Some very interesting pure non-Gaussian states in quantum optics have already been produced experimentally (with one pulsed laser): the single-photon-added coherent states, among others. Important interference phenomena by superposing beams from two independent masers or lasers have been investigated earlier experimentally and theoretically. By pursuing on both subjects altogether, we propose a possible new experiment to generate single-photon-added coherent states, by employing two independent laser sources, both in continuous regime and having approximately equal frequencies and coherence times tc: we expect that such generations could occur during times of the order of tc/3 (possibly, a bit shorter). This expectation follows from a fully quantized multimode analysis of the temporal mode structure, which extends previous studies of parametric down conversion and balanced homodyne detection
Coherent interfaces between optical photons and mechanical excitations provide a promising route towards phonon-state engineering and hybrid quantum information processing. Cavity optomechanical systems enable such interfaces via optomechanically induced transparency (OMIT), allowing coherent mapping between traveling optical fields and localized mechanical modes. However, previous implementations of OMIT conversion protocols were limited to classical input signals with large coherent state photon numbers due to room temperature operation and corresponding thermal mechanical noise. Here, we demonstrate efficient low-noise photon-phonon state transfer close to the single-quantum regime in an optomechanical crystal operated at Millikelvin temperatures. Using weak coherent optical input pulses at the few-photon level, we achieve a record-level photon-phonon conversion efficiency of
η=0.76, a mechanical storage lifetime of
T1=7.3 μs, and a tunable conversion bandwidth exceeding 4.5 MHz. Hanbury Brown-Twiss measurements of the retrieved signal demonstrate the coherent nature of the converted phononic state, evidencing low added thermal noise in the conversion process (
nth=9.0). These results establish optomechanical crystals as efficient optical interfaces to GHz mechanical modes and provide a pathway toward deterministic single-quantum-level mechanical state preparation.