Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Magnetics

Quantum noise in SIS mixers

Alexander B Zorin

Published Mar 1, 1985• 19 citations
Publisher

Abstract

A quantum-statistical analysis of the signal and noise performance of the quasiparticle (SIS) heterodyne mixers is presented. In contrast with the earlier theories, the quantum properties of the signal source have been taken into consistent consideration. In the quantum range of sensitivity the noise properties of the mixer can be characterized by the noise parameter ΘNintroduced earlier for the parametric amplifiers. Using the conventional 3-port model of the mixer circuit and the microscopic theory of the superconducting tunnel junctions we have obtained a general expression for ΘNand evaluated it numerically for various quasiparticle current step widths, dc bias voltages, local oscillator powers, signal frequencies ωs, signal source admittances Ysand operation temperatures T. In a reasonable range of these parameters,\Theta_{N}^{DSB}has turned out to be less than the so-called quantum limith\omega_{s}/2. On the contrary, in the single sideband mode of the mixer performance, ΘNis always larger thanh\omega_{s}/2. The difference between the two modes of operation is discussed from the point of view of the quantum theory of measurements.

DOI
10.1109/tmag.1985.1063669

Related papers

Computer simulations of the performance of quasiparticle heterodyne mixers

T. M. Shen, P. L. Richards

Heterodyne mixers for millimeter wavelengths which have conversion gain and noise comparable to the quantum limit can be made using the non-linearity of the quasi-particle I-V curve of SIS or SIN tunnel junctions. When the voltage range of the non-linearity becomes small compared with hω/e, classical device theory breaks down and photon assisted tunneling theory must be used to understand mixer performance. In this paper we describe detailed computer simulations of SIS and SIN quasiparticle mixers. Predictions for conversion efficiency and noise are given for both devices as a function of operating frequency, bias voltage, RF source conductance and local oscillator power. A novel type of SIN harmonic mixer is proposed for which gain is also predicted.

IEEE Transactions on Magnetics•Jan 1, 1981•24 citations

Noise parameters of SIS mixers

Larry R. D’Addario

It has been shown that low-noise receivers can be constructed at millimeter wavelengths by using mixers containing superconducting tunnel junctions as the nonlinear elements. This is possible because of both the low intrinsic noise of these devices and their potential for high conversion gain. Here, the quantum theory of mixing is used to derive the full-noise parameters and small-signal parameters of sinusoidally pumped SIS (superconductor-insulator-superconductor) junctions. These are then put into a form that allows the theory of two-port linear networks to be brought to bear, allowing calculation of such useful parameters as minimum noise temperature, optimum source impedance, available (or exchangeable) gain at minimum noise, and stability factor. These quantities are properties of the pumped junction that do not depend on the source or load impedance, but do depend on the terminations at the image and harmonic sideband frequencies. The harmonic sidebands are taken to be shorted, and the image termination dependence is studied. Numerical results are presented for both ideal (BSC theory) and practical (measured current-voltage characteristic) junctions. The noise parameters of the cascade connection of an SIS mixer and a (noisy) IF amplifier are considered, leading to a specification of the optimum coupling network between the two. It is noted that the SIS mixer is usually not unconditionally stable, but that oscillation can be avoided by careful design of the IF coupling network.< >

IEEE Transactions on Microwave Theory and Techniques•Jul 1, 1988•20 citations

Signal and Image Port Output Power in the Quantum Theory of Mixing

Qing Ke, M. J. Feldman

The quantum theory of mixing is essential for the interpretation of experimental superconducting quasiparticle (SIS) mixers. When the bias and tuning parameters are known, the theory is quite successful at predicting the mixer performance, gain and noise temperature. However, the theory usually predicts much higher conversion gain for some other set of bias and tuning parameters, and this is not seen in experiment. Thus the theory is less useful for engineering design of SIS mixers. We believe we have resolved this longstanding discrepancy. We find there are two distinct optimum operation modes for ideal SIS mixers. The high gain mode predicted by the theory will not be accessible in real experiments. To understand this we present the equations of a DSB SIS mixer in a novel form, in terms of the complex plane phase angle between the amplitude modulation input admittance vector and the local oscillator input admittance vector.

