Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Light shift reduction in atomic clocks

C. Affolderbach, C. Andreeva, S. Cartaleva, Todor S. Karaulanov, G. Mileti, Dimitar G. Slavov

Published Jun 21, 2004• 0 citations
Publisher

Abstract

In this paper we present a detailed description of a method for reduction of the light shift in laser-pumped gas-cell atomic clocks. The method consists in using a multi-frequency optical pumping obtained through frequency modulation of the laser spectrum with precisely controllable parameters. Experimental evidence of a strong reduction of the frequency dependence of the LS in an optical pumping Rb gas-cell clock is demonstrated in a large frequency interval, which is in a very good agreement with the numerical estimations reported.

DOI
10.1117/12.563196

Related papers

Reducing light-shift effects in optically-pumped gas-cell atomic frequency standards

C. Affolderbach, G. Mileti, C. Andreeva +3 more

We investigate a novel method to suppress the light-shift effect in laser-pumped passive rubidium frequency standards. The reduction of the light-shift due to additional frequency components in the pumping light is studied theoretically and compared to experimental results obtained with a frequency-modulated DBR laser diode as a pumping light source. In this way, a reduction of the light shift by a factor of 55 was successfully demonstrated. Complete cancellation of the light shift can be reached with a suitably adjusted modulation index and frequency.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 8, 2004•5 citations

Simple method of light-shift suppression in optical pumping systems

B. H. McGuyer, Yuan‐Yu Jau, W. Happer

We report a simple method to suppress the light shift in optical pumping systems. This method uses only frequency modulation of a radio frequency or microwave source, which is used to excite an atomic resonance, to simultaneously lock the source frequency to the atomic resonance and lock the pumping light frequency to suppress the light shift. We experimentally validate the method in a vapor-cell atomic clock and verify the results through numerical simulation. This technique can be applied to many optical pumping systems that experience light shifts. It is especially useful for atomic frequency standards because it improves long-term performance, reduces the influence of the laser, and requires less equipment than previous methods.

arXiv:1302.4160•Applied Physics Letters•Jun 22, 2009•59 citations

Light shift and laser sidebands in gas-cell atomic clocks using optical pumping and coherent population trapping

Todor S. Karaulanov, C. Andreeva, S. Cartaleva +7 more

Theoretical and experimental investigation of the light shift in optical pumping and coherent population trapping based gas-cell atomic frequency standards is reported. A possibilty for realization of a minimial (possibly zero) light shift configuration is discussed.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 8, 2003•1 citation

Light shift compensation in a Rb gas cell frequency standard with two-laser-pumping

Jinquan Deng

One of the most important physical processes that occurs in Rb frequency standards is the light shift, which depends strongly on the intensity and the optical frequency detuning of the pumping light. This paper presents a method to compensate the light shift by means of two-laser-pumping. The two-laser-pumping schemes will also improve the signal-to-noise ratio since almost all atoms can be pumped to the desired state.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Nov 8, 2002•4 citations

Reducing the light-shift in the diode laser pumped rubidium atomic clock

James C. Camparo

One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Dec 24, 2002•6 citations

A compact, high-performance laser-pumped rubidium atomic frequency standard

C. Affolderbach, G. Mileti, Fabien Droz

The paper presents the realisation of a high-performance vapour-cell atomic frequency standard demonstrator based on laser optical pumping. The development of such devices aims to fully exploit the advantages of using a narrow-band diode laser pump light source instead of the discharge lamps commonly used in Rb gas-cell clocks. These advantages include improved control over the pump light spectrum, higher selectivity of the optical pumping, and increased signal contrast, and thus show the potential for the realisation of Rb atomic clocks with improved short-term frequency stability.

European Quantum Electronics Conference (EQEC)•Jan 18, 2006•1 citation
In this paper we present a detailed description of a method for reduction of the light shift in laser-pumped gas-cell atomic clocks. The method consists in using a multi-frequency optical pumping obtained through frequency modulation of the laser spectrum with precisely controllable parameters. Experimental evidence of a strong reduction of the frequency dependence of the LS in an optical pumping Rb gas-cell clock is demonstrated in a large frequency interval, which is in a very good agreement with the numerical estimations reported.
We investigate a novel method to suppress the light-shift effect in laser-pumped passive rubidium frequency standards. The reduction of the light-shift due to additional frequency components in the pumping light is studied theoretically and compared to experimental results obtained with a frequency-modulated DBR laser diode as a pumping light source. In this way, a reduction of the light shift by a factor of 55 was successfully demonstrated. Complete cancellation of the light shift can be reached with a suitably adjusted modulation index and frequency.
We report a simple method to suppress the light shift in optical pumping systems. This method uses only frequency modulation of a radio frequency or microwave source, which is used to excite an atomic resonance, to simultaneously lock the source frequency to the atomic resonance and lock the pumping light frequency to suppress the light shift. We experimentally validate the method in a vapor-cell atomic clock and verify the results through numerical simulation. This technique can be applied to many optical pumping systems that experience light shifts. It is especially useful for atomic frequency standards because it improves long-term performance, reduces the influence of the laser, and requires less equipment than previous methods.
One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.
The paper presents the realisation of a high-performance vapour-cell atomic frequency standard demonstrator based on laser optical pumping. The development of such devices aims to fully exploit the advantages of using a narrow-band diode laser pump light source instead of the discharge lamps commonly used in Rb gas-cell clocks. These advantages include improved control over the pump light spectrum, higher selectivity of the optical pumping, and increased signal contrast, and thus show the potential for the realisation of Rb atomic clocks with improved short-term frequency stability.