Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Absence of bistable behavior in the optical response of a dimer

Viktor A. Malyshev, H. Glaeske, K.‐H. Feller

Published Aug 1, 1998• 19 citations
Publisher

Abstract

The problem is examined whether a bistable behavior of optical response of a dimer really exists. We carry out an exact treatment of this problem based on the two-molecule density matrix, without its representation in the form of a product of the one-molecule density matrices of each molecule composing the dimer. Our conclusion is that the bistability discussed is an artifact originating from the splitting procedure. A condition for getting the bistable optical response from a linear chain of a large number of monomers is also formulated.

DOI
10.1103/physreva.58.1496

Related papers

Mirrorless optical bistability of linear molecular aggregates

Victor A Malyshev, Pablo Moreno

The bistable response of linear molecular aggregates modeled as linear chains of two-level systems is shown. We carry out analytical and numerical calculations of the aggregate population by means of the system of coupled nonlinear equations for the density matrices of individual molecules. Our conclusion is that bistable behavior of the population results from the dependence of resonance frequency of the aggregate on the number of excited molecules. \textcopyright{} 1996 The American Physical Society.

Physical Review A•Jan 1, 1996•70 citations

Optical bistable response of a linear molecular aggregate

Viktor A. Malyshev, Pablo Moreno

Optical bistable response of a molecular aggregate modeled as a linear chain of two-level molecules is shown. We have found that bistability may exist but bistable response is strongly affected by spatial inhomogeneity of the aggregate population.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 5, 1996•0 citations

Optical bistable response of an open linear Frenkel chain: Exciton-exciton annihilation and boundary effects

Victor A Malyshev, H. Glaeske, K.‐H. Feller

A numerical study of the optical bistable response of an open linear Frenkel chain of three-level molecules is carried out, making use of the one-molecule density-matrix approach. We analyze the joint effect of the presence of boundaries and of the exciton-exciton annihilation on the bistable behavior of a chain. The former is going to destroy such behavior due to the spatial inhomogeneity of the population growing with time. The latter resists a preferable creation of the population at a certain segment of the chain stabilizing the system and, thus, provides the conditions for bistability to be realized.

Physical Review A•Jul 1, 1998•24 citations

Optical response of a nanohybrid: Molecular dimer + metal nanoparticle

Bintoro Siswo Nugroho, Alexander Agustinus Iskandar, Victor A Malyshev +1 more

We study theoretically the optical response of a hybrid system comprised of a dimer coupled to a metal nanoparticle. The intermolecular coupling between molecules J and the dimer-MNP coupling G drive the optical response of the hybrid. We found that, for certain combinations of J and G, optical bistability can occur.

International Congress on Advanced Electromagnetic Materials in Microwaves and Optics•Sep 1, 2013•0 citations

Optical Bistability In Dimer-Monomer Dye Systems

Shammai Speiser, Frank L. Chisena

Optical bistability has been observed in highly concentrated fluorescein dye solutions and in thin (-1 pm) doped polymeric films. At concentrations larger than 10-5 mole/k dye dimers are formed. For fluorescein dye, the dimer-monomer equilibrium constant is 10 -5 mole/ℓ so that most of the dye species are in the dimer form. At 480 nm the dimer absorption cross section is 10-18 cm2/molecule, while that for the dye monomer molecule is 7.6 x 10-17 cm2/molecule. Upon laser excitation dimers dissociate to form monomers thus providing a highly nonlinear laser induced absorption. This high nonlinear absorption coefficient can be utilized for optically bistable response of the dye system. Optical bistability was observed by placing dye solutions or dye thin films inside a Fabry-Perot resonator and exciting it with 480 nm dye laser pulses of 10 ns duration. The effect is more pronounced in 10-4 mole/ℓ fluorescein than in 10-6 mole/k fluorescein in which dimer formation is not that efficient.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 4, 1988•1 citation

