Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics Letters

Pump Intensity Dependence of Two-Beam Coupling in Doped Lithium Niobate Crystals

Nouel Y. Kamber, Jingjun Xu, Sonia M. Mikha, Song Feng, Guoquan Zhang, Zhang Xin-Zheng, Liu Si-Min, Zhang Guang-Yin

Published Jun 1, 2000• 0 citations
Publisher

Abstract

We demonstrated experimentally the dependence of two-beam coupling on the incident pump intensity in our samples of doped LiNbO 3 crystals. Our results show that there is an optimum pump intensity for the signal beam amplification, which can be easily controlled by doping the LiNbO 3 crystal with suitable concentrations of Fe and damage-resistant dopants such as Mg, In, and Zn.

DOI
10.1088/0256-307x/17/6/016

Related papers

New phenomena on laser-induced photorefractive effect in LiNbO/sub 3/:Fe

Peng Wenji, Qingxing Li, Yu Zhenxin

In this paper, a new and regular oscillation phenomenon appeared in the two-beam coherent coupling in the photorefractive material ion-doped lithium niobate crystal is described.

Digest on Nonlinear Optics: Materials, Phenomena and Devices•Jan 1, 1990•0 citations

Signal-to-pump ratio dependence of buildup and decay rates in photorefractive nonlinear two-beam coupling

Moshe Horowitz, Ron Daisy, Baruch Fischer

The buildup and the decay of photorefractive two-beam coupling are experimentally demonstrated to be strongly dependent on the intensity ratio of the two beams (signal-to-pump ratio). The experiment, done with a BaTiO3 crystal, shows good agreement with the theory of two-beam coupling in the depleted-pump regime. The deviation of the response behavior from the small-signal regime is seen for ratios as small as ∼10−5. These results are significant for applications of two-beam coupling as gain media, especially for the elimination of amplified noise (fanning).

Journal of the Optical Society of America B•Sep 1, 1992•18 citations

Generation of high spectral purity photon-pairs with MgO-doped periodically poled lithium niobate

Mengying Zhan, Qi-Chao Sun, Tong Xiang +1 more

Abstract We study the spectral correlation of photon pairs generated via type-II spontaneous parametric down conversion in periodically poled lithium niobate crystals. By performing Schmidt decomposition on the two-photon wavefunction, we calculate the spectral purity of the two-photon state under various pump laser characteristics and doping concentrations of MgO in lithium niobate crystals. Our results show that periodically poled 5% MgO doped lithium niobate is a good candidate to generate photon-pairs with high spectral purity at telecom wavelength.

Laser Physics•Nov 5, 2015•2 citations

Noiseless, quasi-phase-matched parametric amplifier in bulk lithium niobate

D. J. Lovering, Juan Ariel Levenson, P. Vidaković +2 more

Although noiseless optical amplification has been demonstrated in bulk KTP crystals, and is well understood, there have been no observations of noiseless optical amplification in bulk quasi-phase-matched (QPM) systems. That such an amplifier is possible was predicted recently and indeed squeezing has already been observed in QPM waveguides (using KTP and LiNbO3). QPM materials are attractive for use in quantum-optical devices because they give access to certain (large) components of the nonlinear susceptibility tensor that cannot be used in conventional birefringent phase-matching schemes. They also extend the range of materials accessible for use in parametric amplifiers to include some low-birefringence crystals exhibiting large nonlinearities. Even with the technological advantages offered by certain QPM crystals, efforts to find practical applications for optical parametric amplifiers are hampered by the need for enormous pump-field strengths. The obvious solution to the problem of the pump-field requirement is to confine the incident energy to a narrow interaction region thereby increasing the energy density. However, this approach can only be realised at the expense of sacrificing the homogeneity of the parametric interaction between pump and signal waves. This in turn causes vacuum field fluctuations from parasitic modes to be mixed into the signal mode thereby degrading the signal to noise ratio and negating the advantage of using an optical parametric amplifier. In the experiments presented here, optical signals have been amplified with up to 9dB of gain, yet with a noise figure (NF) of only 1.09, as compared to the minimum possible NF of a classical amplifier with the same gain which would equal 1.86. Furthermore, the interaction is achieved with tightly focused incident fields in a sample of bulk QPM lithium niobate. The entire interaction region is only 200µm thick and 2.8mm long. This performance was achieved with the aid of a theoretical model m which the effect of wavefront curvature and mode distortion are treated within a quantised mode framework using a spatial mode basis. Such a simulation permits the fundamental origin of the excess quantum noise to be easily traced to zero-point fluctuations of high-order spatial modes which couple to the signal mode via the parametric interaction. Furthermore the simulation enabled an experimental geometry to be selected in which an optimal compromise is made between wavefront matching bump beam smaller than signal) and pump-homogeneity (pump larger than signal), so that the overall noise figure remains well into the quantum-performance region.

