Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Ultimate rate densities in optical transmission of information

Mikhail A. Khodasevich, George V. Sinitsyn, Anatoly S. Yasukevich

Published Sep 5, 2003• 0 citations
Publisher

Abstract

Information-rate densities in optical communication systems are investigated on the base of the number-state model. Results of numerical simulation show that the considered characteristics increase monotonically with increasing signal power, reducing passband width and environment temperature. For quasi-monochromatic optical communication channels quantum-statistical peculiarities of information carriers can not be taken into account at large enough singal powers when fluctuation noise can be neglected.

DOI
10.1117/12.518059

Related papers

Limiting speed characteristics of optoelectronic communication channels in the number-state model

Mikhail A. Khodasevich, George V. Sinitsyn, Anatoly S. Yasukevich

We investigate some limiting characteristics of two- component optoelectronic system for information transmission on the base of number-state model and Brillouin's negentropy principle. The expression for the upper bound of the capacity of considered communication system is obtained. It is shown, that the capacity of the whole system is substantially limited by the speed characteristics of an optical subsystem. Only in the limited power range of optical signal it is determined by speed of the information transmission in an electronic subsystem. Such a consideration enables us to get deeper insight into the basic principles of information processing in channels with different nature of carriers.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 24, 2000•0 citations

Influence of laser parameters on information capacity of communication channel

S. A. Shoydin

Contemporary tendencies in developing computing and communication systems are, more than ever, pointing out the necessity of transfer from computer and information systems to the optic and even quantum ones [1–4]. Saturation of microelectronics potencies can be seen in the simple and obvious facts, i.e. slowdown of effectiveness increase rates for the classical Turing computing systems and transfer to multicore parallel computations in electronics, as well as greater attention is paid to the optical communication channels, memory and data transmission systems, which is due to high density of information pack in the optical spectrum of electromagnetic waves [5–7].Taking into account the classical Shannon’s understanding of the information quantity and specific characteristics of an optical communication channel, in this work, we are trying to draw a parallel between the classical communication channel and the quantum one, which enables us, in some simple cases, to consider the approximate dependence of maximum information transmission rate on the key characteristics of laser emitter, including the average transmission power, bandwidth, and polarization.

Optical Memory and Neural Networks•Oct 1, 2014•4 citations

Quantum-statistical restrictions on the information transmission rate in narrow-band photonic and electronic channels

Mikhail A. Khodasevich, Fedor V. Karpushko

On the base of entropy defect principle the models are considered of narrow-band quantum communication channels and compared with the classic description of information channels. The classic model is shown to be applicable in a wide range of channels' parameters. But in the case of fermionic channels it is necessary to take into account that values of signal power and channel capacity are limited. These maximum values can be approximated by the simple expressions. Bosonic channels are free of these limitations. The rough quantum model of narrow-band bosonic channels gives too high values of capacity at low communication rate as compared with accurate one.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 28, 1997•0 citations

Comparison of the capacities of communication channels with different statistics of information carriers

Mikhail A. Khodasevich, George V. Sinitsyn, Anatoly S. Yasukevich

Summary form only given. We investigate reliability of information transmission in the number-state model for fermionic (electronic) channel and consider a special case when the signal excites particles that are initially in the vicinity of fermi energy /sub F/ ("thermal" fermions) and a quantum of signal energy is much greater than kT/sub 0/, where k is Boltzman constant and to is the environment temperature.

Conference on Lasers and Electro-Optics•Aug 29, 2005•0 citations

Quantum Effect on Information Transmission

Francis T.S. Yu, Francis T.S. Yu

We consider a communication system consisting of an information source of electromagnetic radiation. It is assumed that the information source radiates an electromagnetic signal with an average power S, and the signal propagated through the electromagnetic channel is assumed to be perturbed by additive thermal noise at temperature T. For simplicity, we assume that the electromagnetic signal is one-dimensional (i.e., the photon fluctuation is restricted to only one polarized state), in which the propagation occurs in the same direction of the wave vectors. It is emphasized that the corresponding occupation number of the quantum levels can be fully described. Obviously, these occupation quantum levels correspond to the microsignal structure of the information source. It is therefore assumed that these occupation numbers can be uniquely determined for those representing an input signal ensemble. We further assume that an ideal receiver (an ideal photon counter) is used at the output end of the channel. That is, the receiver is able to detect the specified frequencies of the electromagnetic signal. It is also emphasized that in practice the interaction of the electromagnetic signal and the detector are strictly statistical, that is, a certain amount of information loss is expected at the output end of the receiver. The idealized model of the receiver we have proposed mainly simplifies the method by which the quantum effect on the communication channel can be easily calculated.

