Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review B

Phase states in dc SQUIDs with inhomogeneous junction parameters

Roberto De Luca, Francesco Romeo

Published Jun 19, 2006• 2 citations
Publisher

Abstract

By means of perturbation analysis, assuming small inductance values, the dynamical equations for the gauge-invariant superconducting phase differences in a dc superconducting quantum interference device (SQUID), containing junctions with different resistive and coupling parameters, are reduced to a single nonlinear differential equation. The resulting effective reduced potential shows that degenerate phase states exist for half-integer values of the applied flux number ${\ensuremath{\Psi}}_{\mathit{ex}}$ and for zero bias current. It can be also shown that, by small variations of the externally applied flux, this degeneracy can be removed and, for sufficiently low values of the SQUID parameter $\ensuremath{\beta}$, different magnetic states, characterized by opposite magnetic moments, can be reversibly realized.

DOI
10.1103/physrevb.73.214518

Related papers

Asymmetric superconducting quantum interference devices for suppression of phase diffusion in small Josephson junctions

Dan F. Sullivan, S. K. Dutta, Michael Dreyer +5 more

We have measured the switching current versus applied magnetic flux of a highly asymmetric, hysteretic dc superconducting quantum interference device (SQUID) from 30 mK to 400 mK. The SQUID loop had an inductance of 1 nH, and the capacitances of the two Al-Al2O3-Al Josephson junctions comprising the SQUID were 100 fF and 5 fF. As expected, the switching current of the SQUID displayed a small, periodic modulation with applied flux, from which the switching currents of the large and small junctions at 30 mK were determined to be 846.3 ± 0.1 nA and 0.7 ± 0.08 nA, respectively. Measurements of an identically prepared small junction exhibited a highly suppressed switching current (IS < 10 pA), consistent with phase diffusion in this device. The observed modulation in the SQUID thus demonstrates that the quantum mechanical uncertainty in the phase difference across the small junction was significantly reduced by coupling to the large junction through the loop inductance. We discuss the sensitivity of this technique for determining the gauge-invariant phase difference of small Josephson junctions, and the implications for imaging the phase of superconductors at the atomic scale using scanning tunneling microscopy.

Journal of Applied Physics•May 10, 2013•9 citations

Tunable ±φ,φ0 , and φ0±φ Josephson junction

E. Goldobin, D. Koelle, R. Kleiner

We study a 0-$\ensuremath{\pi}$ dc superconducting quantum interference device (SQUID) with asymmetric inductances and critical currents of the two Josephson junctions (JJs). By considering such a dc SQUID as a black box with two terminals, we calculate its effective current-phase relation ${I}_{s}(\ensuremath{\psi})$ and the Josephson energy $U(\ensuremath{\psi})$, where $\ensuremath{\psi}$ is the Josephson phase across the terminals. We show that there is a domain of parameters where the black box has the properties of a $\ensuremath{\varphi}$ JJ with degenerate ground state phases $\ensuremath{\psi}=\ifmmode\pm\else\textpm\fi{}\ensuremath{\varphi}$. The $\ensuremath{\varphi}$ domain is rather large, so one can easily construct a $\ensuremath{\varphi}$ JJ experimentally. We derive the current phase relation and show that it can be tuned in situ by applying an external magnetic flux resulting in a continuous transition between the systems with static solutions $\ensuremath{\psi}=\ifmmode\pm\else\textpm\fi{}\ensuremath{\varphi},\phantom{\rule{0.16em}{0ex}}\ensuremath{\psi}={\ensuremath{\varphi}}_{0} ({\ensuremath{\varphi}}_{0}\ensuremath{\ne}0,\ensuremath{\pi})$ and even $\ensuremath{\psi}={\ensuremath{\varphi}}_{0}\ifmmode\pm\else\textpm\fi{}\ensuremath{\varphi}$. The dependence of ${\ensuremath{\varphi}}_{0}$ on applied magnetic flux is not $2\ensuremath{\pi}$ (one flux quantum) periodic.

arXiv:1504.05858•Physical Review B•Jun 17, 2015•31 citations

Variable superconducting quantum-interference device: Theory

H. J. Fink, V. Grünfeld, S. M. Roberts

A dc superconducting quantum interference device (SQUID) consisting of a symmetric ring circuit with four Josephson junctions and two independent external currents ${I}_{1}$ and ${I}_{2}$, which enter the circuit at different points, has a phase boundary between the fully superconducting and the normal states that is different from that of a conventional SQUID. The control current ${I}_{2}$ modifies the magnetic flux (\ensuremath{\varphi}) periodicity and the value of the maximum measuring current ${I}_{1m}$(\ensuremath{\varphi}). For values of ${I}_{2}$>${I}_{c}$ (critical current of Josephson junction) the fully resistive state exists over flux intervals centered around (n+(1/2)${\ensuremath{\varphi}}_{0}$, where n is an integer and ${\ensuremath{\varphi}}_{0}$ is the fluxoid quantum. A superconducting circuit without Josephson junctions is suggested which should have a phase boundary similar to that found here. Minimization procedures which are usually employed in analyzing SQUID's are discussed.

