Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physica

Microwave oscillations in parallel Josephson junctions

G. Thomas, L. Parthasarathy

Published Jun 1, 1971• 0 citations
Publisher
DOI
10.1016/0031-8914(71)90124-8

Related papers

Microwave-induced steps in Josephson junctions, DC-SQUIDs and parallel arrays

Erik Heinz, P. Seidel

Journal of Low Temperature Physics•Feb 1, 1997•7 citations

Optimized Nonuniform Nb SIS Parallel Josephson Junction Array Oscillators

Faouzi M. Boussaha, Christine Chaumont, A. Féret +2 more

We developed submillimeter superconducting oscillators using Josephson effects in the Nb-based superconductor-insulator-superconductor (SIS) parallel array. The radiation emitted from the array is detected using integrated SIS twin junctions. Despite the small junction number (N = 21), the (I-V ) characteristics of the detector clearly exhibit photon-assisted quasiparticle steps when the array is biased upon its Josephson resonances, ranging from 370 to 500 GHz. The array has a moderate current density (Jc≈= 6 kA/cm2) but provides an output power around 0.28 μW, which would be sufficient in achieving sensitive heterodyne reception. The impedance array can be matched easier to microwave circuits than the usual long Josephson junctions. Furthermore, the parallel array approach can be also extended up to about 1.4 THz using Nb-based SIS junctions.

IEEE Transactions on Applied Superconductivity•Mar 1, 2016•3 citations

MICROWAVE PROPERTIES OF LONG JOSEPHSON JUNCTIONS

Kazuhiro Yoshida, K. Hamasaki, Fumi Irie +1 more

De Gruyter eBooks•Dec 31, 1980•0 citations

Microwave coupling of the Josephson junction arrays with an external source

Insang Song, Yunsung Huh, Gwangseo Park +4 more

We have fabricated a YBa/sub 2/Cu/sub 3/O/sub y/ (YBCO) array of five Josephson junctions designed with additional inductive coupling lines (AICLs). The junctions in this array were dc-biased in parallel to oscillate coherently in-phase and integrated with AICLs to improve the impedance matching between this array and external circuits such as a waveguide. The effect of AICLs was investigated by studying its influence on the current-voltage characteristics of the Josephson junction array (JJA) under external microwave irradiations with frequency of 22 GHz. The experimental results show that the behavior of the Shapiro-steps depends upon the effective inductance of AICLs which affects the total impedance and microwave coupling. We were able to obtain an oscillation frequency of about 73% of the maximum available frequency calculated from the characteristic voltage of the Josephson junctions in the array at a temperature of 12 K. By calculating the total impedance of the array, we obtained the suitable parameters of the array for microwave coupling with waveguide for various values of inductance, ac frequencies and number of Josephson junctions.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•7 citations

MICROWAVE MIXING IN JOSEPHSON JUNCTIONS.

P. Russer

•Jan 1, 1972•0 citations

Synchronization of Bloch Oscillations in array of parallel Josephson Junctions

Rais S. Shaikhaidarov, R. Hussain, V. N. Antonov +1 more

We demonstrate the synchronization of current quantization in a parallel array of weakly coupled Josephson Junctions operating in the regime of the coherent quantum phase slip. The first quantized current step on the voltage-current characteristic of 69 parallel Josephson junctions, under microwave excitation at a frequency of f = 19.325 GHz, is observed at 426 nA. Experiments show that accuracy of quantization does not degrade with increasing number of combined Josephson junctions. This demonstration addresses the issue of quantized current amplitude requirements adopted for a practical quantum standard, while leaving the question of accuracy for further research. At present, the quantum current standard of accepted metrological accuracy in the triangle of electrical units is under development. The other two, the Volt and Ohm standards based on the Josephson and Quantum Hall effects, respectively, are already well established in metrology.

arXiv:2605.24522•May 23, 2026•1 citation
We developed submillimeter superconducting oscillators using Josephson effects in the Nb-based superconductor-insulator-superconductor (SIS) parallel array. The radiation emitted from the array is detected using integrated SIS twin junctions. Despite the small junction number (N = 21), the (I-V ) characteristics of the detector clearly exhibit photon-assisted quasiparticle steps when the array is biased upon its Josephson resonances, ranging from 370 to 500 GHz. The array has a moderate current density (Jc≈= 6 kA/cm2) but provides an output power around 0.28 μW, which would be sufficient in achieving sensitive heterodyne reception. The impedance array can be matched easier to microwave circuits than the usual long Josephson junctions. Furthermore, the parallel array approach can be also extended up to about 1.4 THz using Nb-based SIS junctions.
We have fabricated a YBa/sub 2/Cu/sub 3/O/sub y/ (YBCO) array of five Josephson junctions designed with additional inductive coupling lines (AICLs). The junctions in this array were dc-biased in parallel to oscillate coherently in-phase and integrated with AICLs to improve the impedance matching between this array and external circuits such as a waveguide. The effect of AICLs was investigated by studying its influence on the current-voltage characteristics of the Josephson junction array (JJA) under external microwave irradiations with frequency of 22 GHz. The experimental results show that the behavior of the Shapiro-steps depends upon the effective inductance of AICLs which affects the total impedance and microwave coupling. We were able to obtain an oscillation frequency of about 73% of the maximum available frequency calculated from the characteristic voltage of the Josephson junctions in the array at a temperature of 12 K. By calculating the total impedance of the array, we obtained the suitable parameters of the array for microwave coupling with waveguide for various values of inductance, ac frequencies and number of Josephson junctions.
We demonstrate the synchronization of current quantization in a parallel array of weakly coupled Josephson Junctions operating in the regime of the coherent quantum phase slip. The first quantized current step on the voltage-current characteristic of 69 parallel Josephson junctions, under microwave excitation at a frequency of f = 19.325 GHz, is observed at 426 nA. Experiments show that accuracy of quantization does not degrade with increasing number of combined Josephson junctions. This demonstration addresses the issue of quantized current amplitude requirements adopted for a practical quantum standard, while leaving the question of accuracy for further research. At present, the quantum current standard of accepted metrological accuracy in the triangle of electrical units is under development. The other two, the Volt and Ohm standards based on the Josephson and Quantum Hall effects, respectively, are already well established in metrology.