Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physica B+C

Negative resistance and conversion gain in SIS mixers

A. D. Smith, William R. McGrath, P. L. Richards, Herman van Kempen, D. E. Prober, Padmanabhan Santhanam

Published Aug 1, 1981• 9 citations
Publisher
DOI
10.1016/0378-4363(81)90982-7

Related papers

An 85–115 GHz SIS Mixer Demonstrating Nearly Constant Dynamic Resistance

Wenlei Shan, Zhenqiang Li, Jiaqiang Zhong +1 more

We report the design and experiment results of 85-115 GHz SIS mixers that demonstrate nearly constant dynamic resistance and uniform conversion gain. The dynamic resistance close to 50 Omega allows stable bias and direct connection of the SIS mixer and the cryogenic low noise amplifier without an IF isolator. The tuning circuit consists of a single junction tuned by an equivalent shunt inductance and an impedance transformer used for impedance matching. Since the impedance transformer and the shunt inductance have opposite frequency-dependent admittances, we were able to eliminate the frequency-dependent components of the tuning circuit and managed to achieve nearly constant embedding impedance in the frequency range. Measurement results showing dynamic resistances ranging from 30 Omega to 50 Omega and conversion gain changing less than 3 dB reasonably agree with the simulations.

IEEE Transactions on Applied Superconductivity•May 27, 2009•8 citations

Large conversion efficiency and dynamic range for sis mixers

T. C. L. G. Sollner

Physica B+C•Aug 1, 1981•5 citations

A 100 GHz SIS Quasiparticle Mixer with 10 dB Coupled Gain

Antti V. Räisänen, Denis Crété, P. L. Richards +1 more

We have tested a superconducting qussiparticle mixer for 85-110 GHz which gives much larger coupled gain than has been previously observed. When operated with a negative dynamic resistance of about 2000 Omega, the maximum coupled gain was G/sub M/(DSB)= 12.5 +- 0.5 dB [G/sub M/(SSB)= 9.5 +- 2.5 dB]. The associated mixer noise temperature was 15.9 K (DSB). Large gain was also observed with large positive dynamic resistance, giving the lowest mixer noise temperature of 12.4 K (DSB).

IEEE MTT-S International Microwave Symposium digest•Jan 1, 1987•17 citations

Infinite gain and oscillations in SIS microwave mixers

Aldert van der Ziel

Physica B+C•Jun 1, 1983•0 citations

A Novel LO Power Injection Method for SIS Mixers

Kecheng Xiao, Hideo Ogawa, Yasuo Fukui

International Journal of Infrared and Millimeter Waves•Jan 1, 2002•1 citation

Noise Wave Modeling of an SIS Mixer and Its IF Circuit Using Tucker's Quantum Theory of Mixing

Edward Tong, Paul Grimes, Lingzhen Zeng

Tucker's Quantum Theory of Mixing (QTM) is widely used to model the conversion gain and noise temperature of SIS mixers. In particular, the theory describes the phenomenon of non-classical conversion gain and that of infinite or even negative output impedances in inductively tuned SIS mixers. Common microwave noise theory is inadequate to describe the operation of the IF circuit connected to such mixers. In this paper, we report the use of the noise wave formalism to model the noise properties of a Double-Side-Band SIS mixer together with an IF isolator and low noise amplifier cascade. Starting from QTM, we derive the 4 noise parameters of the SIS mixer, together with an approximate 2-port chain matrix with an upper-side-band RF input port and an IF output port. These matrices are cascaded with the noise correlation matrix of the IF circuit to form a complete noise model of the SIS receiver. Optimum source impedance for the receiver can be derived from this noise model, which can be used in efficient CAD modeling of a complete SIS receiver.

IEEE Transactions on Applied Superconductivity•Mar 18, 2019•2 citations
We report the design and experiment results of 85-115 GHz SIS mixers that demonstrate nearly constant dynamic resistance and uniform conversion gain. The dynamic resistance close to 50 Omega allows stable bias and direct connection of the SIS mixer and the cryogenic low noise amplifier without an IF isolator. The tuning circuit consists of a single junction tuned by an equivalent shunt inductance and an impedance transformer used for impedance matching. Since the impedance transformer and the shunt inductance have opposite frequency-dependent admittances, we were able to eliminate the frequency-dependent components of the tuning circuit and managed to achieve nearly constant embedding impedance in the frequency range. Measurement results showing dynamic resistances ranging from 30 Omega to 50 Omega and conversion gain changing less than 3 dB reasonably agree with the simulations.
Tucker's Quantum Theory of Mixing (QTM) is widely used to model the conversion gain and noise temperature of SIS mixers. In particular, the theory describes the phenomenon of non-classical conversion gain and that of infinite or even negative output impedances in inductively tuned SIS mixers. Common microwave noise theory is inadequate to describe the operation of the IF circuit connected to such mixers. In this paper, we report the use of the noise wave formalism to model the noise properties of a Double-Side-Band SIS mixer together with an IF isolator and low noise amplifier cascade. Starting from QTM, we derive the 4 noise parameters of the SIS mixer, together with an approximate 2-port chain matrix with an upper-side-band RF input port and an IF output port. These matrices are cascaded with the noise correlation matrix of the IF circuit to form a complete noise model of the SIS receiver. Optimum source impedance for the receiver can be derived from this noise model, which can be used in efficient CAD modeling of a complete SIS receiver.