Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Optical memory based on heterodyne-detected accumulated photon echoes

S. Saikan, Kiyoshi Uchikawa, Akira Furusawa, Takanori Kishida, A. Imaoka, H. Oosawa

Published Aug 15, 1989• 22 citations
Publisher

Abstract

Optical memory based on heterodyne-detected accumulated photon echoes has been demonstrated in dye-doped polymers. Compared with previously developed time-domain optical memory, writing and reading of higher bit data is possible owing to the superior time resolution of this method.
DOI
10.1364/ol.14.000841

Related papers

Time- and frequency-domain hybrid optical memory: 16-kbit data storage in Eu^3+:Y_2SiO_5

Masaharu Mitsunaga, Ryuzi Yano, Naoshi Uesugi

We propose and demonstrate a novel type of frequency-selective optical memory that writes and reads the data in both the time domain and the frequency domain. Temporal 16-bit data were stored by accumulated-photon-echo bit-by-bit storage at 103 frequency addresses within the inhomogeneous line of the (7)F(0)-(5)D(0) transition of Eu(3+):Y(2)SiO(5), which yields a total memory capacity of 1.6 kbits in a single spot of 240-microm diameter. The keys to the success of this experiment are this material's long dephasing time and lack of spectral diffusion.

Optics Letters•Dec 1, 1991•122 citations

Improved time resolution in an accumulated photon echo by using a repetitively frequency-scanned dye laser

S. Saikan, Takanori Kishida, A. Imaoka

The time resolution of a heterodyne-detected accumulated photon echo has been improved significantly by using a dye laser whose lasing frequency is repetitively scanned. A time resolution of less than 30 fsec was obtained, even with a non-mode-locked cw dye laser. This technique is applicable provided that the absorption recovery time of the sample is longer than the repetition period of the frequency-scanning dye laser. The absorption recovery times of several dyes that were doped with polyvinyl alcohol have also been measured.

Journal of the Optical Society of America B•Aug 1, 1989•3 citations

High-Frequency Heterodyned Detection of Picosecond Accumulated Photon Echoes

S. Saikan, Atsushi Fujiwara, Takashi Kushida +1 more

Highly sensitive detection of accumulated photon echoes was achieved by means of a high-frequency heterodyned method using a mode-locked CW dye laser. Experimental results on the modulation frequency dependence of the echo signal strength and also the excitation wavelength dependence of the echo decay curves in Nd:silicate glass are presented.

Japanese Journal of Applied Physics•Jun 1, 1987•14 citations

Optical Memory Using Resonant Raman Pulse Excited Spin Echoes

Byoung Seung HAM, M. S. Shahriar, M. K. Kim +1 more

Optical data storage has been interested in several decades because of the potential of fast access time and high-density storage. Recently volume holographic data storage technique has drawn much interest as new materials and improved techniques have developed.1 However, the large of hologram storage is restricted by low diffraction efficiency and mainly focused to read only memory because of the material's characteristic difficult to rewrite in short time interval. Another optical memory technique (photon echo optical memory)2 based on time-domain has developed since 1980's and made big progress for the area of real time image processing and dynamic random access memory. In this technique, data pulses interfere with timely separated write pulse (reference), and their interference pattern is written as population gratings. A read pulse (reference) retrieves each data pulse information as a four-wave mixing process. The write and read pulse separations are restricted by phase and population decay times of the material, respectively, and storage density is determined by the ratio of inhomogeneous to homogeneous linewidths. Even though photon echo technique has advantages of fast access time (≥ ns) and high-density (≥ Mbits/laser spot), its operating temperature is kept extremely low around liquid helium temperature. This is because that homogeneous decay time rapidly shortens as temperature increases due to phonon interactions, i.e., the ratio of inhomogeneous to homogeneous decay rates is ~ 1 at liquid nitrogen temperature (77 K) in a rare-earth doped solid, so that restricts its applications.

Optical Data Storage•Jan 1, 1998•0 citations

Fourier-transform spectroscopy in dye-doped polymers using the femtosecond accumulated photon echo

S. Saikan, Takakazu Nakabayashi, Yasuo Kanematsu +1 more

Fourier-transform spectroscopy using the technique of femtosecond accumulated photon echo with incoherent light has been performed in dye-doped polymers. Several types of interference effect or quantum beat between the zero-phonon line and other spectral components including the phonon sideband, the vibronic lines, and the photoproduct state have been observed. Based on the density matrix incorporating the transition-frequency modulation, it is pointed out that the factorization approximation for the relaxation function holds rigorously in the accumulated photon echo. We also clarified that the Fourier cosine transform of the heterodyne-detected echo signal provides the hole-burning spectrum.

