Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Local-states method for the calculation of free energies in Monte Carlo simulations of lattice models

A. G. Schlijper, A. R. D. van Bergen, Berend Smit

Published Jan 1, 1990• 20 citations
Publisher

Abstract

We present and demonstrate an accurate, reliable, and computationally cheap method for the calculation of free energies in Monte Carlo simulations of lattice models. Even in the critical region it yields good results with comparatively short simulation runs. The method combines upper and lower bounds on the thermodynamic limit entropy density to yield not only an accurate estimate of the free energy but a bound on the possible error as well. The method is demonstrated on the two- and three-dimensional Ising models and the three-dimensional, three-states Potts model.

DOI
10.1103/physreva.41.1175

Related papers

Monte Carlo studies of critical free energies and the simple-cubic Ising model

K. K. Mon

This paper addresses the limitation for routine applications of the proposed Monte Carlo method of direct calculation of absolute free energy by sampling of finite-size dependences and discusses new extensions. The need for multistage sampling is removed and the method is now simpler to apply in practice. To exhibit this, the critical free-energy density for the simple-cubic nearest-neighbor ferromagnetic Ising model is studied for a wide range of lattice sizes, up to 32\ifmmode\times\else\texttimes\fi{}32\ifmmode\times\else\texttimes\fi{}32. The finite-size scaling is demonstrated and the scaling amplitude calculated with higher accuracy than before. These results indicate the possibility that very accurate free-energy density and related quantities such as surface free energy, can be routinely obtained for lattice models from Monte Carlo simulations, even at criticality.

Physical review. B, Condensed matter•Jan 1, 1989•22 citations

Ising-model Monte Carlo simulations: Density of states and mass gap

Nelson Augusto Alves, Bernd A. Berg, Ramon Villanova

We have performed Monte Carlo simulations for the three-dimensional Ising model. Using histogram techniques, we calculate the density of states on ${L}^{3}$ block lattices up to size L=14. Statistical jackknife methods are employed to perform a thorough error analysis. We obtain high-precision estimates for the leading zeros of the partition function, which, using finite-size scaling, translate into \ensuremath{\nu}=0.6285\ifmmode\pm\else\textpm\fi{}0.0019. Along a different line of approach following recent work in lattice-gauge theories, we accurately determine the mass gap m=1/\ensuremath{\xi} (\ensuremath{\xi} correlation length) for cylindrical ${L}^{2}$${L}_{z}$ lattices (with ${L}_{z}$=256 and L up to 12). The finite-size-scaling analysis of the mass-gap data leads to \ensuremath{\nu}=0.6321\ifmmode\pm\else\textpm\fi{}0.0019.

Physical review. B, Condensed matter•Jan 1, 1990•92 citations

Universal finite-size scaling amplitudes of interfacial free energies in Monte Carlo simulations

H Park, Marcel den Nijs

The study of the universal finite-size scaling amplitudes of interfacial free energies in Monte Carlo simulations provides an accurate method of determining the critical temperature and the universality class of phase transitions. These universal amplitudes can replace the critical exponents to identify universality classes. The authors use Bennett's optimisation scheme (1976) for the calculation of the interfacial free energies in Monte Carlo simulations. Tests for the Ising and three-state Potts model confirm the effectiveness of this method.

Journal of Physics A Mathematical and General•Sep 7, 1989•7 citations

Determination of the conformal-field-theory central charge by the Wang-Landau algorithm

P. Belov, Anton Nazarov, А. О. Сорокин

We present a simple method to estimate the central charge of the conformal field theory corresponding to a critical point of a two-dimensional lattice model from Monte Carlo simulations. The main idea is to use the Wang-Landau flat-histogram algorithm, which allows us to obtain the free energy of a lattice model on a torus as a function of torus radii. The central charge is calculated with good precision from a free-energy scaling at the critical point. We apply the method to the Ising, tricritical Ising (Blume-Capel), Potts, and site-diluted Ising models, and we also discuss an estimation of the conformal weights.

arXiv:1612.06374•Physical review. E•Jun 14, 2017•6 citations

New Monte Carlo technique for studying phase transitions

Alan M. Ferrenberg, Robert H. Swendsen

We present a new method for using the data from Monte Carlo simulations that can increase the efficiency by 2 or more orders of magnitude. A single Monte Carlo simulation is sufficient to obtain complete thermodynamic information over the entire scaling region near a phase transition. The accuracy of the method is demonstrated by comparison with exact results for the d=2 Ising model. New results for d=2 eight-state Potts model are also presented. The method is generally applicable to statistical models and lattice-gauge theories.

Physical Review Letters•Dec 5, 1988•2,636 citations

Potts models: Density of states and mass gap from Monte Carlo calculations

Nelson Augusto Alves, Bernd A. Berg, Ramon Villanova

Monte Carlo simulations are performed for first-order phase-transition models. The three-dimensional three-state Potts model has a weak first-order transition. For this model we calculate the density of states on ${\mathit{L}}^{3}$ block lattices (L up to size 36) and obtain high-precision estimates for the leading partition-function zeros. The finite-size-scaling analysis of the first zero exhibits the expected convergence of the critical exponent \ensuremath{\nu} toward 1/D for large L; in particular, we find \ensuremath{\nu}=2.955(26) from our two largest lattices. Analysis of our specific-heat ${\mathit{C}}_{\mathit{v}}$ data yields l=0.080 31(26) for the latent heat. Along another line of approach, we calculate the mass gap m=1/\ensuremath{\xi} (\ensuremath{\xi} is the correlation length) for cylindrical ${\mathit{L}}^{2}$${\mathit{L}}_{\mathit{z}}$ lattices (L up to 24 and ${\mathit{L}}_{\mathit{z}}$=256). The finite size-scaling analysis of these results is also consistent with the convergence of \ensuremath{\nu} toward 1/D, but that the limiting value is 1/D is not yet conclusively established. Some theoretical arguments favor \ensuremath{\nu}\ensuremath{\rightarrow}0 in case of a first-order transition in a cylindrical ${\mathit{L}}^{\mathit{D}\mathrm{\ensuremath{-}}1}$\ensuremath{\infty} geometry. Therefore, we also applied our approach to the 2D ten-state Potts model, which is known to have a strong first-order transition. In this case we find unambiguous evidence in favor of 1/D as the limiting value.