Softwaretechnik-Trends•May 1, 1994•0 citations

Noise properties of a mixer with SIS NbN quasi-particle tunnel junctions

Alexandre Karpov, B. Plathner, K. H. Gundlach +2 more

We present the noise properties of a mixer with the NbN-MgO-NbN quasiparticle tunnel junctions. Our work is based on experiment in the 120-180 GHz range with the NbN tunnel junctions in the mixer. Mixer printed circuit is totally made of NbN. The mixer operates at 5.4 K temperature unacceptable with Nb junctions. The minimum DSB receiver noise temperature is about 65 K at 162 GHz and approaches the Nb SIS mixer performance in mm band. It has been found that the noise sources in the NbN junctions are comparable to the Nb junctions and that the receiver noise with the NbN SIS mixer may be only few times more than the quantum limit of noise in the frequency range below the gap frequency. Output noise of the SIS mixer has been found constant in a wide frequency band and within an important range of the local oscillator amplitudes.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 13, 1995•3 citations

An analytic investigation of the superconductor quasiparticle mixer in the low power limit

M. J. Feldman

The properties of an SIS (Superconductor-insulator-superconductor) mixer using a slightly nonideal junction, with finite local oscillator (LO) power, are determined by analytic expansion of the equations of the quantum theory of mixing. The result is that the conversion gain using any reasonably good quality SIS junction is essentially equal to that using a perfect junction. Quite to the contrary, the minimum noise temperature is controlled by the leakage current of the junction: the increase in the minimum added-noise temperature over the quantum limit T/sub Q/=h omega /2k is given by delta T/sub Q/=(h omega /k) square root I/sub 0/I/sub 2//I/sub 1/; this minimum requires that the LO voltage across the junction is V/sub LO/=(64I/sub 0//I/sub 2/) /sup 1/4/h omega /e. (I/sub n/ is the current measured on the unpumped I-V curve of the junction at voltage V/sub 0/+nh omega /e). Therefore, although an SIS mixer using an ideal junction can reach the quantum noise limit only in the limit of zero LO power, even the most nearly ideal junctions require a considerable LO for best sensitivity.

IEEE Transactions on Magnetics•Mar 1, 1991•11 citations

Quantum-statistical theory of microwave detection using superconducting tunnel junctions

Igor A. Devyatov, L. S. Kuzmin, K. K. Likharev +2 more

A quantum-statistical theory of microwave and millimeter-wave detection using superconducting tunnel junctions is developed, with a rigorous account of quantum, thermal, and shot noise arising from fluctuation sources associated with the junctions, signal source, and matching circuits. The problem of the noise characterization in the quantum sensitivity range is considered and a general noise parameter ΘN is introduced. This parameter is shown to be an adequate figure of merit for most receivers of interest while some devices can require a more complex characterization. Analytical expressions and/or numerically calculated plots for ΘN are presented for the most promising detection modes including the parametric amplification, heterodyne mixing, and quadratic videodetection, using both the quasiparticle-current and the Cooper-pair-current nonlinearities. Ultimate minimum values of ΘN for each detection mode are compared and found to be in agreement with limitations imposed by the quantum-mechanical uncertainty principle.