Physical review. B, Condensed matter•Oct 15, 1988•67 citations

Partial erasing of temporal memory by using picosecond accumulated photon echoes in dye doped polymer film

Ryuzi Yano, N. Uesugi

The stimulated photon echo memory using persistent hole-burning materials has been attracting much attention as a possible candidate for high-density data storage. Most studies have been related to the writing and reading processes and little attention has been paid for a partial erasing. We demonstrate for the first time that partial erasing of photon echo memory can be accomplished by simply employing a half-wave plate. In a photon echo memory, the write and data pulses with a time separation /spl tau/ excite a hole-burning material. These pulses create a periodic absorption modulation (periodic hole) with a frequency of l//spl tau/ in the absorption spectrum. When the read pulse excites the sample, a stimulated echo pulse is emitted at /spl tau/ after the read pulse, We note that a bit of data is stored as a periodic hole in the sample. A rotation of a half-wave plate inserted in the data pulse path (which induce a retardation of /spl lambda//2) creates two periodic holes that have the same frequency and opposite phase. Therefore, erasing a periodic hole can be done by rotating the wave plate. A dye (Sulforhodamin 640) doped polymer film (polyvinyl alcohol) cooled at 2 K was used as a persistent hole-burning material.

Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR)•Jan 20, 2003•0 citations
We propose and demonstrate a novel type of frequency-selective optical memory that writes and reads the data in both the time domain and the frequency domain. Temporal 16-bit data were stored by accumulated-photon-echo bit-by-bit storage at 103 frequency addresses within the inhomogeneous line of the (7)F(0)-(5)D(0) transition of Eu(3+):Y(2)SiO(5), which yields a total memory capacity of 1.6 kbits in a single spot of 240-microm diameter. The keys to the success of this experiment are this material's long dephasing time and lack of spectral diffusion.
The time resolution of a heterodyne-detected accumulated photon echo has been improved significantly by using a dye laser whose lasing frequency is repetitively scanned. A time resolution of less than 30 fsec was obtained, even with a non-mode-locked cw dye laser. This technique is applicable provided that the absorption recovery time of the sample is longer than the repetition period of the frequency-scanning dye laser. The absorption recovery times of several dyes that were doped with polyvinyl alcohol have also been measured.
Optical data storage has been interested in several decades because of the potential of fast access time and high-density storage. Recently volume holographic data storage technique has drawn much interest as new materials and improved techniques have developed.1 However, the large of hologram storage is restricted by low diffraction efficiency and mainly focused to read only memory because of the material's characteristic difficult to rewrite in short time interval. Another optical memory technique (photon echo optical memory)2 based on time-domain has developed since 1980's and made big progress for the area of real time image processing and dynamic random access memory. In this technique, data pulses interfere with timely separated write pulse (reference), and their interference pattern is written as population gratings. A read pulse (reference) retrieves each data pulse information as a four-wave mixing process. The write and read pulse separations are restricted by phase and population decay times of the material, respectively, and storage density is determined by the ratio of inhomogeneous to homogeneous linewidths. Even though photon echo technique has advantages of fast access time (≥ ns) and high-density (≥ Mbits/laser spot), its operating temperature is kept extremely low around liquid helium temperature. This is because that homogeneous decay time rapidly shortens as temperature increases due to phonon interactions, i.e., the ratio of inhomogeneous to homogeneous decay rates is ~ 1 at liquid nitrogen temperature (77 K) in a rare-earth doped solid, so that restricts its applications.
Fourier-transform spectroscopy using the technique of femtosecond accumulated photon echo with incoherent light has been performed in dye-doped polymers. Several types of interference effect or quantum beat between the zero-phonon line and other spectral components including the phonon sideband, the vibronic lines, and the photoproduct state have been observed. Based on the density matrix incorporating the transition-frequency modulation, it is pointed out that the factorization approximation for the relaxation function holds rigorously in the accumulated photon echo. We also clarified that the Fourier cosine transform of the heterodyne-detected echo signal provides the hole-burning spectrum.
The stimulated photon echo memory using persistent hole-burning materials has been attracting much attention as a possible candidate for high-density data storage. Most studies have been related to the writing and reading processes and little attention has been paid for a partial erasing. We demonstrate for the first time that partial erasing of photon echo memory can be accomplished by simply employing a half-wave plate. In a photon echo memory, the write and data pulses with a time separation /spl tau/ excite a hole-burning material. These pulses create a periodic absorption modulation (periodic hole) with a frequency of l//spl tau/ in the absorption spectrum. When the read pulse excites the sample, a stimulated echo pulse is emitted at /spl tau/ after the read pulse, We note that a bit of data is stored as a periodic hole in the sample. A rotation of a half-wave plate inserted in the data pulse path (which induce a retardation of /spl lambda//2) creates two periodic holes that have the same frequency and opposite phase. Therefore, erasing a periodic hole can be done by rotating the wave plate. A dye (Sulforhodamin 640) doped polymer film (polyvinyl alcohol) cooled at 2 K was used as a persistent hole-burning material.