Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Zeitschrift für Naturforschung A

Berechnung der niedrigsten Pole der Zweipunktfunktion in der Quantenmechanik durch funktionale Integration

M. Hoffmann

Published Jun 1, 1969• 0 citations
Publisher

Abstract

The lowest poles of the two-point function in quantum mechanics are calculated for some simple potentials by the method of functional integration, and the results are compared with the results of the usual methods. In most cases there is good agreement. The reasons for the disagreement in other cases are discussed.
DOI
10.1515/zna-1969-0601

Related papers

On the Wave Equation with Small Quantum Numbers

Rudolph E. Langer

The determination of the Eigenwerte, and the normalization of the Eigenfunktionen of the one-dimensional wave equation, with a potential energy that has a single minimum, is customarily based on the use of the so-called phase integral and W.K.B. formulas. These formulas are asymptotic in character. As they have usually been applied, they accordingly lead to conclusions which can be regarded as established only when the respective quantum numbers are sufficiently large. This restriction has been both unfortunate and puzzling. For on the one hand, the cases of small or moderate quantum numbers are often peculiarly interesting while, on the other hand, the phase integral formulas have been found by trial, at least in a variety of simple cases, to give surprisingly good results even in the lower quantum number range.It is shown in this paper how the asymptotic method should be applied when small or moderate quantum numbers are in question. In the case of the Eigenwerte, the characteristic equation appropriate to the lower range is derived, and a comparison of this new equation with the familiar one based on the phase integral is made. It is thus theoretically established that under certain very liberal conditions upon the potential energy the older method does give good approximations. In the special case of the harmonic oscillator the two equations are, in fact, identical. For the normalization of the Eigenfunktionen a method which has been used in principle by W. H. Furry is applied. It is, however, framed in a manner appropriate to the smaller quantum number range. Formulas are given for the normalized Eigenfunktionen over the several intervals of the variable, over the critical interval which includes the minimum of the potential energy and the turning points, as well as over the intervals remote from the turning points.In the special case of the harmonic oscillator, the method here used gives certain exact---not merely asymptotic---results. These, therefore, supply a basis for the appraisal of the corresponding results that are obtainable by other means.

Physical Review•May 15, 1949•17 citations

On the Lattice-cell-volume Dependence in the Calculation of the Two-point Function in Quantum Mechanics by the Method of Functional Integration

M. Hoffmann

It is shown that the transition from lattice space, where the two-point functions were calculated by means of functional integration, to continuous space Ɛ → 0, which requires in field theories some kind of renormalization, is practicable in quantum mechanics after reordering of series without renormalization. An ambiguity, which occurs, is discussed.

Zeitschrift für Naturforschung A•Aug 1, 1967•0 citations

Approximate Functional Integral Methods in Statistical Mechanics. I. Moment Expansions

Armand Siegel, Terence Burke

In this paper, four distinct ideas are combined, which under a wide range of circumstances can give very rapidly converging series expansions for functional integrals. (1) Expansion of the functional being integrated in functional Taylor series. In the familiar case arising in quantum statistical mechanics, that of the Wiener integral of exp[−∫V(x(t))dt],V(x) being the perturbing potential, this is equivalent to expanding the characteristic functional of the probability functional of V(x(t)) in central moments of V(x(t)). The lowest-order term of the series is the approximation obtained by Feynman and Hibbs through a variational method. (2) Transfer of the harmonic term of the potential, when the functional integral is the quantum-statistical density matrix (Green's function of the Bloch equation), to the weighting function. This transforms the functional integral from a Wiener to an Uhlenbeck-Ornstein integral. The formal expressions for the terms of the expansion are somewhat more complicated, but they can be worked out, and the result is a great improvement in the speed of convergence of the series with decreasing temperature and/or decreasing relative magnitude of the anharmonic part of the potential. (3) ``Reservation of variables'' in the integration. This amounts to breaking the averaging process down into an average over subsets of the distributed random function (conditional average), followed by an averaging of these averages. Any step of this kind (it may be repeated within the subsets, etc.) gives an improvement of accuracy. (4) When the quantity being evaluated through functional integration is the partition function, the device introduced by Feynman and Hibbs, of interchanging the functional integration with the integration of the Green's function over the equated initial and final configuration-space points, may be combined with the above techniques. This eliminates one integration in the terms of the expansion and seems to improve accuracy at the same time. The general series obtained is correlated with more conventional operator techniques of quantum-mechanical perturbation theory, in order to answer the perennial question, does the path-integral method bring with it anything that could not be derived by other methods? It is in some sense a Feynman-Dyson expansion of the Green's function, but one that is further modified mathematically in a way characteristic only of the path-integral point of view, and which, moreover, improves its accuracy. It thus appears unlikely that the result is merely one of standard type disguised as a functional integral result. Sample numerical calculations are given to assay the accuracy of the methods, which are shown to compare very favorably with the traditional approximation of finite subdivision of the time interval.

Journal of Mathematical Physics•Nov 1, 1972•13 citations

Notizen: Bemerkung zur Abhängigkeit vom Gitterzellenvolumen bei Berechnung der Zweipunktfunktion in der Quantenmechanik mittels funktionaler Integration

M. Hoffmann

Zeitschrift für Naturforschung A•Sep 1, 1967•0 citations

Frequently Used Integrals in Quantum Mechanics

Yan Li

.This paper introduces the definition and calculating nature of two integral frequently used in Quantum Mechanics,and presents the methods and formularized results of Quantum Mechanics by using integral.

