Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Efficient single-photon frequency upconversion at 1.06 μm with ultralow background counts

Huafang Dong, Haifeng Pan, Yao Li, E Wu, Heping Zeng

Published Aug 18, 2008• 44 citations
Publisher

Abstract

We demonstrated an efficient single-photon frequency upconversion system for the infrared photons at 1.06 μm with ultralow background counts. By pumping the system at a longer wavelength than that of the single-photon signal, the background counts caused by the pump-induced parametric fluorescence in the nonlinear crystal were reduced markedly. We achieved so far the lowest noise of ∼150/s for a near unity conversion efficiency.

DOI
10.1063/1.2968311

Related papers

Efficient mid-infrared single-photon frequency upconversion detection with ultra-low background counts

Xiaorong Gu, Kun Huang, Haifeng Pan +2 more

We demonstrate an efficient mid-infrared single-photon detection system with ultra-low background counts based on the frequency upconversion detection technique. The signal photons of 3.39 μm came from a He–Ne laser and the pump beam was provided by a mode-locked ytterbium-doped fiber laser. Taking into account the pulsed pumping and continuous-wave signaling scheme, the peak conversion efficiency of 64% was achieved at an average pump power of 28.3 mW. The corresponding detection efficiency was inferred to be 6.1% with ultra-low background counts of 400 s −1 .

Laser Physics Letters•Mar 7, 2013•17 citations

Temporal and spectral control of single-photon frequency upconversion for pulsed radiation

Xiaorong Gu, Kun Huang, Yao Li +3 more

We demonstrate efficient single-photon detection at 1.04 μm with quite low background counts by using the frequency upconversion detection technique with pulsed single-photon source and strong pump field prepared from two synchronized fiber lasers. Temporal and spectral control of the pump and signal lasers enabled an upconversion efficiency of 81.1%. As the system was pumped at a wavelength longer than that of the signal, the corresponding background counts were reduced down to 1.5×103 s−1 due to efficient suppression of parametric fluorescence in the periodic poled lithium niobate crystal.

Applied Physics Letters•Mar 29, 2010•39 citations

High-Efficiency Broadband Near-Infrared Single-Photon Frequency Upconversion and Detection*

Jianhui Ma, Huiqin Hu, Yu Chen +3 more

We propose and demonstrate a high efficiency broadband near infrared single-photon upconversion and detection with a broadband pump laser based on sum frequency conversion in the PPLN crystal. By using a pump laser centered at 1040 nm with a spectral bandwidth of 10 nm, the signal single-photons centered at 1562 nm with a broadband bandwidth up to 7.2 nm are frequency-converted from the near infrared to the visible regime. A maximum conversion efficiency of 18.8% is achieved, while the background noise is measured to be only 1.2 × 10−3 counts/pulse. The corresponding spectral linewidth of the upconverted photons is 0.2 nm. This scheme of broadband infrared single-photon upconversion and detection provides potential solutions in infrared laser ranging, broadband infrared imaging and quantum key distribution.

Chinese Physics Letters•Mar 1, 2020•3 citations

Efficient and stable single-photon counting at 155 μm by intracavity frequency upconversion

Haifeng Pan, Heping Zeng

A single-photon signal at 1.55 microm was converted to the visible region by sum-frequency mixing with a strong pumping beam at 1064 nm in a periodically poled lithium niobate crystal placed in a diode-pumped Nd:YVO4 laser cavity. As the intracavity pump laser could be automatically stabilized without cavity lock, robust long-term stability was demonstrated for single-photon frequency upconversion, with a conversion efficiency of 74.3%. Such a stable single-photon upconversion was demonstrated to be efficient and robust for single-photon counting at 1550 nm, and the corresponding background noise was measured at less than 420 x 10(3) s(-1).

Optics Letters•Mar 15, 2006•25 citations

Ultrasensitive mid-infrared up-conversion imaging at few-photon level

Qian Zhou, Kun Huang, Haifeng Pan +2 more

We demonstrated few-photon-level mid-infrared imaging at 3.39 μm by efficient frequency up-conversion. The quantum frequency up-conversion efficiency of mid-infrared photons was high to 32.9%, while mid-infrared images were up-converted with the quantum efficiency of 12.5%. The mid-infrared imaging sensitivity was improved by counting the frequency up-conversion photons temporally confined within the time-window of the pump pulse. The frequency up-conversion system induced a background noise of 1.1 × 103 counts per second.

