Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Soviet Journal of Quantum Electronics

Cross-relaxation quantum amplifier operating at 22.2 GHz

L. Eh. Abramyan, A. A. Akhumyan, R. М. Мartirosyan, V. P. Shakhparyan

Published Sep 30, 1975• 0 citations
Publisher

Abstract

A cross-relaxation ruby quantum amplifier operating at 22.2 GHz was constructed. The 4→3 signal transition and the 2→4 pump transition were used in the θ=76° and 90° orientations. A gain of 18 dB was obtained for a passband of 13 MHz. Possible cross relaxations at the working point were considered. The inversion coefficient was calculated by solving the rate equations in the presence of cross relaxation.

DOI
10.1070/qe1975v004n09abeh011562

Related papers

Cavity Maser Experiments using Ruby at S Band†

W.S.C. Chang, J.C. Cromack, Anthony E.. Siegman

A three-level solid-state maser using ruby has been operated at frequencies near 3000 Mc/s, using a high-efficiency cavity having TEM modes in a rectangular geometry. Two different operating points in the θ = 10° to θ =30 ° region of the ruby spectrum gave maser operation with a pump frequency near 10 500 Mc/s, although the inversion obtained was a. sensitive function of the exact operating point. An operating point at θ = 90°, requiring pumping at 13 500 Mc/s, gave a gain-bandwidth product of better than 50 Mc/s. It was also found possible to pump the 1-4 or ΔM = 3 transition at this same operating point, obtaining 3000 Mc/s amplification with a 23 700 Mc/s pump frequency. Although this mode of operation was not fully explored, it is potentially capable of increasing the gain-bandwidth product by a substantial amount.

Journal of Electronics and Control•Jun 1, 1959•4 citations

Arrays of Josephson tunnel junctions as parametric amplifiers

S. Wahlsten, S. Rudner, T. Claeson

Arrays of 10 or 40 series-connected small densely packed Josephson tunnel junctions were successfully operated as parametric amplifiers at 10 GHz. Between 50 and 90% of the junctions in an array were observed to work coherently in the amplification process. Signal gain exceeding 24 dB was achieved with a pump power as low as −50 to −70 dBm. A power width (i.e., the range of the pump power for a gain within 3 dB of the peak gain) of 0.25 dB and a bandwidth of 15 MHz were measured for 20-dB gain. The power width was in accordance with theory but the bandwidth was reduced, probably due to noise saturation effects. The latter effects can be reduced by lowering the input noise temperature or by including an external band limitation. The noise temperature was also increased by saturation; however, with an external bandwidth of 60 MHz, a noise temperature of 30±20 K was measured. The application of a magnetic field has proved extremely useful as a means of tuning the amplifiers to stable high-gain operating points. This tuning was also utilized in evaluating the amplifier parameters, and the theory by Feldman, Parrish, and Chiao has been verified. The upper frequency limit for a lead tunnel junction amplifier ought to be well above 300 GHz.

Journal of Applied Physics•Jul 1, 1978•61 citations

Seesaw Maser Operation

Paul Forrester, W. B. Mims

Cross relaxation between adjacent intervals may be used to secure an advantage in maser operation comparable to that obtained by ``push-pull'' pumping. Equations for the rate of change of populations in a scheme of four levels (A,B,C,D) when AC is pumped and cross relaxation takes place between BC, CD have been formulated, and the steady-state condition corresponding to various assumptions regarding lattice relaxation times is discussed. In an experimental investigation of maser operation based on this scheme and using ruby as the active material, an inversion of 0.9:1 was obtained at a signal frequency of 14.5 kMc when pumping at 24.5 kMc.

Journal of Applied Physics•Feb 1, 1961•3 citations

Quantum paramagnetic amplifier utilizing synthetic emerald crystals

A. A. Akhumyan, Zh A Arakelyan, G V Bukin +2 more

A quantum paramagnetic amplifier with a resonator was constructed using synthetic emerald crystals. The amplifier gain was 15–18 dB in a band 6–8 MHz wide. For the Cr3+ ion concentrations of 0.26% the inversion coefficient was 6.5. The magnetic Q factor of the active material was ~170.

