Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Coherent π-pulse propagation with pulse breakup in an erbium-doped fiber waveguide amplifier

Masataka Nakazawa, Kazunori Suzuki, Yasuo N. Kimura, Hirokazu Kubota

Published Mar 1, 1992• 53 citations
Publisher

Abstract

Coherent \ensuremath{\pi}-pulse propagation with pulse breakup has been observed in an erbium-doped fiber waveguide amplifier. The waveguide was pumped by a 1.48-\ensuremath{\mu}m ${\mathrm{In}}_{1\mathrm{\ensuremath{-}}\mathit{x}}$${\mathrm{Ga}}_{\mathit{x}}$${\mathrm{As}}_{\mathit{y}}$${\mathrm{P}}_{1\mathrm{\ensuremath{-}}\mathit{y}}$ laser diode. The waveguide had an erbium ion concentration of 8900 ppm and was cooled to 4.2 K. The pulse source was a 1.53-\ensuremath{\mu}m mode-locked Er-doped glass laser with a pulse width of 400 ps. A pulse advance of approximately 130 ps was observed between a low-intensity transmitted pulse with a low pump power and an amplified \ensuremath{\pi} pulse in a 1.5-m-long fiber.

DOI
10.1103/physreva.45.r2682

Related papers

Self-induced-transparency solitons in an erbium-doped fiber waveguide

Masataka Nakazawa, Yasuo N. Kimura, Kenji Kurokawa +1 more

Self-induced transparency (SIT) has been observed in an erbium-doped resonant fiber waveguide. The waveguide had an erbium ion concentration of 8900 ppm, and was cooled to 4.2 K. The pulse source was a 1.53-\ensuremath{\mu}m mode-locked Er-doped glass laser with a pulse width of 500 ps. Stable 2\ensuremath{\pi}, 4\ensuremath{\pi}, and multiple soliton pulses that broke up were clearly observed.

Physical Review A•Jan 1, 1992•80 citations

"Analytical Model of Pulse Amplification in Erbium Doped Fiber Amplifier "

Nour. A. Naser, Muhammed. R. Harb, Hassan Abid Yasser

"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Oct 14, 2020•0 citations

Self-induced transparency soliton propagation in an erbium-doped optical fiber waveguide

Masataka Nakazawa, Yasuo N. Kimura, Kazunori Suzuki +2 more

The recent development of the EDFA (erbium-doped fiber amplifier) offers the possibility for uses of the fibers to experiments on coherent pulse propagation such as self-induced transparency (SIT). The guiding of the radiation by the fiber structure eliminates diffraction effects and makes possible the interaction of the radiation with the fiber medium which has resonance effects over long distances. To date, however, experiments on SIT solitons have suffered from diffraction effects that were further complicated by nonlinear interactions. In the present paper, we report for the first time the observation of SIT soliton propagation in an erbium- doped resonant fiber waveguide.

Annual Meeting Optical Society of America•Jan 1, 1991•0 citations

Pulse propagation of accumulated photon echoes in Nd3+ ion-doped silicate glass fiber

Ryuzi Yano, Naoshi Uesugi

Pulse-propagation phenomena of accumulated photon echo signals was investigated for the F3/24(1)–I9/24 transition of the Nd3+ ion doped with 20 ppm concentration in silicate glass fiber (core diameter of 6 μm) at 4.2 K using an 82 MHz mode-locked dye laser. The intensity of the transmitted probe pulses from the Nd3+ fiber was measured as a function of the Nd3+ fiber length. The fiber length for the maximum probe-pulse intensity induced by the pump pulses was determined to be 4 m when the pump pulses of 0.50 mW average power and the probe pulses of 0.25 mW average power were used. We derived the pulse area equations which take into account the coherent interaction between the pulses and the Nd3+ fiber. The fiber-length dependence of the signal intensity was explained well by the pulse area equations.

Applied Physics Letters•Sep 22, 1997•1 citation

Slow and fast light propagation in erbium-doped fiber

Nikolay N. Lepeshkin, Aaron Schweinsberg, Matthew S. Bigelow +2 more

We study propagation of light pulses and modulation in an Er-doped fiber in the regimes of anomalously slow and superluminal group velocities. The pulses experience either delay or advancement depending on the pump power.

Quantum Electronics and Laser Science Conference•Dec 10, 2005•3 citations

Laser-diode-pumped nonlinear switch in erbium-doped fiber

R. H. Pantell, Robert W. Sadowski, Michel J. F. Digonnet +1 more

We describe a two-mode fiber switch made of a short length of erbium-doped fiber in which switching is accomplished by a nonlinearity that is resonantly enhanced by the dopant. In a 0.95-m fiber pumped with a 1.48-μm laser diode, a 906-nm signal is switched with only 8 mW of absorbed power at a signal absorption loss of 0.25 dB.

Optics Letters•Jul 15, 1992•35 citations
Coherent \ensuremath{\pi}-pulse propagation with pulse breakup has been observed in an erbium-doped fiber waveguide amplifier. The waveguide was pumped by a 1.48-\ensuremath{\mu}m {\mathrm{In}}_{1\mathrm{\ensuremath{-}}\mathit{x}}$${\mathrm{Ga}}_{\mathit{x}}$${\mathrm{As}}_{\mathit{y}}$${\mathrm{P}}_{1\mathrm{\ensuremath{-}}\mathit{y}} laser diode. The waveguide had an erbium ion concentration of 8900 ppm and was cooled to 4.2 K. The pulse source was a 1.53-\ensuremath{\mu}m mode-locked Er-doped glass laser with a pulse width of 400 ps. A pulse advance of approximately 130 ps was observed between a low-intensity transmitted pulse with a low pump power and an amplified \ensuremath{\pi} pulse in a 1.5-m-long fiber.
"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.
The recent development of the EDFA (erbium-doped fiber amplifier) offers the possibility for uses of the fibers to experiments on coherent pulse propagation such as self-induced transparency (SIT). The guiding of the radiation by the fiber structure eliminates diffraction effects and makes possible the interaction of the radiation with the fiber medium which has resonance effects over long distances. To date, however, experiments on SIT solitons have suffered from diffraction effects that were further complicated by nonlinear interactions. In the present paper, we report for the first time the observation of SIT soliton propagation in an erbium- doped resonant fiber waveguide.
Pulse-propagation phenomena of accumulated photon echo signals was investigated for the F3/24(1)–I9/24 transition of the Nd3+ ion doped with 20 ppm concentration in silicate glass fiber (core diameter of 6 μm) at 4.2 K using an 82 MHz mode-locked dye laser. The intensity of the transmitted probe pulses from the Nd3+ fiber was measured as a function of the Nd3+ fiber length. The fiber length for the maximum probe-pulse intensity induced by the pump pulses was determined to be 4 m when the pump pulses of 0.50 mW average power and the probe pulses of 0.25 mW average power were used. We derived the pulse area equations which take into account the coherent interaction between the pulses and the Nd3+ fiber. The fiber-length dependence of the signal intensity was explained well by the pulse area equations.