Applied Physics Letters•Jun 17, 2013•43 citations

High-Speed Single-Photon Frequency Upconversion With Synchronous Pump Pulses

Xiaorong Gu, Yao Li, Haifeng Pan +2 more

Single-photon signals at 1.56 ¿m were converted into the visible region by sum-frequency generation, with synchronous pump pulses at 1.03 ¿m in a periodically poled lithium niobate crystal. The signal and pump sources were provided by two synchronized mode-locked fiber lasers at the operation rate of 7.88 MHz. Such a high-speed single-photon upconversion system has shown an overall detection efficiency of 10.4%. The corresponding background noise was measured to be 3.3 × 103s-1. The noise-equivalent power in this scheme was 9.93 × 10-17W/Hz1/2, which was the lowest compared to the other upconversion systems with similar pump and signal wavelengths.

IEEE Journal of Selected Topics in Quantum Electronics•Jan 1, 2009•9 citations
We demonstrated an efficient single-photon frequency upconversion system for the infrared photons at 1.06 μm with ultralow background counts. By pumping the system at a longer wavelength than that of the single-photon signal, the background counts caused by the pump-induced parametric fluorescence in the nonlinear crystal were reduced markedly. We achieved so far the lowest noise of ∼150/s for a near unity conversion efficiency.
We demonstrate an efficient mid-infrared single-photon detection system with ultra-low background counts based on the frequency upconversion detection technique. The signal photons of 3.39 μm came from a He–Ne laser and the pump beam was provided by a mode-locked ytterbium-doped fiber laser. Taking into account the pulsed pumping and continuous-wave signaling scheme, the peak conversion efficiency of 64% was achieved at an average pump power of 28.3 mW. The corresponding detection efficiency was inferred to be 6.1% with ultra-low background counts of 400 s −1 .
We demonstrate efficient single-photon detection at 1.04 μm with quite low background counts by using the frequency upconversion detection technique with pulsed single-photon source and strong pump field prepared from two synchronized fiber lasers. Temporal and spectral control of the pump and signal lasers enabled an upconversion efficiency of 81.1%. As the system was pumped at a wavelength longer than that of the signal, the corresponding background counts were reduced down to 1.5×103 s−1 due to efficient suppression of parametric fluorescence in the periodic poled lithium niobate crystal.
We propose and demonstrate a high efficiency broadband near infrared single-photon upconversion and detection with a broadband pump laser based on sum frequency conversion in the PPLN crystal. By using a pump laser centered at 1040 nm with a spectral bandwidth of 10 nm, the signal single-photons centered at 1562 nm with a broadband bandwidth up to 7.2 nm are frequency-converted from the near infrared to the visible regime. A maximum conversion efficiency of 18.8% is achieved, while the background noise is measured to be only 1.2 × 10−3 counts/pulse. The corresponding spectral linewidth of the upconverted photons is 0.2 nm. This scheme of broadband infrared single-photon upconversion and detection provides potential solutions in infrared laser ranging, broadband infrared imaging and quantum key distribution.
A single-photon signal at 1.55 microm was converted to the visible region by sum-frequency mixing with a strong pumping beam at 1064 nm in a periodically poled lithium niobate crystal placed in a diode-pumped Nd:YVO4 laser cavity. As the intracavity pump laser could be automatically stabilized without cavity lock, robust long-term stability was demonstrated for single-photon frequency upconversion, with a conversion efficiency of 74.3%. Such a stable single-photon upconversion was demonstrated to be efficient and robust for single-photon counting at 1550 nm, and the corresponding background noise was measured at less than 420 x 10(3) s(-1).
We demonstrated few-photon-level mid-infrared imaging at 3.39 μm by efficient frequency up-conversion. The quantum frequency up-conversion efficiency of mid-infrared photons was high to 32.9%, while mid-infrared images were up-converted with the quantum efficiency of 12.5%. The mid-infrared imaging sensitivity was improved by counting the frequency up-conversion photons temporally confined within the time-window of the pump pulse. The frequency up-conversion system induced a background noise of 1.1 × 103 counts per second.
Single-photon signals at 1.56 ¿m were converted into the visible region by sum-frequency generation, with synchronous pump pulses at 1.03 ¿m in a periodically poled lithium niobate crystal. The signal and pump sources were provided by two synchronized mode-locked fiber lasers at the operation rate of 7.88 MHz. Such a high-speed single-photon upconversion system has shown an overall detection efficiency of 10.4%. The corresponding background noise was measured to be 3.3 × 103s-1. The noise-equivalent power in this scheme was 9.93 × 10-17W/Hz1/2, which was the lowest compared to the other upconversion systems with similar pump and signal wavelengths.