Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Self-pumped HTS Josephson heterodyne tunable mixer

Jia Du, J.C. Macfarlane, Ting Zhang, Y Cai, Ying Guo

Published Jan 10, 2012• 17 citations
Publisher

Abstract

Experimental evaluation of a high-temperature superconducting Josephson heterodyne mixer based on a 'resistive-SQUID' configuration is reported. The device consists of two YBa 2 Cu 3 O 7− x step-edge Josephson junctions connected via a small resistor in an otherwise superconducting loop. It has been previously shown to generate a heterodyne oscillation, which is frequency-tunable by a control current through the resistor. Under certain conditions, this device can operate as a frequency-tunable heterodyne mixer (down-converter) in the presence of an RF signal. In this paper, we describe the operation of the autonomous Josephson mixer–local oscillator device and present the experimental results on the mixer performances in terms of the junction current–voltage characteristics, the frequency tunability, linearity, and dynamic range as well as their temperature dependence for signal frequencies from 1 to 5 GHz.

DOI
10.1088/0953-2048/25/2/025019

Related papers

A self-pumped high-temperature superconducting Josephson mixer: Modelling and measurement

Jia Du, J.C. Macfarlane, Colin M. Pegrum +3 more

We have recently developed a high-temperature superconducting (HTS) Josephson self-pumped mixer with an on-chip heterodyne local oscillator. The device is based on HTS step-edge junction technology and a “resistive-superconducting quantum interference device” (RSQUID) configuration. The heterodyne local oscillator and mixer output are frequency-tunable from below 10 MHz to 5 GHz by a control current. The performance of the autonomous Josephson mixer–local oscillator has been experimentally evaluated in terms of the current-voltage characteristics, intermediate frequency (IF)-tunable bandwidth, operation range, linearity, bias current, and temperature dependence of the IF output (or mixer conversion efficiency). We find the results are in good overall agreement with numerical simulation.

Journal of Applied Physics•Mar 1, 2012•10 citations

Frequency down-conversion in self-pumped HTS R-SQUID mixer

Jia Du, J.C. Macfarlane

A pair of high-temperature-superconducting (HTS) step-edge Josephson junctions connected in the ‘resistive-SQUID’ (R-SQUID) configuration has been previously shown to generate a heterodyne oscillation which is frequency-tunable by a control current across the resistor. A method is described which enables the R-SQUID to act both as the local oscillator (LO) and simultaneously as a radio- frequency down-converter element. For the first time the autonomous Josephson mixer–local oscillator device for signal frequencies between 1–5 GHz, over a temperature range of 20–70 K, is demonstrated.

Electronics Letters•Jun 22, 2011•16 citations

Simulation and Measurement of HTS Josephson Heterodyne Oscillator

J.C. Macfarlane, Jia Du, Richard Taylor +1 more

We report continuing investigations into practical applications of the AC Josephson effect as the basis for a voltage-tunable radio-frequency oscillator. We have previously demonstrated experimentally that useful power levels (10 s of nW) and linewidths of a few kHz can be achieved in the heterodyne output from a high-temperature-superconducting resistive SQUID (HTS-RSQUID) operating in the frequency range 1-50 MHz. Those results were achieved with 2-junction R-SQUIDs incorporating current-biased shunt resistors of a few micro-ohms. We have now modified the fabrication procedures, and adjusted the shunt resistors and bias current values so that higher frequencies can be achieved. The Josephson junctions are of step-edge type, rather than the bi-crystal type used in our earlier work. The step-edge technique permits much more flexibility in the geometrical lay-out and utilizes the more cost-effective single-crystal MgO substrates. In the present paper, we report numerical simulations and experimental measurements on these devices in the frequency range up to 2 GHz.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•17 citations

Characterizations of High-Temperature Superconducting Step-Edge Josephson Junction Mixer

Dan Dan Bai, Jia Du, Yu Sheng He

We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.

IEEE Transactions on Applied Superconductivity•Aug 15, 2014•6 citations

Observation of a voltage-tunable sub-mm wave response from a YBCO Josephson device, operating in self-pumping mode

K. Y. Constantinian, G. A. Ovsyannikov, I. V. Borisenko +1 more

The first experimental data are presented on the observation of a response of a noise signal applied to a tunable-by-voltage high- T C Josephson mixer operating in a self-pumping mode within the frequency band of f = 750–970 GHz at ambient temperature T = 12.5 K. The mixer device was a thin-film YBaCuO bicrystal Josephson junction coupled with the electrodes patterned in log-periodic antenna. Experimental junctions exhibit RSJ-like I–V characteristics with a product of I C R N ≈ 2 mV ( I C is the critical current and R N is the normal state resistance). Down-converted signal response was examined at an intermediate frequency band within 1–2 GHz by means of the Fourier transform spectroscopy technique. Evaluated from Fourier transform spectrograms clear double-side band mixer response functions were registered at any of the fixed bias voltages in the range of V = 1.65–2.1 mV.

