We propose a new measure, suitability, to assess the performance of single-photon guns in the context of specific applications. In particular, we demonstrate the requirements for applications to quantum key distribution (QKD) are quite different, and less stringent, than those for linear optical quantum computing.
The creation of specified quantum states is important for most, if not all, applications in quantum computation and communication. The quality of the state preparation is therefore an essential ingredient in any assessment of a quantum-state gun. We show that the fidelity, under the standard definitions, is not sufficient to assess quantum sources, and we propose a measure of suitability that necessarily depends on the application for the source. We consider the performance of single-photon guns in the context of quantum key distribution (QKD) and linear optical quantum computation. Single-photon sources for QKD need radically different properties than sources for quantum computing. Furthermore, the suitability for single-photon guns is discussed explicitly in terms of experimentally accessible criteria.
When quantum information is encoded in optical polarization, practical protocols must contend with the fact that preparation and measurement reference frames may be misaligned, owing to physical orientations and birefringence effects. For long-distance transmissions, a common solution involves multiplexing strong classical reference signals, providing a basis for correction. Here we numerically investigate the performance of a polarization-frame alignment protocol utilizing single-photon-level signals and measurements, in the context of quantum key distribution (QKD) over channels with detector noise and imperfect sources. To the extent possible, the same states and measurement bases are used as for the QKD protocol we intend to support. Our results show that a small fraction of resources from the overall signal---a few hundred photon detections, in total---are required for good performance, restoring the state to better than 99% of its original quality, and we illustrate the protocol's successful operation and adaptability through experimental demonstrations in which it was used in the laboratory and the field.
Experimental results obtained with silicon single photon avalanche diodes (SPADs) in quantum key distribution (QKD) at short wavelengths reveal remarkable potential for application in local area networks (LAN) and for free-space transmission at high rate. Actual application prospects, however, depend on the performance level and on the suitability of practical systems using the available silicon SPAD devices. They can be essentially divided in two groups: planar p-n junction structures with a thin depletion layer (typically 1 μm); and reach-through structures with a thick depletion layer (from 20 μm to 150μm). The physical mechanisms that control the device behaviour were investigated and the effect on the key parameters of the detector (quantum detection efficiency, dark counting rate, afterpulsing probability and photon-timing jitter) were thoroughly assessed. A quantitative analysis was made of the influence of such parameters on the quantum bit error rate (QBER). Actual parameters were measured and the attainable performance and system suitability of the two device types evaluated. Comparable performance is obtained, but from a system viewpoint thin SPADs appear inherently better suited to high-rate QKD applications, because of their faster response time, ruggedness, low voltage, low power dissipation and fabrication technology, which is simple, efficient, economical and compatible with monolithic integration of detector and associated circuits.