Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics B

Characterization of a velocity-tunable 87 Rb cold atomic source with a high-speed imaging technology

Feng Yan-Ying, Zhu Chang-Xing, Wang Xiao-Jia, Hongbo Xue, Xiongying Ye, Zhou Zhaoying

Published Jul 31, 2009• 3 citations
Publisher

Abstract

This paper has developed and characterized a method to produce a velocity-tunable 87 Rb cold atomic source for atomic interferometry application. Using a high speed fluorescence imaging technology, it reports that the dynamic process of the atomic source formation is observed and the source performances including the flux and the initial velocity are characterized. A tunable atomic source with the initial velocity of 1.4∼2.6 m/s and the atomic source flux of 2 × 10 8 ∼ 6 × 10 9 atoms/s has been obtained with the built experimental setup.

DOI
10.1088/1674-1056/18/8/042

Related papers

An intense 87Rb cold atomic source for atom interferometry

Li Yingying, Xiong Jijun, Zhikun Jiang

We present the implementation and characterization of a slow, intense, and collimated rubidium atomic source for atom interferometry. The continuous87Rb cold atomic beam is produced by a new compact two-dimensional magneto-optical trap. And it is based on the 2D+MOT design but a much smaller size and a higher flux compared to our original LVIS system. The on-line detecting system developed over a combination of time-of-flight and fluorescence methods is used to optimize the beam parameters. The dependence of the beam flux on detuning and power are investigated in detail respectively, for cooling and pushing laser. The re-pumping laser power influence is also considered. With aError! Reference source not found.10 G/cm magnetic gradient, 3ΓError! Reference source not found. red detuning from resonance for cooling laser and 5ΓError! Reference source not found. red detuning for pushing laser, the obtained cold atomic beam has a high flux of 4.7×109atoms/s Error! Reference source not found. Error! Reference source not found. It has a narrow longitudinal velocity distribution with mean velocity 10 m/s and full width at half maximum (FWHM)Error! Reference source not found.2 m/sError! Reference source not found. The two-photo stimulated Raman transitions both in Doppler-free and Doppler-sensitive modes are first proceeded, and stable Raman-Ramsey fringes are achieved with twon/2 Error! Reference source not found. Raman pulses.

International Conference on Optoelectronics and Microelectronics•Jul 1, 2015•0 citations

A cold 87 Rb atomic beam

Xiao-Jia Wang, Yanying Feng, Hongbo Xue +2 more

We demonstrate an experimental setup for the production of a beam source of cold 87Rb atoms. The atoms are extracted from a trapped cold atomic cloud in an unbalanced three-dimensional magneto—optical trap. Via a radiation pressure difference generated by a specially designed leak tunnel along one trapping laser beam, the atoms are pushed out continuously with low velocities and a high flux. The most-probable velocity in the beam is varied from 9 m/s to 19 m/s by varying the detuning of the trapping laser beams in the magneto—optical trap and the flux can be tuned up to 4×109 s−1 by increasing the intensity of the trapping beams. We also present a simple model for describing the dependence of the beam performance on the magneto—optical trap trapping laser intensity and the detuning.

Chinese Physics B•Dec 1, 2011•6 citations

Continuous cold rubidium atomic beam with enhanced flux and tunable velocity

Shengzhe Wang, Zhixin Meng, Peiqiang Yan +2 more

We present a cold atomic beam source based on a two-dimensional (2D)+ magneto-optical trap (MOT), capable of generating a continuous cold beam of 87 Rb atoms with a flux up to 4.3 × 10 9 s -1 , a mean velocity of 10.96(2.20) m/s, and a transverse temperature of 16.90(1.56) µK. Investigating the influence of high cooling laser intensity, we observe a significant population loss of atoms to hyperfine-level dark states. To account for this, we employ a multiple hyperfine level model to calculate the cooling efficiency associated with the population in dark states, subsequently modifying the scattering force. Simulations of beam flux at different cooling and repumping laser intensities using the modified scattering force are in agreement with experimental results. Optimizing repumping and cooling intensities enhances the flux by 50%. The influence of phase modulation on both the pushing and cooling lasers is experimentally studied, revealing that the mean velocity of cold atoms can be tuned from 9.5 m/s to 14.6 m/s with a phase-modulated pushing laser. The versatility of this continuous beam source, featuring high flux, controlled velocity, and narrow transverse temperature, renders it valuable for applications in atom interferometers and clocks, ultimately enhancing bandwidth, sensitivity, and signal contrast in these devices.

