Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Data-driven self-timed RSFQ digital integrated circuit and system

Z.J. Deng, Nobuyuki Yoshikawa, Stephen R. Whiteley, T. Van Duzer

Published Jun 1, 1997• 104 citations
Publisher

Abstract

A novel asynchronous timing scheme, data-driven self-timing (DDST) is proposed and implemented in Rapid Single-Flux-Quantum (RSFQ) superconductive integrated circuits. In this asynchronous approach, the timing signals are generated from the data and no global clock is needed to drive the RSFQ circuit and system. The essence of the self-timing scheme is to localize the system timing in order to avoid the overhead of global clock distribution, and to minimize the timing uncertainty. The DDST scheme has been applied to the design of a shift register, a demultiplexor, and a self-timed high speed digital test system. In this paper, test results of a 4-bit DDST shift register and a high speed on-chip clock generator will be presented to demonstrate the successful DDST operation of RSFQ integrated circuits at a rate of 20 Gb/s.

DOI
10.1109/77.622205

Related papers

riven S~~f-Timed RSFQ Digital Integrate

Z.J. Deng, Nobuyuki Yoshikawa, Stephen R. Whiteley +1 more

A~~t~a~~ --- A novel asynchronous timing scheme, ata-driven self-timing (DDST) is proposed and imple-Flux-Quantum (RSFQ) superircuits. In this asynchronous als are generated from the data ded to drive the RSFQ circuit the self-timing scheme is to g in order to avoid the overhead ion, and to minimize the timing scheme has been applied to the register, a demultiplexor, and a selfst system. In this paper, test register and a high speed onerator will be presented to demonstrate the ST operation of RSFQ integrated circuits at a rate of 20 Gbk.

•Jan 1, 1997•0 citations

Simulation and 18 Gb/s testing of a data-driven self-timed RSFQ demultiplexer

Nobuyuki Yoshikawa, Z.J. Deng, Stephen R. Whiteley +1 more

We have developed a data-driven self-timed (DDST) rapid-single-flux-quantum (RSFQ) demultiplexer (demux) for the interface between on-chip high-speed RSFQ circuits and off-chip low-speed circuits. In order to eliminate the timing issue in a synchronous clocking system we employed the DDST architecture, where a clock signal is localized within a 2-bit basic demux module and dual rail lines are used to transfer the timing information between the modules. A larger demux can be produced simply by connecting the 2-bit modules in a tree structure. The DDST demux was designed for 10 Gb/s operation with sufficient dc bias margin using HYPRES 1 kA/cm/sup 2/ Nb process. We have successfully tested operation of the 2-bit demux up to 18 GHz using the DDST on-chip high-speed test system which was developed in our group.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•9 citations

Asynchronous circuits and systems in superconducting RSFQ digital technology

Z.J. Deng, Nobuyuki Yoshikawa, J. Tierno +2 more

Superconductive Rapid Single Flux Quantum (RSFQ) logic and memory, in which ones and zeros are represented by the presence or absence within a timing window of quantized picosecond voltage pulse (/spl int/v(t)dt=h/2e=2.07 mV/spl middot/ps), corresponding to one SFQ, can be integrated into a digital computing system with an operating rate of several tens of GHz, based on the present Nb Josephson junction integrated circuit technology. It is the most promising technology beyond semiconductor transistors for low-power high-end computation. However, as the operating speed of circuits and systems increase, timing uncertainty from fabrication process variations makes global synchronization very hard. In this paper, we present a globally asynchronous, locally synchronous timing methodology for RSFQ digital design, which can solve the global synchronization problem. We also demonstrate the recent experimental results of some asynchronous circuits and systems implemented in RSFQ technology. Several key components such as a self-timed shift register, a self-timed demultiplexor, a Muller-C element, a completion detector, and a clock generator have been designed and tested. High speed operation has been confirmed up to 20 Gb/s for a prototype data buffer system, which consists two self-timed shift registers and an on-chip 5-38 GHz clock generator.

