Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review Letters

Quantum Nondemolition Detection of Optical Quadrature Amplitudes

M. D. Levenson, Robert M. Shelby, M. D. Reid, Daniel F. Walls

Published Nov 17, 1986• 229 citations
Publisher

Abstract

In an optical fiber, nonlinear optical interactions couple the sideband modes of two strong pump waves at different frequencies just as required for a quantum nondemolition measurement. Experimental measurements demonstrate that 37% of the rms phase fluctuations of one wave are caused by the quantum amplitude fluctuations of the other.
DOI
10.1103/physrevlett.57.2473

Related papers

Quantum nondemolition detection of optical quadrature amplitudes

Robert M. Shelby

The concept of quantum nondemolition (QND) measurement is outlined in the context of quantum optics. As a prototypal QND measurement scheme, the interaction of a light beam with a classical mechanical oscillator via radiation pressure is outlined. Results of QND experiments using cross‐phase modulation of two co‐propagating beams in single mode optical fibers are reviewed, and the prospects for improved schemes briefly discussed.

AIP conference proceedings•Jan 1, 1989•0 citations

Quantum Nondemolition Schemes using Second Order Nonlinearities

Robert M. Shelby, M. D. Levenson

Conventional devices for measuring the amplitude of a light wave absorb the light, thus destroying it. Recently, quantum nondemolition (QND) methods based on the optical Kerr effect have been shown capable of measuring optical amplitude fluctuations with near quantum-limited sensitivity.1 In these experiments, amplitude fluctuations of a signal beam are transferred to the phase fluctuation quadrature of a probe beam which co-propagates with the signal beam, by the intensity-dependent refractive index, without absorption of the signal beam. A pure Kerr nonlinearity can cause only phase modulation of the light wave, and the amplitude of the signal wave is preserved. Such methods should more properly be called back-action evading measurement schemes since the quantity being measured is not perturbed by the back-action that quantum mechanics requires for any measurement. The signal-to-noise ratio achieved in these experiments was limited by the small magnitude of the Kerr nonlinearity relative to the excess phase noise imposed on the probe beam by thermal light scattering processes in the glass fibers that were employed.

•Jul 18, 1988•0 citations

Quantum nondemolition measurements in optical cavities

P. M. Alsing, Gerard J Milburn, Daniel F. Walls

We analyze schemes for performing quantum nondemolition (QND) measurements in optical cavities. We consider three schemes: (1) measurement of a quadrature phase amplitude using a parametric process, (2) measurement of a quadrature phase amplitude using the optical Kerr effect in a nonlinear fiber, and (3) measurement of the photon number also using the Kerr effect in a fiber. We show that in the second scheme an enhancement of the QND effect may be obtained by making the cavity finesse for the signal larger than that for the probe.

Physical Review A•Apr 1, 1988•62 citations

Accurate quantum nondemolition measurements of optical solitons

Victor V. Kozlov, D. A. Ivanov

A fully quantum-mechanical Heisenberg description of the quantum-nondemolition measurements via soliton collision in an optical fiber is provided. Solutions to the equations of motion for meaningful soliton collective operators such as photon number, phase, position, and frequency (momentum) are applied to quantifying the error of inference of photon number and frequency of the signal soliton by performing a measurement on the probe soliton. A detection method based on measuring a four-component quadrature amplitude is proposed and proved to give the best accuracy.

Physical Review A•Jan 15, 2002•10 citations

Conditional measurement of the photon number optical pulse collision

Friedrich König, T. Rechtenwald, M. Zielonka +3 more

Summary form only given. The optical Kerr effect of fibers produced unique nonclassical correlations through intensity-dependent phase shifts in a variety of quadrature-amplitude squeezing and quantum-nondemolition (QND) experiments. Later, a new squeezing mechanism was observed with spectral filtering of fiber-optical pulses. Our novel QND approach applies spectral filtering to two interacting pulses in order to obtain a QND readout that is immune to phase noise. In a pulse collision the spectral separation between the center frequencies of the pulses is transiently enhanced, with the spectral shift of one (meter) pulse depending on the photon number of the other (signal) pulse. Thus photon-number fluctuations of one pulse are transferred to frequency fluctuations of the other pulse which are directly detectable after a spectral filter. The maximum frequency shift occurs in the center of the collision, where the pulses are well separated in frequency space, even if there is a spectral overlap before the collision.

