Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Superposition of helical beams by using a Michelson interferometer

Chunqing Gao, Xiaoqing Qi, Yidong Liu, Horst Weber

Published Dec 22, 2009• 15 citations
Publisher

Abstract

Orbital angular momentum (OAM) of a helical beam is of great interests in the high density optical communication due to its infinite number of eigen-states. In this paper, an experimental setup is realized to the information encoding and decoding on the OAM eigen-states. A hologram designed by the iterative method is used to generate the helical beams, and a Michelson interferometer with two Porro prisms is used for the superposition of two helical beams. The experimental results of the collinear superposition of helical beams and their OAM eigen-states detection are presented.

DOI
10.1364/oe.18.000072

Related papers

Experimental study of detecting orbital angular momentumstates of spiral phase beams

Xiaoqing Qi, Gao Chun-Qing

An experimental setup was built to detect orbital angular momentum (OAM) states of light beams. The helical beams with different OAM states were generated by using a spatial light modulator. A Mach-Zehnder (M-Z) interferometer was used to detect helical beams with odd or even OAM number. Sorting of coaxial helical beams was also experimentally realized.

Acta Physica Sinica•Jan 1, 2011•3 citations

Detection of orbital angular momentum superposition photon states using hologram and path interferometer

Yoko Miyamoto, Mitsuo Wada Takeda, Daisuke Kawase +3 more

Detection of photons in orbital angular momentum (OAM) superposition states is crucial to verification of OAM entanglement. In the past this has been realized by laterally shifting a hologram designed to remove a charge 1 phase singularity at its center. Such a laterally shifted hologram converts a beam with an off-center singularity (similar to that created by superposing an m = 0 beam and an m = 1 beam, where in is the OAM mode number) into a Gaussian beam, which is then filtered through a single mode fiber (SMF). However, it has been shown that a photon detected by this method is not a simple superposition of a photon in the m = 0 Gaussian mode and the m = 1 mode detected with an unshifted hologram, making it necessary to apply complicated analysis. One problem is that the radial distributions of the detected m = 0 and 1 components as determined by the SMF change as the hologram is shifted. Another, possibly more serious problem is the mixing of other OAM components. To overcome this problem we propose a new scheme for the detection of OAM superposition states consisting of a hologram and a path interferometer. The hologram is designed so that the output is equally distributed between the 0th and 1st order diffraction beams. The 0th order is the input beam itself, whose m = 0 Gaussian component is filtered through an SMF. In the 1st order beam the m = 1 component is converted to m = 0 and is filtered through a second SMF. The filtered beams now have the same spatial distribution, and can be superposed by a beam splitter. By inserting attenuators and phase modulators within the interferometer, superpositions with varying amplitude ratios and relative phases can be detected without shifting the hologram.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2007•0 citations

Making and identifying optical superpositions of high orbital angular momenta

Lixiang Chen, Wuhong Zhang, Qinghong Lu +1 more

We report the experimental preparation of optical superpositions of high orbital angular momenta (OAM). Our method is based on the use of a spatial light modulator to modify the standard Laguerre-Gaussian beams to bear excessive phase helices. We demonstrate the surprising performance of a traditional Mach-Zehnder interferometer with one inserted Dove prism to identify these superposed twisted lights, where the high OAM numbers as well as their possible superpositions can be inferred directly from the interfered bright multiring lattices. The possibility of the present scheme working at the photon-count level is also shown using an electron multiplier CCD camera. Our results hold promise in high-dimensional quantum-information applications when high quanta are beneficial.

arXiv:1310.4901•Physical Review A•Nov 20, 2013•56 citations

An OAM Mode Measurement Method by Rotation Angle Estimation

Quanqing Qiao, Shengmei Zhao, Le Wang

In the paper, we present a method for the measurement of the orbital angular momentum (OAM) superposition state by making use of the characteristics of the beam's helical phase structure and Gouy phase. With the rotation angle and the petal-like number of the OAM superposition state, one can efficiently extract the component OAM mode of the OAM super-position state by the method. We derive the simple relationship between the OAM superposition state's rotation angle and the propagation distance, which is verified by numerical simulations and experiments. The results show that the proposed method can detect the sign and the topological charge of the component OAM modes. Additionally, the proposed method has a higher fault tolerance and has significance for optical communication based on OAM superposition state.

IEEE International Conference on Communications workshops•Jun 1, 2021•2 citations

Quantum communication coding based on orbital angular momentum of light

Xizheng Ke

The nondiffracting higher-order Bessel beams carry the orbital angular momentum(OAM). During free propagation,their transverse intensity profile remains nearly invariant in a range.The beam comprises the topological charge l helical phasefronts and carries an orbital angular momentum of lh per photon.The angular momentum number carried by the photon in each eigenmode is represented by l, and the eigenstates |l〉can generate multidimensional quantum entangled states.A method of optical communication is presented that encodes information in two orthogonal orbital angular momentum states based on higher-order Bessel beams.Each photon carries OAM states of information,which can increase the key generation rate of the protocol,and offer a quantum solution for increase of the optical communication distance.