IEEE International Symposium on Asynchronous Circuits and Systems (ASYNC)•Nov 27, 2002•7 citations

Optimised asynchronous self-timing for superconducting RSFQ logic circuits

H.R. Gerber, Coenrad Johann Fourie, Willem Jakobus Perold

Rapid single flux quantum (RSFQ) logic is a digital circuit technology that in recent years has presented itself as an alternative to semiconductors in the application of ultra high speed, very low power applications. The optimal timing of digital circuits operating at hundreds of GHz is still a complex problem for both RSFQ and semiconductor technologies. The fact that most RSFQ gates require a clock signal to function makes this even more complex. Various RSFQ timing schemes have been adapted from semiconductor design methodologies, and some have been designed specifically for RSFQ. Currently, synchronous clocking schemes outperform other schemes, but with the scale of RSFQ circuits ever increasing, the proper use of timing schemes are becoming more crucial. This paper describes a new asynchronous self-timing scheme where the details of clock distribution and clocking are built into the logic gates. Tests were done on the newly developed asynchronous logic gates and an asynchronous full adder was implemented and tested

IEEE AFRICON•Apr 6, 2005•2 citations

Optimised asynchronous timing for superconductive digital circuits

H.R. Gerber, Coenrad Johann Fourie, Willem Jakobus Perold

Rapid Single Flux Quantum (RSFQ) logic is a digital circuit technology that in recent years has presented itself as an alternative to semiconductors in the application of ultra high speed, very low power applications. The optimal timing of digital circuits operating at hundreds of Gigahertz is still a complex problem for both RSFQ and semiconductor technologies. The fact that most RSFQ gates require a clock signal to function makes this even more complex. Various RSFQ liming schemes have been adapted from semiconductor design methodologies, and some have been designed specifically for RSFQ. Currently, synchronous clocking schemes outperform other schemes, but with the scale of RSFQ circuits ever increasing, the proper use of timing schemes are becoming more crucial. This paper describes a new asynchronous self-timing scheme where the details of clock distribution and clocking are built into the logic gates. Tests were done on the newly developed asynchronous logic-gales and a asynchronous full adder was implemented and tested.

SAIEE Africa Research Journal•Sep 1, 2006•0 citations

Design and component test of SFQ shift register memories

K. Fujiwara, H. Hoshina, Y. Yamashiro +1 more

The lack of a high-density and high-speed memory is a serious impediment for realization of large-scale RSFQ digital systems. A shift resister memory, which has high throughput and simple circuit structure, is one candidate to overcome this drawback. We show a design framework of the shift register memory, which is usable for the high-speed register files and the main memories of the RSFQ microprocessor. The proposed system consists of an array of shift registers and a packet decoder that switches a high-speed serial data stream into the specified shift register. The target clock frequency is 16 GHz assuming 2.5 kA/cm/sup 2/ Nb standard process. We have estimated the propagation delay and the circuit area of the data-driven self-timed (DDST) packet decoder. Based on this estimation, we have also evaluated the access time and the area of the memory system. Several key components, including the one-to-two packet switch and the one-to-four DDST packet decoder, were implemented and their correct operations were confirmed.

