Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Multi-gigahertz operation of 3-junction-interferometer-based Josephson latching logic circuits

W. Hioe, M. Hosoya, S. Kominami, Hideyuki Nagaishi, T. Nishino

Published Jun 1, 1997• 2 citations
Publisher

Abstract

Josephson latching logic gates require an ac power supply for correct operation. Owing to the difficulty in fabricating Josephson regulators for large power currents, multi-phase sinusoidal power supply is the preferred method for multi-gigahertz operation. However, the inherently variable ac power reduces device margin for covering process variations. As a result, there exists a strong relationship between circuit size, maximum operating frequency and circuit throughput for a given available margin. The trade-offs between these performance criteria are analyzed for 3-junction-interferometer-based logic gates. Experimental evaluation of the multi-gigahertz operation of small circuits showed that careful design of power supply networks that reduce power supply fluctuations will be needed to maximize performance. Simulation and experimental results are discussed.

DOI
10.1109/77.621743

Related papers

Regulated AC power for Josephson interferometer latching logic circuits

P. Arnett, Dennis Herrell

We have developed an ac power distribution scheme which provides switched regulated power of alternating polarity (no rectification necessary) for Josephson interferometer latching logic circuits. Distribution from the power source relies on a tree system of thin film transformers having single primaries and multiple secondaries to maintain low current levels and small phase skews throughout the system. Power signals are clipped on chip to the desired voltage supply level by series connected large area Josephson junctions ("regulator" junctions) and distributed across the chip by voltage busses. Supply resistors between the regulated voltage bus and the logic circuits define the operating current level. A detailed design is presented for a specific interferometer latching circuit family. We report experimental data on the two major components of the power system design - the regulators and the transformers. A series string of four regulator junctions provides a trapezoidal waveform of 11 mV amplitude at > 66% logic duty cycle (that portion of the machine cycle in which logic operations can be performed). Thin film transformers have their designed inductance (350 pH) and coupling coefficient ( > .90).

IEEE Transactions on Magnetics•Jan 1, 1979•54 citations

High-speed Josephson processor technology

S. Hasuo, Seigo Kotani, A. Inoue +1 more

High-speed operation of Josephson processors is demonstrated. They are a 4-b microprocessor, a 4-b processor, and an 8-b digital signal processor. Key technologies to realize these circuits are described from the viewpoint of circuit design. The technologies are a high-speed logic gate, named MVTL (modified variable threshold logic), and a three-phase sinusoidal power supply system. The MVTL gate has a large operating margin and high sensitivity. The MVTL gate family consists of OR, AND, 2/3 majority (MJ), and timed inverter (TI). Using these gates a variety of processors have been designed. These processors operate with three-phase power. The waveform is sinusoidal with DC-offset. This power supply system needs no latch and regulator circuit. This makes the processor very simple, and thus results in high-speed operation. To fabricate these processors, niobium junctions are very important, because they are reliable, uniform, controllable, and reproducible. High-speed gates, three-phase power supplies, and niobium junctions are indispensable for high-speed Josephson processors.

IEEE Transactions on Magnetics•Mar 1, 1991•25 citations

High-performance Josephson interferometer latching logic and power supplies

Dennis Herrell, P. Arnett, M. Klein

This paper reviews some recent measuremtns on high‐performance Josephson latching logic, and discusses a compatible ac power scheme which provides good voltage regulation and low clock skew performance for a large computing machine.

AIP conference proceedings•Jan 1, 1978•12 citations

Sub-100 ps experimental Josephson interferometer logic gates

M. Klein, Dennis Herrell

Josephson interferometer logic gates have been operated experimentally with an average logic delay of 55 ps per stage. The gates operated with an AC power supply in a latching mode with a reset capability consistent with a machine cycle time less than 5 ns. OR, AND, and INVERT functions and fanout capability were demonstrated. Dissipation per gate was about 2.0 /spl mu/W.

IEEE Journal of Solid-State Circuits•Oct 1, 1978•44 citations

Current-injection Josephson latch employing a single-flux quantum. I

J. Sone, Toshishige Yamada

A new current-injection Josephson latch employing a single-flux quantum is proposed. It has a master-slave circuit configuration and operates under ac power supply. In the circuit, data are stored as a circulating current in a superconducting loop consisting of a single junction and inductances. A two-junction interferometer gate directly coupled to the loop reads out the stored data. Dual-rail signals are generated from the read-out data by Josephson junctions and resister-coupled Josephson logic gates. The isolation between a master circuit and a slave circuit is realized using high-impedance states in the Josephson junctions. The circuit design and computer-simulation results on the circuit operation are described in this paper.

