Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Numerical simulation of nonlinear and bistable response in synthetic opal inside a Fabry-Perot

А. М. Гончаренко, George V. Sinitsyn, A. V. Lyakhnovich, Sergey P. Apanasevich

Published Jun 15, 2007• 0 citations
Publisher

Abstract

Optical hysteresis in Fabry-Perot interferometer having intermediate layer of synthetic SiO2 opal which is filled with nonlinear medium is simulated numerically. Bistable behavior and transverse nonlinear dynamics of transmitted and reflected intensity are analyzed.
DOI
10.1117/12.752335

Related papers

Bistable response from synthetic opal photonic crystals: schemes of realization

George V. Sinitsyn, A. V. Lyakhnovich, Sergey P. Apanasevich +5 more

Possible approaches to observe optical bistable behavior of SiO2 opal matrices are discussed. They include mirrorless schemes exploiting transmission oscillations at the stop-band edge or sharp structure impurity resonances and layouts with opal inside Fabry-Perot interferometer.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jun 15, 2007•0 citations

Optical Bistability from Ferroelectric Fabry-Perot Interferometer

Abdel-Baset M.A. Ibrahim, D. R. Tilley, Junaidah Osman

We study the nonlinear optical bistability and multistability of a nonlinear ferroelectric (FE) Fabry-Perot (FP) interferometer assumed coated with partial dielectric mirrors on its interfaces. The FE material is considered to have an intensity-dependent refractive index where the third order nonlinear susceptibility χ ilmn (3) acts like Kerr coefficient. The nonlinear response of the FE medium is modeled by the Landau-Khalatnikov (LK) dynamical equation. Within a single frequency approximation, the nonlinear wave equation is written in terms of polarization P rather than the electric field E as the dependent variable. The resulting nonlinear polarization equation is numerically integrated across the FP film using the fourth order Runge-Kutta method. The behavior of the resulting polarization and transmission as a function of the field input intensity is investigated.

Ferroelectrics•Sep 4, 2007•7 citations

Self-pulsing and transients of a Fabry–Perot interferometer with quadratic nonlinear medium

B. Wedding, Armin Gasch, D. Jäger

The dynamic properties of a Fabry–Perot interferometer filled with a material exhibiting second-order dispersive nonlinearity are studied both theoretically and experimentally. The response of the medium is described by an intensity dependent phase constant as derived from self-action effects. Considering two relaxation times, that of the material and that of the cavity, the basic relations for the stability analysis and for the numerical calculations are obtained. Bistability and self-pulsing effects are predicted. Moreover, the transient behavior is characterized by anomalous switching properties like overshoot and alternate switching. The corresponding experiments performed on a nonlinear transmission line resonator confirm the theoretical results. In a final discussion, the relations to the field of nonlinear optics are outlined.

Journal of Applied Physics•Sep 1, 1983•8 citations

Transformations of transverse field structures in a bistable Fabry — Perot interferometer

Yu. I. Balkareǐ, Евтихов Михаил Григорьевич, Matvey I. Elinson +1 more

A study is reported of the dynamics of mutual transformations of transverse field structures, associated with optical bistability, in a thin wide-aperture Fabry — Perot interferometer filled with a Kerr nonlinear medium.

Quantum Electronics•Jul 31, 1997•2 citations

Bistable transmission by a Fabry—Perot interferometer filled by a medium characterised by active and reactive nonlinearities

Sergey M. Zakharov

A phenomenological approach and the third-order nonlinear optical susceptibility are used in an analysis of the transmission of coherent light through a Fabry—Perot interferometer filled by a medium with active and reactive nonlinearities. The mean-field approximation is used to demonstrate analytically the feasibility of optical bistability. The conditions for appearance of this bistability are discussed.

Quantum Electronics•Jan 31, 1994•2 citations

Signal Processing With A Nonlinear Fabry-Perot

E. Garmire

In this paper we consider the nonlinear Fabry-Perot and its applications to optical signal and image processing. This paper addresses the signal processing aspects of a nonlinear Fabry-Perot interferometer with emphasis on image processing. The device geometry is shown in Figure 1. A thin nonlinear medium, whose refractive index is a function of the light intensity inside the Fabry-Perot is sandwiched between two plane parallel mirrors. The output as a function of input is shown in Fig. 2, for two different values of the difference between the Fabry-Perot low intensity resonance and the incident wavelength. The bistable curve in 2a is the origin of the term optical bistability and makes possible an optical memory, in which the output is a function of the history of the device. The Figure 2b represents a typical nonlinear transfer curve which may be used for signal processing. It can be seen that small changes in the input intensity Ic make large changes in the output intensity.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 29, 1981•5 citations
We study the nonlinear optical bistability and multistability of a nonlinear ferroelectric (FE) Fabry-Perot (FP) interferometer assumed coated with partial dielectric mirrors on its interfaces. The FE material is considered to have an intensity-dependent refractive index where the third order nonlinear susceptibility χ ilmn (3) acts like Kerr coefficient. The nonlinear response of the FE medium is modeled by the Landau-Khalatnikov (LK) dynamical equation. Within a single frequency approximation, the nonlinear wave equation is written in terms of polarization P rather than the electric field E as the dependent variable. The resulting nonlinear polarization equation is numerically integrated across the FP film using the fourth order Runge-Kutta method. The behavior of the resulting polarization and transmission as a function of the field input intensity is investigated.
The dynamic properties of a Fabry–Perot interferometer filled with a material exhibiting second-order dispersive nonlinearity are studied both theoretically and experimentally. The response of the medium is described by an intensity dependent phase constant as derived from self-action effects. Considering two relaxation times, that of the material and that of the cavity, the basic relations for the stability analysis and for the numerical calculations are obtained. Bistability and self-pulsing effects are predicted. Moreover, the transient behavior is characterized by anomalous switching properties like overshoot and alternate switching. The corresponding experiments performed on a nonlinear transmission line resonator confirm the theoretical results. In a final discussion, the relations to the field of nonlinear optics are outlined.
In this paper we consider the nonlinear Fabry-Perot and its applications to optical signal and image processing. This paper addresses the signal processing aspects of a nonlinear Fabry-Perot interferometer with emphasis on image processing. The device geometry is shown in Figure 1. A thin nonlinear medium, whose refractive index is a function of the light intensity inside the Fabry-Perot is sandwiched between two plane parallel mirrors. The output as a function of input is shown in Fig. 2, for two different values of the difference between the Fabry-Perot low intensity resonance and the incident wavelength. The bistable curve in 2a is the origin of the term optical bistability and makes possible an optical memory, in which the output is a function of the history of the device. The Figure 2b represents a typical nonlinear transfer curve which may be used for signal processing. It can be seen that small changes in the input intensity Ic make large changes in the output intensity.