Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Third-order intermodulation distortion in high-temperature superconductor Josephson junction downconverter at 12 GHz

Katsumi Suzuki, Kunihiko Hayashi, Manabu Fujimoto, Keiichi Yamaguchi, Shuichi Yoshikawa, Youichi Enomoto

Published Jan 4, 1994• 1 citation
Publisher

Abstract

First we report on the microwave characteristics of the third order intermodulation distortion (IMD3) in a High-Tc Superconductor (HTS) Josephson Junction (JJ) Downconverter at 12 GHz. We have successfully developed high quality nonlinear YBCO microbridge Josephson junctions for such an active MMIC as a mixer with RF, LO, IF and bias filters, which have been fabricated on (100) MgO substrates with 20 mm X 20 mm X 0.5 mm dimensions. The minimum conversion loss of the JJ mixer is 11 dB at very small local microwave input power LO equals -20 dBm which is two order less than a Schottky diode mixer. Consequently, this small optimum LO power gives the small rf input power at which the output IF power of the YBCO mixer saturates. Two-tone third-order intercept point (IP3) performance is a significantly important figure of merit typically used to define linearity of devices and circuits. The rf input power equals -15 dBm at the IP3 point is obtained for the YBCO mixer at 15 K and LO equals 10.935 GHz with -22 dBm. We have successfully measured the dependence of IMD3 on temperature, bias current, and LO power.

DOI
10.1117/12.166165

Related papers

Optimised conversion efficiency of a HTS MMIC Josephson down-converter

Jia Du, D D Bai, Ting Zhang +3 more

© 2014 IOP Publishing Ltd. A high-Tc superconducting (HTS) monolithic microwave integrated circuit (MMIC) Josephson down-converter that approaches zero conversion loss is reported. The all-HTS YBa2Cu3O7-x thin-film circuit consists of a step-edge Josephson junction mixer, a 10-12 GHz bandpass filter for the RF input, a lowpass filter for the IF output and a resonant strip line for local oscillator isolation; all are integrated on a single 10 mm × 20 mm MgO substrate. The DC characteristics of the junction and its mixing properties have been experimentally studied and compared to the results of (a) a single Josephson mixer without the on-chip HTS filters, and (b) our previously reported MMIC down-converter which had very different junction characteristics. The Josephson junction parameters are analysed to give insight into their effect on the mixer performance.

Superconductor Science and Technology•Aug 29, 2014•15 citations

Noise figure of HTS JJ MMIC downconverter at 12 GHz

Kenji Suzuki, S. Yoshikawa, Kenzo Yamaguchi +8 more

A YBa/sub 2/Cu/sub 3/O/sub 7- delta / (YBCO) step-edge microbridge JJ (Josephson junction), two 12-GHz YBCO microstrip bandpass filters, a 1-GHz YBCO filter, and current bias and voltage monitor circuits were successfully combined on a 20-mm*20-mm MgO substrate and integrated into a frequency downconverter for receiving DBS (direct broadcast satellite) signals. The YBCO downconverter and the GaAs low-noise IF (intermediate frequency) amplifier were combined in a microwave cryostat. The dependence of mixing signals on temperature and LO (local oscillator) input power was measured. The conversion gain and the noise figure corresponding to the YBCO downconverter package were -14.5 dB and 12.2 dB, respectively, at 15 K and low LO power (-25 dBm). The first demonstration of the HTS (high-temperature superconductive) subsystem, i.e. the monolithic YBCO downconverter, shows potential for applications in mobile radio communications and satellite broadcasting.>

IEEE MTT-S International Microwave Symposium digest•Dec 31, 2002•10 citations

Simulation of HTS Josephson Mixers

Colin M. Pegrum, Ting Zhang, Jia Du +1 more

The Commonwealth Scientific and Industrial Research Organization has developed superconducting microwave monolithic integrated circuit (MMIC) mixers using step-edge Josephson junctions and on-chip filters, made from YBaCuO on MgO substrates. Integration into an MMIC results in a compact and efficiently coupled structure. These have been shown to have outstanding conversion efficiency, dynamic range, and linearity. We report here a range of simulations of this type of mixer. We have mainly used Josephson simulators and analyze the data in both the time and frequency domains. More recently, we have also used microwave simulators incorporating a novel Verilog-A Josephson junction model that we have developed. We have looked at the interactions of junction bias current, local oscillator power, and radio-frequency input power with conversion efficiency, dynamic range, and linearity. Good agreement is found overall with measurements.

IEEE Transactions on Applied Superconductivity•Feb 19, 2016•14 citations

A high-temperature superconducting monolithic microwave integrated Josephson down-converter with high conversion efficiency

Jia Du, Ting Zhang, Y. Jay Guo +1 more

A compact high-Tc superconducting monolithic microwave integrated circuit Josephson down-converter is presented. The circuit consists of a single Josephson junction mixer, a bandpass filter, a lowpass filter, and a resonator for local oscillator fabricated on a single 10 mm × 20 mm chip of YBa2Cu3O7−x film on MgO substrate. The down-converter demonstrates superior performance in terms of conversion efficiency, dynamic range, linearity, and low local oscillator power with stable operation from 20 to 77 K. A maximum conversion gain of −4.7 dB was measured at 20 K and −12.8 dB at 70 K.

Applied Physics Letters•May 27, 2013•20 citations

Characterizations of High-Temperature Superconducting Step-Edge Josephson Junction Mixer

Dan Dan Bai, Jia Du, Yu Sheng He

We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.

