Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Physics B Atomic Molecular and Optical Physics

Laser-induced noise contribution due to imperfect atomic state preparation in an optically pumped caesium beam resonator

Gaëlle Lucas-Leclin, P. Cérez, N. Dimarcq

Published Jan 1, 1999• 12 citations
Publisher

Abstract

Imperfect atomic state preparation in an optically pumped beam resonator results in over-Poissonian fluctuations of the fluorescence emission of residual unpumped atoms. This excess noise is induced by the frequency noise of the pump laser. We evaluate it theoretically for a three-level atomic system interacting with a noisy laser field, and show that it is predominant within a large range of pumping efficiencies and laser linewidths for usual atomic fluxes. Experimentally, extra noise is detected from ratios of unpumped atoms as low as 0.01% of the atomic flux equal to . This noise source debases the short-term stability of an atomic clock in a flop-in configuration if the proportion of unpumped atoms exceeds 1% of the global atomic flux. In a flop-out configuration this excess noise would decrease the clock stability from a proportion of unpumped atoms of 0.01%.

DOI
10.1088/0953-4075/32/2/014

Related papers

Improvement of the short-term stability of atomic fountain clock with state preparation by two-laser optical pumping*

Lei Han, Fang Fang, Weiliang Chen +4 more

To improve the signal to noise ratio (SNR) and the short-term stability of cesium atomic fountain clocks, the work of two-laser optical pumping is presented theoretically and experimentally. The short-term stability of the NIM6 fountain clock has been improved by preparing more cold atoms in the | F = 4, mF = 0〉 clock state with a shortened cycle time. Two π-polarized laser beams overlapped in the horizontal plane have been applied after launching, one is resonant with | F = 4〉 → | F′ = 4〉 transition and the other is resonant with | F = 3〉 → | F′ = 4〉 transition. With optical pumping, the population accumulated in the | mF = 0〉 clock state is improved from 11% to 63%, and the detection signal is increased by a factor of 4.2, the SNR of the clock transition probability and the short-term stability are also improved accordingly.

Chinese Physics B•Feb 2, 2021•4 citations

Photon noise reduction in lasers

Fritz Haake, S. M. Tan, Daniel F. Walls

We consider the problem of reducing the contributions of pump and spontaneous-emission noise to the output noise of a laser field. We consider two models based on an atomic medium, one analytic, the other involving numerical simulation of a sequence of pump cycles. The predictions of both models are shown to agree. For regular pump excitation the intensity fluctuations of a laser well above threshold may be reduced to zero at the cavity resonance frequency if the ratio of the lifetimes of the upper and lower lasing levels is sufficiently large that spontaneous emission is suppressed. When the atomic lifetimes are comparable, spontaneous emission reduces the amount of noise reduction. For example, for equal atomic lifetimes regular pump excitation will result in a maximum noise reduction in the output field of one-half the shot-noise limit.

Physical Review A•Dec 1, 1989•95 citations

Reducing the light-shift in the diode laser pumped rubidium atomic clock

James C. Camparo

One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Dec 24, 2002•6 citations

1996 IEEE INTERNATIONAL FREQUENCY CONTROL SYMPOSIUM REDUCING THE LIGHT-SHIFT IN THE DIODE LASER PUMPED RUBIDIUM ATOMIC CLOCK

James C. Camparo

One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock‘s output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock‘s output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.

•Jan 1, 1996•0 citations

Optical state selection process with optical pumping in a cesium atomic fountain clock*

Lei Han, Fang Fang, Weiliang Chen +5 more

We propose and realize a new optical state selection method on a cesium atomic fountain clock by applying a two-laser 3–3′ optical pumping configuration to spin polarize atoms. The atoms are prepared in |F = 3, mF = 0〉 clock state with optical pumping directly after being launched up, followed by a pushing beam to push away the atoms remaining in the |F = 4〉 state. With a state selection efficiency exceeding 92%, this optical method can substitute the traditional microwave state selection, and helps to develop a more compact physical package. A Ramsey fringe has been achieved with this optical state selection method, and a contrast of 90% is obtained with a full width half maximum of 0.92 Hz. The short-term frequency stability of 6.8 × 10−14 (τ/s)−1/2 is acquired. In addition, the number of detected atoms is increased by a factor of 1.7 with the optical state selection.

