Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

The Journal of Chemical Physics

Comment on “A comment on dielectric hole burning” [J. Chem. Phys. 111, 1043 (1999)]

Oliver Kircher, Ralph V. Chamberlin, Gregor Diezemann, R. Böhmer

Published Oct 15, 2000• 3 citations
Publisher
DOI
10.1063/1.1287061

Related papers

Comments on the determination of dispersion in the kinetics of hole-burning reactions

W. Köhler, J. Friedrich

Chemical Physics Letters•Feb 1, 1987•13 citations

Color effects in pressure-tuned hole-burned spectra

Gerhard Gradl, J. Zollfrank, W. Breinl +1 more

We applied hydrostatic pressure to spectral holes burned into a resorufin doped ethanol/methanol glass. We found that the line shift is perfectly linear with pressure and showed a pronounced dependence on the burn frequency as predicted by theory [J. Chem. Phys. 90, 3274 (1989)]. We exploited the burn frequency dependence to determine the solvent shift of the dye probe and the compressibility of the alcohol glass used. On the other hand, the behavior of the hole width under pressure shows features not predicted by theory: The broadening is, like the line shift, dependent on the burn frequency within the inhomogeneous band, yet in a nonlinear fashion. We attribute the color effect in the pressure induced broadening of the hole to a breakdown of the Gaussian approximation.

The Journal of Chemical Physics•Jun 15, 1991•43 citations

Comment on “a Dynamic Electric Trap for Ground-State Atoms”

Eric Cornell

Europhysics Letters (EPL)•Jun 1, 1995•3 citations

Comment on “Variations on the Aharonov–Bohm effect” [Am. J. Phys. 59 (12), 1080–1085 (1991)]

Stanley A. Bruce

American Journal of Physics•Dec 1, 1998•4 citations

Comparison of photon echo, hole burning, and single molecule spectroscopy data on low-temperature dynamics of organic amorphous solids

Stephan J. Zilker, L. Kador, J. Friebel +3 more

A joint analysis of spectroscopic data obtained at liquid–helium temperatures by three line-narrowing techniques, photon echo (PE), persistent hole burning (HB), and single molecule spectroscopy (SMS), is presented. Two polymer systems, polyisobutylene (PIB) and polymethylmethacrylate (PMMA), doped with tetra-tert-butylterrylene (TBT) were studied via PE and HB techniques and the results are compared with literature data [R. Kettner et al., J. Phys. Chem. 98, 6671 (1994); B. Kozankiewicz et al., J. Chem. Phys. 101, 9377 (1994)] obtained by SMS. Both systems behave quite differently. In TBT/PIB a rather strong influence of a dispersion of the dephasing time T2 was found which plays only a minor role in TBT/PMMA. We have also measured the temperature dependence of T2 for both systems in a broad temperature range (0.4–22 K). Using these data we separated the two different contributions to the optical dephasing — due to an interaction with two-level systems and due to coupling with local low-frequency modes. The data are compared with calculations using a numerical and a semianalytical model in the presence of a large dispersion of the single molecule parameters. Furthermore, we discuss the differences of the linewidths as measured by different experimental methods.

The Journal of Chemical Physics•Oct 22, 1998•31 citations

Persistent Photochemical Hole-Burning in the R-Lines of Tetravalent Manganese in Submicron α-Al2O3

Norfadira Binti Wahib, Hans Riesen

Persistent spectral hole-burning in the R-lines of tetravalent manganese in X-irradiated submicron corundum powder is reported for the first time. Two samples were investigated, namely, nominally 0.4 atom % Mn 3+ -doped and 0.4 atom % Mn 4+, Mg 2+ -codoped α-Al 2 O 3 . The samples were produced by a simple combustion reaction method at 600 °C. Spectral hole-burning properties of Mn 4+ ions burned via the R 1 and R 2 lines were measured either by the photoluminescence excitation mode via monitoring the luminescence signal of a vibrational sideband at ∼694 nm or in luminescence, with blue light excitation after the burn period. The hole widths were studied as a function of burn fluence and temperature in the range from 2 to 90 K. We propose a photochemical hole-burning mechanism for both samples based on photoionization and photoreduction of the tetravalent manganese ion. Interestingly, the 0.4 atom % Mn 4+, Mg 2+ sample displayed a higher hole-burning efficiency than the Mn 3+ sample. The hole widths obtained for the persistent spectral holes in the present powder samples were approximately 300 times broader at 2.2 ± 0.1 GHz compared to the ∼6 MHz width observed in transient hole-burning in a macroscopic crystal [ Riesen, H. Chem. Phys. Lett. 2011, 515 (44), 241−244]. We assign this effect to the disruption of the crystal lattice upon the valence state change of the Mn 4+ ion in the hole-burning process. From the hole width, we obtained a decay time of 0.72 ns for the 2 A̅ → E̅ one-phonon relaxation process within the split 2 E excited state. The stability of the spectral holes burned via the R 1 and R 2 lines was investigated for both samples, and we observed a decay of about 20% within 2 h, indicating slow spontaneous hole-filling. A hole area recovery of ∼70 and ∼64% was observed after a temperature cycle from 2.5 to 70 and 90 K for the 0.4 atom % Mn 3+ and 0.4 atom % Mn 4+, Mg 2+ samples, respectively.