Optical bistability in dye molecules

Shammai Speiser, Frank L. Chisena

Optical bistability has been observed in highly concentrated substituted fluorescein dye solution and in thin (∼1 μm) doped polymeric films. For fluorescein, at concentrations larger than 10−5 mol/ℓ dye dimers are formed. The dimer–monomer equilibrium constant is 105 ℓ/mol so that most of the dye species are in the dimer form. At 480 nm the dimer absorption cross section is 10−18 cm2/molecule, while that for the dye monomer molecule is 7.6×10−17 cm2/molecule. Upon laser excitation dimers dissociate to form monomers thus providing a highly nonlinear laser induced absorption. The high nonlinear absorption coefficient can be utilized for optically bistable response of the dye system. Optical bistability was observed by placing dye solutions or dye thin films inside a Fabry–Perot resonator and exciting it with 480 nm dye laser pulses of 10 ns duration. The effect is more pronounced in 10−4 mol/ ℓ fluorescein than in 10−6 mol/ℓ fluorescein in which dimer formation is not that efficient. In disodium fluorescein, eosin Y and erythrosin B no significant dimer formation is observed even at 10−3 mol/ℓ dye concentration. The observed bistability both in solution and in thin films can be explained in terms of recent models for optical bistability in nonlinearly absorbing molecular system.

The Journal of Chemical Physics•Dec 15, 1988•8 citations
The problem is examined whether a bistable behavior of optical response of a dimer really exists. We carry out an exact treatment of this problem based on the two-molecule density matrix, without its representation in the form of a product of the one-molecule density matrices of each molecule composing the dimer. Our conclusion is that the bistability discussed is an artifact originating from the splitting procedure. A condition for getting the bistable optical response from a linear chain of a large number of monomers is also formulated.
The bistable response of linear molecular aggregates modeled as linear chains of two-level systems is shown. We carry out analytical and numerical calculations of the aggregate population by means of the system of coupled nonlinear equations for the density matrices of individual molecules. Our conclusion is that bistable behavior of the population results from the dependence of resonance frequency of the aggregate on the number of excited molecules. \textcopyright{} 1996 The American Physical Society.
A numerical study of the optical bistable response of an open linear Frenkel chain of three-level molecules is carried out, making use of the one-molecule density-matrix approach. We analyze the joint effect of the presence of boundaries and of the exciton-exciton annihilation on the bistable behavior of a chain. The former is going to destroy such behavior due to the spatial inhomogeneity of the population growing with time. The latter resists a preferable creation of the population at a certain segment of the chain stabilizing the system and, thus, provides the conditions for bistability to be realized.
Optical bistability has been observed in highly concentrated fluorescein dye solutions and in thin (-1 pm) doped polymeric films. At concentrations larger than 10-5 mole/k dye dimers are formed. For fluorescein dye, the dimer-monomer equilibrium constant is 10 -5 mole/ℓ so that most of the dye species are in the dimer form. At 480 nm the dimer absorption cross section is 10-18 cm2/molecule, while that for the dye monomer molecule is 7.6 x 10-17 cm2/molecule. Upon laser excitation dimers dissociate to form monomers thus providing a highly nonlinear laser induced absorption. This high nonlinear absorption coefficient can be utilized for optically bistable response of the dye system. Optical bistability was observed by placing dye solutions or dye thin films inside a Fabry-Perot resonator and exciting it with 480 nm dye laser pulses of 10 ns duration. The effect is more pronounced in 10-4 mole/ℓ fluorescein than in 10-6 mole/k fluorescein in which dimer formation is not that efficient.
Optical bistability has been observed in highly concentrated substituted fluorescein dye solution and in thin (∼1 μm) doped polymeric films. For fluorescein, at concentrations larger than 10−5 mol/ℓ dye dimers are formed. The dimer–monomer equilibrium constant is 105 ℓ/mol so that most of the dye species are in the dimer form. At 480 nm the dimer absorption cross section is 10−18 cm2/molecule, while that for the dye monomer molecule is 7.6×10−17 cm2/molecule. Upon laser excitation dimers dissociate to form monomers thus providing a highly nonlinear laser induced absorption. The high nonlinear absorption coefficient can be utilized for optically bistable response of the dye system. Optical bistability was observed by placing dye solutions or dye thin films inside a Fabry–Perot resonator and exciting it with 480 nm dye laser pulses of 10 ns duration. The effect is more pronounced in 10−4 mol/ ℓ fluorescein than in 10−6 mol/ℓ fluorescein in which dimer formation is not that efficient. In disodium fluorescein, eosin Y and erythrosin B no significant dimer formation is observed even at 10−3 mol/ℓ dye concentration. The observed bistability both in solution and in thin films can be explained in terms of recent models for optical bistability in nonlinearly absorbing molecular system.