-photon detectors (SNSPDs) have attracted remarkable interest for visible and near-infrared single-photon detection due to their outstanding performance. However, conventional SNSPDs are generally used as binary photon-counting detectors. Another important characteristic of light, i.e., polarization, which can provide additional information of the object, has not been resolved using the standalone SNSPD. In this work, we present a first prototype of the polarimeter based on a four-pixel superconducting nanowire array, capable of resolving the polarization state of linearly-polarized light at the single-photon level. The detector array design is based on a division of focal plane configuration in which the orientation of each nanowire division (pixel) is offset by 45°. Each single nanowire pixel operates as a combination of a photon detector and almost linear polarization filter, with an average polarization extinction ratio of ∼10. The total system detection efficiency of the array is ∼1% at a total dark count rate of 680 cps, with a timing jitter of 126 ps, when the detector array is free-space coupled and illuminated with 1550-nm photons. The mean errors of the measured angle of polarization and degree of linear polarization were about -3° and 0.12, respectively. Furthermore, we successfully demonstrated polarization imaging at low-light level using the proposed detector. Our results pave the way for the development of a single-photon sensitive, fast, and large-scale integrated polarization polarimeter or imager. Such detector may find promising application in photon-starved polarization resolving and imaging with high spatial and temporal resolution.
We developed a monolithic integration process for a superconducting nanostrip single-photon detector (SNSPD) and a cryogenic signal processor based on a single-flux-quantum (SFQ) circuit. Sixteen-pixel SNSPDs consisting of a 10-nm-thick and 100-nm-wide NbTiN nanowire were fabricated on a 3-in. Si wafer with an SFQ merger fabricated by the National Institute of Advanced Industrial Science and Technology Nb 2.5 kA/cm2 standard process 2. Subsequently, we illuminated the photons on the 16-pixel SNSPD array through an optical fiber and obtained a similar bias-current dependence of the detection efficiency with a single-pixel SNSPD without the SFQ merger. This indicates that the SFQ merger works correctly, and that the power dissipation of the SFQ circuit, which is estimated to be 200 μW, does not deteriorate the photon detection of SNSPD fabricated on the same chip with a size of 5 × 5 mm2. Furthermore, we measured timing jitter using a pulsed laser as the photon source. Owing to the careful tuning of the wiring length between each pixel of the 16-pixel SNSPD and each input port of the SFQ merger, the obtained timing jitter was 41.4 ps, which is approximately equal to or less than that of the single-pixel SNSPD.
Abstract We demonstrate superconducting single-photon detectors (SPDs) that integrate signals locally at each pixel. This capability is realized by the monolithic integration of superconducting-nanowire SPDs with Josephson electronics. The motivation is to realize superconducting sensor elements with integrating capabilities similar to their CMOS-sensor counterparts. The pixels can operate in several modes. First, we demonstrate that photons can be counted individually, with each detection event adding an identical amount of supercurrent to an integrating element. Second, we demonstrate an active gain control option, in which the signal added per detection event can be dynamically adjusted to account for variable light conditions. Additionally, the pixels can either retain signal indefinitely to record all counts incurred over an integration period, or the pixels can record a fading signal of detection events within a decay time constant. We describe additional semiconductor readout circuitry that will be used in future work to realize scalable, large-format sensor arrays of superconducting SPDs compatible with CMOS array readout architectures.