Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

A subnanosecond clock cryogenic system for Josephson computers

Seigo Kotani, A. Inoue, Hideo Suzuki, S. Hasuo, Toshikazu Takenouchi, K. Fukase, Fumio MIYAGAWA, S. Yoshida, T. Sano, Y. Kamioka

Published Jan 1, 1991• 6 citations
Publisher

Abstract

Using Josephson chips maintained at 4.4 K by a closed-cycle 3-W desk-size refrigerator, the authors verified the correct operation of a 4-b Josephson microprocessor up to 1.1 GHz. Room temperature and liquid He temperature regions are connected with a 130-ps delay using I/O cables passing through sidewalls of a vacuum vessel. It is proposed that both semiconductor and Josephson devices can coexist on circuit boards that constitute the equivalent of a single board.>

DOI
10.1109/77.107401

Related papers

A Sub-ns Clock Cryogenic System For Josephson Computers

Seigo Kotani, A. Inoue, Hideo Suzuki +7 more

Josephson gates have speed and low power dissipation, as demonstrated in a 6300-gate 8b digital signal processor and a 4kb SRAM.1 2 3 Josephson LSI chips operate up to 1GHz but their gate count and memory capacity are not sufficient to permit fabrication of computing systems using only these chips. The solution is to combine them with semiconductor chips. But, in this case, the propagation delay caused by VO cables, typically 1.3m, is a serious problem because Josephson chips must be kept at low temperature, typically 4.2K.

Digest of technical papers/Digest of technical papers - IEEE International Solid-State Circuits Conference•Jan 1, 1991•4 citations

Cryogen-free operation of programmable Josephson voltage standard with a closed-cycle refrigerator

Yonuk Chong, Mun-Seog Kim, Wan-Seop Kim +1 more

We report operation of a programmable Josephson voltage standard on a closed-cycle refrigerator. NIST 1V PJVS chip is used, and we operate the chip with the fingerboard that is adopted from the existing liquid helium dipping probe. We demonstrate operation at 5.5 K of chip temperature, with a flat Shapiro step in the sub-array of the chip.

Conference on Precision Electromagnetic Measurements•Jun 1, 2008•0 citations

A 1-GHz-clock Josephson microcomputer system

S. Yano, Y. Hatano, H. Mori +4 more

A 1-GHz-clock Josephson microcomputer system was developed to demonstrate the possibility of a high-speed superconducting computer system. It consists of a 4-b data processor chip and a 1-kb RAM chip. For the fabrication of these Josephson integrated circuits, a cross-shaped Nb-AlO/sub x/-Nb Josephson junction process was developed in order to realize small junction size and improve critical current uniformity, and has made fabrication of LSIs with several thousand gates possible. A latchup-free DC flip-flop is an important element in the high-speed Josephson logic and memory circuits, having been applied to an all-DC-powered Josephson RAM with asynchronous access capability. A low-inductance chip-to-chip carrier is an architectural and design concept for the Josephson computer's 1-GHz-clock operation, suppressing the crosstalk between the AC power and the output signals. Each chip is 7 mm square and is fabricated using a 2.5- mu m-rule Nb-AlO/sub x/-Nb junction process. The chips are connected on a superconducting carrier by solder bumps in a die size of 15 mm by 25 mm. The system is constructed from 8123 Josephson interferometer devices and is operable in a 1-ns cycle with 50-mW power dissipation.

IEEE Transactions on Magnetics•Mar 1, 1991•15 citations

Toward the Realization of a Josephson Computer

S. Hasuo

High-quality Josephson junctions, with both electrodes made from niobium and with an aluminum-oxide insulating barrier, were introduced in 1983. This niobium junction is very stable, reliable, controllable, and reproducible. Because of these excellent characteristics, these junctions can be applied to large-scale integrated (LSI) circuits, such as microprocessors having a few thousand gates and a few kilobits of memory. These circuits operate much faster and consume less power than any semiconductor circuit now available. Integrated Josephson circuits are now being tested in a closed-cycle refrigerator. The next step is to design a special-purpose, small-scale Josephson computer and to demonstrate its high performance.

Science•Jan 17, 1992•10 citations

Quantum Computer Control using Novel, Hybrid Semiconductor-Superconductor Electronics

Erik P. DeBenedictis

Inspired by recent interest in quantum computing and recent studies of cryo CMOS for control electronics, this paper presents a hybrid semiconductor-superconductor approach for engineering scalable computing systems that operate across the gradient between room temperature and the temperature of a cryogenic payload. Such a hybrid computer architecture would have unique suitability to quantum computers, scalable sensors, and the quantum internet. The approach is enabled by Cryogenic Adiabatic Transistor Circuits (CATCs), a novel way of using adiabatic circuits to substantially reduce cooling requirements. In a hybrid chip of CATCs and a second technology, such as Josephson junctions (JJs) or cryo CMOS, the CATCs complement the speed, power, and density of the second technology as well as becoming a longsought cryogenic memory. This paper describes higher-level design principles for CATC hybrids with a quantum computer control system that includes CATC memory, an FPGA-like logic module that uses CATC for dense configuration logic and JJs for fast configured logic, and I/O subsystems including microwave modulators and low frequency control signals.

