Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics B

Nonlinear spectroscopy with a vertical-cavity surface-emitting laser (VCSEL)

C. Affolderbach, A. Nagel, Svenja A. Knappe, Christian Jung, Dieter Wiedenmann, R. Wynands

Published Mar 1, 2000• 88 citations
Publisher
DOI
10.1007/s003400050066

Related papers

Nonlinear Spectroscopy

Wolfgang Demtröder

Springer eBooks•Jan 1, 2015•4 citations

Reducing PM-to-AM Noise Conversion in Atomic Vapors

Kaitlin Harpenau, Nathaniel Ristoff, James C. Camparo

Laser phase noise (PM) to transmitted intensity noise (AM) conversion is a fundamental aspect of the field/matter interaction, and a major noise process that limits the frequency stability of next-generation atomic clocks. It arises from the absorption cross section’s dependence on laser phase and is especially pernicious for vertical-cavity surface-emitting lasers (VCSELs) given their relatively broad singlemode linewidths (e.g., 40 MHz). This is unfortunate, since VCSELs (with their very low operating power and low probability for mode hops) are otherwise ideal for quantum devices. Here, we demonstrate that atomic spectroscopy with N VCSELs reduces the total PM-to-AM noise by a factor of ~N1/2. Consequently, atomic clocks with (for example) five VCSELs would have a signal-to-noise ratio (SNR5) approximately 120% higher than the same device operating with one VCSEL (SNR1) at the same total power: SNR5/SNR1≌ 2.2.

IEEE Open Journal of Ultrasonics Ferroelectrics and Frequency Control•Jan 1, 2026•0 citations

Nonlinear Spectroscopy

Wolfgang Demtröder

Laser Spectroscopy•Jan 1, 1996•4 citations

Quantum noise and polarization properties of vertical-cavity surface-emitting lasers

Jean-Luc C. Vey, Christian Degen, Karsten Auen +1 more

We present theoretical and experimental results on the quantum noise performances of vertical-cavity-surface-emitting-lasers (VCSELs). Using a semiclassical laser noise approach, we demonstrate that the ratio $M=\overline{S}/\overline{P}$ of the powers in the two polarization modes of the laser is one of the essential parameters governing the VCSELs quantum noise behavior. The generation of amplitude squeezed states of light is only possible for two well-selected cases which are the ideal two-polarization-mode laser $(M\ensuremath{\approx}1)$ and the ideal single-polarization-mode laser $(M\ensuremath{\approx}0),$ respectively. Furthermore, we show that gain suppression, as well as other relevant semiconductor parameters, have also to be taken into account to model realistically the VCSEL's quantum noise. These theoretical investigations are very well supported by our experimental results. We demonstrate experimentally that indeed there exists a direct link between the parameter M and the shot noise normalized amplitude noise. In a two-polarization-mode laser as, e.g., represented by a large diameter air-post VCSEL, squeezed states could not be generated because of insufficiently low values of M even though a strong anticorrelation between the two modes exists. With a single-polarization-mode laser, as realized with small diameter oxide confined VCSELs, we have been able to demonstrate the generation of single-mode squeezed light with a VCSEL. A squeezing level of 0.9 dB has been measured, which with the detection efficiency corrected, results in 1.3 dB at the VCSEL upper facet.

Physical Review A•Oct 1, 1999•30 citations

Nonlinear Spectroscopy

Laser Spectroscopy•Jul 22, 2008•2 citations

Experimental Demonstration of Multi-Bit Optical Buffer Memory Using 1.55-$\mu{\hbox {m}}$ Polarization Bistable Vertical-Cavity Surface-Emitting Lasers

Takeo Katayama, Tomohiro Ooi, Hitoshi Kawaguchi

We demonstrate a novel all-optical buffer memory using 1.55-μm polarization bistable vertical-cavity surface-emitting lasers (VCSELs). A one-bit data is stored as one of two orthogonal polarization states of a VCSEL in this memory. The polarization state is transferred from the VCSEL to another VCSEL which is optically connected in cascade as a shift register. A 4-bit optical buffer memory is constructed using two sets of the shift-register memory connected in parallel. These results show the technical feasibility of multi-bit optical buffer memory.

IEEE Journal of Quantum Electronics•Nov 1, 2009•75 citations
Laser phase noise (PM) to transmitted intensity noise (AM) conversion is a fundamental aspect of the field/matter interaction, and a major noise process that limits the frequency stability of next-generation atomic clocks. It arises from the absorption cross section’s dependence on laser phase and is especially pernicious for vertical-cavity surface-emitting lasers (VCSELs) given their relatively broad singlemode linewidths (e.g., 40 MHz). This is unfortunate, since VCSELs (with their very low operating power and low probability for mode hops) are otherwise ideal for quantum devices. Here, we demonstrate that atomic spectroscopy with N VCSELs reduces the total PM-to-AM noise by a factor of ~N1/2. Consequently, atomic clocks with (for example) five VCSELs would have a signal-to-noise ratio (SNR5) approximately 120% higher than the same device operating with one VCSEL (SNR1) at the same total power: SNR5/SNR1≌ 2.2.
We present theoretical and experimental results on the quantum noise performances of vertical-cavity-surface-emitting-lasers (VCSELs). Using a semiclassical laser noise approach, we demonstrate that the ratio M=S‾/P‾M=\overline{S}/\overline{P}M=S/P of the powers in the two polarization modes of the laser is one of the essential parameters governing the VCSELs quantum noise behavior. The generation of amplitude squeezed states of light is only possible for two well-selected cases which are the ideal two-polarization-mode laser $(M\ensuremath{\approx}1)$ and the ideal single-polarization-mode laser $(M\ensuremath{\approx}0),$ respectively. Furthermore, we show that gain suppression, as well as other relevant semiconductor parameters, have also to be taken into account to model realistically the VCSEL's quantum noise. These theoretical investigations are very well supported by our experimental results. We demonstrate experimentally that indeed there exists a direct link between the parameter M and the shot noise normalized amplitude noise. In a two-polarization-mode laser as, e.g., represented by a large diameter air-post VCSEL, squeezed states could not be generated because of insufficiently low values of M even though a strong anticorrelation between the two modes exists. With a single-polarization-mode laser, as realized with small diameter oxide confined VCSELs, we have been able to demonstrate the generation of single-mode squeezed light with a VCSEL. A squeezing level of 0.9 dB has been measured, which with the detection efficiency corrected, results in 1.3 dB at the VCSEL upper facet.
Experimental Demonstration of Multi-Bit Optical Buffer Memory Using 1.55-μm\mu{\hbox {m}}μm Polarization Bistable Vertical-Cavity Surface-Emitting Lasers
We demonstrate a novel all-optical buffer memory using 1.55-μm polarization bistable vertical-cavity surface-emitting lasers (VCSELs). A one-bit data is stored as one of two orthogonal polarization states of a VCSEL in this memory. The polarization state is transferred from the VCSEL to another VCSEL which is optically connected in cascade as a shift register. A 4-bit optical buffer memory is constructed using two sets of the shift-register memory connected in parallel. These results show the technical feasibility of multi-bit optical buffer memory.