Chinese Physics B•May 29, 2021•3 citations

An optically pumped atomic clock based on a continuous slow cesium beam

Weibin Xie, Qing Wang, Xuan He +8 more

Herein, we report the scheme of an optically pumped atomic clock based on a cold cesium atomic beam source. We propose the laser system and physical mechanism of this atomic clock, wherein the atomic beam travels in an upper parabolic trajectory, thereby eliminating the light shift effect. In the experiments, when the length of the free evolution region was 167 mm, the line width of the Ramsey fringe was 37 Hz. When the expected signal-to-noise ratio of the Ramsey fringe that can be achieved is 36,000, the expected short-term frequency stability is about 3.6 × 10–14/√τ, which is significantly higher than that of a conventional optically pumped cesium clock of similar volume.

Frontiers in Physics•Dec 13, 2022•3 citations
Imperfect atomic state preparation in an optically pumped beam resonator results in over-Poissonian fluctuations of the fluorescence emission of residual unpumped atoms. This excess noise is induced by the frequency noise of the pump laser. We evaluate it theoretically for a three-level atomic system interacting with a noisy laser field, and show that it is predominant within a large range of pumping efficiencies and laser linewidths for usual atomic fluxes. Experimentally, extra noise is detected from ratios of unpumped atoms as low as 0.01% of the atomic flux equal to . This noise source debases the short-term stability of an atomic clock in a flop-in configuration if the proportion of unpumped atoms exceeds 1% of the global atomic flux. In a flop-out configuration this excess noise would decrease the clock stability from a proportion of unpumped atoms of 0.01%.
To improve the signal to noise ratio (SNR) and the short-term stability of cesium atomic fountain clocks, the work of two-laser optical pumping is presented theoretically and experimentally. The short-term stability of the NIM6 fountain clock has been improved by preparing more cold atoms in the | F = 4, mF = 0〉 clock state with a shortened cycle time. Two π-polarized laser beams overlapped in the horizontal plane have been applied after launching, one is resonant with | F = 4〉 → | F′ = 4〉 transition and the other is resonant with | F = 3〉 → | F′ = 4〉 transition. With optical pumping, the population accumulated in the | mF = 0〉 clock state is improved from 11% to 63%, and the detection signal is increased by a factor of 4.2, the SNR of the clock transition probability and the short-term stability are also improved accordingly.
We consider the problem of reducing the contributions of pump and spontaneous-emission noise to the output noise of a laser field. We consider two models based on an atomic medium, one analytic, the other involving numerical simulation of a sequence of pump cycles. The predictions of both models are shown to agree. For regular pump excitation the intensity fluctuations of a laser well above threshold may be reduced to zero at the cavity resonance frequency if the ratio of the lifetimes of the upper and lower lasing levels is sufficiently large that spontaneous emission is suppressed. When the atomic lifetimes are comparable, spontaneous emission reduces the amount of noise reduction. For example, for equal atomic lifetimes regular pump excitation will result in a maximum noise reduction in the output field of one-half the shot-noise limit.
One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.
One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock‘s output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock‘s output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.
We propose and realize a new optical state selection method on a cesium atomic fountain clock by applying a two-laser 3–3′ optical pumping configuration to spin polarize atoms. The atoms are prepared in |F = 3, mF = 0〉 clock state with optical pumping directly after being launched up, followed by a pushing beam to push away the atoms remaining in the |F = 4〉 state. With a state selection efficiency exceeding 92%, this optical method can substitute the traditional microwave state selection, and helps to develop a more compact physical package. A Ramsey fringe has been achieved with this optical state selection method, and a contrast of 90% is obtained with a full width half maximum of 0.92 Hz. The short-term frequency stability of 6.8 × 10−14 (τ/s)−1/2 is acquired. In addition, the number of detected atoms is increased by a factor of 1.7 with the optical state selection.
Herein, we report the scheme of an optically pumped atomic clock based on a cold cesium atomic beam source. We propose the laser system and physical mechanism of this atomic clock, wherein the atomic beam travels in an upper parabolic trajectory, thereby eliminating the light shift effect. In the experiments, when the length of the free evolution region was 167 mm, the line width of the Ramsey fringe was 37 Hz. When the expected signal-to-noise ratio of the Ramsey fringe that can be achieved is 36,000, the expected short-term frequency stability is about 3.6 × 10–14/√τ, which is significantly higher than that of a conventional optically pumped cesium clock of similar volume.