Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Microwave Theory and Techniques

Superconducting Tunnel Junctions As Mixers at 115 Ghz

G. J. Dolan, RICHARD A. LINKE, T. C. L. G. Sollner, D. P. Woody, Tom G. Phillips

Published Feb 1, 1981• 32 citations
Publisher

Abstract

Superconducting tunnel junctions have been used as the nonlinear element for mixing at a signal frequency of 115 GHz. The experimental results are compared with predictions of a theoretical analysis based on the quantum theory of mixing of J. R. Tucker. Qualitative agreement is obtained and suggestions are made for quantitative reconciliation. The junctions were small area (/spl equiv/0.4mu m/sup 2/) with normal resistances of 60 to 100 omega and capacitance approximately 20 fF. Measured sensitivity (T/ sup SSB/sub MXR/=62 K, L/sub c/=7.6 dB) implies receiver noise temperatures superior to the best receivers now in use at this frequency.

DOI
10.1109/tmtt.1981.1130300

Related papers

High-frequency limits of superconducting tunnel junction mixers

Dag Winkler, T. Claeson

We have investigated high-frequency limits of superconducting quasiparticle mixers from experiments on Al/Al-oxide-In/Al (or Ag) tunnel junctions, and from calculations based on Tucker’s quantum theory of mixing (QTM). The small superconducting energy gap of Al enabled us to study mixer performance at around the junction gap frequency, fg =(Δ1+Δ2)/h≊87 GHz, of superconductor-insulator-superconductor (SIS) mixers, and at twice the junction gap frequency for S-I-normal metal (SIN) mixers ( fg =Δ1/h) with available millimeter wave sources. Because of the low transition temperature of Al (Tc ≊1.3 K), a dilution refrigerator was used for providing temperatures below 1 K. The best mixer conversion efficiency was obtained for a low-resistance (∼34 Ω) six-junction array SIS mixer operated at f/fg ≊1 (in this case 73 GHz). The coupled single sideband conversion gain (with no image rejection) was −13.8 dB and the available conversion gain was estimated to −8.4 dB. Complicating nonequilibrium phenomena made it difficult to compare the performance of these relatively high-current-density mixers to the QTM. However, good agreement between calculated and corresponding measured conversion efficiencies and dynamic resistance values was obtained for the low-current-density mixers. Noise due to switching between rf-induced Josephson steps and interference from Josephson mixing could be quenched by a magnetic field. Several high-frequency limits are considered in this paper (such as Josephson switching noise, nonequilibrium phenomena, pair breaking, and energy gap limitations). Our results indicate that submillimeter wave SIS mixer receivers are likely to perform well, at least up to their gap frequencies, i.e., the THz region for large gap superconductors. Our QTM calculations showed that conversion gain larger than unity should be possible up to twice the gap frequency. Above this frequency the conversion loss will increase rapidly.

Journal of Applied Physics•Dec 1, 1987•35 citations

Quantum limited quasiparticle mixers at 100 GHz

C. A. Mears, Qing Hu, P. L. Richards +3 more

Accurate measurements of the noise and gain of superconducting-insulating-superconducting (SIS) mixers using small-area (1 mu m/sup 2/) Ta/Ta/sub 2/O/sub 5//Pb/sub 0.9/Bi/sub 0.1/ tunnel junctions were made. The authors measured an added mixer noise of 0.61+or-0.31 quanta at 95.0 GHz, which is within 25% of the quantum limit of 0.5 quanta. Detailed comparison between theoretical predictions of the quantum theory of mixing has been carried out, and noise and gain have been experimentally measured. The shapes of the I-V curves pumped at the upper and lower sideband frequencies were used to deduce values of the embedding admittances at these frequencies. Using these admittances, the mixer noise and gain predicted by quantum theory are in excellent agreement with experiment.