Physical review. B, Condensed matter•Mar 1, 1991•50 citations
We present and demonstrate an accurate, reliable, and computationally cheap method for the calculation of free energies in Monte Carlo simulations of lattice models. Even in the critical region it yields good results with comparatively short simulation runs. The method combines upper and lower bounds on the thermodynamic limit entropy density to yield not only an accurate estimate of the free energy but a bound on the possible error as well. The method is demonstrated on the two- and three-dimensional Ising models and the three-dimensional, three-states Potts model.
This paper addresses the limitation for routine applications of the proposed Monte Carlo method of direct calculation of absolute free energy by sampling of finite-size dependences and discusses new extensions. The need for multistage sampling is removed and the method is now simpler to apply in practice. To exhibit this, the critical free-energy density for the simple-cubic nearest-neighbor ferromagnetic Ising model is studied for a wide range of lattice sizes, up to 32\ifmmode\times\else\texttimes\fi{}32\ifmmode\times\else\texttimes\fi{}32. The finite-size scaling is demonstrated and the scaling amplitude calculated with higher accuracy than before. These results indicate the possibility that very accurate free-energy density and related quantities such as surface free energy, can be routinely obtained for lattice models from Monte Carlo simulations, even at criticality.
We have performed Monte Carlo simulations for the three-dimensional Ising model. Using histogram techniques, we calculate the density of states on L3{L}^{3}L3 block lattices up to size L=14. Statistical jackknife methods are employed to perform a thorough error analysis. We obtain high-precision estimates for the leading zeros of the partition function, which, using finite-size scaling, translate into \ensuremath{\nu}=0.6285\ifmmode\pm\else\textpm\fi{}0.0019. Along a different line of approach following recent work in lattice-gauge theories, we accurately determine the mass gap m=1/\ensuremath{\xi} (\ensuremath{\xi} correlation length) for cylindrical L2{L}^{2}L2Lz{L}_{z}Lz​ lattices (with Lz{L}_{z}Lz​=256 and L up to 12). The finite-size-scaling analysis of the mass-gap data leads to \ensuremath{\nu}=0.6321\ifmmode\pm\else\textpm\fi{}0.0019.
The study of the universal finite-size scaling amplitudes of interfacial free energies in Monte Carlo simulations provides an accurate method of determining the critical temperature and the universality class of phase transitions. These universal amplitudes can replace the critical exponents to identify universality classes. The authors use Bennett's optimisation scheme (1976) for the calculation of the interfacial free energies in Monte Carlo simulations. Tests for the Ising and three-state Potts model confirm the effectiveness of this method.
We present a simple method to estimate the central charge of the conformal field theory corresponding to a critical point of a two-dimensional lattice model from Monte Carlo simulations. The main idea is to use the Wang-Landau flat-histogram algorithm, which allows us to obtain the free energy of a lattice model on a torus as a function of torus radii. The central charge is calculated with good precision from a free-energy scaling at the critical point. We apply the method to the Ising, tricritical Ising (Blume-Capel), Potts, and site-diluted Ising models, and we also discuss an estimation of the conformal weights.
We present a new method for using the data from Monte Carlo simulations that can increase the efficiency by 2 or more orders of magnitude. A single Monte Carlo simulation is sufficient to obtain complete thermodynamic information over the entire scaling region near a phase transition. The accuracy of the method is demonstrated by comparison with exact results for the d=2 Ising model. New results for d=2 eight-state Potts model are also presented. The method is generally applicable to statistical models and lattice-gauge theories.
Monte Carlo simulations are performed for first-order phase-transition models. The three-dimensional three-state Potts model has a weak first-order transition. For this model we calculate the density of states on L3{\mathit{L}}^{3}L3 block lattices (L up to size 36) and obtain high-precision estimates for the leading partition-function zeros. The finite-size-scaling analysis of the first zero exhibits the expected convergence of the critical exponent \ensuremath{\nu} toward 1/D for large L; in particular, we find \ensuremath{\nu}=2.955(26) from our two largest lattices. Analysis of our specific-heat Cv{\mathit{C}}_{\mathit{v}}Cv​ data yields l=0.080 31(26) for the latent heat. Along another line of approach, we calculate the mass gap m=1/\ensuremath{\xi} (\ensuremath{\xi} is the correlation length) for cylindrical L2{\mathit{L}}^{2}L2Lz{\mathit{L}}_{\mathit{z}}Lz​ lattices (L up to 24 and Lz{\mathit{L}}_{\mathit{z}}Lz​=256). The finite size-scaling analysis of these results is also consistent with the convergence of \ensuremath{\nu} toward 1/D, but that the limiting value is 1/D is not yet conclusively established. Some theoretical arguments favor \ensuremath{\nu}\ensuremath{\rightarrow}0 in case of a first-order transition in a cylindrical ${\mathit{L}}^{\mathit{D}\mathrm{\ensuremath{-}}1}$\ensuremath{\infty} geometry. Therefore, we also applied our approach to the 2D ten-state Potts model, which is known to have a strong first-order transition. In this case we find unambiguous evidence in favor of 1/D as the limiting value.