Physical review. B, Condensed matter•Jul 1, 1987•5 citations

dc SQUID's I–V Characteristics and Its Bias Modes

Yi Zhang, Hui Dong, Hans-Joachim Krause +2 more

The physics of a DC Superconducting QUantum Interference Device (SQUID) involves two phenomena: flux quantization and Josephson tunneling. This chapter describes how to measure and understand a SQUID's I–V characteristics. It also describes how to realize an ideal current source for biasing a SQUID and how to set up a practical voltage source to operate a SQUID in voltage bias mode. To study a DC SQUID's features, the first step is to obtain its I–V characteristics. In contrast to the I–V characteristics of the resistor or the diode, those of the SQUID are modulated by the applied flux but are limited within two flux states of integer and half-integer. An ideal current source is characterized by an internal resistance approaching infinity, compared to the SQUID's dynamic resistance. There are only two realized concepts for the SQUID operation in voltage bias mode.

Wiley eBooks•May 29, 2020•0 citations

Shapiro steps in a dc quantum interference device with multiple identical junctions in each arm

Roberto De Luca, Francesco Romeo

Integer and half-integer Shapiro step amplitudes in the current-voltage characteristics of symmetric superconducting quantum interference devices (SQUIDS), containing more than one Josephson junction on each arm, are analytically calculated for small values of the parameter β and in the absence of noise. This analysis is made possible by the reduction of the dynamical equations of the multiple-junction SQUID to the dynamical equation of a single Josephson junction possessing a nonconventional current-phase relation.

Journal of Applied Physics•Oct 1, 2005•5 citations

Asymmetry in the LC resonance characteristic in dc superconducting quantum interference devices: New method of observing pair-quasiparticle interference in superconducting tunnel junctions

Y. Song

The $\mathrm{LC}$ (inductance-capacitance) resonance phenomenon in the dc SQUID (superconducting quantum interference device) creates a current peak in the $I\ensuremath{-}V$ characteristics at a voltage determined by the resonance frequency. These $I\ensuremath{-}V$ characteristics have been analyzed with the resistively shunted Josephson-junction model in the low-damping and small-oscillation regime. The resonance $I\ensuremath{-}V$ characteristics contain sufficient information to determine all circuit parameters for the dc SQUID's. Specifically, we can apply this analysis to symmetric, tunnel-junction dc SQUID's to deduce the pair-quasiparticle interference conductance ($cos\ensuremath{\theta}$ term).

