Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Journal of Infrared and Millimeter Waves

Minimum noise temperature of a practical SIS quantum mixer

Hans J. Hartfuss, M. Tutter

Published May 1, 1984• 15 citations
Publisher
DOI
10.1007/bf01009604

Related papers

Millimeter and Submillimeter SIS Mixers with the Noise Temperature Close to the Quantum Limit

Alexandre Karpov, J. Blondel, B. Lazareff +1 more

Softwaretechnik-Trends•May 1, 1994•0 citations

Quantum noise in the quantum theory of mixing

M. J. Feldman

The minimum noise temperature obtainable in the quantum theory of mixing, allowing arbitrary terminations at all considered frequencies, is shown to be hω/2k, the same result as for other high-gain linear amplifiers. The conditions for attaining this absolute minimum noise appear to be fulfilled in only two cases, approximated by the super-Schottky mixer with large LO, and by the SIS mixer with small LO. For the ideal SIS mixer, the minimum noise requires one particular value of source impedance, regardless of the image termination. The origin of the quantum noise is discussed.

IEEE Transactions on Magnetics•Mar 1, 1987•27 citations

Multibeam SIS mixer module for a focal plane array receiver

Alexandre Karpov, J. Blondel, M. C. Carter +3 more

The integration of many receiver units into a receiver array is a common method of improvement of imaging systems. This approach, well known in the mm band for Schottky mixer arrays, has not so far been developed for Superconductor-Insulator- Superconductor (SIS) junction mixers, which give the best sensitivity in the short mm wave range and in the submm range. We demonstrate for the first time a practical low noise multibeam receiver module using SIS mixer technology. The module comprises three identical SIS mixers integrated with a common local oscillator, coupled through a three branch waveguide directional coupler. The multibeam module has been developed for a focal plane array receiver of the 30 meter radio telescope of the Institut de Radioastronomie Millimetrique (IRAM). Three such modules will be used in a 3 X 3 array operating near 230 GHz frequency. We discuss the requirements on the performance of the multibeam receiver module and compare it with a single beam receiver arrangement. After the presentation of a single mixer receiver operation the performance of the three mixer module is described. The basis for the integration of several SIS mixers with a common local oscillator source is given by the saturation of the SIS receiver noise dependence upon local oscillator power. The 1.3 mm SIS mixer block is built with a reduced height waveguide. The individual SIS junction area is 2.2 micrometer2 with a Josephson critical current density of about 3.6 KA/cm2. The minimum SSB receiver noise temperature at 230 GHz in a single beam receiver is as low as 50 K. In the module a common local oscillator power source is connected to the three mixers through a common three branch directional coupler. The performance of the three mixers is nearly identical across the 200 - 250 GHz band. The minimum DSB receiver noise temperature of 37 K is obtained simultaneously in all three channels around 230 GHz.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 31, 1998•1 citation

The system noise temperature of quantum amplifiers

Aldert van der Ziel

Proceedings of the IEEE•Jan 1, 1963•7 citations

Noise properties of a mixer with SIS NbN quasi-particle tunnel junctions

Alexandre Karpov, B. Plathner, K. H. Gundlach +2 more

We present the noise properties of a mixer with the NbN-MgO-NbN quasiparticle tunnel junctions. Our work is based on experiment in the 120-180 GHz range with the NbN tunnel junctions in the mixer. Mixer printed circuit is totally made of NbN. The mixer operates at 5.4 K temperature unacceptable with Nb junctions. The minimum DSB receiver noise temperature is about 65 K at 162 GHz and approaches the Nb SIS mixer performance in mm band. It has been found that the noise sources in the NbN junctions are comparable to the Nb junctions and that the receiver noise with the NbN SIS mixer may be only few times more than the quantum limit of noise in the frequency range below the gap frequency. Output noise of the SIS mixer has been found constant in a wide frequency band and within an important range of the local oscillator amplitudes.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 13, 1995•3 citations

Quantum Noise in Resistive Mixers

H. Merkel, Biddut Kumar Banik

•May 1, 2006•0 citations
The minimum noise temperature obtainable in the quantum theory of mixing, allowing arbitrary terminations at all considered frequencies, is shown to be hω/2k, the same result as for other high-gain linear amplifiers. The conditions for attaining this absolute minimum noise appear to be fulfilled in only two cases, approximated by the super-Schottky mixer with large LO, and by the SIS mixer with small LO. For the ideal SIS mixer, the minimum noise requires one particular value of source impedance, regardless of the image termination. The origin of the quantum noise is discussed.
The integration of many receiver units into a receiver array is a common method of improvement of imaging systems. This approach, well known in the mm band for Schottky mixer arrays, has not so far been developed for Superconductor-Insulator- Superconductor (SIS) junction mixers, which give the best sensitivity in the short mm wave range and in the submm range. We demonstrate for the first time a practical low noise multibeam receiver module using SIS mixer technology. The module comprises three identical SIS mixers integrated with a common local oscillator, coupled through a three branch waveguide directional coupler. The multibeam module has been developed for a focal plane array receiver of the 30 meter radio telescope of the Institut de Radioastronomie Millimetrique (IRAM). Three such modules will be used in a 3 X 3 array operating near 230 GHz frequency. We discuss the requirements on the performance of the multibeam receiver module and compare it with a single beam receiver arrangement. After the presentation of a single mixer receiver operation the performance of the three mixer module is described. The basis for the integration of several SIS mixers with a common local oscillator source is given by the saturation of the SIS receiver noise dependence upon local oscillator power. The 1.3 mm SIS mixer block is built with a reduced height waveguide. The individual SIS junction area is 2.2 micrometer2 with a Josephson critical current density of about 3.6 KA/cm2. The minimum SSB receiver noise temperature at 230 GHz in a single beam receiver is as low as 50 K. In the module a common local oscillator power source is connected to the three mixers through a common three branch directional coupler. The performance of the three mixers is nearly identical across the 200 - 250 GHz band. The minimum DSB receiver noise temperature of 37 K is obtained simultaneously in all three channels around 230 GHz.
We present the noise properties of a mixer with the NbN-MgO-NbN quasiparticle tunnel junctions. Our work is based on experiment in the 120-180 GHz range with the NbN tunnel junctions in the mixer. Mixer printed circuit is totally made of NbN. The mixer operates at 5.4 K temperature unacceptable with Nb junctions. The minimum DSB receiver noise temperature is about 65 K at 162 GHz and approaches the Nb SIS mixer performance in mm band. It has been found that the noise sources in the NbN junctions are comparable to the Nb junctions and that the receiver noise with the NbN SIS mixer may be only few times more than the quantum limit of noise in the frequency range below the gap frequency. Output noise of the SIS mixer has been found constant in a wide frequency band and within an important range of the local oscillator amplitudes.