Journal of Applied Physics•Sep 1, 1986•42 citations
A quantum-statistical analysis of the signal and noise performance of the quasiparticle (SIS) heterodyne mixers is presented. In contrast with the earlier theories, the quantum properties of the signal source have been taken into consistent consideration. In the quantum range of sensitivity the noise properties of the mixer can be characterized by the noise parameter ΘNintroduced earlier for the parametric amplifiers. Using the conventional 3-port model of the mixer circuit and the microscopic theory of the superconducting tunnel junctions we have obtained a general expression for ΘNand evaluated it numerically for various quasiparticle current step widths, dc bias voltages, local oscillator powers, signal frequencies ωs, signal source admittances Ysand operation temperatures T. In a reasonable range of these parameters,\Theta_{N}^{DSB}has turned out to be less than the so-called quantum limith\omega_{s}/2. On the contrary, in the single sideband mode of the mixer performance, ΘNis always larger thanh\omega_{s}/2. The difference between the two modes of operation is discussed from the point of view of the quantum theory of measurements.
Heterodyne mixers for millimeter wavelengths which have conversion gain and noise comparable to the quantum limit can be made using the non-linearity of the quasi-particle I-V curve of SIS or SIN tunnel junctions. When the voltage range of the non-linearity becomes small compared with hω/e, classical device theory breaks down and photon assisted tunneling theory must be used to understand mixer performance. In this paper we describe detailed computer simulations of SIS and SIN quasiparticle mixers. Predictions for conversion efficiency and noise are given for both devices as a function of operating frequency, bias voltage, RF source conductance and local oscillator power. A novel type of SIN harmonic mixer is proposed for which gain is also predicted.
It has been shown that low-noise receivers can be constructed at millimeter wavelengths by using mixers containing superconducting tunnel junctions as the nonlinear elements. This is possible because of both the low intrinsic noise of these devices and their potential for high conversion gain. Here, the quantum theory of mixing is used to derive the full-noise parameters and small-signal parameters of sinusoidally pumped SIS (superconductor-insulator-superconductor) junctions. These are then put into a form that allows the theory of two-port linear networks to be brought to bear, allowing calculation of such useful parameters as minimum noise temperature, optimum source impedance, available (or exchangeable) gain at minimum noise, and stability factor. These quantities are properties of the pumped junction that do not depend on the source or load impedance, but do depend on the terminations at the image and harmonic sideband frequencies. The harmonic sidebands are taken to be shorted, and the image termination dependence is studied. Numerical results are presented for both ideal (BSC theory) and practical (measured current-voltage characteristic) junctions. The noise parameters of the cascade connection of an SIS mixer and a (noisy) IF amplifier are considered, leading to a specification of the optimum coupling network between the two. It is noted that the SIS mixer is usually not unconditionally stable, but that oscillation can be avoided by careful design of the IF coupling network.< >
The quantum theory of mixing is essential for the interpretation of experimental superconducting quasiparticle (SIS) mixers. When the bias and tuning parameters are known, the theory is quite successful at predicting the mixer performance, gain and noise temperature. However, the theory usually predicts much higher conversion gain for some other set of bias and tuning parameters, and this is not seen in experiment. Thus the theory is less useful for engineering design of SIS mixers. We believe we have resolved this longstanding discrepancy. We find there are two distinct optimum operation modes for ideal SIS mixers. The high gain mode predicted by the theory will not be accessible in real experiments. To understand this we present the equations of a DSB SIS mixer in a novel form, in terms of the complex plane phase angle between the amplitude modulation input admittance vector and the local oscillator input admittance vector.
We present the noise properties of a mixer with the NbN-MgO-NbN quasiparticle tunnel junctions. Our work is based on experiment in the 120-180 GHz range with the NbN tunnel junctions in the mixer. Mixer printed circuit is totally made of NbN. The mixer operates at 5.4 K temperature unacceptable with Nb junctions. The minimum DSB receiver noise temperature is about 65 K at 162 GHz and approaches the Nb SIS mixer performance in mm band. It has been found that the noise sources in the NbN junctions are comparable to the Nb junctions and that the receiver noise with the NbN SIS mixer may be only few times more than the quantum limit of noise in the frequency range below the gap frequency. Output noise of the SIS mixer has been found constant in a wide frequency band and within an important range of the local oscillator amplitudes.
The properties of an SIS (Superconductor-insulator-superconductor) mixer using a slightly nonideal junction, with finite local oscillator (LO) power, are determined by analytic expansion of the equations of the quantum theory of mixing. The result is that the conversion gain using any reasonably good quality SIS junction is essentially equal to that using a perfect junction. Quite to the contrary, the minimum noise temperature is controlled by the leakage current of the junction: the increase in the minimum added-noise temperature over the quantum limit T/sub Q/=h omega /2k is given by delta T/sub Q/=(h omega /k) square root I/sub 0/I/sub 2//I/sub 1/; this minimum requires that the LO voltage across the junction is V/sub LO/=(64I/sub 0//I/sub 2/) /sup 1/4/h omega /e. (I/sub n/ is the current measured on the unpumped I-V curve of the junction at voltage V/sub 0/+nh omega /e). Therefore, although an SIS mixer using an ideal junction can reach the quantum noise limit only in the limit of zero LO power, even the most nearly ideal junctions require a considerable LO for best sensitivity.
A quantum-statistical theory of microwave and millimeter-wave detection using superconducting tunnel junctions is developed, with a rigorous account of quantum, thermal, and shot noise arising from fluctuation sources associated with the junctions, signal source, and matching circuits. The problem of the noise characterization in the quantum sensitivity range is considered and a general noise parameter ΘN is introduced. This parameter is shown to be an adequate figure of merit for most receivers of interest while some devices can require a more complex characterization. Analytical expressions and/or numerically calculated plots for ΘN are presented for the most promising detection modes including the parametric amplification, heterodyne mixing, and quadratic videodetection, using both the quasiparticle-current and the Cooper-pair-current nonlinearities. Ultimate minimum values of ΘN for each detection mode are compared and found to be in agreement with limitations imposed by the quantum-mechanical uncertainty principle.