IEEE Transactions on Magnetics•Mar 1, 1991•20 citations

A low noise 410-495 GHz Nb/Al/sub 2/O/sub 3//Nb SIS waveguide mixer

Gert J. de Lange, Cornelia E. Honingh, M. M. T. M. Dierichs +5 more

The noise and gain of a heterodyne waveguide mixer using Nb/Al/sub 2/O/sub 3//Nb superconducting tunnel junctions were measured in the 400-500-GHz frequency range. Three different arrays of two junctions in series are analyzed. The minimum receiver noise temperature is 120 K DSB at 480 GHz, measured with an array having integrated tuning stubs. The authors compare data of the pumped I-V curves with the Werthammer-Tucker theory and demonstrate an excellent agreement at frequencies up to 500 GHz. For an array without integrated tuning stubs. a mixer noise temperature of 90+or-30 K and a DSB mixer gain of -12.5+or-0.6 dB were measured. A comparison of the measured gain versus bias voltage with the quantum theory of mixing shows good qualitative agreement, indicating the applicability of this theory to Nb tunnel junctions up to 500 GHz. The noise temperature of an array with a lower gap voltage is 220 K at 495 GHz. This frequency is 85% of the reduced gap frequency, indicating that Nb superconductor insulator-superconductor (SIS) mixers can be used up at least the gap frequency of 680 GHz.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•13 citations

A Superconducting Tunnel Junction Receiver for 230 GHz

Edmund C. Sutton

The performance of superconducting tunnel junctions as high-frequency receivers is discussed. Low-noise mixing in superconductor insulator-superconductor (SIS) quasi-particle tunnel junctions has been seen for frequencies up to 400 GHz. Such mixers have the significant advantage of small local-oscillator power requirements. A receiver has been constructed which has a single-sideband (SSB) receiver noise temperature of 305 K at 241 GHz.

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 1983•59 citations

Performance of NbN superconductive tunnel junctions as SIS mixers at 205 GHz

William R. McGrath, J. A. Stern, Hamid Javadi +3 more

Small area (<or=1- mu m/sup 2/), high-current-density NbN-MgO-NbN tunnel junctions with I-V characteristics suitable for high-frequency mixers have been fabricated. Mesa-geometry junctions with an area of about 1 mu m/sup 2/ and critical current density of 5-10 kA/cm/sup 2/ are integrated with superconducting microstrip lines designed to resonate out the junction capacitance. Accurate values of junction capacitance and magnetic penetration depth are required for the proper design of the microstrip. A study was made of the mixer gain and noise performance near 205 GHz as a function of the inductance provided by the microstrip line. This has confirmed, at a high millimeter-wave frequency, values of junction capacitance of 85 fF/ mu m/sup 2/ and recently measured values of a magnetic penetration depth of 380 nm. Mixer noise temperatures as low as 134 K at 1.5 K have been obtained for properly tuned junctions. A significant improvement in mixer performance on cooling from 4.2 K to 1.5 K was observed. Edge-geometry junctions with an area of 0.3 mu m/sup 3/ and critical current density of 18-25 kA/cm/sup 2/ have also been fabricated. These junctions give a mixer noise temperature of 145 K at 4.2 K without the use of integrated tuning elements. These are the best results ever achieved for NbN-based SIS mixers.

IEEE Transactions on Magnetics•Mar 1, 1991•27 citations

Low-noise 115-GHz mixing in superconducting oxide-barrier tunnel junctions

G. J. Dolan, Tom G. Phillips, D. P. Woody

Small-area (≲1 μm2) oxide-barrier tunnel junctions have been made of thermally cyclable superconducting Pb alloys for use as high-frequency mixers. A single-sideband mixer noise temperature of <100 K has been achieved at 115 GHz. This result was achieved in the quasiparticle (classical) mixing mode.