CRC Press eBooks•Oct 8, 2018•0 citations

The energetical threshold of optical information detection due to thermal noise

Andris O. Ozols, Jurģis Poriņš, Girts Ivanovs

The minimum average optical signal power, Pmin., in optical communications is limited by the photodetector quantum efficiency and by noise. In this paper, the effect of thermal photons irradiated by all materials at absolute temperatures T>0 on optical information detection in communication lines is quantitatively considered. Usually, only the thermal current fluctuations in the photodetector are taken into account. Basing on the negentropy principle of information, assuming the Planck's blackbody radiation spectral distribution of photons, and describing the optical communication channel as non-symmetric noisy binary channel we have calculated the minimum energy required for the detection of one bit of information, ε= 6.5kT/bit, k =1.38×10-23 J/K being the Boltzmann constant. This ε value corresponds to the large error probability q = 0.20. At T = 20°C ε=4.05×10-21 J/bit and for the bit rate of R = 1010 bits/s one finds Pmin = Rε2.63×10-7 mW. In the case of more realistic value of q=10-9 ε=26kT/bit=1.05×10-19 J/bit, Pmin = 1.05×10-6 mW. This is only about 10 times lower than the quantum photodetection limit of conventional photodetectors. For more sensitive photodetectors the thermal photon noise can become important. It is shown that the minimum signal energy estimate ε≈10-19 J/bit is applicable also in a wider error probability range of q=10-3-10-15.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 10, 2008•0 citations
Information-rate densities in optical communication systems are investigated on the base of the number-state model. Results of numerical simulation show that the considered characteristics increase monotonically with increasing signal power, reducing passband width and environment temperature. For quasi-monochromatic optical communication channels quantum-statistical peculiarities of information carriers can not be taken into account at large enough singal powers when fluctuation noise can be neglected.
We investigate some limiting characteristics of two- component optoelectronic system for information transmission on the base of number-state model and Brillouin's negentropy principle. The expression for the upper bound of the capacity of considered communication system is obtained. It is shown, that the capacity of the whole system is substantially limited by the speed characteristics of an optical subsystem. Only in the limited power range of optical signal it is determined by speed of the information transmission in an electronic subsystem. Such a consideration enables us to get deeper insight into the basic principles of information processing in channels with different nature of carriers.
Contemporary tendencies in developing computing and communication systems are, more than ever, pointing out the necessity of transfer from computer and information systems to the optic and even quantum ones [1–4]. Saturation of microelectronics potencies can be seen in the simple and obvious facts, i.e. slowdown of effectiveness increase rates for the classical Turing computing systems and transfer to multicore parallel computations in electronics, as well as greater attention is paid to the optical communication channels, memory and data transmission systems, which is due to high density of information pack in the optical spectrum of electromagnetic waves [5–7].Taking into account the classical Shannon’s understanding of the information quantity and specific characteristics of an optical communication channel, in this work, we are trying to draw a parallel between the classical communication channel and the quantum one, which enables us, in some simple cases, to consider the approximate dependence of maximum information transmission rate on the key characteristics of laser emitter, including the average transmission power, bandwidth, and polarization.
On the base of entropy defect principle the models are considered of narrow-band quantum communication channels and compared with the classic description of information channels. The classic model is shown to be applicable in a wide range of channels' parameters. But in the case of fermionic channels it is necessary to take into account that values of signal power and channel capacity are limited. These maximum values can be approximated by the simple expressions. Bosonic channels are free of these limitations. The rough quantum model of narrow-band bosonic channels gives too high values of capacity at low communication rate as compared with accurate one.
We consider a communication system consisting of an information source of electromagnetic radiation. It is assumed that the information source radiates an electromagnetic signal with an average power S, and the signal propagated through the electromagnetic channel is assumed to be perturbed by additive thermal noise at temperature T. For simplicity, we assume that the electromagnetic signal is one-dimensional (i.e., the photon fluctuation is restricted to only one polarized state), in which the propagation occurs in the same direction of the wave vectors. It is emphasized that the corresponding occupation number of the quantum levels can be fully described. Obviously, these occupation quantum levels correspond to the microsignal structure of the information source. It is therefore assumed that these occupation numbers can be uniquely determined for those representing an input signal ensemble. We further assume that an ideal receiver (an ideal photon counter) is used at the output end of the channel. That is, the receiver is able to detect the specified frequencies of the electromagnetic signal. It is also emphasized that in practice the interaction of the electromagnetic signal and the detector are strictly statistical, that is, a certain amount of information loss is expected at the output end of the receiver. The idealized model of the receiver we have proposed mainly simplifies the method by which the quantum effect on the communication channel can be easily calculated.
The minimum average optical signal power, Pmin., in optical communications is limited by the photodetector quantum efficiency and by noise. In this paper, the effect of thermal photons irradiated by all materials at absolute temperatures T>0 on optical information detection in communication lines is quantitatively considered. Usually, only the thermal current fluctuations in the photodetector are taken into account. Basing on the negentropy principle of information, assuming the Planck's blackbody radiation spectral distribution of photons, and describing the optical communication channel as non-symmetric noisy binary channel we have calculated the minimum energy required for the detection of one bit of information, ε= 6.5kT/bit, k =1.38×10-23 J/K being the Boltzmann constant. This ε value corresponds to the large error probability q = 0.20. At T = 20°C ε=4.05×10-21 J/bit and for the bit rate of R = 1010 bits/s one finds Pmin = Rε2.63×10-7 mW. In the case of more realistic value of q=10-9 ε=26kT/bit=1.05×10-19 J/bit, Pmin = 1.05×10-6 mW. This is only about 10 times lower than the quantum photodetection limit of conventional photodetectors. For more sensitive photodetectors the thermal photon noise can become important. It is shown that the minimum signal energy estimate ε≈10-19 J/bit is applicable also in a wider error probability range of q=10-3-10-15.