Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Intracavity coupled-active-resonator-induced dispersion

Yannick Dumeige, Stéphane Trebaol, Patrice Féron

Published Jan 30, 2009• 13 citations
Publisher

Abstract

We have proposed and experimentally demonstrated tunable cavity-linewidth narrowing by means of coupled-active-resonator-induced dispersion. We have theoretically studied the coupling-resonator-induced-dispersion phenomenon in the general case of $N$ coupled resonators and especially the case of two or three resonators. In the case of two resonators we have experimentally shown that the strong dispersion induced by the coupling of resonators can lead to cavity ringdown effect enhancement. In the case of three resonators, we propose a coupling scheme allowing the quality $(Q)$ factor of a critically coupled resonator to be increased and actively modulated by using two additional coupled resonators. We have experimentally tested the feasibility of the proposition by using a model system consisting of ${\mathrm{Er}}^{3+}$-doped fiber coupled resonators. These experimental results demonstrate the possibility of $Q$-factor tailoring by the use of active artificial photonic media.

DOI
10.1103/physreva.79.013832

Related papers

Active coupled resonator delay lines

Yannick Dumeige, Stéphane Trebaol, Patrice Féron

The possibility of slowing down or storing light holds interests in classical or quantum optical communications. Different schemes have been proposed; among them, active resonator-based devices seem to provide a scalable and low loss solution for this purpose. This paper will be devoted to the theoretical and experimental studies of active coupled resonator delay lines. High-quality (Q) factor resonators are strongly dispersive systems which can be used to control the group velocity of light. As it is the case for atomic systems the dispersion properties of these artificial media is dependent on their absorption or optical gain. Moreover by coupling several resonators it is also possible to tailor their transmission or high dispersion orders . For these two reasons, active coupled resonators may be of high interest for optical dispersion or delay lines. In the aim of practical applications, the first step consists in defining an experimental protocol allowing a resonator complete description to be obtained. Cavity ring down spectroscopy method can be adapted to obtain the essential parameters such as gain/absorption and dispersion. The method has been validated using a model system made of Er3+ doped optical fiber resonators and applied to various high-Q whispering gallery mode resonators including resonators under modal coupling. It is possible to find coupling configurations allowing the dispersion of coupled active resonator systems to be tailored by changing the optical losses or gain of each resonator. In particular these systems may be used as tunable transparent delay lines or for dispersion compensation. This last configuration can be used to enhanced or actively control the quality factor of passive cavities. Finally the dynamic control of dispersion or resonance properties via the gain control of active coupled microresonators could find some applications in optical buffering.

•Nov 4, 2009•0 citations

Artificial dispersion of active optical coupled resonator systems

Stéphane Trebaol, Thị Kim Ngân Nguyên, Hervé Tavernier +3 more

We study both theoretically and experimentally the dispersive properties of single or coupled active resonators. In the case of single resonator systems, we present a simple experimental protocol which allows us to obtain in detail its coupling regime and thus their dispersive properties. We show that the active coupled systems offer some degrees of freedom to tailor the high dispersion orders. All the propositions are experimentally tested using a model system made of Er 3 + doped fiber ring resonators. These artificial media could be used as tunable or amplifying compact optical delay lines. We also show that the proposed experimental protocol can be applied to passive whispering gallery mode resonators.

Comptes Rendus Physique•Dec 1, 2009•4 citations

Cavity linewidth narrowing and broadening due to competing linear and nonlinear dispersions

Haibin Wu, Min Xiao

We experimentally demonstrate cavity linewidth control by manipulating dispersion of the intracavity medium. By making use of the dramatic change of Kerr nonlinearity near electromagnetically induced transparency resonance in a three-level atomic system, the cavity transmission linewidth can be greatly modified. As the cavity input intensity increases, the cavity linewidth changes from below to above empty cavity linewidth, corresponding to subluminal and superluminal photon propagation in the cavity, respectively.