The Journal of Physical Chemistry C•Aug 24, 2023•0 citations
We applied hydrostatic pressure to spectral holes burned into a resorufin doped ethanol/methanol glass. We found that the line shift is perfectly linear with pressure and showed a pronounced dependence on the burn frequency as predicted by theory [J. Chem. Phys. 90, 3274 (1989)]. We exploited the burn frequency dependence to determine the solvent shift of the dye probe and the compressibility of the alcohol glass used. On the other hand, the behavior of the hole width under pressure shows features not predicted by theory: The broadening is, like the line shift, dependent on the burn frequency within the inhomogeneous band, yet in a nonlinear fashion. We attribute the color effect in the pressure induced broadening of the hole to a breakdown of the Gaussian approximation.
A joint analysis of spectroscopic data obtained at liquid–helium temperatures by three line-narrowing techniques, photon echo (PE), persistent hole burning (HB), and single molecule spectroscopy (SMS), is presented. Two polymer systems, polyisobutylene (PIB) and polymethylmethacrylate (PMMA), doped with tetra-tert-butylterrylene (TBT) were studied via PE and HB techniques and the results are compared with literature data [R. Kettner et al., J. Phys. Chem. 98, 6671 (1994); B. Kozankiewicz et al., J. Chem. Phys. 101, 9377 (1994)] obtained by SMS. Both systems behave quite differently. In TBT/PIB a rather strong influence of a dispersion of the dephasing time T2 was found which plays only a minor role in TBT/PMMA. We have also measured the temperature dependence of T2 for both systems in a broad temperature range (0.4–22 K). Using these data we separated the two different contributions to the optical dephasing — due to an interaction with two-level systems and due to coupling with local low-frequency modes. The data are compared with calculations using a numerical and a semianalytical model in the presence of a large dispersion of the single molecule parameters. Furthermore, we discuss the differences of the linewidths as measured by different experimental methods.
Persistent spectral hole-burning in the R-lines of tetravalent manganese in X-irradiated submicron corundum powder is reported for the first time. Two samples were investigated, namely, nominally 0.4 atom % Mn 3+ -doped and 0.4 atom % Mn 4+, Mg 2+ -codoped α-Al 2 O 3 . The samples were produced by a simple combustion reaction method at 600 °C. Spectral hole-burning properties of Mn 4+ ions burned via the R 1 and R 2 lines were measured either by the photoluminescence excitation mode via monitoring the luminescence signal of a vibrational sideband at ∼694 nm or in luminescence, with blue light excitation after the burn period. The hole widths were studied as a function of burn fluence and temperature in the range from 2 to 90 K. We propose a photochemical hole-burning mechanism for both samples based on photoionization and photoreduction of the tetravalent manganese ion. Interestingly, the 0.4 atom % Mn 4+, Mg 2+ sample displayed a higher hole-burning efficiency than the Mn 3+ sample. The hole widths obtained for the persistent spectral holes in the present powder samples were approximately 300 times broader at 2.2 ± 0.1 GHz compared to the ∼6 MHz width observed in transient hole-burning in a macroscopic crystal [ Riesen, H. Chem. Phys. Lett. 2011, 515 (44), 241−244]. We assign this effect to the disruption of the crystal lattice upon the valence state change of the Mn 4+ ion in the hole-burning process. From the hole width, we obtained a decay time of 0.72 ns for the 2 A̅ → E̅ one-phonon relaxation process within the split 2 E excited state. The stability of the spectral holes burned via the R 1 and R 2 lines was investigated for both samples, and we observed a decay of about 20% within 2 h, indicating slow spontaneous hole-filling. A hole area recovery of ∼70 and ∼64% was observed after a temperature cycle from 2.5 to 70 and 90 K for the 0.4 atom % Mn 3+ and 0.4 atom % Mn 4+, Mg 2+ samples, respectively.