IEEE Transactions on Applied Superconductivity•Aug 15, 2014•6 citations

Monolithic high-temperature superconducting heterodyne Josephson frequency down-converter

Jia Du, Ting Zhang, J.C. Macfarlane +2 more

A monolithic microwave integrated circuit (MMIC) frequency down-converter based on a compact high-Tc superconducting (HTS) device is demonstrated. The on-chip integrated HTS down-converter consists of a 7–9 GHz bandpass filter for RF input, a lowpass filter for intermediate frequency output, and a self-pumped Josephson heterodyne mixer. All the above passive and active components are fabricated on a single 10 mm × 20 mm chip of YBa2Cu3O7−x film on MgO substrate. Characterization of this MMIC HTS down-converter in terms of frequency response, conversion gain, frequency-tuneability, bias dependence, dynamic range, linearity, and intrinsic noise are presented in this paper.

Applied Physics Letters•Jun 25, 2012•13 citations
First we report on the microwave characteristics of the third order intermodulation distortion (IMD3) in a High-Tc Superconductor (HTS) Josephson Junction (JJ) Downconverter at 12 GHz. We have successfully developed high quality nonlinear YBCO microbridge Josephson junctions for such an active MMIC as a mixer with RF, LO, IF and bias filters, which have been fabricated on (100) MgO substrates with 20 mm X 20 mm X 0.5 mm dimensions. The minimum conversion loss of the JJ mixer is 11 dB at very small local microwave input power LO equals -20 dBm which is two order less than a Schottky diode mixer. Consequently, this small optimum LO power gives the small rf input power at which the output IF power of the YBCO mixer saturates. Two-tone third-order intercept point (IP3) performance is a significantly important figure of merit typically used to define linearity of devices and circuits. The rf input power equals -15 dBm at the IP3 point is obtained for the YBCO mixer at 15 K and LO equals 10.935 GHz with -22 dBm. We have successfully measured the dependence of IMD3 on temperature, bias current, and LO power.
© 2014 IOP Publishing Ltd. A high-Tc superconducting (HTS) monolithic microwave integrated circuit (MMIC) Josephson down-converter that approaches zero conversion loss is reported. The all-HTS YBa2Cu3O7-x thin-film circuit consists of a step-edge Josephson junction mixer, a 10-12 GHz bandpass filter for the RF input, a lowpass filter for the IF output and a resonant strip line for local oscillator isolation; all are integrated on a single 10 mm × 20 mm MgO substrate. The DC characteristics of the junction and its mixing properties have been experimentally studied and compared to the results of (a) a single Josephson mixer without the on-chip HTS filters, and (b) our previously reported MMIC down-converter which had very different junction characteristics. The Josephson junction parameters are analysed to give insight into their effect on the mixer performance.
A YBa/sub 2/Cu/sub 3/O/sub 7- delta / (YBCO) step-edge microbridge JJ (Josephson junction), two 12-GHz YBCO microstrip bandpass filters, a 1-GHz YBCO filter, and current bias and voltage monitor circuits were successfully combined on a 20-mm*20-mm MgO substrate and integrated into a frequency downconverter for receiving DBS (direct broadcast satellite) signals. The YBCO downconverter and the GaAs low-noise IF (intermediate frequency) amplifier were combined in a microwave cryostat. The dependence of mixing signals on temperature and LO (local oscillator) input power was measured. The conversion gain and the noise figure corresponding to the YBCO downconverter package were -14.5 dB and 12.2 dB, respectively, at 15 K and low LO power (-25 dBm). The first demonstration of the HTS (high-temperature superconductive) subsystem, i.e. the monolithic YBCO downconverter, shows potential for applications in mobile radio communications and satellite broadcasting.>
The Commonwealth Scientific and Industrial Research Organization has developed superconducting microwave monolithic integrated circuit (MMIC) mixers using step-edge Josephson junctions and on-chip filters, made from YBaCuO on MgO substrates. Integration into an MMIC results in a compact and efficiently coupled structure. These have been shown to have outstanding conversion efficiency, dynamic range, and linearity. We report here a range of simulations of this type of mixer. We have mainly used Josephson simulators and analyze the data in both the time and frequency domains. More recently, we have also used microwave simulators incorporating a novel Verilog-A Josephson junction model that we have developed. We have looked at the interactions of junction bias current, local oscillator power, and radio-frequency input power with conversion efficiency, dynamic range, and linearity. Good agreement is found overall with measurements.
A compact high-Tc superconducting monolithic microwave integrated circuit Josephson down-converter is presented. The circuit consists of a single Josephson junction mixer, a bandpass filter, a lowpass filter, and a resonator for local oscillator fabricated on a single 10 mm × 20 mm chip of YBa2Cu3O7−x film on MgO substrate. The down-converter demonstrates superior performance in terms of conversion efficiency, dynamic range, linearity, and low local oscillator power with stable operation from 20 to 77 K. A maximum conversion gain of −4.7 dB was measured at 20 K and −12.8 dB at 70 K.
We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.
A monolithic microwave integrated circuit (MMIC) frequency down-converter based on a compact high-Tc superconducting (HTS) device is demonstrated. The on-chip integrated HTS down-converter consists of a 7–9 GHz bandpass filter for RF input, a lowpass filter for intermediate frequency output, and a self-pumped Josephson heterodyne mixer. All the above passive and active components are fabricated on a single 10 mm × 20 mm chip of YBa2Cu3O7−x film on MgO substrate. Characterization of this MMIC HTS down-converter in terms of frequency response, conversion gain, frequency-tuneability, bias dependence, dynamic range, linearity, and intrinsic noise are presented in this paper.