Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Erbium-Based Photonic Flip-Flop Memories: Model and Experimental Validation

Luca Potì

Published Mar 12, 2008• 6 citations
Publisher

Abstract

Operating principle for a flip-flop memory cell based on erbium-doped devices is presented. A complete model for memory dynamics is introduced taking into account, at the same time, for memory writing, reading, and erasing. Simple equations are found relating writing, spontaneous and stimulated erasing times to device physical parameters, signals wavelength and power. In principle, for example, increasing writing and erasing energies at the appropriate wavelength it is possible to dramatically reduce transition times. Extinction ratio (ER) is also determined as a function of host medium, and signals properties. An optimization technique is proposed for erasing signal design in order to guarantee maximum ER. Numerical example are provided for Er and Er-Yb doped fibers whose doping ion density is rho = 1.1413middot1024ions/m3, and 2.0 middot1025ions/m3, respectively. Finally, an experimental demonstration giving an Er higher than 5 and 16 dB for the two fibers, respectively, is provided and discussed.

DOI
10.1109/jqe.2007.914297

Related papers

Erbium–Ytterbium-Doped Fiber-Based Optical Flip-Flop

Antonio Malacarne, Antonella Bogoni, Luca Potì

Erbium-ytterbium-doped fiber absorption and fluorescence are exploited to realize an optical bistable device. An all-optical flip-flop with 10-ns transition time, 18.48-nJ set, and 19.82-nJ reset energies, is experimentally demonstrated. The possibility to reach an extinction ratio of more than 8 dB is demonstrated as well

IEEE Photonics Technology Letters•Jun 1, 2007•17 citations

An optical memory cell based on erbium-doped fiber

Filippo Ponzini, Nicola Andriolli, P. Castoldi +3 more

The optical packet switching (OPS) paradigm, where optical packets flow in the network within the optical layer, has the potential to solve the mismatch between the ever increasing link transmission capacity and the node switching capacity, limited by electronics constraints. Anyway, to make this solution feasible and cost-effective, some technological issues must be faced. In particular OPS network nodes, in analogy with current electronic packet network nodes, require some buffering capability to store the optical packets. Since optical random access memories (RAM) are not available, current solutions exploit fiber delay lines (FDL), whose drawbacks are the fixed and finite memorization time and the sequential access. In this paper we propose a novel approach for optical memories, which exploits erbium-doped fiber fluorescence. In particular, an erbium-doped fiber span serves as a one-bit all-optical memory cell associating the bit 1 to the fiber transparency state induced by a strong writing signal, and the bit 0 to the fiber absorption state without excitation. The memory state can be probed injecting a low power reading signal in the fiber span: if it reaches the output port the stored bit is 1, if it is completely absorbed the stored bit is 0. The advantages of this architecture are a long memorization time (up to millisecond range) and the possibility to read the cell at any time (rather than at fixed instants, as happens with FDL). If the memory needs to be reset, a proper erasing signal is sent to speed up the memory cleaning. Experimental results have shown the feasibility of the proposed approach: a one-bit optical memory cell with 2.5 ms refresh time, 752 /spl mu/J writing energy, 316 /spl mu/J erasing energy, and contrast ratio up to 21 dB is experimentally demonstrated.

IEEE/LEOS Workshop on Fibres and Optical Passive Components (WFOPC)•Jul 13, 2005•4 citations

One-bit all-optical memory

Filippo Ponzini

Erbium-doped fiber properties are exploited to store energy. An all-optical memory cell with 2.5 ms refresh time, 752 μJ writing energy, 316 pJ erasing energy, and contrast ratio up to 21 dB is experimentally demonstrated. (2 pages)

European Conference on Optical Communication•Jan 1, 2005•5 citations

Passive Fiber Ring Flip-Flop Memory Based On Polarization Dynamics

Jorge García-Mateos, Fernando Canal, Marc Haelterman

Passive fiber ring resonators synchronously pumped by cw trains of ultrashort pulses are shown to exhibit polarization symmetry breaking. Application of this feature to all-optical storage is considered. The proposed storage device operates in the flip-flop mode which makes possible all-optical writing and erasing operations on individual bits. Numerical simulations suggest that a storage capacity of the order of thousand bits could be attainable at bit rates of hundreds of Gb/s with a maximum information processing rate of several Gb/s

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jan 1, 1996•0 citations

Optical memory effect in Si:Er

M. Forcales, T. Gregorkiewicz

In spite of a small and indirect bandgap, silicon features properties that are potentially very attractive for optical applications. The unsurpassed level of impurity control leads to suppression of nonradiative recombination paths and provides for a very long minority carrier lifetime. Up to the present, observation of an optical memory effect has not been reported for crystalline silicon (c-Si). In contrast, it has been observed in GaAs and GaN. In this study, we have used c-Si doped with erbium (Er) ions, since the trivalent Er3+ ion emits at a wavelength of 1.54 μm that is suitable for telecommunication applications. In a two-color experiment, utilizing a Nd:YAG pulse excitation as a writing beam and a free-electron laser (FEL) as a reading beam, we revealed that Si exhibits optical memory and afterglow effects at low temperatures T<50 K. Both effects are, in fact, manifestations of the properties of Si itself, conveniently revealed by the optical dopant. Detailed investigations of the FEL-induced emission at 1.54 μm show that this excitation mechanism is governed by the release of a single type of charge carrier. This implies that hole and electron capture events necessary for the Er excitation could, in principle, be separated in time. Therefore it appears possible to combine optical and electrical write/read procedures for the reported memory effect.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jun 30, 2003•0 citations