Journal of Yili Normal University•Jan 1, 2007•0 citations

Quantenmechanische Berechnung der Linienbreite und Intensitätskorrelation der Laserstrahlung

W. Brunner, Henryk Paul, D. Rauh

Abstract Extending the method developed in a previous paper [1] the correlation functions both for electric field strength and intensity are calculated. In the latter case the result is obtained quite easily by solving a differential equation. In the first case, on the contrary, a detailed knowledge of the photon creation operator b+ is necessary, especially of the different temporal behaviour with respect to phase and amplitude. In the main, the results are in agreement with those published by other authors. Of special interest is the result that the damping constant for intensity correlations tends to the value corresponding to the case of thermal radiation, in the region far from threshold. In addition, the ansatz b+ = (ro + ϱ) exp{i χ(t)} (ro c‐number) introduced by HAKEN is discussed from a quantum mechanical point of view.

Annalen der Physik•Jan 1, 1969•3 citations
The determination of the Eigenwerte, and the normalization of the Eigenfunktionen of the one-dimensional wave equation, with a potential energy that has a single minimum, is customarily based on the use of the so-called phase integral and W.K.B. formulas. These formulas are asymptotic in character. As they have usually been applied, they accordingly lead to conclusions which can be regarded as established only when the respective quantum numbers are sufficiently large. This restriction has been both unfortunate and puzzling. For on the one hand, the cases of small or moderate quantum numbers are often peculiarly interesting while, on the other hand, the phase integral formulas have been found by trial, at least in a variety of simple cases, to give surprisingly good results even in the lower quantum number range.It is shown in this paper how the asymptotic method should be applied when small or moderate quantum numbers are in question. In the case of the Eigenwerte, the characteristic equation appropriate to the lower range is derived, and a comparison of this new equation with the familiar one based on the phase integral is made. It is thus theoretically established that under certain very liberal conditions upon the potential energy the older method does give good approximations. In the special case of the harmonic oscillator the two equations are, in fact, identical. For the normalization of the Eigenfunktionen a method which has been used in principle by W. H. Furry is applied. It is, however, framed in a manner appropriate to the smaller quantum number range. Formulas are given for the normalized Eigenfunktionen over the several intervals of the variable, over the critical interval which includes the minimum of the potential energy and the turning points, as well as over the intervals remote from the turning points.In the special case of the harmonic oscillator, the method here used gives certain exact---not merely asymptotic---results. These, therefore, supply a basis for the appraisal of the corresponding results that are obtainable by other means.
In this paper, four distinct ideas are combined, which under a wide range of circumstances can give very rapidly converging series expansions for functional integrals. (1) Expansion of the functional being integrated in functional Taylor series. In the familiar case arising in quantum statistical mechanics, that of the Wiener integral of exp[−∫V(x(t))dt],V(x) being the perturbing potential, this is equivalent to expanding the characteristic functional of the probability functional of V(x(t)) in central moments of V(x(t)). The lowest-order term of the series is the approximation obtained by Feynman and Hibbs through a variational method. (2) Transfer of the harmonic term of the potential, when the functional integral is the quantum-statistical density matrix (Green's function of the Bloch equation), to the weighting function. This transforms the functional integral from a Wiener to an Uhlenbeck-Ornstein integral. The formal expressions for the terms of the expansion are somewhat more complicated, but they can be worked out, and the result is a great improvement in the speed of convergence of the series with decreasing temperature and/or decreasing relative magnitude of the anharmonic part of the potential. (3) ``Reservation of variables'' in the integration. This amounts to breaking the averaging process down into an average over subsets of the distributed random function (conditional average), followed by an averaging of these averages. Any step of this kind (it may be repeated within the subsets, etc.) gives an improvement of accuracy. (4) When the quantity being evaluated through functional integration is the partition function, the device introduced by Feynman and Hibbs, of interchanging the functional integration with the integration of the Green's function over the equated initial and final configuration-space points, may be combined with the above techniques. This eliminates one integration in the terms of the expansion and seems to improve accuracy at the same time. The general series obtained is correlated with more conventional operator techniques of quantum-mechanical perturbation theory, in order to answer the perennial question, does the path-integral method bring with it anything that could not be derived by other methods? It is in some sense a Feynman-Dyson expansion of the Green's function, but one that is further modified mathematically in a way characteristic only of the path-integral point of view, and which, moreover, improves its accuracy. It thus appears unlikely that the result is merely one of standard type disguised as a functional integral result. Sample numerical calculations are given to assay the accuracy of the methods, which are shown to compare very favorably with the traditional approximation of finite subdivision of the time interval.
Abstract Extending the method developed in a previous paper [1] the correlation functions both for electric field strength and intensity are calculated. In the latter case the result is obtained quite easily by solving a differential equation. In the first case, on the contrary, a detailed knowledge of the photon creation operator b+ is necessary, especially of the different temporal behaviour with respect to phase and amplitude. In the main, the results are in agreement with those published by other authors. Of special interest is the result that the damping constant for intensity correlations tends to the value corresponding to the case of thermal radiation, in the region far from threshold. In addition, the ansatz b+ = (ro + ϱ) exp{i χ(t)} (ro c‐number) introduced by HAKEN is discussed from a quantum mechanical point of view.