Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Low Temperature Physics

Noise in the rf SQUID

L. D. Jackel, Robert A. Buhrman

Published May 1, 1975• 119 citations
Publisher
DOI
10.1007/bf00116178

Related papers

Theory of the signal transfer and noise properties of the rf SQUID

G. J. Ehnholm

Journal of Low Temperature Physics•Oct 1, 1977•43 citations

A Numerical Treatment of the rf SQUID: II. Noise Temperature

R. Kleiner, D. Koelle, John L. Clarke

arXiv:cond-mat/0701719•Journal of Low Temperature Physics•Oct 17, 2007•2 citations

A Numerical Treatment of the rf SQUID: I. General Properties and Noise Energy

R. Kleiner, D. Koelle, John L. Clarke

arXiv:cond-mat/0701718•Journal of Low Temperature Physics•Oct 16, 2007•9 citations

Investigation of the origin of the low-frequency noise in liquid nitrogen rf SQUIDs

S.S. Tinchev, Y. Zhang

Physics Letters A•Oct 1, 1990•0 citations

Flicker noise in rf SQUIDs based on high-temperature superconductors

Y. M. Galperin, J. R. Anderson

Technical Physics•May 1, 1993•0 citations

Investigation and reduction of excess low-frequency noise in rf superconducting quantum interference devices

Michael Mück, Christoph Heiden, John L. Clarke

A detailed study has been made of the low-frequency excess noise of rf superconducting quantum interference devices (SQUIDs), fabricated from thin niobium films and operated at 4.2 K, with rf bias frequencies of 0.15, 1.7, and 3 GHz. When the SQUIDs were operated in an open-loop configuration in the absence of low-frequency flux modulation, the demodulated rf voltage exhibited a substantial level 1/f noise, which was essentially independent of the rf bias frequency. As the rf bias frequency was increased, the crossover frequency at which the 1/f noise power was equal to the white noise power moved to higher frequencies, because of the reduction in white noise. On the other hand, when the SQUID was flux modulated at 50 kHz and operated in a flux locked loop, no 1/f noise was observed at frequencies above 0.5 Hz. A detailed description of how the combination of rf bias and flux modulation removes 1/f noise due to critical current fluctuations is given. Thus, the results demonstrate that the 1/f noise observed in these SQUIDs is generated by critical current fluctuations, rather than by the hopping of flux vortices in the niobium films.

Journal of Applied Physics•May 1, 1994•26 citations
A detailed study has been made of the low-frequency excess noise of rf superconducting quantum interference devices (SQUIDs), fabricated from thin niobium films and operated at 4.2 K, with rf bias frequencies of 0.15, 1.7, and 3 GHz. When the SQUIDs were operated in an open-loop configuration in the absence of low-frequency flux modulation, the demodulated rf voltage exhibited a substantial level 1/f noise, which was essentially independent of the rf bias frequency. As the rf bias frequency was increased, the crossover frequency at which the 1/f noise power was equal to the white noise power moved to higher frequencies, because of the reduction in white noise. On the other hand, when the SQUID was flux modulated at 50 kHz and operated in a flux locked loop, no 1/f noise was observed at frequencies above 0.5 Hz. A detailed description of how the combination of rf bias and flux modulation removes 1/f noise due to critical current fluctuations is given. Thus, the results demonstrate that the 1/f noise observed in these SQUIDs is generated by critical current fluctuations, rather than by the hopping of flux vortices in the niobium films.