Chinese Journal of Quantum Electronics•Jan 1, 2010•1 citation

Encoding and Verification of Composite Vortex Beams with Spaced Orbital Angular Momentum

Tianpeng Xu, Xinping Han, Xiaodie Wang +3 more

A novel encoding method based on the orbital angular momentum (OAM) mode and radial mode of composite vortex beams is proposed. The superposition of two vortex beams generates 32 different types of composite vortex beams: one of them is a Laguerre–Gaussian (LG) beam with a fixed OAM mode and radial mode, and the other is a LG beam containing four radial modes (p = 0, 1, 2, 3) and eight OAM modes with the same interval (l = ±3, ±5, ±7, ±9). A specially designed composite fork-shaped grating (CFG) is utilized to generate the intensity array pattern, and the received composite vortex beam is diffracted into a Gaussian beam with the relevant coordinates. Based on the coordinates and the number of bright rings in the intensity pattern, the OAM modes and radial modes of the two vortex beams composing the superposition state are determined, and finally the received composite vortex beam is decoded into the initially propagated information sequence. The correctness and effectiveness of the proposed encoding are confirmed through the comparative analysis of the correlation of the optical fields at both the transmitter and receiver in the two scenarios of interval and non-interval encoding. The proposed encoding method can significantly improve the efficiency of information transmission and its resistance to interference, holding great potential for future applications in free-space optical communication.

Photonics•Aug 19, 2025•3 citations
Orbital angular momentum (OAM) of a helical beam is of great interests in the high density optical communication due to its infinite number of eigen-states. In this paper, an experimental setup is realized to the information encoding and decoding on the OAM eigen-states. A hologram designed by the iterative method is used to generate the helical beams, and a Michelson interferometer with two Porro prisms is used for the superposition of two helical beams. The experimental results of the collinear superposition of helical beams and their OAM eigen-states detection are presented.
Detection of photons in orbital angular momentum (OAM) superposition states is crucial to verification of OAM entanglement. In the past this has been realized by laterally shifting a hologram designed to remove a charge 1 phase singularity at its center. Such a laterally shifted hologram converts a beam with an off-center singularity (similar to that created by superposing an m = 0 beam and an m = 1 beam, where in is the OAM mode number) into a Gaussian beam, which is then filtered through a single mode fiber (SMF). However, it has been shown that a photon detected by this method is not a simple superposition of a photon in the m = 0 Gaussian mode and the m = 1 mode detected with an unshifted hologram, making it necessary to apply complicated analysis. One problem is that the radial distributions of the detected m = 0 and 1 components as determined by the SMF change as the hologram is shifted. Another, possibly more serious problem is the mixing of other OAM components. To overcome this problem we propose a new scheme for the detection of OAM superposition states consisting of a hologram and a path interferometer. The hologram is designed so that the output is equally distributed between the 0th and 1st order diffraction beams. The 0th order is the input beam itself, whose m = 0 Gaussian component is filtered through an SMF. In the 1st order beam the m = 1 component is converted to m = 0 and is filtered through a second SMF. The filtered beams now have the same spatial distribution, and can be superposed by a beam splitter. By inserting attenuators and phase modulators within the interferometer, superpositions with varying amplitude ratios and relative phases can be detected without shifting the hologram.
We report the experimental preparation of optical superpositions of high orbital angular momenta (OAM). Our method is based on the use of a spatial light modulator to modify the standard Laguerre-Gaussian beams to bear excessive phase helices. We demonstrate the surprising performance of a traditional Mach-Zehnder interferometer with one inserted Dove prism to identify these superposed twisted lights, where the high OAM numbers as well as their possible superpositions can be inferred directly from the interfered bright multiring lattices. The possibility of the present scheme working at the photon-count level is also shown using an electron multiplier CCD camera. Our results hold promise in high-dimensional quantum-information applications when high quanta are beneficial.
In the paper, we present a method for the measurement of the orbital angular momentum (OAM) superposition state by making use of the characteristics of the beam's helical phase structure and Gouy phase. With the rotation angle and the petal-like number of the OAM superposition state, one can efficiently extract the component OAM mode of the OAM super-position state by the method. We derive the simple relationship between the OAM superposition state's rotation angle and the propagation distance, which is verified by numerical simulations and experiments. The results show that the proposed method can detect the sign and the topological charge of the component OAM modes. Additionally, the proposed method has a higher fault tolerance and has significance for optical communication based on OAM superposition state.
The nondiffracting higher-order Bessel beams carry the orbital angular momentum(OAM). During free propagation,their transverse intensity profile remains nearly invariant in a range.The beam comprises the topological charge l helical phasefronts and carries an orbital angular momentum of lh per photon.The angular momentum number carried by the photon in each eigenmode is represented by l, and the eigenstates |l〉can generate multidimensional quantum entangled states.A method of optical communication is presented that encodes information in two orthogonal orbital angular momentum states based on higher-order Bessel beams.Each photon carries OAM states of information,which can increase the key generation rate of the protocol,and offer a quantum solution for increase of the optical communication distance.
A novel encoding method based on the orbital angular momentum (OAM) mode and radial mode of composite vortex beams is proposed. The superposition of two vortex beams generates 32 different types of composite vortex beams: one of them is a Laguerre–Gaussian (LG) beam with a fixed OAM mode and radial mode, and the other is a LG beam containing four radial modes (p = 0, 1, 2, 3) and eight OAM modes with the same interval (l = ±3, ±5, ±7, ±9). A specially designed composite fork-shaped grating (CFG) is utilized to generate the intensity array pattern, and the received composite vortex beam is diffracted into a Gaussian beam with the relevant coordinates. Based on the coordinates and the number of bright rings in the intensity pattern, the OAM modes and radial modes of the two vortex beams composing the superposition state are determined, and finally the received composite vortex beam is decoded into the initially propagated information sequence. The correctness and effectiveness of the proposed encoding are confirmed through the comparative analysis of the correlation of the optical fields at both the transmitter and receiver in the two scenarios of interval and non-interval encoding. The proposed encoding method can significantly improve the efficiency of information transmission and its resistance to interference, holding great potential for future applications in free-space optical communication.