An Optical Flip-Flop Based on Erbium-Ytterbium Doped Fibre

Antonio Malacarne, Antonella Bogoni, Luca Potì

Erbium-Ytterbium doped fibre absorption and fluorescence are exploited to realize an optical bistable device. An all-optical flip-flop with 10 ns transition time, 18.48 nJ set and 19.82 nJ reset energies, is experimentally demonstrated.

European Conference on Optical Communication•Sep 1, 2006•8 citations
Operating principle for a flip-flop memory cell based on erbium-doped devices is presented. A complete model for memory dynamics is introduced taking into account, at the same time, for memory writing, reading, and erasing. Simple equations are found relating writing, spontaneous and stimulated erasing times to device physical parameters, signals wavelength and power. In principle, for example, increasing writing and erasing energies at the appropriate wavelength it is possible to dramatically reduce transition times. Extinction ratio (ER) is also determined as a function of host medium, and signals properties. An optimization technique is proposed for erasing signal design in order to guarantee maximum ER. Numerical example are provided for Er and Er-Yb doped fibers whose doping ion density is rho = 1.1413middot1024ions/m3, and 2.0 middot1025ions/m3, respectively. Finally, an experimental demonstration giving an Er higher than 5 and 16 dB for the two fibers, respectively, is provided and discussed.
The optical packet switching (OPS) paradigm, where optical packets flow in the network within the optical layer, has the potential to solve the mismatch between the ever increasing link transmission capacity and the node switching capacity, limited by electronics constraints. Anyway, to make this solution feasible and cost-effective, some technological issues must be faced. In particular OPS network nodes, in analogy with current electronic packet network nodes, require some buffering capability to store the optical packets. Since optical random access memories (RAM) are not available, current solutions exploit fiber delay lines (FDL), whose drawbacks are the fixed and finite memorization time and the sequential access. In this paper we propose a novel approach for optical memories, which exploits erbium-doped fiber fluorescence. In particular, an erbium-doped fiber span serves as a one-bit all-optical memory cell associating the bit 1 to the fiber transparency state induced by a strong writing signal, and the bit 0 to the fiber absorption state without excitation. The memory state can be probed injecting a low power reading signal in the fiber span: if it reaches the output port the stored bit is 1, if it is completely absorbed the stored bit is 0. The advantages of this architecture are a long memorization time (up to millisecond range) and the possibility to read the cell at any time (rather than at fixed instants, as happens with FDL). If the memory needs to be reset, a proper erasing signal is sent to speed up the memory cleaning. Experimental results have shown the feasibility of the proposed approach: a one-bit optical memory cell with 2.5 ms refresh time, 752 /spl mu/J writing energy, 316 /spl mu/J erasing energy, and contrast ratio up to 21 dB is experimentally demonstrated.
Passive fiber ring resonators synchronously pumped by cw trains of ultrashort pulses are shown to exhibit polarization symmetry breaking. Application of this feature to all-optical storage is considered. The proposed storage device operates in the flip-flop mode which makes possible all-optical writing and erasing operations on individual bits. Numerical simulations suggest that a storage capacity of the order of thousand bits could be attainable at bit rates of hundreds of Gb/s with a maximum information processing rate of several Gb/s
In spite of a small and indirect bandgap, silicon features properties that are potentially very attractive for optical applications. The unsurpassed level of impurity control leads to suppression of nonradiative recombination paths and provides for a very long minority carrier lifetime. Up to the present, observation of an optical memory effect has not been reported for crystalline silicon (c-Si). In contrast, it has been observed in GaAs and GaN. In this study, we have used c-Si doped with erbium (Er) ions, since the trivalent Er3+ ion emits at a wavelength of 1.54 μm that is suitable for telecommunication applications. In a two-color experiment, utilizing a Nd:YAG pulse excitation as a writing beam and a free-electron laser (FEL) as a reading beam, we revealed that Si exhibits optical memory and afterglow effects at low temperatures T<50 K. Both effects are, in fact, manifestations of the properties of Si itself, conveniently revealed by the optical dopant. Detailed investigations of the FEL-induced emission at 1.54 μm show that this excitation mechanism is governed by the release of a single type of charge carrier. This implies that hole and electron capture events necessary for the Er excitation could, in principle, be separated in time. Therefore it appears possible to combine optical and electrical write/read procedures for the reported memory effect.