•Jan 1, 1996•0 citations

One approximation to multiple beam amplification in negative Kerr-type media

F. Marroquin, A. Apolinar-Iribe

It is shown that the interaction of two strong pumps with four weak signal beams, not coplanar with the pump beam, gives rise to the exponential amplification of the weak beams in a Kerr-type negative medium.The theory developed is applied to the case of noise formation in iron-doped lithium niobate.

Prace Naukowe Uniwersytetu Ekonomicznego we Wrocławiu•Jan 1, 2012•0 citations

Transition from Backscattering Speckles to Phase Conjugation in LiNbO 3 :Fe

Qiang Wu, Jingjun Xu, R. A. Rupp +3 more

We investigate the backscattering for converging beams in iron-doped lithium niobate crystals. Due to the nonlinear properties of the crystal, backscattering exhibits temporally fluctuating speckles that make a transition to the phase conjugate of the incident beam under certain circumstances. Our observation seems to point to a new kind of self-pumped phase conjugation in photorefractive media.

Chinese Physics Letters•Jul 21, 2006•2 citations
We demonstrated experimentally the dependence of two-beam coupling on the incident pump intensity in our samples of doped LiNbO 3 crystals. Our results show that there is an optimum pump intensity for the signal beam amplification, which can be easily controlled by doping the LiNbO 3 crystal with suitable concentrations of Fe and damage-resistant dopants such as Mg, In, and Zn.
The buildup and the decay of photorefractive two-beam coupling are experimentally demonstrated to be strongly dependent on the intensity ratio of the two beams (signal-to-pump ratio). The experiment, done with a BaTiO3 crystal, shows good agreement with the theory of two-beam coupling in the depleted-pump regime. The deviation of the response behavior from the small-signal regime is seen for ratios as small as ∼10−5. These results are significant for applications of two-beam coupling as gain media, especially for the elimination of amplified noise (fanning).
Abstract We study the spectral correlation of photon pairs generated via type-II spontaneous parametric down conversion in periodically poled lithium niobate crystals. By performing Schmidt decomposition on the two-photon wavefunction, we calculate the spectral purity of the two-photon state under various pump laser characteristics and doping concentrations of MgO in lithium niobate crystals. Our results show that periodically poled 5% MgO doped lithium niobate is a good candidate to generate photon-pairs with high spectral purity at telecom wavelength.
Although noiseless optical amplification has been demonstrated in bulk KTP crystals, and is well understood, there have been no observations of noiseless optical amplification in bulk quasi-phase-matched (QPM) systems. That such an amplifier is possible was predicted recently and indeed squeezing has already been observed in QPM waveguides (using KTP and LiNbO3). QPM materials are attractive for use in quantum-optical devices because they give access to certain (large) components of the nonlinear susceptibility tensor that cannot be used in conventional birefringent phase-matching schemes. They also extend the range of materials accessible for use in parametric amplifiers to include some low-birefringence crystals exhibiting large nonlinearities. Even with the technological advantages offered by certain QPM crystals, efforts to find practical applications for optical parametric amplifiers are hampered by the need for enormous pump-field strengths. The obvious solution to the problem of the pump-field requirement is to confine the incident energy to a narrow interaction region thereby increasing the energy density. However, this approach can only be realised at the expense of sacrificing the homogeneity of the parametric interaction between pump and signal waves. This in turn causes vacuum field fluctuations from parasitic modes to be mixed into the signal mode thereby degrading the signal to noise ratio and negating the advantage of using an optical parametric amplifier. In the experiments presented here, optical signals have been amplified with up to 9dB of gain, yet with a noise figure (NF) of only 1.09, as compared to the minimum possible NF of a classical amplifier with the same gain which would equal 1.86. Furthermore, the interaction is achieved with tightly focused incident fields in a sample of bulk QPM lithium niobate. The entire interaction region is only 200µm thick and 2.8mm long. This performance was achieved with the aid of a theoretical model m which the effect of wavefront curvature and mode distortion are treated within a quantised mode framework using a spatial mode basis. Such a simulation permits the fundamental origin of the excess quantum noise to be easily traced to zero-point fluctuations of high-order spatial modes which couple to the signal mode via the parametric interaction. Furthermore the simulation enabled an experimental geometry to be selected in which an optimal compromise is made between wavefront matching bump beam smaller than signal) and pump-homogeneity (pump larger than signal), so that the overall noise figure remains well into the quantum-performance region.