Applied Physics Letters•Mar 1, 1979•138 citations
Superconducting tunnel junctions have been used as the nonlinear element for mixing at a signal frequency of 115 GHz. The experimental results are compared with predictions of a theoretical analysis based on the quantum theory of mixing of J. R. Tucker. Qualitative agreement is obtained and suggestions are made for quantitative reconciliation. The junctions were small area (/spl equiv/0.4mu m/sup 2/) with normal resistances of 60 to 100 omega and capacitance approximately 20 fF. Measured sensitivity (T/ sup SSB/sub MXR/=62 K, L/sub c/=7.6 dB) implies receiver noise temperatures superior to the best receivers now in use at this frequency.
We have investigated high-frequency limits of superconducting quasiparticle mixers from experiments on Al/Al-oxide-In/Al (or Ag) tunnel junctions, and from calculations based on Tucker’s quantum theory of mixing (QTM). The small superconducting energy gap of Al enabled us to study mixer performance at around the junction gap frequency, fg =(Δ1+Δ2)/h≊87 GHz, of superconductor-insulator-superconductor (SIS) mixers, and at twice the junction gap frequency for S-I-normal metal (SIN) mixers ( fg =Δ1/h) with available millimeter wave sources. Because of the low transition temperature of Al (Tc ≊1.3 K), a dilution refrigerator was used for providing temperatures below 1 K. The best mixer conversion efficiency was obtained for a low-resistance (∼34 Ω) six-junction array SIS mixer operated at f/fg ≊1 (in this case 73 GHz). The coupled single sideband conversion gain (with no image rejection) was −13.8 dB and the available conversion gain was estimated to −8.4 dB. Complicating nonequilibrium phenomena made it difficult to compare the performance of these relatively high-current-density mixers to the QTM. However, good agreement between calculated and corresponding measured conversion efficiencies and dynamic resistance values was obtained for the low-current-density mixers. Noise due to switching between rf-induced Josephson steps and interference from Josephson mixing could be quenched by a magnetic field. Several high-frequency limits are considered in this paper (such as Josephson switching noise, nonequilibrium phenomena, pair breaking, and energy gap limitations). Our results indicate that submillimeter wave SIS mixer receivers are likely to perform well, at least up to their gap frequencies, i.e., the THz region for large gap superconductors. Our QTM calculations showed that conversion gain larger than unity should be possible up to twice the gap frequency. Above this frequency the conversion loss will increase rapidly.
Accurate measurements of the noise and gain of superconducting-insulating-superconducting (SIS) mixers using small-area (1 mu m/sup 2/) Ta/Ta/sub 2/O/sub 5//Pb/sub 0.9/Bi/sub 0.1/ tunnel junctions were made. The authors measured an added mixer noise of 0.61+or-0.31 quanta at 95.0 GHz, which is within 25% of the quantum limit of 0.5 quanta. Detailed comparison between theoretical predictions of the quantum theory of mixing has been carried out, and noise and gain have been experimentally measured. The shapes of the I-V curves pumped at the upper and lower sideband frequencies were used to deduce values of the embedding admittances at these frequencies. Using these admittances, the mixer noise and gain predicted by quantum theory are in excellent agreement with experiment.
The noise and gain of a heterodyne waveguide mixer using Nb/Al/sub 2/O/sub 3//Nb superconducting tunnel junctions were measured in the 400-500-GHz frequency range. Three different arrays of two junctions in series are analyzed. The minimum receiver noise temperature is 120 K DSB at 480 GHz, measured with an array having integrated tuning stubs. The authors compare data of the pumped I-V curves with the Werthammer-Tucker theory and demonstrate an excellent agreement at frequencies up to 500 GHz. For an array without integrated tuning stubs. a mixer noise temperature of 90+or-30 K and a DSB mixer gain of -12.5+or-0.6 dB were measured. A comparison of the measured gain versus bias voltage with the quantum theory of mixing shows good qualitative agreement, indicating the applicability of this theory to Nb tunnel junctions up to 500 GHz. The noise temperature of an array with a lower gap voltage is 220 K at 495 GHz. This frequency is 85% of the reduced gap frequency, indicating that Nb superconductor insulator-superconductor (SIS) mixers can be used up at least the gap frequency of 680 GHz.>
Small area (<or=1- mu m/sup 2/), high-current-density NbN-MgO-NbN tunnel junctions with I-V characteristics suitable for high-frequency mixers have been fabricated. Mesa-geometry junctions with an area of about 1 mu m/sup 2/ and critical current density of 5-10 kA/cm/sup 2/ are integrated with superconducting microstrip lines designed to resonate out the junction capacitance. Accurate values of junction capacitance and magnetic penetration depth are required for the proper design of the microstrip. A study was made of the mixer gain and noise performance near 205 GHz as a function of the inductance provided by the microstrip line. This has confirmed, at a high millimeter-wave frequency, values of junction capacitance of 85 fF/ mu m/sup 2/ and recently measured values of a magnetic penetration depth of 380 nm. Mixer noise temperatures as low as 134 K at 1.5 K have been obtained for properly tuned junctions. A significant improvement in mixer performance on cooling from 4.2 K to 1.5 K was observed. Edge-geometry junctions with an area of 0.3 mu m/sup 3/ and critical current density of 18-25 kA/cm/sup 2/ have also been fabricated. These junctions give a mixer noise temperature of 145 K at 4.2 K without the use of integrated tuning elements. These are the best results ever achieved for NbN-based SIS mixers.