Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Josephson oscillations in a series array Josephson voltage standard

H.‐G. Meyer, Wolfram Krech, B. Mikolajczak

Published Jun 1, 1989• 8 citations
Publisher

Abstract

Josephson oscillations in a large series array of Josephson junctions designed as a superconducting microwave transmission line are studied. For descriptions of the Josephson junctions both the Stewart–McCumber model and the Werthamer model are used. The attenuation of the Josephson oscillations in the considered array is composed of two terms rising from the stripline and from the Josephson junctions. The latter one is of increasing significance for lower than usually applied drive frequencies.

DOI
10.1063/1.343294

Related papers

Theoretical investigations of microwave-driven Josephson junctions in a large frequency range

B. Mikolajczak, H.‐G. Meyer, P. Seidel

Based on the Werthamer model [Phys. Rev. 147, 255 (1966)] we investigate the current-voltage characteristic of Josephson tunnel junctions irradiated by a microwave. Within the first harmonic approximation we derive relations for the constant-voltage steps and the corresponding stability conditions. The results are compared with investigations in the frame of the Stewart–McCumber model. [Appl. Phys. 12, 277 (1968); J. Appl. Phys. 39, 3113 (1968)].

Journal of Applied Physics•Jul 15, 1989•5 citations

Implementation of Josephson tunnel junction series array stripline with high characteristic impedance for quantum voltage standards

P. Gutmann, E. Vollmer, J. Kohlmann +3 more

A Josephson voltage standard based on a tunnel junction series array stripline with a characteristic impedance of 77Ω has been developed and implemented demonstrating improved performance compared to the usual design with characteristic impedances below 5Ω.

Electronics Letters•Jul 16, 1992•3 citations

Lumped 50- Ω\OmegaΩ Arrays of SNS Josephson Junctions

N. Hadacek, Paul D. Dresselhaus, Samuel P. Benz

For the first time, lumped series arrays of Josephson junctions have been fabricated with a transmission line-matched 50-Omega resistance. These arrays also have the thousands of junctions necessary to produce a metrologically significant voltage. This approach is expected to increase the output voltage per array and to optimize their performance for Josephson voltage standards. Traditional Josephson arrays for voltage standards have used distributed microwave structures, where array lengths are several multiples of the driving wavelength. The lumped arrays in this work have physical lengths shorter than a quarter of the microwave drive wavelength and total normal-state resistances nearly equal to the transmission line impedance. Fabrication of these arrays was made possible by use of a newly developed Nb-(MoSi2-Nb)nstacked junction technology. We present measurements of the microwave response of lumped arrays with total normal resistances up to 54 Omega and with various termination resistances. A simple numerical model is presented that accounts for the spatial distribution of the microwave current and for the nonuniformity of the junction critical currents. The resulting simulations agree well with experimental results

IEEE Transactions on Applied Superconductivity•Dec 1, 2006•6 citations

Integrated microwave circuits for digital-to-analogue converters based on high-temperature superconducting Josephson junction arrays

Alexander M. Klushin, C. Weber, M. Siegel +5 more

A digital-to-analogue converter based on series arrays of high-temperature superconducting Josephson junctions can work properly when the microwave bias current distribution in large arrays is uniform. Unfortunately, the considerable microwave attenuation per overdamped junction with normal resistances RN0.1 results in a strong total attenuation of the microwave signal in a traditional layout. Also, the meander geometry of the array, necessary when using bicrystal junctions, disturbs the uniformity of the rf current, especially in the millimetre waveband. To overcome these drawbacks we coupled the meander array inductively to a parallel transmission line. The mechanism of microwave coupling in which both external and mutual frequency locking takes place was studied numerically. A circuit with a coplanar waveguide feed line was fabricated and successfully tested at an operating frequency of 30 GHz. A microstrip line with a small attenuation for pumping of junction arrays at frequencies up to 120 GHz was demonstrated.

Superconductor Science and Technology•Nov 1, 1999•2 citations

Oscillation spectral linewidth for some phase-locked Josephson-junction arrays

Victor K. Kornev, Alexey Arzumanov

High effective autoregressive method has been applied to the calculation of the oscillation line width for the promising phase-locked Josephson-junction arrays. It has been found, that the oscillation linewidth decreases with the number N of Josephson junctions proportionally to N for one-dimensional arrays or even more fast for two-dimensional arrays until number N exceeds the coupling radius. It has been shown that in the case of parallel array inserted into superconducting microstrip line, the phase-locked oscillation state in-phase could be provided by the strong interaction between Josephson junctions and electromagnetic standing wave regardless to applied magnetic field. The necessary amplitude of the standing wave is easy attained at McCumber parameter value /spl beta/>1, when the high-frequency Josephson-junction impedance is small in comparison with the strip-line wave impedance. An extra reduction in the linewidth caused by electromagnetic standing wave impact has also been studied. The results are discussed from viewpoint of the possible applications of the structures as submillimeter wave generators.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•2 citations