Physical review. B, Condensed matter•Sep 1, 1981•0 citations
By means of perturbation analysis, assuming small inductance values, the dynamical equations for the gauge-invariant superconducting phase differences in a dc superconducting quantum interference device (SQUID), containing junctions with different resistive and coupling parameters, are reduced to a single nonlinear differential equation. The resulting effective reduced potential shows that degenerate phase states exist for half-integer values of the applied flux number \ensuremathΨex{\ensuremath{\Psi}}_{\mathit{ex}}\ensuremathΨex​ and for zero bias current. It can be also shown that, by small variations of the externally applied flux, this degeneracy can be removed and, for sufficiently low values of the SQUID parameter \ensuremathβ\ensuremath{\beta}\ensuremathβ, different magnetic states, characterized by opposite magnetic moments, can be reversibly realized.
We have measured the switching current versus applied magnetic flux of a highly asymmetric, hysteretic dc superconducting quantum interference device (SQUID) from 30 mK to 400 mK. The SQUID loop had an inductance of 1 nH, and the capacitances of the two Al-Al2O3-Al Josephson junctions comprising the SQUID were 100 fF and 5 fF. As expected, the switching current of the SQUID displayed a small, periodic modulation with applied flux, from which the switching currents of the large and small junctions at 30 mK were determined to be 846.3 ± 0.1 nA and 0.7 ± 0.08 nA, respectively. Measurements of an identically prepared small junction exhibited a highly suppressed switching current (IS < 10 pA), consistent with phase diffusion in this device. The observed modulation in the SQUID thus demonstrates that the quantum mechanical uncertainty in the phase difference across the small junction was significantly reduced by coupling to the large junction through the loop inductance. We discuss the sensitivity of this technique for determining the gauge-invariant phase difference of small Josephson junctions, and the implications for imaging the phase of superconductors at the atomic scale using scanning tunneling microscopy.
We study a 0-$\ensuremath{\pi}$ dc superconducting quantum interference device (SQUID) with asymmetric inductances and critical currents of the two Josephson junctions (JJs). By considering such a dc SQUID as a black box with two terminals, we calculate its effective current-phase relation ${I}_{s}(\ensuremath{\psi})$ and the Josephson energy $U(\ensuremath{\psi})$, where $\ensuremath{\psi}$ is the Josephson phase across the terminals. We show that there is a domain of parameters where the black box has the properties of a $\ensuremath{\varphi}$ JJ with degenerate ground state phases $\ensuremath{\psi}=\ifmmode\pm\else\textpm\fi{}\ensuremath{\varphi}$. The $\ensuremath{\varphi}$ domain is rather large, so one can easily construct a $\ensuremath{\varphi}$ JJ experimentally. We derive the current phase relation and show that it can be tuned in situ by applying an external magnetic flux resulting in a continuous transition between the systems with static solutions $\ensuremath{\psi}=\ifmmode\pm\else\textpm\fi{}\ensuremath{\varphi},\phantom{\rule{0.16em}{0ex}}\ensuremath{\psi}={\ensuremath{\varphi}}_{0} ({\ensuremath{\varphi}}_{0}\ensuremath{\ne}0,\ensuremath{\pi})$ and even $\ensuremath{\psi}={\ensuremath{\varphi}}_{0}\ifmmode\pm\else\textpm\fi{}\ensuremath{\varphi}$. The dependence of ${\ensuremath{\varphi}}_{0}$ on applied magnetic flux is not $2\ensuremath{\pi}$ (one flux quantum) periodic.
A dc superconducting quantum interference device (SQUID) consisting of a symmetric ring circuit with four Josephson junctions and two independent external currents I1{I}_{1}I1​ and I2{I}_{2}I2​, which enter the circuit at different points, has a phase boundary between the fully superconducting and the normal states that is different from that of a conventional SQUID. The control current I2{I}_{2}I2​ modifies the magnetic flux (\ensuremath{\varphi}) periodicity and the value of the maximum measuring current I1m{I}_{1m}I1m​(\ensuremath{\varphi}). For values of I2{I}_{2}I2​>Ic{I}_{c}Ic​ (critical current of Josephson junction) the fully resistive state exists over flux intervals centered around (n+(1/2)${\ensuremath{\varphi}}_{0}$, where n is an integer and ${\ensuremath{\varphi}}_{0}$ is the fluxoid quantum. A superconducting circuit without Josephson junctions is suggested which should have a phase boundary similar to that found here. Minimization procedures which are usually employed in analyzing SQUID's are discussed.
The physics of a DC Superconducting QUantum Interference Device (SQUID) involves two phenomena: flux quantization and Josephson tunneling. This chapter describes how to measure and understand a SQUID's I–V characteristics. It also describes how to realize an ideal current source for biasing a SQUID and how to set up a practical voltage source to operate a SQUID in voltage bias mode. To study a DC SQUID's features, the first step is to obtain its I–V characteristics. In contrast to the I–V characteristics of the resistor or the diode, those of the SQUID are modulated by the applied flux but are limited within two flux states of integer and half-integer. An ideal current source is characterized by an internal resistance approaching infinity, compared to the SQUID's dynamic resistance. There are only two realized concepts for the SQUID operation in voltage bias mode.
Integer and half-integer Shapiro step amplitudes in the current-voltage characteristics of symmetric superconducting quantum interference devices (SQUIDS), containing more than one Josephson junction on each arm, are analytically calculated for small values of the parameter β and in the absence of noise. This analysis is made possible by the reduction of the dynamical equations of the multiple-junction SQUID to the dynamical equation of a single Josephson junction possessing a nonconventional current-phase relation.
The LC\mathrm{LC}LC (inductance-capacitance) resonance phenomenon in the dc SQUID (superconducting quantum interference device) creates a current peak in the $I\ensuremath{-}V$ characteristics at a voltage determined by the resonance frequency. These $I\ensuremath{-}V$ characteristics have been analyzed with the resistively shunted Josephson-junction model in the low-damping and small-oscillation regime. The resonance $I\ensuremath{-}V$ characteristics contain sufficient information to determine all circuit parameters for the dc SQUID's. Specifically, we can apply this analysis to symmetric, tunnel-junction dc SQUID's to deduce the pair-quasiparticle interference conductance ($cos\ensuremath{\theta}$ term).