Journal of Applied Physics•May 1, 1986•2 citations

Damped three-junction interferometers for latching logic

Linda Geppert, J. H. Greiner, Dennis Herrell +1 more

This paper describes the design, fabrication and characterization of damped three-junction interferometers suitable for LSI latching logic. The high speed and low power dissipation of Josephson interferometers make them ideal devices for logic applications. However, their inherent high Q gives rise to resonances which appear as current steps in the quasiparticle curve. If not controlled, these current steps can interfere with the proper operation of logic circuits. Studies have shown that these resonances can be effectively damped by shunting the interferometer inductance with a small resistance. In this work the interferometers were made by placing the interferometer loops parallel to the groundplane and clustering the Josephson junctions together. This minimized the loop inductance associated with the counterelectrode which in turn meant that adequate damping could be achieved with metallurgically compatible short resistors connected only to the base electrode. The resultant structure with two overlying control lines each 2.5μm wide had an area of 0.008mm2. The Josephson junctions were 5μm in diameter. The measured damped resonance characteristics and threshold characteristics (Ig(Vg) and Im(Ic) respectively) of these structures agreed very well with theory.

IEEE Transactions on Magnetics•Jan 1, 1979•24 citations
Josephson latching logic gates require an ac power supply for correct operation. Owing to the difficulty in fabricating Josephson regulators for large power currents, multi-phase sinusoidal power supply is the preferred method for multi-gigahertz operation. However, the inherently variable ac power reduces device margin for covering process variations. As a result, there exists a strong relationship between circuit size, maximum operating frequency and circuit throughput for a given available margin. The trade-offs between these performance criteria are analyzed for 3-junction-interferometer-based logic gates. Experimental evaluation of the multi-gigahertz operation of small circuits showed that careful design of power supply networks that reduce power supply fluctuations will be needed to maximize performance. Simulation and experimental results are discussed.
We have developed an ac power distribution scheme which provides switched regulated power of alternating polarity (no rectification necessary) for Josephson interferometer latching logic circuits. Distribution from the power source relies on a tree system of thin film transformers having single primaries and multiple secondaries to maintain low current levels and small phase skews throughout the system. Power signals are clipped on chip to the desired voltage supply level by series connected large area Josephson junctions ("regulator" junctions) and distributed across the chip by voltage busses. Supply resistors between the regulated voltage bus and the logic circuits define the operating current level. A detailed design is presented for a specific interferometer latching circuit family. We report experimental data on the two major components of the power system design - the regulators and the transformers. A series string of four regulator junctions provides a trapezoidal waveform of 11 mV amplitude at > 66% logic duty cycle (that portion of the machine cycle in which logic operations can be performed). Thin film transformers have their designed inductance (350 pH) and coupling coefficient ( > .90).
High-speed operation of Josephson processors is demonstrated. They are a 4-b microprocessor, a 4-b processor, and an 8-b digital signal processor. Key technologies to realize these circuits are described from the viewpoint of circuit design. The technologies are a high-speed logic gate, named MVTL (modified variable threshold logic), and a three-phase sinusoidal power supply system. The MVTL gate has a large operating margin and high sensitivity. The MVTL gate family consists of OR, AND, 2/3 majority (MJ), and timed inverter (TI). Using these gates a variety of processors have been designed. These processors operate with three-phase power. The waveform is sinusoidal with DC-offset. This power supply system needs no latch and regulator circuit. This makes the processor very simple, and thus results in high-speed operation. To fabricate these processors, niobium junctions are very important, because they are reliable, uniform, controllable, and reproducible. High-speed gates, three-phase power supplies, and niobium junctions are indispensable for high-speed Josephson processors.
A new current-injection Josephson latch employing a single-flux quantum is proposed. It has a master-slave circuit configuration and operates under ac power supply. In the circuit, data are stored as a circulating current in a superconducting loop consisting of a single junction and inductances. A two-junction interferometer gate directly coupled to the loop reads out the stored data. Dual-rail signals are generated from the read-out data by Josephson junctions and resister-coupled Josephson logic gates. The isolation between a master circuit and a slave circuit is realized using high-impedance states in the Josephson junctions. The circuit design and computer-simulation results on the circuit operation are described in this paper.
This paper describes the design, fabrication and characterization of damped three-junction interferometers suitable for LSI latching logic. The high speed and low power dissipation of Josephson interferometers make them ideal devices for logic applications. However, their inherent high Q gives rise to resonances which appear as current steps in the quasiparticle curve. If not controlled, these current steps can interfere with the proper operation of logic circuits. Studies have shown that these resonances can be effectively damped by shunting the interferometer inductance with a small resistance. In this work the interferometers were made by placing the interferometer loops parallel to the groundplane and clustering the Josephson junctions together. This minimized the loop inductance associated with the counterelectrode which in turn meant that adequate damping could be achieved with metallurgically compatible short resistors connected only to the base electrode. The resultant structure with two overlying control lines each 2.5μm wide had an area of 0.008mm2. The Josephson junctions were 5μm in diameter. The measured damped resonance characteristics and threshold characteristics (Ig(Vg) and Im(Ic) respectively) of these structures agreed very well with theory.