Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physica C Superconductivity

Control of return current flows in the single-flux-quantum circuits using positive/negative bias supply lines

Masamitsu Tanaka, Hiroyuki Akaike, Akira Fujimaki

Published Jun 1, 2009• 10 citations
Publisher
DOI
10.1016/j.physc.2009.05.040

Related papers

Design and evaluation of single flux quantum circuits using local flux bias

Shunta Asada, Yuki Yamanashi, Nobuyuki Yoshikawa

The Japan Society of Applied Physics•Jan 25, 2019•0 citations

Improvement of Operation Speed of LR-Biased Low-Power Single-Flux Quantum Circuits by Introduction of Dynamic Resetting of Bias Currents

Ryuta Tsutsumi, Koji Sato, Yuki Yamanashi +1 more

We propose a new inductive- and resistive- (LR) biased low-power single-flux quantum (SFQ) circuit that has a dynamic resetting mechanism of the bias current. Because the bias current returns to the initial state rapidly by switching of a Josephson junction in the bias circuit after circuit operation, the operating frequency of the LR-biased SFQ circuit can be improved. We simulated a Josephson transmission line (JTL) that employs the proposed biasing scheme and evaluated the bias current recovery time. Circuit simulation results show that the bias current recovery time of the proposed circuit is improved by 10-20% compared to that of the conventional LR-biased JTL. We have designed and measured a 10-stage JTL and an 8-bit concurrent-flow shift register (SR) with the proposed biasing scheme. We have experimentally demonstrated operation of the JTL with the bias margin of ±29.4% at the operating frequency of up to 70.4 GHz and operation of the 8-bit SR up to 12.3 GHz by the on-chip high-speed test.

IEEE Transactions on Applied Superconductivity•Aug 10, 2016•3 citations

Flux flow amplifiers and logic operating at millimeter wave frequencies

J. Martens, T. E. Zipperian, VINCENT M. HIETALA +4 more

Superconducting flux flow transistors (SFFTs) have recently been used in a W-band amplifier operating from 91 to 98 GHz and in an invertor configured as an oscillator operating at 86 GHz. These SFFTs consist of three weakened YBaCuO links in parallel. The links are about 1- mu m wide, 3- mu m long, and 20-nm thick (relative to an electrode thickness of about 200 nm). The links are biased above their local critical field so that vortices flow through the links in accordance with the Lorentz-type force supplied by the bias. The 'gate' is a control line located proximate to the link system and supplies a local magnetic field. Above a critical current, flux flow begins and the device enters the active region characterized by a transresistive response to control current and a finite output resistance. A flux flow invertor circuit can consist of 2 SFFTs: both devices are in parallel with the current bias and the input is a control current to one device.

IEEE Transactions on Electron Devices•Jan 1, 1992•0 citations

A new optimization procedure for single flux quantum circuits

N Mori, A. Akahori, Tomoyuki Sato +3 more

Physica C Superconductivity•Aug 1, 2001•54 citations

Investigation to Speed Up Single-flux-quantum Circuits by Applying Higher Bias Voltage

Tanaka Masamitsu, Akaike Hiroyuki, Fujimaki Akira +4 more

IEICE Technical Report; IEICE Tech. Rep.•Jul 15, 2010•0 citations

Effects of a DC-Power Layer Under a Ground Plane in SFQ Circuits

Hiroyuki Akaike, Akira Fujimaki, T. Satoh +4 more

Large-scale SFQ integrated circuits require a large amount of dc-bias current. The magnetic fields induced by the dc-bias currents and the return currents flowing in a ground plane have a great influence on the performance of SFQ circuits. As an approach to reduce the influence, the dc-power (DCP) layer placed under a ground plane is newly introduced in SRL advanced Nb process. We have experimentally evaluated the effects of the DCP layer using SQUIDs and large-scale Josephson transmission line (JTL) circuits with more than 10,000 junctions. The SQUIDs showed that there was small magnetic flux coupling between the DCP lines and themselves and that the coupled flux was enhanced by the return current. The coupled flux decreased with increasing line width of the DCP lines and with increasing distance from the centerlines of them. In the large-scale JTL tests, the cells with DCP patterns showed wider operating margins than the CONNECT OPEN cells with partial magnetic shielding of bias current lines. The test results also showed that a line shape along the periphery of a cell was more effective than a plane shape within a cell as a DCP layer pattern for bias current feeds.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•15 citations
We propose a new inductive- and resistive- (LR) biased low-power single-flux quantum (SFQ) circuit that has a dynamic resetting mechanism of the bias current. Because the bias current returns to the initial state rapidly by switching of a Josephson junction in the bias circuit after circuit operation, the operating frequency of the LR-biased SFQ circuit can be improved. We simulated a Josephson transmission line (JTL) that employs the proposed biasing scheme and evaluated the bias current recovery time. Circuit simulation results show that the bias current recovery time of the proposed circuit is improved by 10-20% compared to that of the conventional LR-biased JTL. We have designed and measured a 10-stage JTL and an 8-bit concurrent-flow shift register (SR) with the proposed biasing scheme. We have experimentally demonstrated operation of the JTL with the bias margin of ±29.4% at the operating frequency of up to 70.4 GHz and operation of the 8-bit SR up to 12.3 GHz by the on-chip high-speed test.
Superconducting flux flow transistors (SFFTs) have recently been used in a W-band amplifier operating from 91 to 98 GHz and in an invertor configured as an oscillator operating at 86 GHz. These SFFTs consist of three weakened YBaCuO links in parallel. The links are about 1- mu m wide, 3- mu m long, and 20-nm thick (relative to an electrode thickness of about 200 nm). The links are biased above their local critical field so that vortices flow through the links in accordance with the Lorentz-type force supplied by the bias. The 'gate' is a control line located proximate to the link system and supplies a local magnetic field. Above a critical current, flux flow begins and the device enters the active region characterized by a transresistive response to control current and a finite output resistance. A flux flow invertor circuit can consist of 2 SFFTs: both devices are in parallel with the current bias and the input is a control current to one device.
Large-scale SFQ integrated circuits require a large amount of dc-bias current. The magnetic fields induced by the dc-bias currents and the return currents flowing in a ground plane have a great influence on the performance of SFQ circuits. As an approach to reduce the influence, the dc-power (DCP) layer placed under a ground plane is newly introduced in SRL advanced Nb process. We have experimentally evaluated the effects of the DCP layer using SQUIDs and large-scale Josephson transmission line (JTL) circuits with more than 10,000 junctions. The SQUIDs showed that there was small magnetic flux coupling between the DCP lines and themselves and that the coupled flux was enhanced by the return current. The coupled flux decreased with increasing line width of the DCP lines and with increasing distance from the centerlines of them. In the large-scale JTL tests, the cells with DCP patterns showed wider operating margins than the CONNECT OPEN cells with partial magnetic shielding of bias current lines. The test results also showed that a line shape along the periphery of a cell was more effective than a plane shape within a cell as a DCP layer pattern for bias current feeds.