Optics Letters•Oct 22, 2007•30 citations

Complete transparency with three active-passive-coupled optical resonators

Xiao-Bo Yan, Liu Yang, Bing He

The phenomena of induced transparency, with the typical examples of electromagnetically induced transparency (EIT) in atomic media and those based on coupled optical resonators, have attracted tremendous interest since their discoveries. Owing to the limitations of the involved physical elements, however, near-100\% transmissions were reported under highly demanding experimental conditions. With a structure of three linearly coupled optical resonators, an active one carrying optical gain and two passive ones simply with dissipation, we demonstrate that a transmitted light field can become completely transparent through the structure, which displays all properties similar to those of EIT. It is due to a destructive interference mechanism that totally eliminates the intracavity field in the dissipative resonator directly coupled to the transmitted field of any feasible power, when the coupling strength of two other resonators is tuned across a point determined by their associated gain and loss rates. This mechanism works for all possible coupling strengths of the dark resonator with the input field and its neighboring resonator, as well as for any available quality factor from its fabrication. The transparency window size and output field intensity can be freely adjusted by tuning two inter-cavity couplings of wide ranges, without modifying the built-in optical gain which can be just slightly stronger than the dissipation of the active resonator.

quant-pharXiv:2601.18937•Jan 28, 2026•0 citations

Measurement of the dispersion induced by a slow-light system based on coupled active-resonator-induced transparency

Yannick Dumeige, Thị Kim Ngân Nguyên, Laura Ghişa +2 more

We demonstrate experimentally coupled active-resonator-induced transparency in a fiber system. We show that the use of ${\mathrm{Er}}^{3+}$-doped fibers can compensate for the optical losses leading to a high transparency of the system. Using a Mach-Zehnder fiber interferometer, we measure the dispersion properties of our coupled active resonators under different pumping rates. We show that the active feature of the system allows us to engineer the different orders of its artificial dispersion. This experimental demonstration shows the potential of active coupled resonators for dispersion tailoring and slow-light applications.

Physical Review A•Jul 11, 2008•40 citations

Ultra high-Q tunable microring resonators enabled by slow light

Priyash Barya, Ashwith Prabhu, Laura Heller +2 more

High-Q nanophotonic resonators are crucial for many applications in classical and quantum optical processing, communication, and sensing. We achieve ultra-high quality factors via a method previously limited to bulk systems, preparing a highly transparent and strongly dispersive medium within the resonator that causes a reduction in the group velocity and a corresponding increase in the quality factor. We implement this via spectral hole burning in erbium-doped thin-film lithium niobate microring resonators, and show Q-factors enhanced by nearly three orders of magnitude to exceed 108. Additionally, we show dynamic control of the resonances via electro-optic tuning. Finally, we present a theoretical model for our experimentally observed resonator linewidths, which are not well-described by the standard Bloch equations. Our results show a dramatic reduction in the erbium dephasing rate under a strong optical drive, leading to much narrower linewidths than would otherwise be expected given the large circulating intensity in the resonator. Light can be slowed to extreme degrees in engineered media, giving rise to unique behavior. Here, the authors show that slow light enables the formation of ultra-narrow tunable mirroring resonators, introducing a new paradigm for controlling optical responses on a photonic chip.