arXiv:2312.12027•Optics Express•Jan 31, 2024•5 citations

High-Flux Beam Source for Cold, Slow Atoms or Molecules

Stephen Maxwell, Nathan Brahms, Robert deCarvalho +7 more

We demonstrate and characterize a high-flux beam source for cold, slow atoms or molecules. The desired species is vaporized using laser ablation, then cooled by thermalization in a cryogenic cell of buffer gas. The beam is formed by particles exiting a hole in the buffer gas cell. We characterize the properties of the beam (flux, forward velocity, temperature) for both an atom (Na) and a molecule (PbO) under varying buffer gas density, and discuss conditions for optimizing these beam parameters. Our source compares favorably to existing techniques of beam formation, for a variety of applications.

arXiv:physics/0508100•Physical Review Letters•Oct 17, 2005•188 citations

Low velocity intense rubidium beam source from a 3D magneto-optical trap

Xiaojia Wang, Yanying Feng, Hongbo Xue +1 more

We present an experimental set-up for the production of a beam source of cold 87Rb atoms, which is formed from a trapped cold atomic cloud in a three-dimensional (3D) magneto-optical trap (MOT). Via a radiation pressure difference generated by a specially designed leak tunnel along one trapping laser beam, the atoms are pushed out continuously with low velocity and high flux. The beam was measured to have a mean velocity of 12m/s and a longitudinal velocity spread of about 3m/s under nominal experimental conditions, based on the fluorescence and the time of flight (TOF) technologies. And its flux can be tuned by adjusting the MOT parameters from 108 to 109 atoms/s. Especially the beam performance dependence on trapping laser detuning and power is experimentally studied.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 25, 2011•0 citations