Microwave coupling of frequency-locked Josephson junction arrays

Insang Song, Yongheum Eom, Gwangseo Park +2 more

A high temperature superconducting YBa2Cu3Oy array of five Josephson junctions designed with additional coupling lines has been developed to demonstrate the effects of frequency locking and impedance matching for applications such as oscillators, mixers, and detectors. The Josephson self-radiation power was directly detected by a superheterodyne receiver, and Shapiro steps were also measured. The Josephson self-radiation properties reveal good quality of phase locking and microwave coupling with external circuits. The maximum self-radiation power of our array is about 50 pW which is several ten times higher than that of a single Josephson junction, and its peak point exactly satisfies the Josephson current-voltage relation. The Shapiro-step measurements show that the behavior of current-voltage curve depends on the effective inductance of coupling lines which affects the total impedance of Josephson junction array and microwave coupling. The Josephson oscillation frequency was obtained up to about 880 GHz which is 73% of the maximum available frequency calculated from the characteristic voltage of the Josephson junctions. Experimental results show that this type of Josephson junction array can improve the Josephson self-radiation power and increase the maximum detectable frequency.

Applied Physics Letters•Jun 16, 1997•8 citations
Josephson oscillations in a large series array of Josephson junctions designed as a superconducting microwave transmission line are studied. For descriptions of the Josephson junctions both the Stewart–McCumber model and the Werthamer model are used. The attenuation of the Josephson oscillations in the considered array is composed of two terms rising from the stripline and from the Josephson junctions. The latter one is of increasing significance for lower than usually applied drive frequencies.
For the first time, lumped series arrays of Josephson junctions have been fabricated with a transmission line-matched 50-Omega resistance. These arrays also have the thousands of junctions necessary to produce a metrologically significant voltage. This approach is expected to increase the output voltage per array and to optimize their performance for Josephson voltage standards. Traditional Josephson arrays for voltage standards have used distributed microwave structures, where array lengths are several multiples of the driving wavelength. The lumped arrays in this work have physical lengths shorter than a quarter of the microwave drive wavelength and total normal-state resistances nearly equal to the transmission line impedance. Fabrication of these arrays was made possible by use of a newly developed Nb-(MoSi2-Nb)nstacked junction technology. We present measurements of the microwave response of lumped arrays with total normal resistances up to 54 Omega and with various termination resistances. A simple numerical model is presented that accounts for the spatial distribution of the microwave current and for the nonuniformity of the junction critical currents. The resulting simulations agree well with experimental results
A digital-to-analogue converter based on series arrays of high-temperature superconducting Josephson junctions can work properly when the microwave bias current distribution in large arrays is uniform. Unfortunately, the considerable microwave attenuation per overdamped junction with normal resistances RN0.1 results in a strong total attenuation of the microwave signal in a traditional layout. Also, the meander geometry of the array, necessary when using bicrystal junctions, disturbs the uniformity of the rf current, especially in the millimetre waveband. To overcome these drawbacks we coupled the meander array inductively to a parallel transmission line. The mechanism of microwave coupling in which both external and mutual frequency locking takes place was studied numerically. A circuit with a coplanar waveguide feed line was fabricated and successfully tested at an operating frequency of 30 GHz. A microstrip line with a small attenuation for pumping of junction arrays at frequencies up to 120 GHz was demonstrated.
High effective autoregressive method has been applied to the calculation of the oscillation line width for the promising phase-locked Josephson-junction arrays. It has been found, that the oscillation linewidth decreases with the number N of Josephson junctions proportionally to N for one-dimensional arrays or even more fast for two-dimensional arrays until number N exceeds the coupling radius. It has been shown that in the case of parallel array inserted into superconducting microstrip line, the phase-locked oscillation state in-phase could be provided by the strong interaction between Josephson junctions and electromagnetic standing wave regardless to applied magnetic field. The necessary amplitude of the standing wave is easy attained at McCumber parameter value /spl beta/>1, when the high-frequency Josephson-junction impedance is small in comparison with the strip-line wave impedance. An extra reduction in the linewidth caused by electromagnetic standing wave impact has also been studied. The results are discussed from viewpoint of the possible applications of the structures as submillimeter wave generators.
A high temperature superconducting YBa2Cu3Oy array of five Josephson junctions designed with additional coupling lines has been developed to demonstrate the effects of frequency locking and impedance matching for applications such as oscillators, mixers, and detectors. The Josephson self-radiation power was directly detected by a superheterodyne receiver, and Shapiro steps were also measured. The Josephson self-radiation properties reveal good quality of phase locking and microwave coupling with external circuits. The maximum self-radiation power of our array is about 50 pW which is several ten times higher than that of a single Josephson junction, and its peak point exactly satisfies the Josephson current-voltage relation. The Shapiro-step measurements show that the behavior of current-voltage curve depends on the effective inductance of coupling lines which affects the total impedance of Josephson junction array and microwave coupling. The Josephson oscillation frequency was obtained up to about 880 GHz which is 73% of the maximum available frequency calculated from the characteristic voltage of the Josephson junctions. Experimental results show that this type of Josephson junction array can improve the Josephson self-radiation power and increase the maximum detectable frequency.