Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review Letters

Experimental realization of a quantum optical tap

J.-Ph. Poizat, Philippe Grangier

Published Jan 18, 1993• 127 citations
Publisher

Abstract

We have realized a system which is able to read out information encoded on the amplitude of a laser beam without degrading the signal-to-noise ratio of the carrier. This has been implemented using the two-photon cross-phase-modulation effect of a three-level system in a sodium atomic beam located in a doubly resonant optical cavity. We have achieved an improvement by a factor of 1.35 of the overall information transer compared to any classical optical tap, where a perfect quantum duplicator would reach the ideal value of 2.

DOI
10.1103/physrevlett.70.271

Related papers

Observation of backaction-evading measurement of an optical intensity in a three-level atomic nonlinear system

Philippe Grangier, Jean-François Roch, Gérard Roger

Backaction-evading measurement of an optical intensity has been observed, using a three-level system in a sodium atomic beam as a nonlinear medium. The principle of this experiment is to use the cross-phase-modulation effect, which in principle allows one to read nondestructively the quantum intensity fluctuations of the ``signal'' beam when detecting the phase fluctuations of the ``meter'' beam. Using a cavity-enhancement scheme, the quantum noise measured when recombining the signal and meter photocurrents is 0.8 dB below the shot-noise level.

Physical Review Letters•Mar 18, 1991•94 citations

Experimental realization of a semiconductor photon number amplifier and a quantum optical tap

E. Goobar, Anders Karlsson, Gunnar G. Bjork

Two configurations involving high quantum efficiency photodetectors and light emitting diodes have been investigated. A light beam was detected with a photodetector and its photocurrent was used to measure the incoming beam. Simultaneously, the photocurrent was used, with and without amplification, to regenerate the absorbed beam. With these schemes photon number amplification, duplication, and information tapping without introducing any significant noise to the downstream propagating beam could be experimentally realized.

Physical Review Letters•Sep 27, 1993•52 citations

Sub-shot-noise manipulation of light using semiconductor emitters and receivers

Jean-François Roch, J.-Ph. Poizat, Philippe Grangier

We describe an amplifying system using a photodiode and a light emitting diode, which is able to measure and to ``recreate'' the quantum statistics of the intensity of a light beam. This system acts therefore as a nonclassical ``quantum optical repeater.'' The overall information transfer is improved by a factor of 1.8 compared to a classical device, while the ideal quantum value would be 2, and the correlation between the signal and meter outputs is 1.2 dB below the shot-noise limit. We also demonstrate the use of this device for both detecting and recreating an input squeezed state.

Physical Review Letters•Sep 27, 1993•57 citations

Optical resonances in a strong modulated laser beam

P. Thomann

The fluorescent intensity of two-level atoms irradiated by a near-resonant amplitude-modulated light wave is calculated in the Bloch model. The analogy with magnetic resonance in a strong oscillating field making an arbitrary angle with the static field is pointed out. Experimental evidence of the predicted parametric and multiple quantum resonances has been obtained with an atomic beam of sodium. Optical pumping was used to prepare the sodium atoms as two-level systems.

Journal of Physics B Atomic and Molecular Physics•Mar 28, 1980•43 citations

The conversion of phase to amplitude fluctuations of a light beam by an optical cavity

Alessandro S. Villar

Very low intensity and phase fluctuations are present in a bright light field such as a laser beam. These subtle quantum fluctuations may be used to encode quantum information. Although intensity is easily measured with common photodetectors, accessing the phase information requires interference experiments. We introduce one such technique, the rotation of the noise ellipse of light, which employs an optical cavity to achieve the conversion of phase to intensity fluctuations. We describe the quantum noise of light and how it can be manipulated by employing an optical resonance technique and compare it to similar techniques, such as Pound–Drever–Hall laser stabilization and homodyne detection.

arXiv:0805.0528•American Journal of Physics•Sep 15, 2008•68 citations

Cascaded Amplifying Quantum Optical Taps: A Robust Noiseless Optical Bus

Kamel Bencheikh, C. Simonneau, Juan Ariel Levenson

Two identical amplifying quantum optical taps, based on noiseless optical parametric amplification and twin beam quantum correlation, have been implemented in a series configuration and experimentally investigated. The result is an optical bus which we have shown to be robust with respect to downstream losses.

Physical Review Letters•Jan 6, 1997•25 citations
We have realized a system which is able to read out information encoded on the amplitude of a laser beam without degrading the signal-to-noise ratio of the carrier. This has been implemented using the two-photon cross-phase-modulation effect of a three-level system in a sodium atomic beam located in a doubly resonant optical cavity. We have achieved an improvement by a factor of 1.35 of the overall information transer compared to any classical optical tap, where a perfect quantum duplicator would reach the ideal value of 2.
Backaction-evading measurement of an optical intensity has been observed, using a three-level system in a sodium atomic beam as a nonlinear medium. The principle of this experiment is to use the cross-phase-modulation effect, which in principle allows one to read nondestructively the quantum intensity fluctuations of the ``signal'' beam when detecting the phase fluctuations of the ``meter'' beam. Using a cavity-enhancement scheme, the quantum noise measured when recombining the signal and meter photocurrents is 0.8 dB below the shot-noise level.
Two configurations involving high quantum efficiency photodetectors and light emitting diodes have been investigated. A light beam was detected with a photodetector and its photocurrent was used to measure the incoming beam. Simultaneously, the photocurrent was used, with and without amplification, to regenerate the absorbed beam. With these schemes photon number amplification, duplication, and information tapping without introducing any significant noise to the downstream propagating beam could be experimentally realized.
We describe an amplifying system using a photodiode and a light emitting diode, which is able to measure and to ``recreate'' the quantum statistics of the intensity of a light beam. This system acts therefore as a nonclassical ``quantum optical repeater.'' The overall information transfer is improved by a factor of 1.8 compared to a classical device, while the ideal quantum value would be 2, and the correlation between the signal and meter outputs is 1.2 dB below the shot-noise limit. We also demonstrate the use of this device for both detecting and recreating an input squeezed state.
Very low intensity and phase fluctuations are present in a bright light field such as a laser beam. These subtle quantum fluctuations may be used to encode quantum information. Although intensity is easily measured with common photodetectors, accessing the phase information requires interference experiments. We introduce one such technique, the rotation of the noise ellipse of light, which employs an optical cavity to achieve the conversion of phase to intensity fluctuations. We describe the quantum noise of light and how it can be manipulated by employing an optical resonance technique and compare it to similar techniques, such as Pound–Drever–Hall laser stabilization and homodyne detection.