A multi-channel tunable source for atomic sensors

Matthew S. Bigelow, Tony Roberts, Shirley McNeil +2 more

We have designed and completed initial testing on a laser source suitable for atomic interferometry from compact, robust, integrated components. Our design is enabled by capitalizing on robust, well-commercialized, low-noise telecom components with high reliability and declining costs which will help to drive the widespread deployment of this system. The key innovation is the combination of current telecom-based fiber laser and modulator technology with periodicallypoled waveguide technology to produce tunable laser light at rubidium D1 and D2 wavelengths (and expandable to other alkalis) using second harmonic generation (SHG). Unlike direct-diode sources, this source is immune to feedback at the Rb line eliminating the need for bulky high-power isolators in the system. In addition, the source has GHz-level frequency agility and in our experiments was found to only be limited by the agility of our RF generator. As a proof-of principle, the source was scanned through the Doppler-broadened Rb D2 absorption line. With this technology, multiple channels can be independently tuned to produce the fields needed for addressing atomic states in atom interferometers and clocks. Thus, this technology could be useful in the development cold-atom inertial sensors and gyroscopes.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 1, 2015•1 citation
This paper has developed and characterized a method to produce a velocity-tunable 87 Rb cold atomic source for atomic interferometry application. Using a high speed fluorescence imaging technology, it reports that the dynamic process of the atomic source formation is observed and the source performances including the flux and the initial velocity are characterized. A tunable atomic source with the initial velocity of 1.4∼2.6 m/s and the atomic source flux of 2 × 10 8 ∼ 6 × 10 9 atoms/s has been obtained with the built experimental setup.
We present the implementation and characterization of a slow, intense, and collimated rubidium atomic source for atom interferometry. The continuous87Rb cold atomic beam is produced by a new compact two-dimensional magneto-optical trap. And it is based on the 2D+MOT design but a much smaller size and a higher flux compared to our original LVIS system. The on-line detecting system developed over a combination of time-of-flight and fluorescence methods is used to optimize the beam parameters. The dependence of the beam flux on detuning and power are investigated in detail respectively, for cooling and pushing laser. The re-pumping laser power influence is also considered. With aError! Reference source not found.10 G/cm magnetic gradient, 3ΓError! Reference source not found. red detuning from resonance for cooling laser and 5ΓError! Reference source not found. red detuning for pushing laser, the obtained cold atomic beam has a high flux of 4.7×109atoms/s Error! Reference source not found. Error! Reference source not found. It has a narrow longitudinal velocity distribution with mean velocity 10 m/s and full width at half maximum (FWHM)Error! Reference source not found.2 m/sError! Reference source not found. The two-photo stimulated Raman transitions both in Doppler-free and Doppler-sensitive modes are first proceeded, and stable Raman-Ramsey fringes are achieved with twon/2 Error! Reference source not found. Raman pulses.
We demonstrate an experimental setup for the production of a beam source of cold 87Rb atoms. The atoms are extracted from a trapped cold atomic cloud in an unbalanced three-dimensional magneto—optical trap. Via a radiation pressure difference generated by a specially designed leak tunnel along one trapping laser beam, the atoms are pushed out continuously with low velocities and a high flux. The most-probable velocity in the beam is varied from 9 m/s to 19 m/s by varying the detuning of the trapping laser beams in the magneto—optical trap and the flux can be tuned up to 4×109 s−1 by increasing the intensity of the trapping beams. We also present a simple model for describing the dependence of the beam performance on the magneto—optical trap trapping laser intensity and the detuning.
We present a cold atomic beam source based on a two-dimensional (2D)+ magneto-optical trap (MOT), capable of generating a continuous cold beam of 87 Rb atoms with a flux up to 4.3 × 10 9 s -1 , a mean velocity of 10.96(2.20) m/s, and a transverse temperature of 16.90(1.56) µK. Investigating the influence of high cooling laser intensity, we observe a significant population loss of atoms to hyperfine-level dark states. To account for this, we employ a multiple hyperfine level model to calculate the cooling efficiency associated with the population in dark states, subsequently modifying the scattering force. Simulations of beam flux at different cooling and repumping laser intensities using the modified scattering force are in agreement with experimental results. Optimizing repumping and cooling intensities enhances the flux by 50%. The influence of phase modulation on both the pushing and cooling lasers is experimentally studied, revealing that the mean velocity of cold atoms can be tuned from 9.5 m/s to 14.6 m/s with a phase-modulated pushing laser. The versatility of this continuous beam source, featuring high flux, controlled velocity, and narrow transverse temperature, renders it valuable for applications in atom interferometers and clocks, ultimately enhancing bandwidth, sensitivity, and signal contrast in these devices.
We demonstrate and characterize a high-flux beam source for cold, slow atoms or molecules. The desired species is vaporized using laser ablation, then cooled by thermalization in a cryogenic cell of buffer gas. The beam is formed by particles exiting a hole in the buffer gas cell. We characterize the properties of the beam (flux, forward velocity, temperature) for both an atom (Na) and a molecule (PbO) under varying buffer gas density, and discuss conditions for optimizing these beam parameters. Our source compares favorably to existing techniques of beam formation, for a variety of applications.
We present an experimental set-up for the production of a beam source of cold 87Rb atoms, which is formed from a trapped cold atomic cloud in a three-dimensional (3D) magneto-optical trap (MOT). Via a radiation pressure difference generated by a specially designed leak tunnel along one trapping laser beam, the atoms are pushed out continuously with low velocity and high flux. The beam was measured to have a mean velocity of 12m/s and a longitudinal velocity spread of about 3m/s under nominal experimental conditions, based on the fluorescence and the time of flight (TOF) technologies. And its flux can be tuned by adjusting the MOT parameters from 108 to 109 atoms/s. Especially the beam performance dependence on trapping laser detuning and power is experimentally studied.
We have designed and completed initial testing on a laser source suitable for atomic interferometry from compact, robust, integrated components. Our design is enabled by capitalizing on robust, well-commercialized, low-noise telecom components with high reliability and declining costs which will help to drive the widespread deployment of this system. The key innovation is the combination of current telecom-based fiber laser and modulator technology with periodicallypoled waveguide technology to produce tunable laser light at rubidium D1 and D2 wavelengths (and expandable to other alkalis) using second harmonic generation (SHG). Unlike direct-diode sources, this source is immune to feedback at the Rb line eliminating the need for bulky high-power isolators in the system. In addition, the source has GHz-level frequency agility and in our experiments was found to only be limited by the agility of our RF generator. As a proof-of principle, the source was scanned through the Doppler-broadened Rb D2 absorption line. With this technology, multiple channels can be independently tuned to produce the fields needed for addressing atomic states in atom interferometers and clocks. Thus, this technology could be useful in the development cold-atom inertial sensors and gyroscopes.