Superconductor Science and Technology•Nov 14, 2001•6 citations

Linewidth of a resistively shunted high-temperature-superconductor Josephson heterodyne oscillator

J.C. Macfarlane, L. Hao, D.A. Peden +1 more

High-temperature-superconducting (HTS) resistively shunted superconducting quantum interference devices, consisting of two yttrium–barium–copper–oxide (YBCO) grain boundary junctions shunted by gold-film resistors of ∼20 μΩ, have been prepared and characterized at temperatures from 17 to 74 K. The small value and stability of the resistor allows narrow-band heterodyne oscillations to be generated between the Josephson oscillations in the individual junctions. The frequency can be precisely controlled in accordance with the ac Josephson effect by adjustment of an external current applied to the YBCO–Au–YBCO shunt resistor, and the linewidth is determined in principle only by Johnson noise in the resistor. Off-chip detection and spectral analysis of the heterodyne signal generated in this way has not been previously reported. Measurements of the signal power (∼nW), the tunability of the center frequency from 5 to 50 MHz, the frequency stability and the linewidth of the heterodyne Josephson oscillation are described. Although linewidth broadening due to nonthermal fluctuations is observed, the linewidth of ∼30 kHz at T=17 K, at a center frequency of 24 MHz, is believed to be the narrowest reported for Josephson oscillations in an HTS device of this type.

Applied Physics Letters•Mar 27, 2000•14 citations
Experimental evaluation of a high-temperature superconducting Josephson heterodyne mixer based on a 'resistive-SQUID' configuration is reported. The device consists of two YBa 2 Cu 3 O 7− x step-edge Josephson junctions connected via a small resistor in an otherwise superconducting loop. It has been previously shown to generate a heterodyne oscillation, which is frequency-tunable by a control current through the resistor. Under certain conditions, this device can operate as a frequency-tunable heterodyne mixer (down-converter) in the presence of an RF signal. In this paper, we describe the operation of the autonomous Josephson mixer–local oscillator device and present the experimental results on the mixer performances in terms of the junction current–voltage characteristics, the frequency tunability, linearity, and dynamic range as well as their temperature dependence for signal frequencies from 1 to 5 GHz.
We have recently developed a high-temperature superconducting (HTS) Josephson self-pumped mixer with an on-chip heterodyne local oscillator. The device is based on HTS step-edge junction technology and a “resistive-superconducting quantum interference device” (RSQUID) configuration. The heterodyne local oscillator and mixer output are frequency-tunable from below 10 MHz to 5 GHz by a control current. The performance of the autonomous Josephson mixer–local oscillator has been experimentally evaluated in terms of the current-voltage characteristics, intermediate frequency (IF)-tunable bandwidth, operation range, linearity, bias current, and temperature dependence of the IF output (or mixer conversion efficiency). We find the results are in good overall agreement with numerical simulation.
A pair of high-temperature-superconducting (HTS) step-edge Josephson junctions connected in the ‘resistive-SQUID’ (R-SQUID) configuration has been previously shown to generate a heterodyne oscillation which is frequency-tunable by a control current across the resistor. A method is described which enables the R-SQUID to act both as the local oscillator (LO) and simultaneously as a radio- frequency down-converter element. For the first time the autonomous Josephson mixer–local oscillator device for signal frequencies between 1–5 GHz, over a temperature range of 20–70 K, is demonstrated.
We report continuing investigations into practical applications of the AC Josephson effect as the basis for a voltage-tunable radio-frequency oscillator. We have previously demonstrated experimentally that useful power levels (10 s of nW) and linewidths of a few kHz can be achieved in the heterodyne output from a high-temperature-superconducting resistive SQUID (HTS-RSQUID) operating in the frequency range 1-50 MHz. Those results were achieved with 2-junction R-SQUIDs incorporating current-biased shunt resistors of a few micro-ohms. We have now modified the fabrication procedures, and adjusted the shunt resistors and bias current values so that higher frequencies can be achieved. The Josephson junctions are of step-edge type, rather than the bi-crystal type used in our earlier work. The step-edge technique permits much more flexibility in the geometrical lay-out and utilizes the more cost-effective single-crystal MgO substrates. In the present paper, we report numerical simulations and experimental measurements on these devices in the frequency range up to 2 GHz.
We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.
The first experimental data are presented on the observation of a response of a noise signal applied to a tunable-by-voltage high- T C Josephson mixer operating in a self-pumping mode within the frequency band of f = 750–970 GHz at ambient temperature T = 12.5 K. The mixer device was a thin-film YBaCuO bicrystal Josephson junction coupled with the electrodes patterned in log-periodic antenna. Experimental junctions exhibit RSJ-like I–V characteristics with a product of I C R N ≈ 2 mV ( I C is the critical current and R N is the normal state resistance). Down-converted signal response was examined at an intermediate frequency band within 1–2 GHz by means of the Fourier transform spectroscopy technique. Evaluated from Fourier transform spectrograms clear double-side band mixer response functions were registered at any of the fixed bias voltages in the range of V = 1.65–2.1 mV.
High-temperature-superconducting (HTS) resistively shunted superconducting quantum interference devices, consisting of two yttrium–barium–copper–oxide (YBCO) grain boundary junctions shunted by gold-film resistors of ∼20 μΩ, have been prepared and characterized at temperatures from 17 to 74 K. The small value and stability of the resistor allows narrow-band heterodyne oscillations to be generated between the Josephson oscillations in the individual junctions. The frequency can be precisely controlled in accordance with the ac Josephson effect by adjustment of an external current applied to the YBCO–Au–YBCO shunt resistor, and the linewidth is determined in principle only by Johnson noise in the resistor. Off-chip detection and spectral analysis of the heterodyne signal generated in this way has not been previously reported. Measurements of the signal power (∼nW), the tunability of the center frequency from 5 to 50 MHz, the frequency stability and the linewidth of the heterodyne Josephson oscillation are described. Although linewidth broadening due to nonthermal fluctuations is observed, the linewidth of ∼30 kHz at T=17 K, at a center frequency of 24 MHz, is believed to be the narrowest reported for Josephson oscillations in an HTS device of this type.