Soviet Journal of Quantum Electronics•Jan 31, 1979•2 citations

Two-frequency ruby maser

Zh A Arakelyan, I G Karayan, R. М. Мartirosyan +1 more

A description is given of a two-frequency ruby maser capable of amplification at frequencies of 1.3 and 9.4 GHz. The values of the inversion coefficients and gains at these frequencies are given. It is shown that the same configuration can be used to widen the maser band when the energy intervals 1?2 and 3?4 between the levels differ by the ESR line width. Possible applications of such amplifiers are indicated.

Soviet Journal of Quantum Electronics•Dec 31, 1975•1 citation

X-band singly degenerate parametric amplification in a Josephson tunnel junction

J. Mygind, N. F. Pedersen, O. H. Soerensen

Preliminary measurements on a (quasi-) degenerate parametric amplifier using a single Josephson tunnel junction as the active element is reported. The pump frequency is at 18 GHz and the signal and idler frequencies are both at about 9 GHz. A power gain of 16 dB in a 4-MHz 3-dB bandwidth is achieved at the top of the cryostat.

Applied Physics Letters•Jan 1, 1978•26 citations
A cross-relaxation ruby quantum amplifier operating at 22.2 GHz was constructed. The 4→3 signal transition and the 2→4 pump transition were used in the θ=76° and 90° orientations. A gain of 18 dB was obtained for a passband of 13 MHz. Possible cross relaxations at the working point were considered. The inversion coefficient was calculated by solving the rate equations in the presence of cross relaxation.
A three-level solid-state maser using ruby has been operated at frequencies near 3000 Mc/s, using a high-efficiency cavity having TEM modes in a rectangular geometry. Two different operating points in the θ = 10° to θ =30 ° region of the ruby spectrum gave maser operation with a pump frequency near 10 500 Mc/s, although the inversion obtained was a. sensitive function of the exact operating point. An operating point at θ = 90°, requiring pumping at 13 500 Mc/s, gave a gain-bandwidth product of better than 50 Mc/s. It was also found possible to pump the 1-4 or ΔM = 3 transition at this same operating point, obtaining 3000 Mc/s amplification with a 23 700 Mc/s pump frequency. Although this mode of operation was not fully explored, it is potentially capable of increasing the gain-bandwidth product by a substantial amount.
Arrays of 10 or 40 series-connected small densely packed Josephson tunnel junctions were successfully operated as parametric amplifiers at 10 GHz. Between 50 and 90% of the junctions in an array were observed to work coherently in the amplification process. Signal gain exceeding 24 dB was achieved with a pump power as low as −50 to −70 dBm. A power width (i.e., the range of the pump power for a gain within 3 dB of the peak gain) of 0.25 dB and a bandwidth of 15 MHz were measured for 20-dB gain. The power width was in accordance with theory but the bandwidth was reduced, probably due to noise saturation effects. The latter effects can be reduced by lowering the input noise temperature or by including an external band limitation. The noise temperature was also increased by saturation; however, with an external bandwidth of 60 MHz, a noise temperature of 30±20 K was measured. The application of a magnetic field has proved extremely useful as a means of tuning the amplifiers to stable high-gain operating points. This tuning was also utilized in evaluating the amplifier parameters, and the theory by Feldman, Parrish, and Chiao has been verified. The upper frequency limit for a lead tunnel junction amplifier ought to be well above 300 GHz.
Cross relaxation between adjacent intervals may be used to secure an advantage in maser operation comparable to that obtained by ``push-pull'' pumping. Equations for the rate of change of populations in a scheme of four levels (A,B,C,D) when AC is pumped and cross relaxation takes place between BC, CD have been formulated, and the steady-state condition corresponding to various assumptions regarding lattice relaxation times is discussed. In an experimental investigation of maser operation based on this scheme and using ruby as the active material, an inversion of 0.9:1 was obtained at a signal frequency of 14.5 kMc when pumping at 24.5 kMc.