IEEE Transactions on Applied Superconductivity•Jun 1, 2003•14 citations
A novel asynchronous timing scheme, data-driven self-timing (DDST) is proposed and implemented in Rapid Single-Flux-Quantum (RSFQ) superconductive integrated circuits. In this asynchronous approach, the timing signals are generated from the data and no global clock is needed to drive the RSFQ circuit and system. The essence of the self-timing scheme is to localize the system timing in order to avoid the overhead of global clock distribution, and to minimize the timing uncertainty. The DDST scheme has been applied to the design of a shift register, a demultiplexor, and a self-timed high speed digital test system. In this paper, test results of a 4-bit DDST shift register and a high speed on-chip clock generator will be presented to demonstrate the successful DDST operation of RSFQ integrated circuits at a rate of 20 Gb/s.
A~~t~a~~ --- A novel asynchronous timing scheme, ata-driven self-timing (DDST) is proposed and imple-Flux-Quantum (RSFQ) superircuits. In this asynchronous als are generated from the data ded to drive the RSFQ circuit the self-timing scheme is to g in order to avoid the overhead ion, and to minimize the timing scheme has been applied to the register, a demultiplexor, and a selfst system. In this paper, test register and a high speed onerator will be presented to demonstrate the ST operation of RSFQ integrated circuits at a rate of 20 Gbk.
We have developed a data-driven self-timed (DDST) rapid-single-flux-quantum (RSFQ) demultiplexer (demux) for the interface between on-chip high-speed RSFQ circuits and off-chip low-speed circuits. In order to eliminate the timing issue in a synchronous clocking system we employed the DDST architecture, where a clock signal is localized within a 2-bit basic demux module and dual rail lines are used to transfer the timing information between the modules. A larger demux can be produced simply by connecting the 2-bit modules in a tree structure. The DDST demux was designed for 10 Gb/s operation with sufficient dc bias margin using HYPRES 1 kA/cm/sup 2/ Nb process. We have successfully tested operation of the 2-bit demux up to 18 GHz using the DDST on-chip high-speed test system which was developed in our group.
Superconductive Rapid Single Flux Quantum (RSFQ) logic and memory, in which ones and zeros are represented by the presence or absence within a timing window of quantized picosecond voltage pulse (/spl int/v(t)dt=h/2e=2.07 mV/spl middot/ps), corresponding to one SFQ, can be integrated into a digital computing system with an operating rate of several tens of GHz, based on the present Nb Josephson junction integrated circuit technology. It is the most promising technology beyond semiconductor transistors for low-power high-end computation. However, as the operating speed of circuits and systems increase, timing uncertainty from fabrication process variations makes global synchronization very hard. In this paper, we present a globally asynchronous, locally synchronous timing methodology for RSFQ digital design, which can solve the global synchronization problem. We also demonstrate the recent experimental results of some asynchronous circuits and systems implemented in RSFQ technology. Several key components such as a self-timed shift register, a self-timed demultiplexor, a Muller-C element, a completion detector, and a clock generator have been designed and tested. High speed operation has been confirmed up to 20 Gb/s for a prototype data buffer system, which consists two self-timed shift registers and an on-chip 5-38 GHz clock generator.
Rapid single flux quantum (RSFQ) logic is a digital circuit technology that in recent years has presented itself as an alternative to semiconductors in the application of ultra high speed, very low power applications. The optimal timing of digital circuits operating at hundreds of GHz is still a complex problem for both RSFQ and semiconductor technologies. The fact that most RSFQ gates require a clock signal to function makes this even more complex. Various RSFQ timing schemes have been adapted from semiconductor design methodologies, and some have been designed specifically for RSFQ. Currently, synchronous clocking schemes outperform other schemes, but with the scale of RSFQ circuits ever increasing, the proper use of timing schemes are becoming more crucial. This paper describes a new asynchronous self-timing scheme where the details of clock distribution and clocking are built into the logic gates. Tests were done on the newly developed asynchronous logic gates and an asynchronous full adder was implemented and tested
Rapid Single Flux Quantum (RSFQ) logic is a digital circuit technology that in recent years has presented itself as an alternative to semiconductors in the application of ultra high speed, very low power applications. The optimal timing of digital circuits operating at hundreds of Gigahertz is still a complex problem for both RSFQ and semiconductor technologies. The fact that most RSFQ gates require a clock signal to function makes this even more complex. Various RSFQ liming schemes have been adapted from semiconductor design methodologies, and some have been designed specifically for RSFQ. Currently, synchronous clocking schemes outperform other schemes, but with the scale of RSFQ circuits ever increasing, the proper use of timing schemes are becoming more crucial. This paper describes a new asynchronous self-timing scheme where the details of clock distribution and clocking are built into the logic gates. Tests were done on the newly developed asynchronous logic-gales and a asynchronous full adder was implemented and tested.
The lack of a high-density and high-speed memory is a serious impediment for realization of large-scale RSFQ digital systems. A shift resister memory, which has high throughput and simple circuit structure, is one candidate to overcome this drawback. We show a design framework of the shift register memory, which is usable for the high-speed register files and the main memories of the RSFQ microprocessor. The proposed system consists of an array of shift registers and a packet decoder that switches a high-speed serial data stream into the specified shift register. The target clock frequency is 16 GHz assuming 2.5 kA/cm/sup 2/ Nb standard process. We have estimated the propagation delay and the circuit area of the data-driven self-timed (DDST) packet decoder. Based on this estimation, we have also evaluated the access time and the area of the memory system. Several key components, including the one-to-two packet switch and the one-to-four DDST packet decoder, were implemented and their correct operations were confirmed.