arXiv:1912.11532•Dec 15, 2019•3 citations

Superconducting memories employing Josephson devices

W. Anacker

Experimental superconducting Josephson devices being investigated for use in digital logic and memory circuits have been demonstrated to switch in the 10 to 100 picosecond (1 picosecond = 10-12 sec) range. Projections based on the operation of individual logic circuits indicate that they may surpass semiconductor circuits in very high performance CPU's. This potential is based on the fact that these circuits dissipate extremely little energy, on the order of 10 to 1000 attojoules (attojoule = 10-18 joule), while operating with subnanosecond delays. It should, therefore, be possible to package Josephson devices very densely and interconnect them by properly terminated superconducting transmission lines so that the fast switching speed of individual circuits is retained throughout large logic networks.

AFIPS National Computer Conference (NCC)•Jan 1, 1975•2 citations
Using Josephson chips maintained at 4.4 K by a closed-cycle 3-W desk-size refrigerator, the authors verified the correct operation of a 4-b Josephson microprocessor up to 1.1 GHz. Room temperature and liquid He temperature regions are connected with a 130-ps delay using I/O cables passing through sidewalls of a vacuum vessel. It is proposed that both semiconductor and Josephson devices can coexist on circuit boards that constitute the equivalent of a single board.>
Josephson gates have speed and low power dissipation, as demonstrated in a 6300-gate 8b digital signal processor and a 4kb SRAM.1 2 3 Josephson LSI chips operate up to 1GHz but their gate count and memory capacity are not sufficient to permit fabrication of computing systems using only these chips. The solution is to combine them with semiconductor chips. But, in this case, the propagation delay caused by VO cables, typically 1.3m, is a serious problem because Josephson chips must be kept at low temperature, typically 4.2K.
A 1-GHz-clock Josephson microcomputer system was developed to demonstrate the possibility of a high-speed superconducting computer system. It consists of a 4-b data processor chip and a 1-kb RAM chip. For the fabrication of these Josephson integrated circuits, a cross-shaped Nb-AlO/sub x/-Nb Josephson junction process was developed in order to realize small junction size and improve critical current uniformity, and has made fabrication of LSIs with several thousand gates possible. A latchup-free DC flip-flop is an important element in the high-speed Josephson logic and memory circuits, having been applied to an all-DC-powered Josephson RAM with asynchronous access capability. A low-inductance chip-to-chip carrier is an architectural and design concept for the Josephson computer's 1-GHz-clock operation, suppressing the crosstalk between the AC power and the output signals. Each chip is 7 mm square and is fabricated using a 2.5- mu m-rule Nb-AlO/sub x/-Nb junction process. The chips are connected on a superconducting carrier by solder bumps in a die size of 15 mm by 25 mm. The system is constructed from 8123 Josephson interferometer devices and is operable in a 1-ns cycle with 50-mW power dissipation.
High-quality Josephson junctions, with both electrodes made from niobium and with an aluminum-oxide insulating barrier, were introduced in 1983. This niobium junction is very stable, reliable, controllable, and reproducible. Because of these excellent characteristics, these junctions can be applied to large-scale integrated (LSI) circuits, such as microprocessors having a few thousand gates and a few kilobits of memory. These circuits operate much faster and consume less power than any semiconductor circuit now available. Integrated Josephson circuits are now being tested in a closed-cycle refrigerator. The next step is to design a special-purpose, small-scale Josephson computer and to demonstrate its high performance.
Inspired by recent interest in quantum computing and recent studies of cryo CMOS for control electronics, this paper presents a hybrid semiconductor-superconductor approach for engineering scalable computing systems that operate across the gradient between room temperature and the temperature of a cryogenic payload. Such a hybrid computer architecture would have unique suitability to quantum computers, scalable sensors, and the quantum internet. The approach is enabled by Cryogenic Adiabatic Transistor Circuits (CATCs), a novel way of using adiabatic circuits to substantially reduce cooling requirements. In a hybrid chip of CATCs and a second technology, such as Josephson junctions (JJs) or cryo CMOS, the CATCs complement the speed, power, and density of the second technology as well as becoming a longsought cryogenic memory. This paper describes higher-level design principles for CATC hybrids with a quantum computer control system that includes CATC memory, an FPGA-like logic module that uses CATC for dense configuration logic and JJs for fast configured logic, and I/O subsystems including microwave modulators and low frequency control signals.
Experimental superconducting Josephson devices being investigated for use in digital logic and memory circuits have been demonstrated to switch in the 10 to 100 picosecond (1 picosecond = 10-12 sec) range. Projections based on the operation of individual logic circuits indicate that they may surpass semiconductor circuits in very high performance CPU's. This potential is based on the fact that these circuits dissipate extremely little energy, on the order of 10 to 1000 attojoules (attojoule = 10-18 joule), while operating with subnanosecond delays. It should, therefore, be possible to package Josephson devices very densely and interconnect them by properly terminated superconducting transmission lines so that the fast switching speed of individual circuits is retained throughout large logic networks.