Conference on Lasers and Electro-Optics•Aug 29, 2005•0 citations

Experimental quantum nondemolitional measurements using soliton collisions

S. R. Friberg, S. Machida, Y. Yamamoto

The collision of two optical solitons, one a probe and the other a signal, writes out the energy of the signal soliton as a phase shift of the probe soliton. Consequently, a readout of the probe phase shift gives the photon number of the signal soliton. If the collision takes place in a low-loss optical fiber with the usual Kerr nonlinearity, the photon number of the signal soliton is preserved, and the measurement can be a quantum nondemolitional (QND) measurement. We describe experimental progress towards soliton collision QND measurements. We have collided two solitons at 1.460 nm (probe) and 1.463 nm (signal) and with the help of a delayed reference soliton (identical to the probe) in a homodyne detector system, we have measured the resulting probe soliton phase shifts. Toward a QND measurement, we correlate the shot noise fluctuations of the signal soliton with the corresponding phase noise fluctuations written on the probe. We present our current results.

Annual Meeting Optical Society of America•Jan 1, 1991•1 citation
Conventional devices for measuring the amplitude of a light wave absorb the light, thus destroying it. Recently, quantum nondemolition (QND) methods based on the optical Kerr effect have been shown capable of measuring optical amplitude fluctuations with near quantum-limited sensitivity.1 In these experiments, amplitude fluctuations of a signal beam are transferred to the phase fluctuation quadrature of a probe beam which co-propagates with the signal beam, by the intensity-dependent refractive index, without absorption of the signal beam. A pure Kerr nonlinearity can cause only phase modulation of the light wave, and the amplitude of the signal wave is preserved. Such methods should more properly be called back-action evading measurement schemes since the quantity being measured is not perturbed by the back-action that quantum mechanics requires for any measurement. The signal-to-noise ratio achieved in these experiments was limited by the small magnitude of the Kerr nonlinearity relative to the excess phase noise imposed on the probe beam by thermal light scattering processes in the glass fibers that were employed.
We analyze schemes for performing quantum nondemolition (QND) measurements in optical cavities. We consider three schemes: (1) measurement of a quadrature phase amplitude using a parametric process, (2) measurement of a quadrature phase amplitude using the optical Kerr effect in a nonlinear fiber, and (3) measurement of the photon number also using the Kerr effect in a fiber. We show that in the second scheme an enhancement of the QND effect may be obtained by making the cavity finesse for the signal larger than that for the probe.
A fully quantum-mechanical Heisenberg description of the quantum-nondemolition measurements via soliton collision in an optical fiber is provided. Solutions to the equations of motion for meaningful soliton collective operators such as photon number, phase, position, and frequency (momentum) are applied to quantifying the error of inference of photon number and frequency of the signal soliton by performing a measurement on the probe soliton. A detection method based on measuring a four-component quadrature amplitude is proposed and proved to give the best accuracy.
Summary form only given. The optical Kerr effect of fibers produced unique nonclassical correlations through intensity-dependent phase shifts in a variety of quadrature-amplitude squeezing and quantum-nondemolition (QND) experiments. Later, a new squeezing mechanism was observed with spectral filtering of fiber-optical pulses. Our novel QND approach applies spectral filtering to two interacting pulses in order to obtain a QND readout that is immune to phase noise. In a pulse collision the spectral separation between the center frequencies of the pulses is transiently enhanced, with the spectral shift of one (meter) pulse depending on the photon number of the other (signal) pulse. Thus photon-number fluctuations of one pulse are transferred to frequency fluctuations of the other pulse which are directly detectable after a spectral filter. The maximum frequency shift occurs in the center of the collision, where the pulses are well separated in frequency space, even if there is a spectral overlap before the collision.
The collision of two optical solitons, one a probe and the other a signal, writes out the energy of the signal soliton as a phase shift of the probe soliton. Consequently, a readout of the probe phase shift gives the photon number of the signal soliton. If the collision takes place in a low-loss optical fiber with the usual Kerr nonlinearity, the photon number of the signal soliton is preserved, and the measurement can be a quantum nondemolitional (QND) measurement. We describe experimental progress towards soliton collision QND measurements. We have collided two solitons at 1.460 nm (probe) and 1.463 nm (signal) and with the help of a delayed reference soliton (identical to the probe) in a homodyne detector system, we have measured the resulting probe soliton phase shifts. Toward a QND measurement, we correlate the shot noise fluctuations of the signal soliton with the corresponding phase noise fluctuations written on the probe. We present our current results.