arXiv:2504.19465•Nature Communications•Nov 25, 2025•14 citations
We have proposed and experimentally demonstrated tunable cavity-linewidth narrowing by means of coupled-active-resonator-induced dispersion. We have theoretically studied the coupling-resonator-induced-dispersion phenomenon in the general case of NNN coupled resonators and especially the case of two or three resonators. In the case of two resonators we have experimentally shown that the strong dispersion induced by the coupling of resonators can lead to cavity ringdown effect enhancement. In the case of three resonators, we propose a coupling scheme allowing the quality (Q)(Q)(Q) factor of a critically coupled resonator to be increased and actively modulated by using two additional coupled resonators. We have experimentally tested the feasibility of the proposition by using a model system consisting of Er3+{\mathrm{Er}}^{3+}Er3+-doped fiber coupled resonators. These experimental results demonstrate the possibility of QQQ-factor tailoring by the use of active artificial photonic media.
The possibility of slowing down or storing light holds interests in classical or quantum optical communications. Different schemes have been proposed; among them, active resonator-based devices seem to provide a scalable and low loss solution for this purpose. This paper will be devoted to the theoretical and experimental studies of active coupled resonator delay lines. High-quality (Q) factor resonators are strongly dispersive systems which can be used to control the group velocity of light. As it is the case for atomic systems the dispersion properties of these artificial media is dependent on their absorption or optical gain. Moreover by coupling several resonators it is also possible to tailor their transmission or high dispersion orders . For these two reasons, active coupled resonators may be of high interest for optical dispersion or delay lines. In the aim of practical applications, the first step consists in defining an experimental protocol allowing a resonator complete description to be obtained. Cavity ring down spectroscopy method can be adapted to obtain the essential parameters such as gain/absorption and dispersion. The method has been validated using a model system made of Er3+ doped optical fiber resonators and applied to various high-Q whispering gallery mode resonators including resonators under modal coupling. It is possible to find coupling configurations allowing the dispersion of coupled active resonator systems to be tailored by changing the optical losses or gain of each resonator. In particular these systems may be used as tunable transparent delay lines or for dispersion compensation. This last configuration can be used to enhanced or actively control the quality factor of passive cavities. Finally the dynamic control of dispersion or resonance properties via the gain control of active coupled microresonators could find some applications in optical buffering.
We study both theoretically and experimentally the dispersive properties of single or coupled active resonators. In the case of single resonator systems, we present a simple experimental protocol which allows us to obtain in detail its coupling regime and thus their dispersive properties. We show that the active coupled systems offer some degrees of freedom to tailor the high dispersion orders. All the propositions are experimentally tested using a model system made of Er 3 + doped fiber ring resonators. These artificial media could be used as tunable or amplifying compact optical delay lines. We also show that the proposed experimental protocol can be applied to passive whispering gallery mode resonators.
We experimentally demonstrate cavity linewidth control by manipulating dispersion of the intracavity medium. By making use of the dramatic change of Kerr nonlinearity near electromagnetically induced transparency resonance in a three-level atomic system, the cavity transmission linewidth can be greatly modified. As the cavity input intensity increases, the cavity linewidth changes from below to above empty cavity linewidth, corresponding to subluminal and superluminal photon propagation in the cavity, respectively.
The phenomena of induced transparency, with the typical examples of electromagnetically induced transparency (EIT) in atomic media and those based on coupled optical resonators, have attracted tremendous interest since their discoveries. Owing to the limitations of the involved physical elements, however, near-100\% transmissions were reported under highly demanding experimental conditions. With a structure of three linearly coupled optical resonators, an active one carrying optical gain and two passive ones simply with dissipation, we demonstrate that a transmitted light field can become completely transparent through the structure, which displays all properties similar to those of EIT. It is due to a destructive interference mechanism that totally eliminates the intracavity field in the dissipative resonator directly coupled to the transmitted field of any feasible power, when the coupling strength of two other resonators is tuned across a point determined by their associated gain and loss rates. This mechanism works for all possible coupling strengths of the dark resonator with the input field and its neighboring resonator, as well as for any available quality factor from its fabrication. The transparency window size and output field intensity can be freely adjusted by tuning two inter-cavity couplings of wide ranges, without modifying the built-in optical gain which can be just slightly stronger than the dissipation of the active resonator.
We demonstrate experimentally coupled active-resonator-induced transparency in a fiber system. We show that the use of Er3+{\mathrm{Er}}^{3+}Er3+-doped fibers can compensate for the optical losses leading to a high transparency of the system. Using a Mach-Zehnder fiber interferometer, we measure the dispersion properties of our coupled active resonators under different pumping rates. We show that the active feature of the system allows us to engineer the different orders of its artificial dispersion. This experimental demonstration shows the potential of active coupled resonators for dispersion tailoring and slow-light applications.
High-Q nanophotonic resonators are crucial for many applications in classical and quantum optical processing, communication, and sensing. We achieve ultra-high quality factors via a method previously limited to bulk systems, preparing a highly transparent and strongly dispersive medium within the resonator that causes a reduction in the group velocity and a corresponding increase in the quality factor. We implement this via spectral hole burning in erbium-doped thin-film lithium niobate microring resonators, and show Q-factors enhanced by nearly three orders of magnitude to exceed 108. Additionally, we show dynamic control of the resonances via electro-optic tuning. Finally, we present a theoretical model for our experimentally observed resonator linewidths, which are not well-described by the standard Bloch equations. Our results show a dramatic reduction in the erbium dephasing rate under a strong optical drive, leading to much narrower linewidths than would otherwise be expected given the large circulating intensity in the resonator. Light can be slowed to extreme degrees in engineered media, giving rise to unique behavior. Here, the authors show that slow light enables the formation of ultra-narrow tunable mirroring resonators, introducing a new paradigm for controlling optical responses on a photonic chip.